Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1501.02359 · New Journal of Physics

Weak value amplification of atomic cat states

Sumei Huang, G. S. Agarwal

Published Sep 18, 2015• 16 citations
arXivHTMLPDF

Abstract

We show the utility of the weak value amplification to observe the quantum interference between two close lying atomic coherent states in a post-selected atomic cat state, produced in a system of N identical two-level atoms weakly interacting with a single photon field. Through the observation of the negative parts of the Wigner distribution of the post-selected atomic cat state, we find that the post-selected atomic cat state becomes more nonclassical when the post-selected polarization state of the single photon field tends toward becoming orthogonal to its pre-selected state. We show that the small phase shift in the post-selected atomic cat state can be amplified via measuring the peak shift of its phase distribution when the post-selected state of the single photon field is nearly orthogonal to its pre-selected state. We find that the amplification factor of 15 [5] can be obtained for a sample of 10 [100] atoms. This effectively provides us with a method to discriminate between two close lying states on the Bloch sphere. We discuss possible experimental implementation of the scheme, and conclude with a discussion of the Fisher information.

DOI
10.1088/1367-2630/17/9/093032

Related papers

Weak Value Amplification of a Post-Selected Single Photon

Matin Hallaji

Weak value amplification (WVA) is a measurement technique in which the effect of a pre- and post-selected system on a weakly interacting probe is magnified. In this thesis, I present the first experimental observation of WVA of a single photon. We observed that a signal photon - sent through a polarization interferometer and post-selected by photodetection in the almost-dark port - can act like eight photons. The effect of this single photon is measured as a nonlinear phase shift on a separate laser beam. The interaction between the two is mediated by a sample of laser- cooled 85Rb atoms. Electromagnetically induced transparency (EIT) is used to enhance the nonlinearity and overcome resonant absorption. I believe this work to be the first demonstration of WVA where a deterministic interaction is used to entangle two distinct optical systems. In WVA, the amplification is contingent on discarding a large portion of the original data set. While amplification increases measurement sensitivity, discarding data worsens it. Questioning whether these competing effects conspire to improve or diminish measurement accuracy has resulted recently in controversy. I address this question by calculating the maximum amount of information achievable with the WVA technique. By comparing this information to that achievable by the standard technique, where no post-selection is employed, I show that the WVA technique can be advantageous under a certain class of noise models. Finally, I propose a way to optimally apply the WVA technique.

•Jun 1, 2016•1 citation

Enhanced weak-value amplification with Schrödinger cat-like states

Krishna Mishra, Gaurav Shukla, Devendra Mishra

Weak-value amplification (WVA) has emerged as an effective technique for detecting extremely small physical parameters by combining weak system–meter interactions with a carefully chosen post-selection strategy. In this paper, we explore how WVA performs when the meter is prepared in a Schrödinger cat-like state (SCS). Using the Fisher information (FI) as the primary figure of merit, we assess the attainable precision in estimating the interaction parameter. We compare the sensitivities of even coherent states (ECSs), odd coherent states (OCSs), and Yurke–Stoler states (YSSs) against coherent states (CS). We demonstrate that ECS and OCS as meters provide higher FI than the CS as a meter in some cases, depending on the measurement strategy. Also, ECS yields the largest conventional FI among the four meter states. Furthermore, we explore the impact of vacuum superposition with the meter on FI. We find that optimizing the vacuum coefficient enhances the FI in some conditions. This study shows that SCSs can be useful as meter states for improving precision in weak-measurement metrology.

Journal of the Optical Society of America B•Oct 8, 2026•0 citations

Amplification of Schrödinger-cat state in a degenerate optical parametric amplifier

Radim Filip

Amplification of the Schrödinger-cat state (even coherent-state superposition) can be accompanied by its non-exponential decoherence and strong squeezing effect in the degenerate optical parametric amplifier. In the classical pump approximation and small thermal noise limit, the Wigner function behaviour illustrates that this non-exponential effect is induced by the phase-selective character of amplification. The non-exponential decoherence is much slower, in contrast with phase-unselective amplification exhibiting faster exponential decay. Thus, if one is able to produce the Schrödinger-cat state with at least a small amplitude, then it can be partially amplified with only a weak decoherence effect.

