Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1809.08747 · Physical Review Applied

Design of an On-Chip Superconducting Microwave Circulator with Octave Bandwidth

Benjamin J. Chapman, Eric I. Rosenthal, Konrad W. Lehnert

Published Apr 16, 2019• 27 citations
arXivHTMLPDF

Abstract

Superconducting qubits are a promising platform for quantum computing, but measurements of such circuits rely on the use of ferrite circulators, which are difficult to miniaturize or make lossless. Replacing those circulators with on-chip superconducting ones has become a major research thrust, but so far most of these replacements have been narrow-band. Thus the authors design an on-chip circulator that combines low-loss circulation with instantaneous bandwidth an octave wide. Such a device could enable the multiplexed readout of hundreds of qubits, facilitating the scale-up that is currently a major hurdle in quantum information processing with superconducting circuits.

DOI
10.1103/physrevapplied.11.044048

Related papers

Widely Tunable On-Chip Microwave Circulator for Superconducting Quantum Circuits

Benjamin J. Chapman, Eric I. Rosenthal, Joseph Kerckhoff +7 more

We report on the design and performance of an on-chip microwave circulator with a widely (GHz) tunable operation frequency.Nonreciprocity is created with a combination of frequency conversion and delay, and requires neither permanent magnets nor microwave bias tones, allowing on-chip integration with other superconducting circuits without the need for high-bandwidth control lines.Isolation in the device exceeds 20 dB over a bandwidth of tens of MHz, and its insertion loss is small, reaching as low as 0.9 dB at select operation frequencies.Furthermore, the device is linear with respect to input power for signal powers up to hundreds of fW (≈10 3 circulating photons), and the direction of circulation can be dynamically reconfigured.We demonstrate its operation at a selection of frequencies between 4 and 6 GHz.

arXiv:1707.04565•Physical Review X•Nov 22, 2017•141 citations

Widely Tunable On-Chip Microwave Circulator for Superconducting Quantum Circuits

Benjamin J. Chapman, Eric I. Rosenthal, Joseph Kerckhoff +6 more

This thesis develops theory for and experimentally demonstrates a new way to break Lorentz reciprocity—the symmetry, in an electrical network, under exchange of source and detector. The approach is based on the sequential application of frequency conversion and delay; as frequency and time are Fourier duals, these operations do not generally commute. We apply this method in the construction of an on-chip superconducting microwave circulator, a critical component for the unidirectional routing of quantum information in superconducting networks. The device requires neither permanent magnets nor microwave control tones, allowing on-chip integration with other superconducting circuits without expensive control hardware. Isolation in the device exceeds 20 dB over a bandwidth of tens of MHz, and its insertion loss is small, reaching as low as 0.9 dB at select operation frequencies. Furthermore, the device is linear with respect to input power for signal powers up to many hundreds of fW (~103 circulating photons), and the direction of circulation can be dynamically reconfigured. We demonstrate its tunability with operation at a selection of frequencies between 4 and 6 GHz. Given the current status of quantum error-correction and architectures for quantum information processing with superconducting circuits, such scalable non-reciprocal devices will almost certainly be necessary for construction of a superconducting quantum computer intended to be more than a proof-of-principle.

•Nov 22, 2017•133 citations

Design of on-chip superconducting parametric circulators based on time-modulated coupled-resonator loops

Yang Liangliang, Kaiyong He, Genting Dai +5 more

Abstract In quantum information detection, significant interest has recently emerged in replacing conventional ferrite circulators with superconducting magnetic-free nonreciprocal devices. However, superconducting non-reciprocal devices with simpler structures and easier manufacturing processes still require further development. Inspired by conventional microwave circuits, we demonstrate a superconducting nonreciprocal circulator by parametric modulation of three identical, strongly and symmetrically coupled resonators. The circulator requires only three DC superconducting quantum interference devices, achieving an isolation of 20 dB , insertion loss of 0.47 dB , and return loss better than 25 dB over an instantaneous bandwidth of 50 MHz . The center frequency of the circulator is tunable within the range of 4– 8 GHz . Detailed design considerations for the experimental realization of a three-port superconducting circulator are presented, together with simulation results for a four-port circulator. Compared with previously reported superconducting magnetic-free nonreciprocal devices, the proposed circulator features a simpler circuit topology, demonstrating strong potential for scalable superconducting quantum information detection.

