While it has been shown that backscattering induced phase noise can be suppressed by adopting acoustic-optic-modulators (AOMs) at the local and remote sites to break the frequency symmetry in both directions. However, this issue can not be avoided for conventional fiber-optic multiple-access coherent optical phase dissemination in which the interference of the signal light with the Rayleigh backscattered light will probably destroy the coherence of the stabilized optical signal. We suppress the backscattering effect by locally breaking the frequency symmetry at the extraction point by inserting an additional AOM. Here, we theoretically analyze and experimentally demonstrate an add-drop one more AOM approach for suppressing the Rayleigh backscattering within the fiber link. Near-complete suppression of backscattering noise is experimentally confirmed through the measurement the elimination of a common interference term of the signal light and the Rayleigh backscattered light. The results demonstrate that the Rayleigh backscattering light has a limited effect compared to the residual delay-limited fiber phase noise on the system's performance. Our results also provide new evidence that it is possible to largely suppress Rayleigh and other backscattering noise within a long optical fiber link, where the accumulated phase noise could be large, by using frequency symmetry breaking at each access node to achieve robust multiple-access coherent optical phase propagation in spite of scatters or defects.
While it has been shown that backscattering induced phase noise can be suppressed by adopting acoustic-optic-modulators (AOMs) at the local and remote sites to break the frequency symmetry in both directions. However, this issue can not be avoided for conventional fiber-optic multiple-access coherent optical phase dissemination in which the interference of the signal light with the Rayleigh backscattered light will probably destroy the coherence of the stabilized optical signal. We suppress the backscattering effect by locally breaking the frequency symmetry at the extraction point by inserting an additional AOM. Here, we theoretically analyze and experimentally demonstrate an add-drop one more AOM approach for suppressing the Rayleigh backscattering within the fiber link. Near-complete suppression of backscattering noise is experimentally confirmed through the measurement the elimination of a common interference term of the signal light and the Rayleigh backscattered light. The results demonstrate that the Rayleigh backscattering light has a limited effect compared to the residual delay-limited fiber phase noise on the system's performance. Our results also provide new evidence that it is possible to largely suppress Rayleigh and other backscattering noise within a long optical fiber link, where the accumulated phase noise could be large, by using frequency symmetry breaking at each access node to achieve robust multiple-access coherent optical phase propagation in spite of scatters or defects.
In this study, we propose an optical frequency transfer scheme based on digitally enhanced heterodyne interferometry (DEHI) to suppress cycle slips induced by fiber-induced backscattering. An in-loop acousto-optic modulator (AOM) performs simultaneous Pseudo-Random Bit Sequence (PRBS) phase modulation and phase compensation, ensuring optical path reciprocity. A dual-stage demodulation architecture, specifically designed for optical frequency transfer, matches the AOM’s intrinsic delay and the round-trip propagation time of the fiber link, thereby effectively suppressing spurious light interference in the beat signal. To evaluate the performance enhancement, we compare the proposed DEHI scheme with the traditional transfer scheme over a 500 km spooled fiber link and a 300 km urban fiber link. The DEHI scheme effectively suppresses backscattering-induced phase errors and exhibits no cycle slips over 86,000 s measurements. It achieves a transfer stability of 1.3 × 10−20at 10,000 s on a 500 km link and 3 × 10−20at 10,000 s on a 300 km link, outperforming the traditional scheme by at least one order of magnitude. This scheme provides a critical solution for establishing future large-scale optical clock networks and high-precision fiber-based frequency dissemination infrastructure.