Journal of Optics B Quantum and Semiclassical Optics•Jan 25, 2001•18 citations

Implementation of weak measurement amplification with the weak coherent light and optomechanical system

Gang Li, Wen Yang

Abstract Most studies for postselected weak measurement in optomechanical system focus on using a single photon as a measured system. However, we find that using weak coherent light instead of a single photon can also amplify the mirror’s position displacement of one photon. In the weak value amplification (WVA) regime, the weak value of one photon can lie outside the eigenvalue spectrum, proportional to the difference of the mirror’s position displacement between the successful and failed postselection and its successful postselection probability is dependent of the mean photon number of the coherent light and improved by adjusting it accordingly. Outside the WVA regime, the amplification limit can reach the level of the vacuum fluctuations, and when the mean photon number and the optomechanical coupling parameter are selected appropriately, its successful postselection probability becomes higher, which is beneficial to observe the maximum amplification value under the current experimental conditions. This result breaks the constraint that it is difficult to detect outside the WVA regime. This opens up a new regime for the study of a single photon nonlinearity in optomechanical system.

arXiv:2104.03561•Journal of Physics B Atomic Molecular and Optical Physics•Jun 9, 2021•2 citations

Optical amplification of single-photon polarization qubit using weak measurement

Ruitong Zhao, Jianjun Guo, Lianglun Cheng

Abstract Single-photon amplification can be used to overcome the photon loss in long-distance quantum communication. However, the trade-off of success probability and amplification gain should be further improved. We propose a single-photon polarization qubit amplification using weak measurement. The polarization qubit can be amplified by the pre- and post-selection of the single-photon meter state weakly coupling with the input state. The success probability does not decrease asymptotically to 0 with increasing amplification gain in the presented proposal, and is higher than that in entanglement-based schemes, without coincidence detection required. Our proposal is feasible in current technology, and helpful for near-future quantum communication.

Applied Physics Express•Nov 18, 2020•3 citations

Optimal Settings for Amplification and Estimation Of Small Effects In Postselected Ensembles

A. M. Rostom

Abstract To describe the pre‐ and postselected quantum ensembles, a complex quantity called the weak value of an operator is used. The weak value is highly controversial due to the fact that it is not bounded by the possible eigenvalues of the corresponding operator. Nevertheless, the obtaining of the anomalous weak value is regarded as a powerful technique in the quantum interferometry nowadays. Here it is shown that the postselection of a quantum system recovers a completely hidden interference effect in the measurement apparatus. Studying the interference pattern shows the optimal settings for the amplification and the parameter estimation. It also proves that the weak value is not an element of reality. Using single photons, it is investigated how a postselected photon can impart a π phase shift (the peak of the amplification) to a photon interacting weakly with it in a nonlinear optical medium. The increasing of the degree of the entanglement lies behind the effectiveness of the postselection in the parameter estimation. In particular, arranging to postselect on pure entangled states can optimize the signal‐to‐noise ratio, allowing to achieve high‐sensitive measurements using low input power.

