Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1405.3371 · Review of Scientific Instruments

Modular cryogenic interconnects for multi-qubit devices

James Colless, D. J. Reilly

Published Nov 1, 2014• 20 citations
arXivHTMLPDF

Abstract

We have developed a modular interconnect platform for the control and readout of multiple solid-state qubits at cryogenic temperatures. The setup provides 74 filtered dc-bias connections, 32 control and readout connections with -3 dB frequency above 5 GHz, and 4 microwave feed lines that allow low loss (less than 3 dB) transmission 10 GHz. The incorporation of a radio-frequency interposer enables the platform to be separated into two printed circuit boards, decoupling the simple board that is bonded to the qubit chip from the multilayer board that incorporates expensive connectors and components. This modular approach lifts the burden of duplicating complex interconnect circuits for every prototype device. We report the performance of this platform at milli-Kelvin temperatures, including signal transmission and crosstalk measurements.

DOI
10.1063/1.4900948

Related papers

Cryogenic high-frequency readout and control platform for spin qubits

James Colless, D. J. Reilly

We have developed a cryogenic platform for the control and readout of spin qubits that comprises a high density of dc and radio frequency sample interconnects based on a set of coupled printed circuit boards. The modular setup incorporates 24 filtered dc lines, 14 control and readout lines with bandwidth from dc to above 6 GHz, and 2 microwave connections for excitation to 40 GHz. We report the performance of this platform, including signal integrity and crosstalk measurements and discuss design criteria for constructing sample interconnect technology needed for multi-qubit devices.

arXiv:1111.6440•Review of Scientific Instruments•Feb 1, 2012•23 citations

CryoCMOS RF multiplexer for superconducting qubit control, readout and flux biasing at millikelvin temperatures with picowatt power consumption

Liam Fallik, Sriram Balamurali, Alican Caglar +12 more

Large-scale cryogenic quantum systems are constrained by an input-output bottleneck between room-temperature electronics and millikelvin stages, particularly in superconducting qubit platforms. This bottleneck is most acute for output lines, where bulky and expensive microwave components limit scalability. A promising approach for scalable characterization and testing is to perform signal multiplexing directly at the qubit plane. We demonstrate a cryogenic CMOS (cryoCMOS) RF multiplexer operating at 10 millikelvin with record-low static power consumption of 200 pW. The device provides < 2 dB insertion loss and > 30 dB isolation across DC-8 GHz. Direct connection to transmon qubits marginally affects coherence times in the range of 100 microseconds, enabling multiplexing of readout, flux and, in principle, XY drive lines. This work introduces cryoCMOS multiplexers as valuable tools for scalable, high-throughput cryogenic characterization and testing, and advances co-integrated quantum-classical control for future large-scale quantum processors.

quant-pharXiv:2603.16608•npj Quantum Information•Mar 18, 2026•0 citations

3D Integrated Embedded Filters for Superconducting Quantum Circuits

Waqas Ahmad, Gioele Consani, Mohammad Tasnimul Haque +2 more

Microwave filtering for superconducting qubits is a key element of quantum computing technology, enabling high coherence and fast state detection. This work presents the design and implementation of novel microwave Purcell filters for superconducting quantum circuits, integrated within a multilayer printed circuit board (PCB). The off-chip design removes all filter components from the qubit substrate, reducing device complexity, improving layout footprint and allowing better scalability to large qubit counts. Each embedded filter can couple up to nine readout resonators, enabling efficient multiplexed readout. Electromagnetic simulations of the filter predict a thousand-fold improvement in qubit isolation from the readout port. The design was experimentally validated under cryogenic conditions in conjunction with a 35-qubit device, demonstrating compatibility of the PCB-based filter with high-coherence superconducting qubits. The comparison of the measured qubit median T1 of 84 $μ$s with the expected radiative limit from electromagnetic simulations validated the presence of Purcell filtering in the system.