We present a technique for coherence transfer of laser light through a branching fiber link, where the optical phase noise induced by environmental perturbations via the fiber link is passively compensated by remote users without the requirements of any active servo components. At each remote site, an acousto-optic modulator (AOM) is simultaneously taken as a frequency distinguisher for distinguishing its unique frequency from other sites' and as an optical actuator for compensating the phase noise coming from the optical fiber. With this configuration, we incorporate a long outside loop path consisting of a fiber-pigtailed AOM into the loop, enabling the significant reduction of the outside loop phase noise in the passive way. To further address the residual out-of-loop phase noise coming from the interferometer and the two-way optical frequency comparison setup, we design a low-noise active temperature stabilization system. Measurements with a back-to-back system show that the stability in our stabilization system is 2×10-16at 1 s, reaching 2×10-20after 10,000s. Adopting these techniques, we demonstrate transfer of a laser light through a branching fiber network with 50 km and 145 km two fiber links. After being compensated for the 145 km fiber link, the relative frequency instability is 3.4×10-15at the 1 s averaging time and scales down to 3.7×10-19at the 10,000 s averaging time. This proposed technique is suitable for the simultaneous transfer of an optical signal to a number of independent users within a local area.
In this Letter, we propose and demonstrate a multi-access fiber-optic radio frequency dissemination with passive phase noise cancelation. A forward phase-conjugated signal is generated at the local site by frequency mixing between the standard signal and the round-trip probe signal. A stable frequency signal is achieved by frequency mixing the tapped forward phase-conjugated signal and the backward probe signal at an arbitrary point along the fiber link. Different wavelengths for forward and backward directions are employed to efficiently suppress the effect of backscattering. At the same time, the increase of bidirectional asymmetry with the increase of user ends is avoided by employing the same wavelengths for all user ends. A multi-access frequency transfer over a 45 km fiber link based on the proposed scheme is demonstrated. The radio frequency signals with relative frequency stabilities of 10−17/20,000 s level are reproduced at two points of 5 and 40 km far from the local site along the fiber link, respectively.
We report a technique for coherence transfer of laser light through a fiber link, where the optical phase noise induced by environmental perturbations via the fiber link is compensated by remote users with passive phase noise correction, rather than at the local site as is conventional. Neither phase discrimination nor active phase tracking is required due to the open-loop design, mitigating some technical problems such as the limited compensation speed and the finite compensation precision as conventional active phase noise cancellation. We theoretically analyze and experimentally demonstrate that the delay-limited residual fiber phase noise after phase noise compensation is a factor of seven higher than the conventional techniques. Using this technique, we demonstrate the transfer laser light through a 145-km-long, lab-based spooled fiber. After being compensated, a relative frequency instability is 1.9 × 10-15at the integration time of 1 s and scales down to the level of 10-18-range at 10,000 s. The frequency uncertainty of the light after transferring through the fiber relative to that of the input light is (-0.36 ± 2.6) × 10-18. As the transmitted optical signal remains unaltered until it reaches the remote sites, it can be transmitted simultaneously to multiple remote sites on an arbitrarily complex fiber network, paving a way to develop a multi-node optical frequency dissemination system with post automatic phase noise correction for a number of end-users.
We report the effect of the double Rayleigh backscattering (DRB) noise, in which the interference of the signal light with the double Rayleigh backscattered light, on the fiber-optic radio-frequency (RF) transfer system. Here, we theoretically analyze and experimentally demonstrate that the DRB noise within the fiber link will become the dominative noise on the fiber-optic RF transfer system once narrow linewidth lasers are used. The strong DRB noise is experimentally confirmed through the measurement of the effect of the coherent interference term of the signal light and the double Rayleigh backscattered light on the 100 km RF transfer system. Our results provide evidence that the conventional RF transfer technique with the telecommunications-grade lasers, in which the chromatic dispersion effect in the single-mode fiber is compensated by dispersion compensation fibers (DCFs), could be the better choice for high-performance RF transfer.
SummaryOptical fibers have been regarded as one of the most promising materials for coherent optical frequency dissemination over thousands of kilometers. For suppressing the fiber-induced phase noise along the fiber network, we demonstrate the passive phase noise cancellation (PNC) technique without the need of phase detector could be preferable for noisy fiber links. A fiber-pigtailed acousto-optic modulator (AOM) with two diffraction order outputs (0 and -1 order) has been installed at the local site and been employed as the phase compensated device in the optical frequency transfer system. With a 550 km noisy fiber link, we demonstrate a fractional transfer frequency instability of 1.3 × 10-14at the integration time of 1 s and scales down to 5.5 × 10-19at 10,000 s in terms of modified Allan deviation.