Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1707.08906 · Physical Review Applied

On-Chip Quantum-Dot Light Source for Quantum-Device Readout

Y.-Y. Liu, J. Stehlik, X. Mi, Thomas R. Hartke, M. J. Gullans, J. R. Petta

Published Jan 29, 2018• 9 citations
arXivHTMLPDF

Abstract

Microwave readout of charge states and spin states is important for quantum information science, but is difficult to scale to a large number of qubits, due to cost and the size of the components required to faithfully transmit the signal from room temperature to mK qubit temperatures. In this study, a voltage-biased semiconductor double quantum dot is used to generate microwave photons, yielding a cryogenic on-chip source for charge-state readout. Surprisingly, the emission properties of the double dot are affected by other qubits placed in the same microwave cavity. These results should facilitate the development of a large quantum processor to realize true quantum supremacy.

DOI
10.1103/physrevapplied.9.014030

Related papers

Micro-scale photon source in a hybrid cQED system*

Mingbo Chen, Bao‐Chuan Wang, Si‐Si Gu +4 more

Coherent photon source is an important element that has been widely used in spectroscopy, imaging, detection, and teleportation in quantum optics. However, it is still a challenge to realize micro-scale coherent emitters in semiconductor systems. We report the observation of gain in a cavity-coupled GaAs double quantum dot system with a voltage bias across the device. By characterizing and analyzing the cavity responses to different quantum dot behaviors, we distinguish the microwave photon emission from the signal gain. This study provides a possibility to realize micro-scale amplifiers or coherent microwave photon sources in circuit quantum electrodynamics (cQED) hybrid systems.

Chinese Physics B•Feb 3, 2021•2 citations

A cryogenic on-chip microwave pulse generator for large-scale superconducting quantum computing

Zenghui Bao, Yan Li, Zhiling Wang +7 more

For superconducting quantum processors, microwave signals are delivered to each qubit from room-temperature electronics to the cryogenic environment through coaxial cables. Limited by the heat load of cabling and the massive cost of electronics, such an architecture is not viable for millions of qubits required for fault-tolerant quantum computing. Monolithic integration of the control electronics and the qubits provides a promising solution, which, however, requires a coherent cryogenic microwave pulse generator that is compatible with superconducting quantum circuits. Here, we report such a signal source driven by digital-like signals, generating pulsed microwave emission with well-controlled phase, intensity, and frequency directly at millikelvin temperatures. We showcase high-fidelity readout of superconducting qubits with the microwave pulse generator. The device demonstrated here has a small footprint, negligible heat load, great flexibility to operate, and is fully compatible with today's superconducting quantum circuits, thus providing an enabling technology for large-scale superconducting quantum computers.

arXiv:2407.11775•Nature Communications•Jul 16, 2024•31 citations

Large Dispersive Interaction between a CMOS Double Quantum Dot and Microwave Photons

David J. Ibberson, Theodor Lundberg, James A. Haigh +11 more

A dual-chip architecture is presented for gate dispersive readout of charge states in quantum electronic devices, which outperforms previous fully-integrated systems and may facilitate scaling of spin-qubits.

arXiv:2004.00334•PRX Quantum•May 5, 2021•57 citations

Input-output theory for spin-photon coupling in Si double quantum dots

Mónica Benito, Xiao Mi, Jacob M. Taylor +2 more

The interaction of qubits via microwave frequency photons enables long-distance qubit-qubit coupling and facilitates the realization of a large-scale quantum processor. However, qubits based on electron spins in semiconductor quantum dots have proven challenging to couple to microwave photons. In this theoretical work we show that a sizable coupling for a single electron spin is possible via spin-charge hybridization using a magnetic field gradient in a silicon double quantum dot. Based on parameters already shown in recent experiments, we predict optimal working points to achieve a coherent spin-photon coupling, an essential ingredient for the generation of long-range entanglement. Furthermore, we employ input-output theory to identify observable signatures of spin-photon coupling in the cavity output field, which may provide guidance to the experimental search for strong coupling in such spin-photon systems and opens the way to cavity-based readout of the spin qubit.

