Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1901.07211 · Applied Physics Letters

Multiplexed readout of four qubits in 3D circuit QED architecture using a broadband Josephson parametric amplifier

S. Kundu, Nicolas Gheeraert, Sumeru Hazra, Tanay Roy, Kishor V. Salunkhe, Meghan P. Patankar, Rajamani Vijay

Published Apr 29, 2019• 30 citations
arXivHTMLPDF

Abstract

We propose and demonstrate a frequency-multiplexed readout scheme in 3D circuit-quantum electrodynamics (cQED) architecture. We use four transmon qubits coupled to individual rectangular cavities which are aperture-coupled to a common rectangular waveguide feedline. A coaxial to waveguide transformer at the other end of the feedline allows one to launch and collect the multiplexed signal. The reflected readout signal is amplified by an impedance-engineered broadband parametric amplifier with 380 MHz bandwidth. This provides us high fidelity single-shot readout of multiple qubits using compact microwave circuitry, an efficient way for scaling up to more qubits in 3D cQED.

DOI
10.1063/1.5089729

Related papers

High-Fidelity Multiplexed Single-Shot Readout for Transmon Qubits With High-Power Measurement

Hwan‐Seop Yeo, Seungwook Woo, Jeongwon Kim +7 more

Single-shot readout of a quantum state is an essential component in building a large-scale quantum processor, and reducing the readout error is the key challenge. To achieve a high signal-to-noise ratio, quantum-limited low-noise amplifiers such as Josephson parametric amplifiers are typically used. However, a high-fidelity single-shot readout method without a parametric amplifier would be advantageous, as it would reduce system complexity. In this paper, we present a high-fidelity result of frequency-multiplexed, high-power single-shot readout for superconducting qubitswithoutusing a parametric amplifier. We achieved a high readout fidelity of 98.3% with a 400 ns pulse and confirmed that the high-power readout can be used in tomography of an entangled state. We have demonstrated the potential usefulness of this technique in characterizing the final quantum state at the end of quantum operations in a superconducting quantum processor.

IEEE Transactions on Applied Superconductivity•Mar 9, 2023•2 citations

Towards single-shot readout in double-sided coaxial circuit-QED

Martina Esposito, Joseph Rahamim, A. Patterson +11 more

We developed and characterized a Josephson parametric amplifier based on an LC resonator and an array of superconducting quantum interference devices (SQUIDs). We performed preliminary experiments of qubit readout in a double-sided coaxial circuit-QED architecture.

Quantum Information and Measurement (QIM)•Jan 1, 2019•0 citations

Towards quantum-noise limited multiplexed microwave readout of qubits

Kevin P. O’Brien, Chris Macklin, David J. Hover +5 more

Coherent circuits based on superconducting elements hold tremendous promise for the practical implementation of quantum information technology: advanced computation, cryptography, and hardware simulation of complex materials systems are envisioned applications. Such circuits are essentially engineered atoms with level transitions in the 4-8 GHz regime; as such “read” and “write” operations are performed with the aid of fast microwave pulses and low-noise amplifiers, respectively. Recent advances in cavity-based superconducting parametric amplifiers have enabled real-time measurement and feedback in one and two qubits. We demonstrate a novel Josephson junction transmission-line based traveling-wave amplifier which employs sub-wavelength phase matching resonators to achieve high gain, several GHz of bandwidth, and near quantum-noise limited performance. Such devices will enable multiplexed qubit readout in integrated architectures comprised of a variety of microwave frequency analog and digital superconducting technologies: signal sources, multiplexers, ADCs, DACs, mixers, and amplifiers.

IEEE MTT-S International Microwave Symposium digest•May 1, 2016•2 citations

Flux-pumped impedance-engineered broadband Josephson parametric amplifier

Joel Grebel, Audrey Bienfait, Étienne Dumur +7 more

Broadband quantum-limited amplifiers play a critical role in the single-shot readout of superconducting qubits, but a popular implementation, the traveling wave parametric amplifier, involves a complex design and fabrication process. Here, we present a simple design for a Josephson parametric amplifier, using a lumped element resonator comprising a superconducting quantum interference device whose useful bandwidth is enhanced with an on-chip impedance-matching circuit. We demonstrate a flux-coupling geometry that maximizes the coupling to the Josephson loop and minimizes spurious excitation of the amplifier resonant circuit. The amplifier, which operates in a flux-pumped mode, is demonstrated with a power gain of more than 20 dB over a bandwidth of about 300 MHz, where approximate noise measurements indicate quantum-limited performance. A procedure is given for optimizing the bandwidth for this kind of amplifier, using a linearized circuit simulation while minimizing non-linearities.

