Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Conference on Decision and Control (CDC)

Strong measurement and quantum feedback for persistent Rabi oscillations in circuit QED experiments

Mazyar Mirrahimi, Benjamin Huard, Michel Devoret

Published Dec 1, 2012• 3 citations
Publisher

Abstract

We investigate the stabilization of the dynamical state of a superconducting qubit. In a series of papers, A. Korotkov and his co-workers suggested that continuous weak measurement of the state of a qubit and applying an appropriate feedback on the amplitude of a Rabi drive, should maintain the coherence of the Rabi oscillations for arbitrary time. Here, in the aim of addressing a metrological application of these persistent Rabi oscillations, we explore a new variant of such strategies. This variant is based on performing strong measurements in a discrete manner and using the measurement record to correct the phase of the Rabi oscillations. Noting that such persistent Rabi oscillations can be viewed as an amplitude-to-frequency convertor (converting the amplitude of the Rabi microwave drive to a precise frequency), we propose another feedback layer consisting of a simple analog phase locked loop to compensate the low frequency deviations in the amplitude of the Rabi drive.

DOI
10.1109/cdc.2012.6426309

Related papers

Feedback control of Rabi oscillations in circuit QED

Wei Cui, Franco Nori

We consider the feedback stabilization of Rabi oscillations in a superconducting qubit which is coupled to a microwave readout cavity. The signal is readout by homodyne detection of the in-phase quadrature amplitude of the weak-measurement output. By multiplying the time-delayed Rabi reference, one can extract the signal, with maximum signal-to-noise ratio, from the noise current. We further track and stabilize the Rabi oscillations by using Lyapunov feedback control to properly adjust the input Rabi drives. Theoretical and simulation results illustrate the effectiveness of the proposed control law.

arXiv:1304.5919•Physical Review A•Dec 10, 2013•45 citations

Persistent Rabi oscillations probed via low-frequency noise correlation

Alexander N. Korotkov

The qubit Rabi oscillations are known to be nondecaying (though with a fluctuating phase) if the qubit is continuously monitored in the weak-coupling regime. In this Rapid Communication we propose an experiment to demonstrate these persistent Rabi oscillations via low-frequency noise correlation. The idea is to measure a qubit by two detectors, biased stroboscopically at the Rabi frequency. The low-frequency noise depends on the relative phase between the two combs of biasing pulses, with a strong increase of telegraph noise in both detectors for the in-phase or antiphase combs. This happens because of self-synchronization between the persistent Rabi oscillations and measurement pulses. Almost perfect correlation of the noise in the two detectors for the in-phase regime and almost perfect anticorrelation for the antiphase regime indicates a presence of synchronized persistent Rabi oscillations. The experiment can be realized with semiconductor or superconductor qubits.

arXiv:1004.0220•Physical Review B•Jan 31, 2011•6 citations

Measurement back action and feedback in superconducting circuits

Philippe Campagne-Ibarcq

This thesis presents a series of experiments highlighting measurement back action and decoherence in a basic open quantum system, the superconducting qubit. These observations are enabled by recent advances in amplification close to the quantum limit using Josephson circuits. The information extracted from the system can then be used as input in quantum feedback. A stroboscopic projective readout is performed and a feedback loop is used to correct for detected errors, thus stabilizing an arbitrary predetermined state of the qubit. When monitoring continuously the environment of the qubit by heterodyne detection of its fluorescence, we reconstruct individual quantum trajectories during relaxation. Conditioning this detection to the outcome of a following projective measurement, we access the weak values of the fluorescence signal. Included in a continuous feedback loop, this detection is also used to stabilize an arbitrary state of the qubit. Finally, a last experiment witnesses quantum Zeno dynamics of a resonant microwave mode, entailed by its coupling to the qubit.

