Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1702.08077 · npj Quantum Information

Correlators in simultaneous measurement of non-commuting qubit observables

Juan Atalaya, Shay Hacohen-Gourgy, Leigh S. Martin, Irfan A. Siddiqi, Alexander N. Korotkov

Published Aug 29, 2018• 24 citations
arXivHTMLPDF

Abstract

Abstract One of the hallmarks of quantum mechanics is the impossibility of simultaneous measurement of non-commuting observables with projective measurements. This, however, can be circumvented by using continuous quantum measurements. Here we investigate the temporal correlations of the output signals of detectors continuously and simultaneously measuring the qubit observables σz and σz cosφ + σx sinφ, for various angles φ. Using the quantum Bayesian formalism, we obtain analytical expressions for the correlators, which we find to be in good agreement with those obtained from experimentally measured output signals. The agreement is particularly good for cross-correlators, even at times shorter than the cavity modes decay time. We further discuss how the correlators can be applied for parameter estimation, and use them to infer a small residual qubit Hamiltonian arising from calibration inaccuracy in the experimental data. Our work opens up new possibilities to perform quantum metrology based on temporal correlations of measured data.

DOI
10.1038/s41534-018-0091-1

Related papers

Simultaneous continuous measurement of noncommuting observables: Quantum state correlations

Areeya Chantasri, Juan Atalaya, Shay Hacohen-Gourgy +3 more

We consider the temporal correlations of the quantum state of a qubit subject to simultaneous continuous measurement of two noncommuting qubit observables. Such qubit state correlators are defined for an ensemble of qubit trajectories, which has the same fixed initial state and can also be optionally constrained by a fixed final state. We develop a stochastic path integral description for the continuous quantum measurement and use it to calculate the considered correlators. Exact analytic results are possible in the case of ideal measurements of equal strength and are also shown to agree with solutions obtained using the Fokker-Planck equation. For a more general case with decoherence effects and inefficiency, we use a diagrammatic approach to find the correlators perturbatively in the quantum efficiency. We also calculate the state correlators for the quantum trajectories which are extracted from readout signals measured in a transmon qubit experiment, by means of the quantum Bayesian state update. We find an excellent agreement between the correlators based on the experimental data and those obtained from our analytical and numerical results.

arXiv:1706.09670•Physical Review A•Jan 17, 2018•28 citations

Multitime correlators in continuous measurement of qubit observables

Juan Atalaya, Shay Hacohen-Gourgy, Leigh S. Martin +2 more

We consider multitime correlators for output signals from linear detectors, continuously measuring several qubit observables at the same time. Using the quantum Bayesian formalism, we show that for unital (symmetric) evolution in the absence of phase backaction, an $N$-time correlator can be expressed as a product of two-time correlators when $N$ is even. For odd $N$, there is a similar factorization, which also includes a single-time average. Theoretical predictions agree well with experimental results for two detectors, which simultaneously measure noncommuting qubit observables.

arXiv:1710.05249•Physical Review A•Feb 9, 2018•16 citations

Continuous Quantum Measurement with Independent Detector Cross Correlations

Andrew N. Jordan, Μ. Büttiker

We investigate the advantages of using two independent, linear detectors for continuous quantum measurement. For single-shot measurement, the detection process may be quantum limited if the detectors are twins. For weak continuous measurement, cross correlations allow a violation of the Korotkov-Averin bound for the detector's signal-to-noise ratio. The joint weak measurement of noncommuting observables is also investigated, and we find the cross correlation changes sign as a function of frequency, reflecting a crossover from incoherent relaxation to coherent, out of phase oscillations. Our results are applied to a double quantum-dot charge qubit, simultaneously measured by two quantum point contacts.

arXiv:cond-mat/0505044•Physical Review Letters•Nov 21, 2005•70 citations

Nonideal quantum detectors in Bayesian formalism

Alexander N. Korotkov

The Bayesian formalism for a continuous measurement of solid-state qubits is extended to a model which takes into account several factors of the detector nonideality. In particular, we consider additional classical output and backaction noises (with finite correlation), together with quantum-limited output and backaction noises, and take into account possible asymmetry of the detector coupling. The formalism is first derived for a single qubit and then generalized to the measurement of entangled qubits.

arXiv:cond-mat/0211647•Physical review. B, Condensed matter•Jun 10, 2003•28 citations

Parameters estimation by fitting correlation functions of continuous quantum measurement

Pierre Guilmin, Pierre Rouchon, Antoine Tilloy

We propose a simple method to estimate the parameters of a continuously measured quantum system, by fitting correlation functions of the measured signal. We demonstrate the approach in simulation, both on toy examples and on a recent superconducting circuits experiment which proved particularly difficult to characterise using conventional methods. The idea is applicable to any system whose evolution is described by a jump or diffusive stochastic master equation. It allows the simultaneous estimation of many parameters, is practical for everyday use, is suitable for large Hilbert space dimensions, and takes into account experimental constraints such as detector imperfections and signal filtering and digitisation. Unlike existing methods, it also provides a direct way to understand how each parameter is estimated from the measured signal. This makes the approach interpretable, facilitates debugging, and enables validating the adequacy of a model with the observed data.