Applied Physics Letters•Apr 5, 2021•54 citations

Multiplexed readout of transmon qubits with Josephson bifurcation amplifiers

Vivien Schmitt, Xin Zhou, Kristinn Júlíusson +5 more

Achieving individual qubit readout is a major challenge in the development of scalable superconducting quantum processors. We have implemented the multiplexed readout of a four transmon qubit circuit using nonlinear resonators operated as Josephson bifurcation amplifiers. We demonstrate the simultaneous measurement of Rabi oscillations of the four transmons. We find that multiplexed Josephson bifurcation is a high-fidelity readout method, the scalability of which is not limited by the need of a large-bandwidth, nearly quantum-limited amplifier as is the case with linear readout resonators.

arXiv:1409.5647•Physical Review A•Dec 22, 2014•38 citations

Experiments on multi-level superconducting qubits and coaxial circuit QED

Michael Peterer

Superconducting qubits are a promising technology for building a scalable quantum computer. An important architecture employed in the field is called Circuit Quantum Electrodynamics (circuit QED), where such qubits are combined with high quality microwave cavities to study the interaction between artificial atoms and single microwave photons. The ultra-strong coupling achieved in these systems allows for control and readout of the quantum state of qubits to perform quantum information processing. The work on circuit QED performed in this thesis consisted of realizing an experimental setup for qubit experiments in a new laboratory, investigating the coherence and decay of higher energy levels of superconducting transmon qubits and finally demonstrating a novel coaxial form of circuit QED. Designing and building a 3D circuit QED setup involved the following main accomplishments: producing high quality 3D cavities; designing and installing the cryogenic microwave setup as well as the room temperature amplification and data acquisition circuitry; successfully developing a recipe for the fabrication of Josephson junctions; controlling and measuring superconducting 3D transmon qubits at 10mK. Several qubits were fully characterised and have shown coherence times of several microseconds and relaxation times up to 25μs. Superconducting qubits in fact possess higher energy levels that can provide significant computational advantages in quantum information applications. In experiments performed at MIT, preparation and control of the five lowest states of a transmon qubit was demonstrated, followed by an investigation of the phase coherence and decay dynamics of these higher energy levels. The decay was found to proceed mainly sequentially with relaxation times in excess of 20μs for all transitions. A direct measurement of the charge dispersion of these levels was performed to explore their characteristics of dephasing. This experiment was also reproduced on a 3D transmon fabricated and measured in Oxford, where due to a higher effective qubit temperature a multi-level decay model including thermal excitations was developed to explain the observed relaxation dynamics. Finally, a coaxial transmon, which we name the coaxmon, is presented and measured with a coaxial LC readout resonator and input/output coupling ports placed inline along the third dimension. This novel coaxial circuit QED architecture holds great promise for developing a scalable planar grid of qubits to build a quantum computer.