quant-pharXiv:2602.24003•Mar 2, 2026•1 citation

Compact radio frequency module for gate-defined quantum dot qubits

Zhiyuan Wu, Zheng Zhou, Xuanyue Pan +2 more

Semiconductor quantum dot spin qubits, which employ radio frequency (RF) techniques for manipulation and readout, present a compelling pathway toward scalable quantum computation. We introduce a robust, miniaturized, and modular RF package designed for high-fidelity, low-crosstalk control of quantum dot qubit systems. This design integrates a master board with an interchangeable daughterboard for rapid sample exchange. Its compact footprint (28 × 50 × 12 mm3) is compatible with standard dilution refrigerator stages. The module provides 48 low-pass-filtered DC bias lines, 28 of which support combined RF/DC operation for qubit control. Dedicated RF lines include eight microwave channels with a DC to 6 GHz bandwidth and 20 DC pulse gate lines with a −3 dB cutoff at 3 GHz. A significant feature of this design is the suppression of crosstalk between adjacent microwave lines to <−30 dB (or less than 0.1% signal leakage) from DC to 6 GHz. This is achieved using optimized alternating ground planes and fencing vias. The module directly supports baseband control strategies, thereby mitigating gigahertz-frequency heating effects in high-density qubit arrays.

Applied Physics Letters•Nov 24, 2025•0 citations

All-optical superconducting qubit readout

Georg Arnold, Thomas Werner, Rishabh Sahu +3 more

The rapid development of superconducting quantum hardware is expected to run into substantial restrictions on scalability because error correction in a cryogenic environment has stringent input-output requirements. Classical data centres rely on fibre-optic interconnects to remove similar networking bottlenecks. In the same spirit, ultracold electro-optic links have been proposed and used to generate qubit control signals, or to replace cryogenic readout electronics. So far, these approaches have suffered from either low efficiency, low bandwidth or additional noise. Here we realize radio-over-fibre qubit readout at millikelvin temperatures. We use one device to simultaneously perform upconversion and downconversion between microwave and optical frequencies and so do not require any active or passive cryogenic microwave equipment. We demonstrate all-optical single-shot readout in a circulator-free readout scheme. Importantly, we do not observe any direct radiation impact on the qubit state, despite the absence of shielding elements. This compatibility between superconducting circuits and telecom-wavelength light is not only a prerequisite to establish modular quantum networks, but it is also relevant for multiplexed readout of superconducting photon detectors and classical superconducting logic.

arXiv:2310.16817•Nature Physics•Feb 11, 2025•48 citations

Cryogenic Multiplexing Control Chip for Superconducting Quantum Processor

Rutian Huang, Xiao Geng, Xinyu Wu +4 more

This paper proposes a scheme and design of cryogenic multiplexing control chip (MCC) which enables one microwave cable to control many superconducting qubits. Designed based on adjustable inductor, MCC is a non-reciprocal device which generates microwave signals between 4 and 8 GHz and constructs XY control circuit to operate qubits. The effects of filters, isolators, power splitters, qubits and load impedance on MCC are analyzed in the frequency-domain simulation. And in time-domain simulation, the response time, Gaussian pulses, single-sideband, amplitude and frequency compensation of MCC are examined. The MCC can be integrated with the superconducting qubits on the same package at 20 mK temperature stage, and output specific microwave pulses used to drive the superconducting qubits without crosstalks. The MCC can greatly reduce the number of microwave control lines and is beneficial to the development of large-scale superconducting quantum processor.

