Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1504.04713 · Optics Express

Dark counts of superconducting nanowire single-photon detector under illumination

Sijing Chen, Lixing You, Weijun Zhang, Xiaoyan Yang, Hao Li, Lu Zhang, Zhen Wang, Xiaoming Xie

Published Apr 17, 2015• 30 citations
arXivHTMLPDF

Abstract

An abnormal increase in the SDE was observed for superconducting nanowire single-photon detectors (SNSPDs) when the bias current (I(b)) was close to the switching current (I(sw)). By introducing the time-correlated single-photon counting technique, we investigated the temporal histogram of the detection counts of an SNSPD under illumination. The temporal information helps us to distinguish photon counts from dark counts in the time domain. In this manner, the dark count rate (DCR) under illumination and the accurate SDE can be determined. The DCR under moderate illumination may be significantly larger than the conventional DCR measured without illumination under a high I(b), which causes the abnormal increase in the SDE. The increased DCR may be explained by the suppression of I(sw) under illumination.

DOI
10.1364/oe.23.010786

Related papers

Effect of temperature on superconducting nanowire single-photon detector noise

A. Bahgat Shehata, Alessandro Ruggeri, Franco Stellari +6 more

Today Superconducting Nanowire Single-Photon Detectors (SNSPDs) are commonly used in different photon-starved applications, including testing and diagnostics of VLSI circuits. Detecting very faint signals in the near-infrared wavelength range requires not only good detection efficiency, but also very low Dark Count Rate (DCR) and jitter. For example, low noise is crucial to enable ultra-low voltage optical testing of integrated circuits. The effect of detector temperature and background thermal radiation on the noise of superconducting single-photon detectors made of NbN meanders is studied in this paper. It is shown that two different regimes can be identified in the DCR vs. bias current characteristics. At high bias, the dark count rate is dominated by the intrinsic noise of the detector, while at low bias current it is dominated by the detection of stray photons that get onto the SNSPD. Changing the detector temperature changes its switching current and only affects the high bias branch of the characteristics: a reduction of the DCR can be achieved by lowering the SNSPD base temperature. On the other hand, changing the temperature of the single-photon light source (e.g. the VLSI circuit under test) only affects the low bias regime: a lower target temperature leads to a smaller DCR.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Aug 28, 2015•2 citations

Investigation of the Performance of an Ultralow-Dark-Count Superconducting Nanowire Single-Photon Detector

Shanthi Subashchandran, Ryo Okamoto, Labao Zhang +6 more

The realization of an ultralow-dark-count rate (DCR) along with the conservation of high detection efficiency (DE) is critical for many applications using single photon detectors in quantum information technologies, material sciences, and biological sensing. For this purpose, a fiber-coupled superconducting nanowire single-photon detector (SNSPD) with a meander-type niobium nitride nanowire (width: 50 nm) is studied. Precise measurements of the bias current dependence of DE are carried out for a wide spectral range (from 500 to 1650 nm in steps of 50 nm) using a white light source and a laser line Bragg tunable band-pass filter. An ultralow DCR (0.0015 cps) and high DE (32%) are simultaneously achieved by the SNSPD at a wavelength of 500 nm.

Japanese Journal of Applied Physics•Oct 1, 2013•11 citations

Dark counts double switching rates in NbTiN Superconducting Nanowire Single Photon Detectors

Daniela Salvoni, Mikkel Ejrnaes, L. Parlato +5 more

Abstract In this work we present a study of the dark counts rate in a NbTiN Superconducting Nanowire Single Photon Detectors (SNSPD). We measure the distribution of the time intervals elapsed between two consecutive dark pulses at the fixed temperature of 4,2K. Due to the stochastic nature of the dark counts, the distribution is expected to have a Poisson shape but what we observe is a combination of two Poisson-like processes. A further analysis of the distributions dependence on the bias current highlights that the weight of the two process is not constant. In the scenario presented by Ejrnaes et al. [1], this result can confirm that, in this temperature regime, dark counts are generated mainly by multiple consecutive fluctuation events and the contribution to the dark counts rate coming from single fluctuations increases in the high bias current region.

