Abstract We propose and analyze a passive architecture for realizing on-chip, scalable cascaded quantum devices. In contrast to standard approaches, our scheme does not rely on breaking Lorentz reciprocity. Rather, we engineer the interplay between pairs of superconducting transmon qubits and a microwave transmission line, in such a way that two delocalized orthogonal excitations emit (and absorb) photons propagating in opposite directions. We show how such cascaded quantum devices can be exploited to passively probe and measure complex many-body operators on quantum registers of stationary qubits, thus enabling the heralded transfer of quantum states between distant qubits, as well as the generation and manipulation of stabilizer codes for quantum error correction.
Abstract We propose and analyze a passive architecture for realizing on-chip, scalable cascaded quantum devices. In contrast to standard approaches, our scheme does not rely on breaking Lorentz reciprocity. Rather, we engineer the interplay between pairs of superconducting transmon qubits and a microwave transmission line, in such a way that two delocalized orthogonal excitations emit (and absorb) photons propagating in opposite directions. We show how such cascaded quantum devices can be exploited to passively probe and measure complex many-body operators on quantum registers of stationary qubits, thus enabling the heralded transfer of quantum states between distant qubits, as well as the generation and manipulation of stabilizer codes for quantum error correction.
This thesis develops theory for and experimentally demonstrates a new way to break Lorentz reciprocity—the symmetry, in an electrical network, under exchange of source and detector. The approach is based on the sequential application of frequency conversion and delay; as frequency and time are Fourier duals, these operations do not generally commute. We apply this method in the construction of an on-chip superconducting microwave circulator, a critical component for the unidirectional routing of quantum information in superconducting networks. The device requires neither permanent magnets nor microwave control tones, allowing on-chip integration with other superconducting circuits without expensive control hardware. Isolation in the device exceeds 20 dB over a bandwidth of tens of MHz, and its insertion loss is small, reaching as low as 0.9 dB at select operation frequencies. Furthermore, the device is linear with respect to input power for signal powers up to many hundreds of fW (~103 circulating photons), and the direction of circulation can be dynamically reconfigured. We demonstrate its tunability with operation at a selection of frequencies between 4 and 6 GHz. Given the current status of quantum error-correction and architectures for quantum information processing with superconducting circuits, such scalable non-reciprocal devices will almost certainly be necessary for construction of a superconducting quantum computer intended to be more than a proof-of-principle.
The ability to control the direction of scattered light is crucial to provide flexibility and scalability for a wide range of on-chip applications, such as integrated photonics, quantum information processing, and nonlinear optics. Tunable directionality can be achieved by applying external magnetic fields that modify optical selection rules, by using nonlinear effects, or interactions with vibrations. However, these approaches are less suitable to control microwave photon propagation inside integrated superconducting quantum devices. Here, we demonstrate on-demand tunable directional scattering based on two periodically modulated transmon qubits coupled to a transmission line at a fixed distance. By changing the relative phase between the modulation tones, we realize unidirectional forward or backward photon scattering. Such an in-situ switchable mirror represents a versatile tool for intra- and inter-chip microwave photonic processors. In the future, a lattice of qubits can be used to realize topological circuits that exhibit strong nonreciprocity or chirality.
Quantum optics in superconducting circuits, known as circuit QED, studies the interaction of photons at microwave frequencies with artificial atoms made of Josephson junctions. Although quite young, remarkable progress has been made in this field over the past decade, especially given the interest in building a quantum computer using superconducting circuits. In this thesis based on the appended papers, we look at generation, engineering and detection of microwave photons using superconducting circuits. We do this by taking advantage of the strong coupling, on-chip tunability and huge nonlinearity available in superconducting circuits. First, we present the strong photon-photon interaction measured experimentally, as shown in the giant cross-Kerr effect. In this work, conditional phase shift of about 20 degrees per photon was measured between two coherent fields at single photon level. Given this strong interaction, we propose and analyze a cascaded setup based on the cross-Kerr effect to detect itinerant microwave photons, a long outstanding problem with only recent experimental realizations. We show that a nondestructive detection of microwave photons is possible with few cascaded transmons. The on-chip tunability of Superconducting Quantum Interference Device (SQUID) is exploited to create a tunable superconducting resonator in the next presented experimental work. Finally, we show that by placing the atom at the end of a transmission line, microwave photons can be generated efficiently and on-demand. We also present a setup that can generate the photons in arbitrary wave packets.
Quantum microwave photonics aims at generating, routing, and manipulating propagating quantum microwave fields in the spirit of optical photonics.To this end, the strong nonlinearities of superconducting quantum circuits can be used to either improve or move beyond the implementation of concepts from the optical domain.In this context, the design of a well-controlled broadband environment for the superconducting quantum circuits is a central task.In this work, we place a superconducting transmon qubit in one arm of an on-chip Mach-Zehnder interferometer composed of two superconducting microwave beam splitters.By measuring its relaxation and dephasing rates we use the qubit as a sensitive spectrometer at the quantum level to probe the broadband electromagnetic environment.For frequencies near the qubit transition frequency, this environment can be well described by an ensemble of harmonic oscillators coupled to the transmon qubit.At low frequencies 0 w , we find experimental evidence for colored quasi-static Gaussian noise with a high spectral weight, as it is typical for ensembles of two-level fluctuators.Our work paves the way towards possible applications of propagating microwave photons, such as emulating quantum impurity models or a novel architecture for quantum information processing.
The quantum sensing landscape has been revolutionized by advanced technologies like superconducting circuits and qubit-based systems which have furthered the ability to probe and understand fundamental properties of quantum matter. Here, we propose an integrated photonic device where a transmon qubit capacitively couples to a microwave cross-resonator, and the setup is employed for sensing of time reversal broken order in materials. In this sensing scheme, the transmon qubit plays a dual role as both a control element and a passive detector, while the photonic cross-resonator serves as the host for the sample, enabling a contact-free spectroscopic method suitable for studying materials where reliable electrical contacts are challenging to obtain, e.g., in van der Waal 2D heterostructures. We show that by tuning the coupling strength and phase between the transmon and the cross-resonator, the system allows selective control over the interaction dynamics and leads to a highly sensitive detection method that can be compactly understood in terms of evolution of excited state population and quantum metric of the resonator-transmon hybrid state. This architecture has the potential to host a wide range of quantum phenomena that can be precisely encoded in the dynamics of the transmon qubit and, in this way, potentially allows access to elusive aspects of correlated materials.
We study a quantum computing system using microwave photons in transmission line resonators on a superconducting chip as qubits. We show that linear optics and other controls necessary for quantum computing can be implemented by coupling to Josephson devices on the same chip. By taking advantage of the strong nonlinearities in Josephson junctions, photonic qubit interactions can be realized. We analyze the gate error rate to demonstrate that our scheme is realistic even for Josephson devices with limited decoherence times. As a conceptually innovative solution based on existing technologies, our scheme provides an integrated and scalable approach to the next key milestone for photonic qubit quantum computing.