quant-pharXiv:2610.19599•Physical Review Applied•Oct 15, 2026•15 citations
We have developed a modular interconnect platform for the control and readout of multiple solid-state qubits at cryogenic temperatures. The setup provides 74 filtered dc-bias connections, 32 control and readout connections with -3 dB frequency above 5 GHz, and 4 microwave feed lines that allow low loss (less than 3 dB) transmission 10 GHz. The incorporation of a radio-frequency interposer enables the platform to be separated into two printed circuit boards, decoupling the simple board that is bonded to the qubit chip from the multilayer board that incorporates expensive connectors and components. This modular approach lifts the burden of duplicating complex interconnect circuits for every prototype device. We report the performance of this platform at milli-Kelvin temperatures, including signal transmission and crosstalk measurements.
We have developed a cryogenic platform for the control and readout of spin qubits that comprises a high density of dc and radio frequency sample interconnects based on a set of coupled printed circuit boards. The modular setup incorporates 24 filtered dc lines, 14 control and readout lines with bandwidth from dc to above 6 GHz, and 2 microwave connections for excitation to 40 GHz. We report the performance of this platform, including signal integrity and crosstalk measurements and discuss design criteria for constructing sample interconnect technology needed for multi-qubit devices.
Large-scale cryogenic quantum systems are constrained by an input-output bottleneck between room-temperature electronics and millikelvin stages, particularly in superconducting qubit platforms. This bottleneck is most acute for output lines, where bulky and expensive microwave components limit scalability. A promising approach for scalable characterization and testing is to perform signal multiplexing directly at the qubit plane. We demonstrate a cryogenic CMOS (cryoCMOS) RF multiplexer operating at 10 millikelvin with record-low static power consumption of 200 pW. The device provides < 2 dB insertion loss and > 30 dB isolation across DC-8 GHz. Direct connection to transmon qubits marginally affects coherence times in the range of 100 microseconds, enabling multiplexing of readout, flux and, in principle, XY drive lines. This work introduces cryoCMOS multiplexers as valuable tools for scalable, high-throughput cryogenic characterization and testing, and advances co-integrated quantum-classical control for future large-scale quantum processors.
Microwave filtering for superconducting qubits is a key element of quantum computing technology, enabling high coherence and fast state detection. This work presents the design and implementation of novel microwave Purcell filters for superconducting quantum circuits, integrated within a multilayer printed circuit board (PCB). The off-chip design removes all filter components from the qubit substrate, reducing device complexity, improving layout footprint and allowing better scalability to large qubit counts. Each embedded filter can couple up to nine readout resonators, enabling efficient multiplexed readout. Electromagnetic simulations of the filter predict a thousand-fold improvement in qubit isolation from the readout port. The design was experimentally validated under cryogenic conditions in conjunction with a 35-qubit device, demonstrating compatibility of the PCB-based filter with high-coherence superconducting qubits. The comparison of the measured qubit median T1 of 84 μμμs with the expected radiative limit from electromagnetic simulations validated the presence of Purcell filtering in the system.
Semiconductor quantum dot spin qubits, which employ radio frequency (RF) techniques for manipulation and readout, present a compelling pathway toward scalable quantum computation. We introduce a robust, miniaturized, and modular RF package designed for high-fidelity, low-crosstalk control of quantum dot qubit systems. This design integrates a master board with an interchangeable daughterboard for rapid sample exchange. Its compact footprint (28 × 50 × 12 mm3) is compatible with standard dilution refrigerator stages. The module provides 48 low-pass-filtered DC bias lines, 28 of which support combined RF/DC operation for qubit control. Dedicated RF lines include eight microwave channels with a DC to 6 GHz bandwidth and 20 DC pulse gate lines with a −3 dB cutoff at 3 GHz. A significant feature of this design is the suppression of crosstalk between adjacent microwave lines to <−30 dB (or less than 0.1% signal leakage) from DC to 6 GHz. This is achieved using optimized alternating ground planes and fencing vias. The module directly supports baseband control strategies, thereby mitigating gigahertz-frequency heating effects in high-density qubit arrays.
The rapid development of superconducting quantum hardware is expected to run into substantial restrictions on scalability because error correction in a cryogenic environment has stringent input-output requirements. Classical data centres rely on fibre-optic interconnects to remove similar networking bottlenecks. In the same spirit, ultracold electro-optic links have been proposed and used to generate qubit control signals, or to replace cryogenic readout electronics. So far, these approaches have suffered from either low efficiency, low bandwidth or additional noise. Here we realize radio-over-fibre qubit readout at millikelvin temperatures. We use one device to simultaneously perform upconversion and downconversion between microwave and optical frequencies and so do not require any active or passive cryogenic microwave equipment. We demonstrate all-optical single-shot readout in a circulator-free readout scheme. Importantly, we do not observe any direct radiation impact on the qubit state, despite the absence of shielding elements. This compatibility between superconducting circuits and telecom-wavelength light is not only a prerequisite to establish modular quantum networks, but it is also relevant for multiplexed readout of superconducting photon detectors and classical superconducting logic.
This paper proposes a scheme and design of cryogenic multiplexing control chip (MCC) which enables one microwave cable to control many superconducting qubits. Designed based on adjustable inductor, MCC is a non-reciprocal device which generates microwave signals between 4 and 8 GHz and constructs XY control circuit to operate qubits. The effects of filters, isolators, power splitters, qubits and load impedance on MCC are analyzed in the frequency-domain simulation. And in time-domain simulation, the response time, Gaussian pulses, single-sideband, amplitude and frequency compensation of MCC are examined. The MCC can be integrated with the superconducting qubits on the same package at 20 mK temperature stage, and output specific microwave pulses used to drive the superconducting qubits without crosstalks. The MCC can greatly reduce the number of microwave control lines and is beneficial to the development of large-scale superconducting quantum processor.