Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1702.00494 · Optics Express

Rydberg-atom based radio-frequency electrometry using frequency modulation spectroscopy in room temperature vapor cells

Santosh Kumar, Haoquan Fan, Harald Kübler, Akbar J. Jahangiri, James P. Shaffer

Published Apr 4, 2017• 175 citations
arXivHTMLPDF

Abstract

sensitivity is achieved and is found to be photon shot noise limited.
DOI
10.1364/oe.25.008625

Related papers

Radio-frequency Electrometry Using Rydberg Atoms in Vapor Cells: Towards the Shot Noise Limit

Santosh Kumar, Haoquan Fan, Akbar Jahangiri Jozani +2 more

Bulletin of the American Physical Society•May 25, 2016•0 citations

Photon Shot Noise Limited Radio Frequency Electric Field Sensing Using Rydberg Atoms in Vapor Cells

Santosh Kumar, Akbar Jahangiri Jozani, Haoquan Fan +2 more

Bulletin of the American Physical Society•Jun 9, 2017•0 citations

Photon shot-noise-limited Rydberg-EIT electrometry

Gyeongmin Ju, Ye Jin Yu, Heewoo Kim +4 more

Rydberg-atom electrometry is a core technique in the development of highly sensitive quantum electric-field sensors. Its sensitivity based on atom-photon interaction is typically limited by photon shot-noise (PSN) and spectral broadenings. Here, we experimentally demonstrate a near PSN-limited Rydberg electrometry from a 85Rb atomic vapor cell. By engineering atomic coherence through control of residual magnetic fields and laser frequency noise, we achieve the Rydberg electromagnetically induced transparency (EIT) with the narrow linewidth of 1.6 MHz, yielding an enhanced spectral slope for high-sensitivity Rydberg-EIT electrometry. Under optimized superheterodyne detection conditions, we obtain an electric-field sensitivity of 12.5(8) nV cm^-1 Hz^-1/2 at 37 GHz, in close agreement with the calculated PSN limit. These results provide direct experimental evidence of the high-sensitive quantum electrometry and establish a practical route toward quantum-noise-limited Rydberg electrometry.

physics.atom-phCross-listedarXiv:2606.04354•Jun 4, 2026•1 citation

Quantum-Assisted Electrometry using Electromagnetically Induced Transparency with Rydberg Atoms in a Vapor Cell

Haoquan Fan, Santosh Kumar, Renate Daschner +3 more

APS•May 1, 2014•0 citations

Precision timing of radio-frequency pulses using Rydberg atom electrometry

Stephanie M. Bohaichuk, Donald W. Booth, James P. Shaffer

In this work, we present theoretical and experimental data on detecting pulsed radio frequency fields. We focus on pulse arrival time detection accuracy. We measure two-photon Rydberg atom EIT in response to ~μs pulse-modulated radio-frequency signals resonant with a Rydberg-Rydberg transition, using a room temperature cesium vapor cell with the lasers locked on atomic resonances. We study the dependence of the atomic response on optical and radio-frequency Rabi frequencies as well as effects such as atomic collisions, ionization, and transit time broadening. We find good agreement with time-dependent simulations performed using a density matrix approach, with a dark state added to account for Rydberg atom decay. We present factors that can influence the sensitivity and timing precision of radio frequency pulses detected under these conditions. Such a system demonstrates potential for the detection of weak radio-frequency pulses in communications and radar applications.

Quantum Sensing and Nano Electronics and Photonics•Mar 4, 2022•0 citations

Three-photon Rydberg atom electrometry with enhanced sensitivity

Vijin Venu, Stephanie M. Bohaichuk, Florian Christaller +3 more

In this work, we present a high-sensitivity, all-optical, atom-based radio-frequency electrometry technique, implemented via a collinear three-photon excitation scheme in a room-temperature cesium vapor cell. By employing a wave-vector matching condition unique to cesium, our approach reduces the residual Doppler broadening so that it does not dominate the electromagnetically induced absorption linewidth, achieving linewidths below 200 kHz. The narrow linewidth enables the expansion of the self-calibrated Autler-Townes sensing regime and increased sensitivity when compared to methods where Doppler broadening dominates the linewidth. In this paper, we report our latest sensitivity measurements which successfully detected radio-frequency (RF) Rabi frequencies of 2π×43 kHz using a 480 kHz measurement bandwidth at 10.7 GHz, corresponding to a sensitivity of 45 nV/cm/ √ Hz. The results of our experiment show a thirteen-fold improvement compared to our previously reported findings for all-optical atom-based electrometry. Our measurements demonstrate the ability to detect time-varying signals suitable for radar and communication applications with high sensitivity.

Optical and Quantum Sensing and Precision Metrology II•Mar 19, 2025•2 citations
Rydberg-atom electrometry is a core technique in the development of highly sensitive quantum electric-field sensors. Its sensitivity based on atom-photon interaction is typically limited by photon shot-noise (PSN) and spectral broadenings. Here, we experimentally demonstrate a near PSN-limited Rydberg electrometry from a 85Rb atomic vapor cell. By engineering atomic coherence through control of residual magnetic fields and laser frequency noise, we achieve the Rydberg electromagnetically induced transparency (EIT) with the narrow linewidth of 1.6 MHz, yielding an enhanced spectral slope for high-sensitivity Rydberg-EIT electrometry. Under optimized superheterodyne detection conditions, we obtain an electric-field sensitivity of 12.5(8) nV cm^-1 Hz^-1/2 at 37 GHz, in close agreement with the calculated PSN limit. These results provide direct experimental evidence of the high-sensitive quantum electrometry and establish a practical route toward quantum-noise-limited Rydberg electrometry.
In this work, we present theoretical and experimental data on detecting pulsed radio frequency fields. We focus on pulse arrival time detection accuracy. We measure two-photon Rydberg atom EIT in response to ~μs pulse-modulated radio-frequency signals resonant with a Rydberg-Rydberg transition, using a room temperature cesium vapor cell with the lasers locked on atomic resonances. We study the dependence of the atomic response on optical and radio-frequency Rabi frequencies as well as effects such as atomic collisions, ionization, and transit time broadening. We find good agreement with time-dependent simulations performed using a density matrix approach, with a dark state added to account for Rydberg atom decay. We present factors that can influence the sensitivity and timing precision of radio frequency pulses detected under these conditions. Such a system demonstrates potential for the detection of weak radio-frequency pulses in communications and radar applications.
In this work, we present a high-sensitivity, all-optical, atom-based radio-frequency electrometry technique, implemented via a collinear three-photon excitation scheme in a room-temperature cesium vapor cell. By employing a wave-vector matching condition unique to cesium, our approach reduces the residual Doppler broadening so that it does not dominate the electromagnetically induced absorption linewidth, achieving linewidths below 200 kHz. The narrow linewidth enables the expansion of the self-calibrated Autler-Townes sensing regime and increased sensitivity when compared to methods where Doppler broadening dominates the linewidth. In this paper, we report our latest sensitivity measurements which successfully detected radio-frequency (RF) Rabi frequencies of 2π×43 kHz using a 480 kHz measurement bandwidth at 10.7 GHz, corresponding to a sensitivity of 45 nV/cm/ √ Hz. The results of our experiment show a thirteen-fold improvement compared to our previously reported findings for all-optical atom-based electrometry. Our measurements demonstrate the ability to detect time-varying signals suitable for radar and communication applications with high sensitivity.