Journal of Physics Conference Series•Jun 1, 2020•0 citations

Enhancement of photon detection in superconducting nanowire single photon detector exposed to oscillating magnetic field

Ilan Hakimi, Naor Vardi, Amos Sharoni +2 more

We measured the photon count rate (PCR) and dark count rate (DCR) of a superconducting nanowire single photon detector (SNSPD) exposed to either a DC magnetic field (up to 60 mT) or to a low-amplitude oscillating field (0.12–0.48 mT, up to 50 kHz). In both cases, the results show an increase in the PCR and the DCR as the DC field or the frequency of the AC field increase. However, the ratio DCR/(PCR + DCR) increases significantly with an increasing DC field, whereas this ratio is approximately constant as the frequency of the AC field increases up to frequencies in the kHz regime. The results suggest a more favorable effect of AC fields on the operation of the SNSPD.

Applied Physics Letters•Jun 7, 2021•3 citations

Geometric origin of intrinsic dark counts in superconducting nanowire single-photon detectors

Xingyu Zhang, Xiaofu Zhang, Jia Huang +10 more

The dark count is one of the key physical issues for superconducting nanowire single-photon detectors (SNSPDs) that limits various applications for optical quantum information and classical optics. When the bias current approaches the switching current of SNSPDs, the dark count is actually dominated by the intrinsic dark counts (iDCs). However, the origin of iDCs and its relation to constrictions remains unclear for practical SNSPDs. We herein systematically characterize the iDCs of the SNSPDs with and without artificial geometric constrictions by applying the differential readout method. For these devices with constrictions, we have observed distinct Gaussian distributions in the temporal distribution of iDCs, in which the time difference between the distributions is consistent with the geometric distance between constrictions, and the rates of iDCs produced by each constriction are in good agreement with constrictions' widths. With respect to practical SNSPDs, surprisingly, we also observe several Gaussian distributions in the temporal domain and it shows no significant dependence on the devices’ sizes, demonstrating that the iDCs of SNSPDs are mainly dominated by a few specific constrictions.

Superconductivity•Mar 1, 2022•15 citations

Photon response induced by single quantum phase slip of superconducting nanowire single photon detector

Biao Zhang, Labao Zhang

The superconducting nanowire single photon detector (SNSPD) is currently one of the best detectors with comprehensive performance in the mid-infrared wavelength, which has been widely used in quantum optics, LiDAR, and biological fluorescence detection. To develop new devices with excellent performance, the photon detection mechanism of SNSPD still needs further research. Here we find that the single quantum phase slip is the dominating mechanism leading to dark-count and photon-response events in SNSPD below the quantum temperature. We fabricate the nanowire with a length of 7.5 μm and a width of 25 nm using niobium nitride film with a thickness of 5 nm. The distribution of the superconducting switching current is measured as a function of temperature at temperatures ranging from 0.3 to 7 K. We observe single quantum phase slips in the nanowire at the temperature below 1.2 K, and we further investigate the quantitative relationship between the single quantum phase slip rate and the superconducting switching rate of the nanowire under the laser illumination. Experimental results show that the single quantum phase slip is a significant factor leading to photon response and dark counts in the nanowire below the quantum temperature. Our research helps to further reveal the photon detection mechanism of the SNSPD, laying a theoretical foundation for the development of high-performance SNSPD.

