Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1602.05479 · Physical Review Letters

Using Spontaneous Emission of a Qubit as a Resource for Feedback Control

Philippe Campagne-Ibarcq, S. Jézouin, Nathanaël Cottet, Pierre Six, Landry Bretheau, F. Mallet, Alain Sarlette, Pierre Rouchon, Benjamin Huard

Published Aug 1, 2016• 48 citations
arXivHTMLPDF

Abstract

Persistent control of a transmon qubit is performed by a feedback protocol based on continuous heterodyne measurement of its fluorescence. By driving the qubit and cavity with microwave signals whose amplitudes depend linearly on the instantaneous values of the quadratures of the measured fluorescence field, we show that it is possible to stabilize permanently the qubit in any targeted state. Using a Josephson mixer as a phase-preserving amplifier, it was possible to reach a total measurement efficiency η=35%, leading to a maximum of 59% of excitation and 44% of coherence for the stabilized states. The experiment demonstrates multiple-input multiple-output analog Markovian feedback in the quantum regime.

DOI
10.1103/physrevlett.117.060502

Related papers

Feedback Control of a Solid-State Qubit Using High-Fidelity Projective Measurement

Diego Ristè, Cornelis Christiaan Bultink, Konrad W. Lehnert +1 more

We demonstrate feedback control of a superconducting transmon qubit using discrete, projective measurement and conditional coherent driving. Feedback realizes a fast and deterministic qubit reset to a target state with 2.4% error averaged over input superposition states, and allows concatenating experiments more than 10 times faster than by passive initialization. This closed-loop qubit control is necessary for measurement-based protocols such as quantum error correction and teleportation.

arXiv:1207.2944•Physical Review Letters•Dec 10, 2012•200 citations

Strong measurement and quantum feedback for persistent Rabi oscillations in circuit QED experiments

Mazyar Mirrahimi, Benjamin Huard, Michel Devoret

We investigate the stabilization of the dynamical state of a superconducting qubit. In a series of papers, A. Korotkov and his co-workers suggested that continuous weak measurement of the state of a qubit and applying an appropriate feedback on the amplitude of a Rabi drive, should maintain the coherence of the Rabi oscillations for arbitrary time. Here, in the aim of addressing a metrological application of these persistent Rabi oscillations, we explore a new variant of such strategies. This variant is based on performing strong measurements in a discrete manner and using the measurement record to correct the phase of the Rabi oscillations. Noting that such persistent Rabi oscillations can be viewed as an amplitude-to-frequency convertor (converting the amplitude of the Rabi microwave drive to a precise frequency), we propose another feedback layer consisting of a simple analog phase locked loop to compensate the low frequency deviations in the amplitude of the Rabi drive.

IEEE Conference on Decision and Control (CDC)•Dec 1, 2012•3 citations

Feedback control of Rabi oscillations in circuit QED

Wei Cui, Franco Nori

We consider the feedback stabilization of Rabi oscillations in a superconducting qubit which is coupled to a microwave readout cavity. The signal is readout by homodyne detection of the in-phase quadrature amplitude of the weak-measurement output. By multiplying the time-delayed Rabi reference, one can extract the signal, with maximum signal-to-noise ratio, from the noise current. We further track and stabilize the Rabi oscillations by using Lyapunov feedback control to properly adjust the input Rabi drives. Theoretical and simulation results illustrate the effectiveness of the proposed control law.

arXiv:1304.5919•Physical Review A•Dec 10, 2013•45 citations

Measurement back action and feedback in superconducting circuits

Philippe Campagne-Ibarcq

This thesis presents a series of experiments highlighting measurement back action and decoherence in a basic open quantum system, the superconducting qubit. These observations are enabled by recent advances in amplification close to the quantum limit using Josephson circuits. The information extracted from the system can then be used as input in quantum feedback. A stroboscopic projective readout is performed and a feedback loop is used to correct for detected errors, thus stabilizing an arbitrary predetermined state of the qubit. When monitoring continuously the environment of the qubit by heterodyne detection of its fluorescence, we reconstruct individual quantum trajectories during relaxation. Conditioning this detection to the outcome of a following projective measurement, we access the weak values of the fluorescence signal. Included in a continuous feedback loop, this detection is also used to stabilize an arbitrary state of the qubit. Finally, a last experiment witnesses quantum Zeno dynamics of a resonant microwave mode, entailed by its coupling to the qubit.

•Jun 26, 2015•7 citations

Quantum feedback experiments with atoms and cavities

J. M. Raimond, C. Sayrin, I. Dotsenko +6 more

We implement a permanent quantum feedback procedure. It prepares on-demand and stabilizes photon-number states in a high-quality superconducting microwave cavity. The feedback uses sensitive circular atoms to probe the cavity field in a Quantum Non Demolition way. This information is used by a controller and an actuator to feed small coherent amplitudes into the cavity, leading it deterministically towards the target state with a high fidelity. Quantum jumps of the photon number are detected and their effect is then actively compensated, protecting this fragile quantum resource against decoherence.