Superconductor Science and Technology•Dec 11, 2025•0 citations

Low-loss on-chip superconducting microwave circulator assisted by shunting capacitors

N. Pradeep Kumar, Dat Thanh Le, Prasanna Pakkiam +2 more

Ferrite-free circulators that are passive and readily integratable on a chip are highly sought-after in quantum technologies based on superconducting circuits. In our previous work, we implemented such a circulator using a three-Josephson-junction loop that exhibited unambiguous nonreciprocity and signal circulation, but required junction energies to be within 1 % of design values. This tolerance is tighter than standard junction fabrication methods provide, so we propose and demonstrate a design improvement that relaxes the required junction fabrication precision, allowing for higher device performance and fabrication yield. Specifically, we introduce large direct capacitive couplings between the waveguides, which based on the modeling we describe here, requires less stringent junction fabrication tolerance. We implement the design, and measure enhanced “circulation fidelity” above 97 % , with optimized on-resonance insertion loss of 0.2 dB, isolation of 18 dB, and power reflectance of − 15 dB , in good agreement with model calculations.

arXiv:2406.14821•Physical Review Research•Jan 21, 2025•8 citations

Operating a passive on-chip superconducting circulator: Device control and quasiparticle effects

Dat Thanh Le, Clemens Müller, Rohit Navarathna +2 more

Microwave circulators play an important role in quantum technology based on superconducting circuits. The conventional circulator design, which employs ferrite materials, is bulky and involves strong magnetic fields, rendering it unsuitable for integration on superconducting chips. One promising design for an on-chip superconducting circulator is based on a passive Josephson-junction ring. In this paper, we consider two operational issues for such a device: circuit tuning and the effects of quasiparticle tunneling. We compute the scattering matrix using adiabatic elimination and derive the parameter constraints to achieve optimal circulation. We then numerically optimize the circulator performance over the full set of external control parameters, including gate voltages and flux bias, to demonstrate that this multidimensional optimization converges quickly to find optimal working points. We also consider the possibility of quasiparticle tunneling in the circulator ring and how it affects signal circulation. Our results form the basis for practical operation of a passive on-chip superconducting circulator made from a ring of Josephson junctions.

arXiv:2103.02759•Physical Review Research•Dec 23, 2021•10 citations

All-optical superconducting qubit readout

Georg Arnold, Thomas Werner, Rishabh Sahu +3 more

The rapid development of superconducting quantum hardware is expected to run into substantial restrictions on scalability because error correction in a cryogenic environment has stringent input-output requirements. Classical data centres rely on fibre-optic interconnects to remove similar networking bottlenecks. In the same spirit, ultracold electro-optic links have been proposed and used to generate qubit control signals, or to replace cryogenic readout electronics. So far, these approaches have suffered from either low efficiency, low bandwidth or additional noise. Here we realize radio-over-fibre qubit readout at millikelvin temperatures. We use one device to simultaneously perform upconversion and downconversion between microwave and optical frequencies and so do not require any active or passive cryogenic microwave equipment. We demonstrate all-optical single-shot readout in a circulator-free readout scheme. Importantly, we do not observe any direct radiation impact on the qubit state, despite the absence of shielding elements. This compatibility between superconducting circuits and telecom-wavelength light is not only a prerequisite to establish modular quantum networks, but it is also relevant for multiplexed readout of superconducting photon detectors and classical superconducting logic.