•Jun 26, 2015•7 citations

Feedback control of persistent-current oscillation based on the atomic-clock technique

Deshui Yu, Rainer Dumke

We propose a scheme of stabilizing the persistent-current Rabi oscillation based on the flux qubit-resonator-atom hybrid structure. The low-$Q$ $LC$ resonator weakly interacts with the flux qubit and maps the persistent-current Rabi oscillation of the flux qubit onto the intraresonator electric field. This oscillating electric field is further coupled to a Rydberg-Rydberg transition of the $^{87}\mathrm{Rb}$ atoms. The Rabi-frequency fluctuation of the flux qubit is deduced from measuring the atomic population via the fluorescence detection and stabilized by feedback controlling the external flux bias. Our numerical simulation indicates that the feedback-control method can efficiently suppress the background fluctuations in the flux qubit, especially in the low-frequency limit. This technique may be extensively applicable to different types of superconducting circuits, paving a way to long-term-coherence superconducting quantum information processing.

arXiv:1805.00594•Physical Review A•May 11, 2018•7 citations

Simple quadrature-based quantum feedback of a solid-state qubit (Invited Paper)

Alexander N. Korotkov

We analyze the newly proposed quantum feedback loop for a solid-state qubit, based on monitoring the quadrature components of the current from a weakly coupled detector, which continuously measures the qubit. Similar to the earlier proposal of the "Bayesian" feedback, the feedback loop is used to maintain the coherent (Rabi)oscillations in a qubit for an arbitrarily long time; however, this is done in a significantly simpler way, which requires much smaller bandwidth of the control circuitry. The price for simplicity is a less-than-ideal operation: the fidelity is limited to about 95%. The feedback loop operation can be experimentally verified by appearance of a positive in-phase component of the detector current relative to an external oscillating signal used for synchronization. The quadrature-based quantum feedback seems to be within the reach of the present-day technology.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 23, 2005•0 citations

Quantum Jumps and Measurement Backaction in a Superconducting Qubit

D. H. Slichter

Real-time monitoring of a quantum state provides powerful tools for studying the backaction of quantum measurement and performing quantum feedback. Historically, this monitoring capability has been the exclusive province of atomic and optical physics. This thesis describes the implementation of the first such high-fidelity readout scheme in a solid state circuit, a superconducting quantum bit (qubit) coupled to a microwave cavity in the circuit quantum electrodynamics (circuit QED) architecture. The qubit-state-dependent resonance frequency of the cavity is probed with a microwave drive tone, and the resulting signal amplified using a fast, ultralow-noise superconducting parametric amplifier. This arrangement enables the observation of quantum jumps between the qubit states in real time. The ability to monitor the qubit continuously with high fidelity and resolve quantum jumps can be used to investigate the backaction of the measurement process on the qubit. This thesis examines the quantum Zeno effect--where strong measurement inhibits the evolution of a quantum system-- as well as the transition to non-ideal measurement with increasing measurement strength in the circuit QED architecture, a phenomenon shown to be due to the upconversion of low-frequency dephasing noise. These data allow probes of ``universal'' flux noise in previously inaccessible frequency ranges. The work presented here opens the door for quantum feedback and error correction in solid-state quantum systems using continuous weak measurement.