arXiv:1710.02508•Physical review. B./Physical review. B•Dec 22, 2017•111 citations

A programmable quantum photonic platform integrating coherent emitters

Hanna Salamon, Mikkel T. Mikkelsen, Zhe Liu +4 more

Photonic quantum technologies require the integration of high-quality quantum light sources with programmable photonic circuitry to enable on-chip quantum information processing. Semiconductor quantum dots have emerged as a leading platform for quantum light generation, yet their monolithic integration with cryogenic-compatible, programmable photonic circuitry remains challenging. Here we demonstrate a programmable quantum photonic platform that enables simultaneous control of highly coherent quantum dot-based single photon emitters and reconfigurable optical elements at cryogenic temperatures. System-level integration enables individual electrical and optical addressing of active components on a single chip, allowing their concurrent operation while preserving coherent non-classical light emission. We demonstrate multiple quantum-photonic functionalities, including pure single-photon generation, two-photon interference, and resonant transmission and reflection measurements of integrated emitters. These results mark a step from isolated quantum-optical devices towards programmable quantum-photonic hardware platforms capable of combining coherent quantum emitters with large-scale photonic functionality.

quant-pharXiv:2610.06451•Oct 6, 2026•0 citations

Development of a Silicon Semiconductor Quantum Dot Qubit with Dispersive Microwave Readout

Edward Henry

Semiconductor quantum dots in silicon demonstrate exceptionally long spin lifetimes as qubits and are therefore promising candidates for quantum information processing. However, control and readout techniques for these devices have thus far employed low frequency electrons, in contrast to high speed temperature readout techniques used in other qubit architectures, and coupling between multiple quantum dot qubits has not been satisfactorily addressed.This dissertation presents the design and characterization of a semiconductor charge qubit based on double quantum dot in silicon with an integrated microwave resonator for control and readout. The 6 GHz resonator is designed to achieve strong coupling with the quantum dot qubit, allowing the use of circuit QED control and readout techniques which have not previously been applicable to semiconductor qubits. To achieve this coupling, this document demonstrates successful operation of a novel silicon double quantum dot design with a single active metallic layer and a coplanar stripline resonator with a bias tee for dc excitation.Experiments presented here demonstrate quantum localization and measurement of both electrons on the quantum dot and photons in the resonator. Further, it is shown that the resonator-qubit coupling in these devices is sufficient to reach the strong coupling regime of circuit QED. The details of a measurement setup capable of performing simultaneous low noise measurements of the resonator and quantum dot structure are also presented here.The ultimate aim of this research is to integrate the long coherence times observed in electron spins in silicon with the sophisticated readout architectures available in circuit QED based quantum information systems. This would allow superconducting qubits to be coupled directly to semiconductor qubits to create hybrid quantum systems with separate quantum memory and processing components.