arXiv:2303.09786•Annalen der Physik•Dec 2, 2021•5 citations
We show the utility of the weak value amplification to observe the quantum interference between two close lying atomic coherent states in a post-selected atomic cat state, produced in a system of N identical two-level atoms weakly interacting with a single photon field. Through the observation of the negative parts of the Wigner distribution of the post-selected atomic cat state, we find that the post-selected atomic cat state becomes more nonclassical when the post-selected polarization state of the single photon field tends toward becoming orthogonal to its pre-selected state. We show that the small phase shift in the post-selected atomic cat state can be amplified via measuring the peak shift of its phase distribution when the post-selected state of the single photon field is nearly orthogonal to its pre-selected state. We find that the amplification factor of 15 [5] can be obtained for a sample of 10 [100] atoms. This effectively provides us with a method to discriminate between two close lying states on the Bloch sphere. We discuss possible experimental implementation of the scheme, and conclude with a discussion of the Fisher information.
Weak value amplification (WVA) is a measurement technique in which the effect of a pre- and post-selected system on a weakly interacting probe is magnified. In this thesis, I present the first experimental observation of WVA of a single photon. We observed that a signal photon - sent through a polarization interferometer and post-selected by photodetection in the almost-dark port - can act like eight photons. The effect of this single photon is measured as a nonlinear phase shift on a separate laser beam. The interaction between the two is mediated by a sample of laser- cooled 85Rb atoms. Electromagnetically induced transparency (EIT) is used to enhance the nonlinearity and overcome resonant absorption. I believe this work to be the first demonstration of WVA where a deterministic interaction is used to entangle two distinct optical systems. In WVA, the amplification is contingent on discarding a large portion of the original data set. While amplification increases measurement sensitivity, discarding data worsens it. Questioning whether these competing effects conspire to improve or diminish measurement accuracy has resulted recently in controversy. I address this question by calculating the maximum amount of information achievable with the WVA technique. By comparing this information to that achievable by the standard technique, where no post-selection is employed, I show that the WVA technique can be advantageous under a certain class of noise models. Finally, I propose a way to optimally apply the WVA technique.
Weak-value amplification (WVA) has emerged as an effective technique for detecting extremely small physical parameters by combining weak system–meter interactions with a carefully chosen post-selection strategy. In this paper, we explore how WVA performs when the meter is prepared in a Schrödinger cat-like state (SCS). Using the Fisher information (FI) as the primary figure of merit, we assess the attainable precision in estimating the interaction parameter. We compare the sensitivities of even coherent states (ECSs), odd coherent states (OCSs), and Yurke–Stoler states (YSSs) against coherent states (CS). We demonstrate that ECS and OCS as meters provide higher FI than the CS as a meter in some cases, depending on the measurement strategy. Also, ECS yields the largest conventional FI among the four meter states. Furthermore, we explore the impact of vacuum superposition with the meter on FI. We find that optimizing the vacuum coefficient enhances the FI in some conditions. This study shows that SCSs can be useful as meter states for improving precision in weak-measurement metrology.
Amplification of the Schrödinger-cat state (even coherent-state superposition) can be accompanied by its non-exponential decoherence and strong squeezing effect in the degenerate optical parametric amplifier. In the classical pump approximation and small thermal noise limit, the Wigner function behaviour illustrates that this non-exponential effect is induced by the phase-selective character of amplification. The non-exponential decoherence is much slower, in contrast with phase-unselective amplification exhibiting faster exponential decay. Thus, if one is able to produce the Schrödinger-cat state with at least a small amplitude, then it can be partially amplified with only a weak decoherence effect.
Abstract Most studies for postselected weak measurement in optomechanical system focus on using a single photon as a measured system. However, we find that using weak coherent light instead of a single photon can also amplify the mirror’s position displacement of one photon. In the weak value amplification (WVA) regime, the weak value of one photon can lie outside the eigenvalue spectrum, proportional to the difference of the mirror’s position displacement between the successful and failed postselection and its successful postselection probability is dependent of the mean photon number of the coherent light and improved by adjusting it accordingly. Outside the WVA regime, the amplification limit can reach the level of the vacuum fluctuations, and when the mean photon number and the optomechanical coupling parameter are selected appropriately, its successful postselection probability becomes higher, which is beneficial to observe the maximum amplification value under the current experimental conditions. This result breaks the constraint that it is difficult to detect outside the WVA regime. This opens up a new regime for the study of a single photon nonlinearity in optomechanical system.
Abstract Single-photon amplification can be used to overcome the photon loss in long-distance quantum communication. However, the trade-off of success probability and amplification gain should be further improved. We propose a single-photon polarization qubit amplification using weak measurement. The polarization qubit can be amplified by the pre- and post-selection of the single-photon meter state weakly coupling with the input state. The success probability does not decrease asymptotically to 0 with increasing amplification gain in the presented proposal, and is higher than that in entanglement-based schemes, without coincidence detection required. Our proposal is feasible in current technology, and helpful for near-future quantum communication.
Abstract To describe the pre‐ and postselected quantum ensembles, a complex quantity called the weak value of an operator is used. The weak value is highly controversial due to the fact that it is not bounded by the possible eigenvalues of the corresponding operator. Nevertheless, the obtaining of the anomalous weak value is regarded as a powerful technique in the quantum interferometry nowadays. Here it is shown that the postselection of a quantum system recovers a completely hidden interference effect in the measurement apparatus. Studying the interference pattern shows the optimal settings for the amplification and the parameter estimation. It also proves that the weak value is not an element of reality. Using single photons, it is investigated how a postselected photon can impart a π phase shift (the peak of the amplification) to a photon interacting weakly with it in a nonlinear optical medium. The increasing of the degree of the entanglement lies behind the effectiveness of the postselection in the parameter estimation. In particular, arranging to postselect on pure entangled states can optimize the signal‐to‐noise ratio, allowing to achieve high‐sensitive measurements using low input power.