•Jan 1, 2016•1 citation
We propose and demonstrate a frequency-multiplexed readout scheme in 3D circuit-quantum electrodynamics (cQED) architecture. We use four transmon qubits coupled to individual rectangular cavities which are aperture-coupled to a common rectangular waveguide feedline. A coaxial to waveguide transformer at the other end of the feedline allows one to launch and collect the multiplexed signal. The reflected readout signal is amplified by an impedance-engineered broadband parametric amplifier with 380 MHz bandwidth. This provides us high fidelity single-shot readout of multiple qubits using compact microwave circuitry, an efficient way for scaling up to more qubits in 3D cQED.
Single-shot readout of a quantum state is an essential component in building a large-scale quantum processor, and reducing the readout error is the key challenge. To achieve a high signal-to-noise ratio, quantum-limited low-noise amplifiers such as Josephson parametric amplifiers are typically used. However, a high-fidelity single-shot readout method without a parametric amplifier would be advantageous, as it would reduce system complexity. In this paper, we present a high-fidelity result of frequency-multiplexed, high-power single-shot readout for superconducting qubitswithoutusing a parametric amplifier. We achieved a high readout fidelity of 98.3% with a 400 ns pulse and confirmed that the high-power readout can be used in tomography of an entangled state. We have demonstrated the potential usefulness of this technique in characterizing the final quantum state at the end of quantum operations in a superconducting quantum processor.
Coherent circuits based on superconducting elements hold tremendous promise for the practical implementation of quantum information technology: advanced computation, cryptography, and hardware simulation of complex materials systems are envisioned applications. Such circuits are essentially engineered atoms with level transitions in the 4-8 GHz regime; as such “read” and “write” operations are performed with the aid of fast microwave pulses and low-noise amplifiers, respectively. Recent advances in cavity-based superconducting parametric amplifiers have enabled real-time measurement and feedback in one and two qubits. We demonstrate a novel Josephson junction transmission-line based traveling-wave amplifier which employs sub-wavelength phase matching resonators to achieve high gain, several GHz of bandwidth, and near quantum-noise limited performance. Such devices will enable multiplexed qubit readout in integrated architectures comprised of a variety of microwave frequency analog and digital superconducting technologies: signal sources, multiplexers, ADCs, DACs, mixers, and amplifiers.
Broadband quantum-limited amplifiers play a critical role in the single-shot readout of superconducting qubits, but a popular implementation, the traveling wave parametric amplifier, involves a complex design and fabrication process. Here, we present a simple design for a Josephson parametric amplifier, using a lumped element resonator comprising a superconducting quantum interference device whose useful bandwidth is enhanced with an on-chip impedance-matching circuit. We demonstrate a flux-coupling geometry that maximizes the coupling to the Josephson loop and minimizes spurious excitation of the amplifier resonant circuit. The amplifier, which operates in a flux-pumped mode, is demonstrated with a power gain of more than 20 dB over a bandwidth of about 300 MHz, where approximate noise measurements indicate quantum-limited performance. A procedure is given for optimizing the bandwidth for this kind of amplifier, using a linearized circuit simulation while minimizing non-linearities.
Achieving individual qubit readout is a major challenge in the development of scalable superconducting quantum processors. We have implemented the multiplexed readout of a four transmon qubit circuit using nonlinear resonators operated as Josephson bifurcation amplifiers. We demonstrate the simultaneous measurement of Rabi oscillations of the four transmons. We find that multiplexed Josephson bifurcation is a high-fidelity readout method, the scalability of which is not limited by the need of a large-bandwidth, nearly quantum-limited amplifier as is the case with linear readout resonators.
Superconducting qubits are a promising technology for building a scalable quantum computer. An important architecture employed in the field is called Circuit Quantum Electrodynamics (circuit QED), where such qubits are combined with high quality microwave cavities to study the interaction between artificial atoms and single microwave photons. The ultra-strong coupling achieved in these systems allows for control and readout of the quantum state of qubits to perform quantum information processing. The work on circuit QED performed in this thesis consisted of realizing an experimental setup for qubit experiments in a new laboratory, investigating the coherence and decay of higher energy levels of superconducting transmon qubits and finally demonstrating a novel coaxial form of circuit QED. Designing and building a 3D circuit QED setup involved the following main accomplishments: producing high quality 3D cavities; designing and installing the cryogenic microwave setup as well as the room temperature amplification and data acquisition circuitry; successfully developing a recipe for the fabrication of Josephson junctions; controlling and measuring superconducting 3D transmon qubits at 10mK. Several qubits were fully characterised and have shown coherence times of several microseconds and relaxation times up to 25μs. Superconducting qubits in fact possess higher energy levels that can provide significant computational advantages in quantum information applications. In experiments performed at MIT, preparation and control of the five lowest states of a transmon qubit was demonstrated, followed by an investigation of the phase coherence and decay dynamics of these higher energy levels. The decay was found to proceed mainly sequentially with relaxation times in excess of 20μs for all transitions. A direct measurement of the charge dispersion of these levels was performed to explore their characteristics of dephasing. This experiment was also reproduced on a 3D transmon fabricated and measured in Oxford, where due to a higher effective qubit temperature a multi-level decay model including thermal excitations was developed to explain the observed relaxation dynamics. Finally, a coaxial transmon, which we name the coaxmon, is presented and measured with a coaxial LC readout resonator and input/output coupling ports placed inline along the third dimension. This novel coaxial circuit QED architecture holds great promise for developing a scalable planar grid of qubits to build a quantum computer.