Research in Optical Sciences•Jan 1, 2012•0 citations

Quantum Feedback and Traveling-wave Parametric Amplification in Superconducting Circuits

Christopher Stewart Macklin

Feedback control in classical systems is an indispensable, ubiquitous tool. The theoretical basis for achieving optimal classical control is well understood, and crucially relies on a very classical assumption: that measurements of the state of a system under control need not perturb that state. In a quantum context this assumption is fundamentally invalid. Although many aspects of the theory of quantum feedback control are relatively well developed, the technological basis for feedback control of a single quantum system has only very recently matured. We demonstrate the experimental realization of a quantum feedback control protocol, perpetually stabilizing the coherent Rabi oscillations of a superconducting qubit. This is the first utilization of quantum feedback control for stabilizing a dynamical process, and the first application of quantum feedback in a solid-state system of any kind. This demonstration comprises the first half of this thesis. The feedback protocol is predicated on the ability to make high-fidelity quantum measurements, which are enabled by quantum-limited Josephson parametric amplifiers (JPAs). The design and realization of the novel Josephson traveling-wave parametric amplifier (JTWPA) comprises the second half of this thesis. The JTWPA achieves order-of-magnitude improvements over state of the art JPAs in bandwidth and signal power handling while providing quantum-limited noise performance, potentially enabling the simultaneous readout of dozens of superconducting qubits and the generation of broadband multi-mode squeezing in the microwave domain.

•Jan 1, 2015•4 citations
Persistent control of a transmon qubit is performed by a feedback protocol based on continuous heterodyne measurement of its fluorescence. By driving the qubit and cavity with microwave signals whose amplitudes depend linearly on the instantaneous values of the quadratures of the measured fluorescence field, we show that it is possible to stabilize permanently the qubit in any targeted state. Using a Josephson mixer as a phase-preserving amplifier, it was possible to reach a total measurement efficiency η=35%, leading to a maximum of 59% of excitation and 44% of coherence for the stabilized states. The experiment demonstrates multiple-input multiple-output analog Markovian feedback in the quantum regime.
We investigate the stabilization of the dynamical state of a superconducting qubit. In a series of papers, A. Korotkov and his co-workers suggested that continuous weak measurement of the state of a qubit and applying an appropriate feedback on the amplitude of a Rabi drive, should maintain the coherence of the Rabi oscillations for arbitrary time. Here, in the aim of addressing a metrological application of these persistent Rabi oscillations, we explore a new variant of such strategies. This variant is based on performing strong measurements in a discrete manner and using the measurement record to correct the phase of the Rabi oscillations. Noting that such persistent Rabi oscillations can be viewed as an amplitude-to-frequency convertor (converting the amplitude of the Rabi microwave drive to a precise frequency), we propose another feedback layer consisting of a simple analog phase locked loop to compensate the low frequency deviations in the amplitude of the Rabi drive.
We consider the feedback stabilization of Rabi oscillations in a superconducting qubit which is coupled to a microwave readout cavity. The signal is readout by homodyne detection of the in-phase quadrature amplitude of the weak-measurement output. By multiplying the time-delayed Rabi reference, one can extract the signal, with maximum signal-to-noise ratio, from the noise current. We further track and stabilize the Rabi oscillations by using Lyapunov feedback control to properly adjust the input Rabi drives. Theoretical and simulation results illustrate the effectiveness of the proposed control law.
This thesis presents a series of experiments highlighting measurement back action and decoherence in a basic open quantum system, the superconducting qubit. These observations are enabled by recent advances in amplification close to the quantum limit using Josephson circuits. The information extracted from the system can then be used as input in quantum feedback. A stroboscopic projective readout is performed and a feedback loop is used to correct for detected errors, thus stabilizing an arbitrary predetermined state of the qubit. When monitoring continuously the environment of the qubit by heterodyne detection of its fluorescence, we reconstruct individual quantum trajectories during relaxation. Conditioning this detection to the outcome of a following projective measurement, we access the weak values of the fluorescence signal. Included in a continuous feedback loop, this detection is also used to stabilize an arbitrary state of the qubit. Finally, a last experiment witnesses quantum Zeno dynamics of a resonant microwave mode, entailed by its coupling to the qubit.
We implement a permanent quantum feedback procedure. It prepares on-demand and stabilizes photon-number states in a high-quality superconducting microwave cavity. The feedback uses sensitive circular atoms to probe the cavity field in a Quantum Non Demolition way. This information is used by a controller and an actuator to feed small coherent amplitudes into the cavity, leading it deterministically towards the target state with a high fidelity. Quantum jumps of the photon number are detected and their effect is then actively compensated, protecting this fragile quantum resource against decoherence.
Feedback control in classical systems is an indispensable, ubiquitous tool. The theoretical basis for achieving optimal classical control is well understood, and crucially relies on a very classical assumption: that measurements of the state of a system under control need not perturb that state. In a quantum context this assumption is fundamentally invalid. Although many aspects of the theory of quantum feedback control are relatively well developed, the technological basis for feedback control of a single quantum system has only very recently matured. We demonstrate the experimental realization of a quantum feedback control protocol, perpetually stabilizing the coherent Rabi oscillations of a superconducting qubit. This is the first utilization of quantum feedback control for stabilizing a dynamical process, and the first application of quantum feedback in a solid-state system of any kind. This demonstration comprises the first half of this thesis. The feedback protocol is predicated on the ability to make high-fidelity quantum measurements, which are enabled by quantum-limited Josephson parametric amplifiers (JPAs). The design and realization of the novel Josephson traveling-wave parametric amplifier (JTWPA) comprises the second half of this thesis. The JTWPA achieves order-of-magnitude improvements over state of the art JPAs in bandwidth and signal power handling while providing quantum-limited noise performance, potentially enabling the simultaneous readout of dozens of superconducting qubits and the generation of broadband multi-mode squeezing in the microwave domain.