Advanced Fiber Laser Conference (AFL)•Mar 18, 2024•0 citations
An abnormal increase in the SDE was observed for superconducting nanowire single-photon detectors (SNSPDs) when the bias current (I(b)) was close to the switching current (I(sw)). By introducing the time-correlated single-photon counting technique, we investigated the temporal histogram of the detection counts of an SNSPD under illumination. The temporal information helps us to distinguish photon counts from dark counts in the time domain. In this manner, the dark count rate (DCR) under illumination and the accurate SDE can be determined. The DCR under moderate illumination may be significantly larger than the conventional DCR measured without illumination under a high I(b), which causes the abnormal increase in the SDE. The increased DCR may be explained by the suppression of I(sw) under illumination.
Today Superconducting Nanowire Single-Photon Detectors (SNSPDs) are commonly used in different photon-starved applications, including testing and diagnostics of VLSI circuits. Detecting very faint signals in the near-infrared wavelength range requires not only good detection efficiency, but also very low Dark Count Rate (DCR) and jitter. For example, low noise is crucial to enable ultra-low voltage optical testing of integrated circuits. The effect of detector temperature and background thermal radiation on the noise of superconducting single-photon detectors made of NbN meanders is studied in this paper. It is shown that two different regimes can be identified in the DCR vs. bias current characteristics. At high bias, the dark count rate is dominated by the intrinsic noise of the detector, while at low bias current it is dominated by the detection of stray photons that get onto the SNSPD. Changing the detector temperature changes its switching current and only affects the high bias branch of the characteristics: a reduction of the DCR can be achieved by lowering the SNSPD base temperature. On the other hand, changing the temperature of the single-photon light source (e.g. the VLSI circuit under test) only affects the low bias regime: a lower target temperature leads to a smaller DCR.
The realization of an ultralow-dark-count rate (DCR) along with the conservation of high detection efficiency (DE) is critical for many applications using single photon detectors in quantum information technologies, material sciences, and biological sensing. For this purpose, a fiber-coupled superconducting nanowire single-photon detector (SNSPD) with a meander-type niobium nitride nanowire (width: 50 nm) is studied. Precise measurements of the bias current dependence of DE are carried out for a wide spectral range (from 500 to 1650 nm in steps of 50 nm) using a white light source and a laser line Bragg tunable band-pass filter. An ultralow DCR (0.0015 cps) and high DE (32%) are simultaneously achieved by the SNSPD at a wavelength of 500 nm.
Abstract In this work we present a study of the dark counts rate in a NbTiN Superconducting Nanowire Single Photon Detectors (SNSPD). We measure the distribution of the time intervals elapsed between two consecutive dark pulses at the fixed temperature of 4,2K. Due to the stochastic nature of the dark counts, the distribution is expected to have a Poisson shape but what we observe is a combination of two Poisson-like processes. A further analysis of the distributions dependence on the bias current highlights that the weight of the two process is not constant. In the scenario presented by Ejrnaes et al. [1], this result can confirm that, in this temperature regime, dark counts are generated mainly by multiple consecutive fluctuation events and the contribution to the dark counts rate coming from single fluctuations increases in the high bias current region.
We measured the photon count rate (PCR) and dark count rate (DCR) of a superconducting nanowire single photon detector (SNSPD) exposed to either a DC magnetic field (up to 60 mT) or to a low-amplitude oscillating field (0.12–0.48 mT, up to 50 kHz). In both cases, the results show an increase in the PCR and the DCR as the DC field or the frequency of the AC field increase. However, the ratio DCR/(PCR + DCR) increases significantly with an increasing DC field, whereas this ratio is approximately constant as the frequency of the AC field increases up to frequencies in the kHz regime. The results suggest a more favorable effect of AC fields on the operation of the SNSPD.
The dark count is one of the key physical issues for superconducting nanowire single-photon detectors (SNSPDs) that limits various applications for optical quantum information and classical optics. When the bias current approaches the switching current of SNSPDs, the dark count is actually dominated by the intrinsic dark counts (iDCs). However, the origin of iDCs and its relation to constrictions remains unclear for practical SNSPDs. We herein systematically characterize the iDCs of the SNSPDs with and without artificial geometric constrictions by applying the differential readout method. For these devices with constrictions, we have observed distinct Gaussian distributions in the temporal distribution of iDCs, in which the time difference between the distributions is consistent with the geometric distance between constrictions, and the rates of iDCs produced by each constriction are in good agreement with constrictions' widths. With respect to practical SNSPDs, surprisingly, we also observe several Gaussian distributions in the temporal domain and it shows no significant dependence on the devices’ sizes, demonstrating that the iDCs of SNSPDs are mainly dominated by a few specific constrictions.
The superconducting nanowire single photon detector (SNSPD) is currently one of the best detectors with comprehensive performance in the mid-infrared wavelength, which has been widely used in quantum optics, LiDAR, and biological fluorescence detection. To develop new devices with excellent performance, the photon detection mechanism of SNSPD still needs further research. Here we find that the single quantum phase slip is the dominating mechanism leading to dark-count and photon-response events in SNSPD below the quantum temperature. We fabricate the nanowire with a length of 7.5 μm and a width of 25 nm using niobium nitride film with a thickness of 5 nm. The distribution of the superconducting switching current is measured as a function of temperature at temperatures ranging from 0.3 to 7 K. We observe single quantum phase slips in the nanowire at the temperature below 1.2 K, and we further investigate the quantitative relationship between the single quantum phase slip rate and the superconducting switching rate of the nanowire under the laser illumination. Experimental results show that the single quantum phase slip is a significant factor leading to photon response and dark counts in the nanowire below the quantum temperature. Our research helps to further reveal the photon detection mechanism of the SNSPD, laying a theoretical foundation for the development of high-performance SNSPD.