arXiv:2310.16817•Nature Physics•Feb 11, 2025•48 citations
Superconducting qubits are a promising platform for quantum computing, but measurements of such circuits rely on the use of ferrite circulators, which are difficult to miniaturize or make lossless. Replacing those circulators with on-chip superconducting ones has become a major research thrust, but so far most of these replacements have been narrow-band. Thus the authors design an on-chip circulator that combines low-loss circulation with instantaneous bandwidth an octave wide. Such a device could enable the multiplexed readout of hundreds of qubits, facilitating the scale-up that is currently a major hurdle in quantum information processing with superconducting circuits.
We report on the design and performance of an on-chip microwave circulator with a widely (GHz) tunable operation frequency.Nonreciprocity is created with a combination of frequency conversion and delay, and requires neither permanent magnets nor microwave bias tones, allowing on-chip integration with other superconducting circuits without the need for high-bandwidth control lines.Isolation in the device exceeds 20 dB over a bandwidth of tens of MHz, and its insertion loss is small, reaching as low as 0.9 dB at select operation frequencies.Furthermore, the device is linear with respect to input power for signal powers up to hundreds of fW (≈10 3 circulating photons), and the direction of circulation can be dynamically reconfigured.We demonstrate its operation at a selection of frequencies between 4 and 6 GHz.
This thesis develops theory for and experimentally demonstrates a new way to break Lorentz reciprocity—the symmetry, in an electrical network, under exchange of source and detector. The approach is based on the sequential application of frequency conversion and delay; as frequency and time are Fourier duals, these operations do not generally commute. We apply this method in the construction of an on-chip superconducting microwave circulator, a critical component for the unidirectional routing of quantum information in superconducting networks. The device requires neither permanent magnets nor microwave control tones, allowing on-chip integration with other superconducting circuits without expensive control hardware. Isolation in the device exceeds 20 dB over a bandwidth of tens of MHz, and its insertion loss is small, reaching as low as 0.9 dB at select operation frequencies. Furthermore, the device is linear with respect to input power for signal powers up to many hundreds of fW (~103 circulating photons), and the direction of circulation can be dynamically reconfigured. We demonstrate its tunability with operation at a selection of frequencies between 4 and 6 GHz. Given the current status of quantum error-correction and architectures for quantum information processing with superconducting circuits, such scalable non-reciprocal devices will almost certainly be necessary for construction of a superconducting quantum computer intended to be more than a proof-of-principle.
Abstract In quantum information detection, significant interest has recently emerged in replacing conventional ferrite circulators with superconducting magnetic-free nonreciprocal devices. However, superconducting non-reciprocal devices with simpler structures and easier manufacturing processes still require further development. Inspired by conventional microwave circuits, we demonstrate a superconducting nonreciprocal circulator by parametric modulation of three identical, strongly and symmetrically coupled resonators. The circulator requires only three DC superconducting quantum interference devices, achieving an isolation of 20 dB , insertion loss of 0.47 dB , and return loss better than 25 dB over an instantaneous bandwidth of 50 MHz . The center frequency of the circulator is tunable within the range of 4– 8 GHz . Detailed design considerations for the experimental realization of a three-port superconducting circulator are presented, together with simulation results for a four-port circulator. Compared with previously reported superconducting magnetic-free nonreciprocal devices, the proposed circulator features a simpler circuit topology, demonstrating strong potential for scalable superconducting quantum information detection.
Ferrite-free circulators that are passive and readily integratable on a chip are highly sought-after in quantum technologies based on superconducting circuits. In our previous work, we implemented such a circulator using a three-Josephson-junction loop that exhibited unambiguous nonreciprocity and signal circulation, but required junction energies to be within 1 % of design values. This tolerance is tighter than standard junction fabrication methods provide, so we propose and demonstrate a design improvement that relaxes the required junction fabrication precision, allowing for higher device performance and fabrication yield. Specifically, we introduce large direct capacitive couplings between the waveguides, which based on the modeling we describe here, requires less stringent junction fabrication tolerance. We implement the design, and measure enhanced “circulation fidelity” above 97 % , with optimized on-resonance insertion loss of 0.2 dB, isolation of 18 dB, and power reflectance of − 15 dB , in good agreement with model calculations.
Microwave circulators play an important role in quantum technology based on superconducting circuits. The conventional circulator design, which employs ferrite materials, is bulky and involves strong magnetic fields, rendering it unsuitable for integration on superconducting chips. One promising design for an on-chip superconducting circulator is based on a passive Josephson-junction ring. In this paper, we consider two operational issues for such a device: circuit tuning and the effects of quasiparticle tunneling. We compute the scattering matrix using adiabatic elimination and derive the parameter constraints to achieve optimal circulation. We then numerically optimize the circulator performance over the full set of external control parameters, including gate voltages and flux bias, to demonstrate that this multidimensional optimization converges quickly to find optimal working points. We also consider the possibility of quasiparticle tunneling in the circulator ring and how it affects signal circulation. Our results form the basis for practical operation of a passive on-chip superconducting circulator made from a ring of Josephson junctions.
The rapid development of superconducting quantum hardware is expected to run into substantial restrictions on scalability because error correction in a cryogenic environment has stringent input-output requirements. Classical data centres rely on fibre-optic interconnects to remove similar networking bottlenecks. In the same spirit, ultracold electro-optic links have been proposed and used to generate qubit control signals, or to replace cryogenic readout electronics. So far, these approaches have suffered from either low efficiency, low bandwidth or additional noise. Here we realize radio-over-fibre qubit readout at millikelvin temperatures. We use one device to simultaneously perform upconversion and downconversion between microwave and optical frequencies and so do not require any active or passive cryogenic microwave equipment. We demonstrate all-optical single-shot readout in a circulator-free readout scheme. Importantly, we do not observe any direct radiation impact on the qubit state, despite the absence of shielding elements. This compatibility between superconducting circuits and telecom-wavelength light is not only a prerequisite to establish modular quantum networks, but it is also relevant for multiplexed readout of superconducting photon detectors and classical superconducting logic.