arXiv:2410.11955•Oct 15, 2024•7 citations

Multi-time quantum correlations with no spatial analog

Martin Ringbauer, Fabio Costa, M. E. Goggin +2 more

Abstract Multipartite quantum correlations are a powerful resource that underpins applications from quantum metrology to quantum computing. While most research has focused on spatial correlations, it is now becoming clear that a sequence of measurements on a single quantum system at different points in time reveals a similarly rich, yet fundamentally different structure of multipartite temporal correlations. Here we experimentally observe genuine multi-time correlations in a sequence of three generalized measurements on a single photon. These correlations, manifest by a simultaneous violation of all pairwise Bell inequalities, cannot be reproduced by any spatial quantum state of equal dimension. Our work lays the foundation for the exploration of temporal correlations arising in quantum networks for quantum information applications.

npj Quantum Information•Jul 25, 2018•29 citations
Abstract One of the hallmarks of quantum mechanics is the impossibility of simultaneous measurement of non-commuting observables with projective measurements. This, however, can be circumvented by using continuous quantum measurements. Here we investigate the temporal correlations of the output signals of detectors continuously and simultaneously measuring the qubit observables σz and σz cosφ + σx sinφ, for various angles φ. Using the quantum Bayesian formalism, we obtain analytical expressions for the correlators, which we find to be in good agreement with those obtained from experimentally measured output signals. The agreement is particularly good for cross-correlators, even at times shorter than the cavity modes decay time. We further discuss how the correlators can be applied for parameter estimation, and use them to infer a small residual qubit Hamiltonian arising from calibration inaccuracy in the experimental data. Our work opens up new possibilities to perform quantum metrology based on temporal correlations of measured data.
We consider the temporal correlations of the quantum state of a qubit subject to simultaneous continuous measurement of two noncommuting qubit observables. Such qubit state correlators are defined for an ensemble of qubit trajectories, which has the same fixed initial state and can also be optionally constrained by a fixed final state. We develop a stochastic path integral description for the continuous quantum measurement and use it to calculate the considered correlators. Exact analytic results are possible in the case of ideal measurements of equal strength and are also shown to agree with solutions obtained using the Fokker-Planck equation. For a more general case with decoherence effects and inefficiency, we use a diagrammatic approach to find the correlators perturbatively in the quantum efficiency. We also calculate the state correlators for the quantum trajectories which are extracted from readout signals measured in a transmon qubit experiment, by means of the quantum Bayesian state update. We find an excellent agreement between the correlators based on the experimental data and those obtained from our analytical and numerical results.
We consider multitime correlators for output signals from linear detectors, continuously measuring several qubit observables at the same time. Using the quantum Bayesian formalism, we show that for unital (symmetric) evolution in the absence of phase backaction, an NNN-time correlator can be expressed as a product of two-time correlators when NNN is even. For odd NNN, there is a similar factorization, which also includes a single-time average. Theoretical predictions agree well with experimental results for two detectors, which simultaneously measure noncommuting qubit observables.
We investigate the advantages of using two independent, linear detectors for continuous quantum measurement. For single-shot measurement, the detection process may be quantum limited if the detectors are twins. For weak continuous measurement, cross correlations allow a violation of the Korotkov-Averin bound for the detector's signal-to-noise ratio. The joint weak measurement of noncommuting observables is also investigated, and we find the cross correlation changes sign as a function of frequency, reflecting a crossover from incoherent relaxation to coherent, out of phase oscillations. Our results are applied to a double quantum-dot charge qubit, simultaneously measured by two quantum point contacts.
The Bayesian formalism for a continuous measurement of solid-state qubits is extended to a model which takes into account several factors of the detector nonideality. In particular, we consider additional classical output and backaction noises (with finite correlation), together with quantum-limited output and backaction noises, and take into account possible asymmetry of the detector coupling. The formalism is first derived for a single qubit and then generalized to the measurement of entangled qubits.
We propose a simple method to estimate the parameters of a continuously measured quantum system, by fitting correlation functions of the measured signal. We demonstrate the approach in simulation, both on toy examples and on a recent superconducting circuits experiment which proved particularly difficult to characterise using conventional methods. The idea is applicable to any system whose evolution is described by a jump or diffusive stochastic master equation. It allows the simultaneous estimation of many parameters, is practical for everyday use, is suitable for large Hilbert space dimensions, and takes into account experimental constraints such as detector imperfections and signal filtering and digitisation. Unlike existing methods, it also provides a direct way to understand how each parameter is estimated from the measured signal. This makes the approach interpretable, facilitates debugging, and enables validating the adequacy of a model with the observed data.
Abstract Multipartite quantum correlations are a powerful resource that underpins applications from quantum metrology to quantum computing. While most research has focused on spatial correlations, it is now becoming clear that a sequence of measurements on a single quantum system at different points in time reveals a similarly rich, yet fundamentally different structure of multipartite temporal correlations. Here we experimentally observe genuine multi-time correlations in a sequence of three generalized measurements on a single photon. These correlations, manifest by a simultaneous violation of all pairwise Bell inequalities, cannot be reproduced by any spatial quantum state of equal dimension. Our work lays the foundation for the exploration of temporal correlations arising in quantum networks for quantum information applications.