•Jan 1, 2013•0 citations
Microwave readout of charge states and spin states is important for quantum information science, but is difficult to scale to a large number of qubits, due to cost and the size of the components required to faithfully transmit the signal from room temperature to mK qubit temperatures. In this study, a voltage-biased semiconductor double quantum dot is used to generate microwave photons, yielding a cryogenic on-chip source for charge-state readout. Surprisingly, the emission properties of the double dot are affected by other qubits placed in the same microwave cavity. These results should facilitate the development of a large quantum processor to realize true quantum supremacy.
Coherent photon source is an important element that has been widely used in spectroscopy, imaging, detection, and teleportation in quantum optics. However, it is still a challenge to realize micro-scale coherent emitters in semiconductor systems. We report the observation of gain in a cavity-coupled GaAs double quantum dot system with a voltage bias across the device. By characterizing and analyzing the cavity responses to different quantum dot behaviors, we distinguish the microwave photon emission from the signal gain. This study provides a possibility to realize micro-scale amplifiers or coherent microwave photon sources in circuit quantum electrodynamics (cQED) hybrid systems.
For superconducting quantum processors, microwave signals are delivered to each qubit from room-temperature electronics to the cryogenic environment through coaxial cables. Limited by the heat load of cabling and the massive cost of electronics, such an architecture is not viable for millions of qubits required for fault-tolerant quantum computing. Monolithic integration of the control electronics and the qubits provides a promising solution, which, however, requires a coherent cryogenic microwave pulse generator that is compatible with superconducting quantum circuits. Here, we report such a signal source driven by digital-like signals, generating pulsed microwave emission with well-controlled phase, intensity, and frequency directly at millikelvin temperatures. We showcase high-fidelity readout of superconducting qubits with the microwave pulse generator. The device demonstrated here has a small footprint, negligible heat load, great flexibility to operate, and is fully compatible with today's superconducting quantum circuits, thus providing an enabling technology for large-scale superconducting quantum computers.
The interaction of qubits via microwave frequency photons enables long-distance qubit-qubit coupling and facilitates the realization of a large-scale quantum processor. However, qubits based on electron spins in semiconductor quantum dots have proven challenging to couple to microwave photons. In this theoretical work we show that a sizable coupling for a single electron spin is possible via spin-charge hybridization using a magnetic field gradient in a silicon double quantum dot. Based on parameters already shown in recent experiments, we predict optimal working points to achieve a coherent spin-photon coupling, an essential ingredient for the generation of long-range entanglement. Furthermore, we employ input-output theory to identify observable signatures of spin-photon coupling in the cavity output field, which may provide guidance to the experimental search for strong coupling in such spin-photon systems and opens the way to cavity-based readout of the spin qubit.
Photonic quantum technologies require the integration of high-quality quantum light sources with programmable photonic circuitry to enable on-chip quantum information processing. Semiconductor quantum dots have emerged as a leading platform for quantum light generation, yet their monolithic integration with cryogenic-compatible, programmable photonic circuitry remains challenging. Here we demonstrate a programmable quantum photonic platform that enables simultaneous control of highly coherent quantum dot-based single photon emitters and reconfigurable optical elements at cryogenic temperatures. System-level integration enables individual electrical and optical addressing of active components on a single chip, allowing their concurrent operation while preserving coherent non-classical light emission. We demonstrate multiple quantum-photonic functionalities, including pure single-photon generation, two-photon interference, and resonant transmission and reflection measurements of integrated emitters. These results mark a step from isolated quantum-optical devices towards programmable quantum-photonic hardware platforms capable of combining coherent quantum emitters with large-scale photonic functionality.
Semiconductor quantum dots in silicon demonstrate exceptionally long spin lifetimes as qubits and are therefore promising candidates for quantum information processing. However, control and readout techniques for these devices have thus far employed low frequency electrons, in contrast to high speed temperature readout techniques used in other qubit architectures, and coupling between multiple quantum dot qubits has not been satisfactorily addressed.This dissertation presents the design and characterization of a semiconductor charge qubit based on double quantum dot in silicon with an integrated microwave resonator for control and readout. The 6 GHz resonator is designed to achieve strong coupling with the quantum dot qubit, allowing the use of circuit QED control and readout techniques which have not previously been applicable to semiconductor qubits. To achieve this coupling, this document demonstrates successful operation of a novel silicon double quantum dot design with a single active metallic layer and a coplanar stripline resonator with a bias tee for dc excitation.Experiments presented here demonstrate quantum localization and measurement of both electrons on the quantum dot and photons in the resonator. Further, it is shown that the resonator-qubit coupling in these devices is sufficient to reach the strong coupling regime of circuit QED. The details of a measurement setup capable of performing simultaneous low noise measurements of the resonator and quantum dot structure are also presented here.The ultimate aim of this research is to integrate the long coherence times observed in electron spins in silicon with the sophisticated readout architectures available in circuit QED based quantum information systems. This would allow superconducting qubits to be coupled directly to semiconductor qubits to create hybrid quantum systems with separate quantum memory and processing components.