•Jan 1, 2011•14 citations
We investigate the stabilization of the dynamical state of a superconducting qubit. In a series of papers, A. Korotkov and his co-workers suggested that continuous weak measurement of the state of a qubit and applying an appropriate feedback on the amplitude of a Rabi drive, should maintain the coherence of the Rabi oscillations for arbitrary time. Here, in the aim of addressing a metrological application of these persistent Rabi oscillations, we explore a new variant of such strategies. This variant is based on performing strong measurements in a discrete manner and using the measurement record to correct the phase of the Rabi oscillations. Noting that such persistent Rabi oscillations can be viewed as an amplitude-to-frequency convertor (converting the amplitude of the Rabi microwave drive to a precise frequency), we propose another feedback layer consisting of a simple analog phase locked loop to compensate the low frequency deviations in the amplitude of the Rabi drive.
We consider the feedback stabilization of Rabi oscillations in a superconducting qubit which is coupled to a microwave readout cavity. The signal is readout by homodyne detection of the in-phase quadrature amplitude of the weak-measurement output. By multiplying the time-delayed Rabi reference, one can extract the signal, with maximum signal-to-noise ratio, from the noise current. We further track and stabilize the Rabi oscillations by using Lyapunov feedback control to properly adjust the input Rabi drives. Theoretical and simulation results illustrate the effectiveness of the proposed control law.
The qubit Rabi oscillations are known to be nondecaying (though with a fluctuating phase) if the qubit is continuously monitored in the weak-coupling regime. In this Rapid Communication we propose an experiment to demonstrate these persistent Rabi oscillations via low-frequency noise correlation. The idea is to measure a qubit by two detectors, biased stroboscopically at the Rabi frequency. The low-frequency noise depends on the relative phase between the two combs of biasing pulses, with a strong increase of telegraph noise in both detectors for the in-phase or antiphase combs. This happens because of self-synchronization between the persistent Rabi oscillations and measurement pulses. Almost perfect correlation of the noise in the two detectors for the in-phase regime and almost perfect anticorrelation for the antiphase regime indicates a presence of synchronized persistent Rabi oscillations. The experiment can be realized with semiconductor or superconductor qubits.
This thesis presents a series of experiments highlighting measurement back action and decoherence in a basic open quantum system, the superconducting qubit. These observations are enabled by recent advances in amplification close to the quantum limit using Josephson circuits. The information extracted from the system can then be used as input in quantum feedback. A stroboscopic projective readout is performed and a feedback loop is used to correct for detected errors, thus stabilizing an arbitrary predetermined state of the qubit. When monitoring continuously the environment of the qubit by heterodyne detection of its fluorescence, we reconstruct individual quantum trajectories during relaxation. Conditioning this detection to the outcome of a following projective measurement, we access the weak values of the fluorescence signal. Included in a continuous feedback loop, this detection is also used to stabilize an arbitrary state of the qubit. Finally, a last experiment witnesses quantum Zeno dynamics of a resonant microwave mode, entailed by its coupling to the qubit.
We propose a scheme of stabilizing the persistent-current Rabi oscillation based on the flux qubit-resonator-atom hybrid structure. The low-QQQ LCLCLC resonator weakly interacts with the flux qubit and maps the persistent-current Rabi oscillation of the flux qubit onto the intraresonator electric field. This oscillating electric field is further coupled to a Rydberg-Rydberg transition of the 87Rb^{87}\mathrm{Rb}87Rb atoms. The Rabi-frequency fluctuation of the flux qubit is deduced from measuring the atomic population via the fluorescence detection and stabilized by feedback controlling the external flux bias. Our numerical simulation indicates that the feedback-control method can efficiently suppress the background fluctuations in the flux qubit, especially in the low-frequency limit. This technique may be extensively applicable to different types of superconducting circuits, paving a way to long-term-coherence superconducting quantum information processing.
We analyze the newly proposed quantum feedback loop for a solid-state qubit, based on monitoring the quadrature components of the current from a weakly coupled detector, which continuously measures the qubit. Similar to the earlier proposal of the "Bayesian" feedback, the feedback loop is used to maintain the coherent (Rabi)oscillations in a qubit for an arbitrarily long time; however, this is done in a significantly simpler way, which requires much smaller bandwidth of the control circuitry. The price for simplicity is a less-than-ideal operation: the fidelity is limited to about 95%. The feedback loop operation can be experimentally verified by appearance of a positive in-phase component of the detector current relative to an external oscillating signal used for synchronization. The quadrature-based quantum feedback seems to be within the reach of the present-day technology.
Real-time monitoring of a quantum state provides powerful tools for studying the backaction of quantum measurement and performing quantum feedback. Historically, this monitoring capability has been the exclusive province of atomic and optical physics. This thesis describes the implementation of the first such high-fidelity readout scheme in a solid state circuit, a superconducting quantum bit (qubit) coupled to a microwave cavity in the circuit quantum electrodynamics (circuit QED) architecture. The qubit-state-dependent resonance frequency of the cavity is probed with a microwave drive tone, and the resulting signal amplified using a fast, ultralow-noise superconducting parametric amplifier. This arrangement enables the observation of quantum jumps between the qubit states in real time. The ability to monitor the qubit continuously with high fidelity and resolve quantum jumps can be used to investigate the backaction of the measurement process on the qubit. This thesis examines the quantum Zeno effect--where strong measurement inhibits the evolution of a quantum system-- as well as the transition to non-ideal measurement with increasing measurement strength in the circuit QED architecture, a phenomenon shown to be due to the upconversion of low-frequency dephasing noise. These data allow probes of ``universal'' flux noise in previously inaccessible frequency ranges. The work presented here opens the door for quantum feedback and error correction in solid-state quantum systems using continuous weak measurement.