Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1306.1683 · Applied Physics Letters

Memory cell based on a φ Josephson junction

E. Goldobin, H. Sickinger, Martin P. Weides, N. Ruppelt, H. Kohlstedt, R. Kleiner, D. Koelle

Published Jun 17, 2013• 89 citations
arXivHTMLPDF

Abstract

The φ Josephson junction has a doubly degenerate ground state with the Josephson phases ±φ. We demonstrate the use of such a φ Josephson junction as a memory cell (classical bit), where writing is done by applying a magnetic field and reading by applying a bias current. In the “store” state, the junction does not require any bias or magnetic field, but just needs to stay cooled for permanent storage of the logical bit. Straightforward integration with rapid single flux quantum logic is possible.

DOI
10.1063/1.4811752

Related papers

Memories with Josephson Junctions

Peter Wolf

The talk is based on an overview which was published recently (1). For this reason, only an abstract is given here, which includes Later results not contained in the aforementioned overview. The presently-known Josephson memory cells store information as persistent currents in superconducting loops, or what is equivalent as a magnetic flux in the area of the ring. This method of storage is nonvolatile and has no power consumption in the storing state. In a superconducting ring system, the magnetic flux is quantized, and cells have been built which operate either with only one flux quantum, or with many of them. For the Latter cells with many flux quanta (ring cells), quite a number of designs exist. They have one or two Josephson junctions in the ring, which allow writing. An external junction which is controlled by the ring current serves for non-destructive reading of the information. The smallest cell realized had an area of 900 ?m2 with a 2 ?m minimum line width. Switching speed was ? 80 ps. Cells which store information as a single-flux quantum (single flux-quantum cells = SFQ cells) in the ring, usually contain two Josephson junctions used for reading and writing. Read-out in most of these cells is destructive, but methods of reading non-destructively have also been proposed. The smallest device made had an area of ? 150 ?m2 with a minimum line width of 2 ?m. The read signal had a rise time ? 100 ps.

European Solid-State Circuits Conference (ESSCIRC)•Sep 1, 1978•0 citations

Two-Josephson-junction interferometer memory cell for n.d.r.o.

H. Beha

A single-flux-quantum random-access memory cell for nondestructive read-out and write has been designed and successfully simulated. The binary information is stored in an interferometer with two unequal Josephson junctions. No bias current is needed to store the information. Reasonable operation margins are obtained.

Electronics Letters•Sep 29, 1977•11 citations

A capacitively coupled SFQ Josephson memory cell

Hideo Suzuki, S. Hasuo

The design and experimental results for a novel type of Josephson memory cell are presented. The cell has a simpler construction than the conventional Henkels-type, using a one-junction SQUID (superconducting quantum interference device) capacitively coupled to a single junction. Binary data are stored as single flux quanta and are destructively read out by sensing a pulse caused by a vortex-mode transition. Computer simulations suggest that the read operation could be performed with a bias margin for the sense junction of +or-28% and that the rise time of the sense current in a 16-bit memory cell would be as fast as 30 ps, despite having to sense a vortex-mode transition. Results are presented for a memory cell fabricated with Nb-AlO/sub x/-Nb junctions.>

IEEE Transactions on Electron Devices•Jul 1, 1988•10 citations

Nonvolatile memory cell using a superconducting-ferromagnetic π Josephson junction

Junwen Zeng, Lei Chen, Xianghai Zhong +8 more

Abstract Storage of a single magnetic flux quantum in a superconducting loop containing a Josephson junction represents a promising unit cell configuration for construction of a cryogenic memory of superconducting digital circuits. However, application of a DC bias current is required for operation of such a memory cell to maintain trapping of the flux quantum in the storage loop. In this work, we present a superconducting memory cell that uses a superconducting-magnetic π junction. The cell characteristics show flux quantum hysteresis centering at the zero-bias current. We develop a fabrication process that combines superconductor–ferromagnet–superconductor (SFS) junctions with superconductor–normal metal–superconductor (SNS) junctions. The critical current density of the SFS junctions shows a 0–π oscillation as a function of the ferromagnetic layer thickness. The formation of the π junction is confirmed further by the flux modulation curves of a superconducting quantum interference device made from SNS junctions with an additional SFS junction.

Superconductor Science and Technology•Jul 13, 2022•9 citations

Single Josephson junction superconducting memory cell

James A. Blackburn, H. Smith

It is argued that a large-inductance superconducting loop interrupted by a single Josephson junction can function as a memory element. Bundles of flux quanta can be stored in the cell and removed from it by the application of appropriate bias currents or fields.

Electronics Letters•Aug 31, 1978•2 citations

Rapid single flux quantum random access memory

Stanislav V. Polonsky, Alex F. Kirichenko, Vasili K. Semenov +1 more

A new design concept for the Josephson-junction random access memory (RAM) has been developed. In contrast to previous RAMs based on single flux quantization (SFQ), in our system READ and WRITE operations employ ballistic transfer of SFQ pulses along bit lines (either Josephson transmission lines, or passive superconducting microstrip lines, or their combination). The basic memory cells are the single-junction SQUIDs, connected serially by the bit lines and inductively coupled to word lines. READ and WRITE operations are performed by sending SFQ pulses in appropriate directions along bit lines, and DC currents of appropriate polarity into word lines. This approach allows design of very dense memories with n/spl les/2 Josephson junctions per bit, memory cell area smaller than 80 /spl lambda//sup 2/ (where /spl lambda/ is the minimum feature size), and the critical parameter margin well above /spl plusmn/20%. In this paper we present the general structure of the RSFQ RAM, as well as design and results of testing of the basic memory cell and decoder circuitry using Hypres' 3.5-/spl mu/m, 1-kA/cm/sup 2/ Nb-trilayer technology.>

IEEE Transactions on Applied Superconductivity•Jun 1, 1995•46 citations
The φ Josephson junction has a doubly degenerate ground state with the Josephson phases ±φ. We demonstrate the use of such a φ Josephson junction as a memory cell (classical bit), where writing is done by applying a magnetic field and reading by applying a bias current. In the “store” state, the junction does not require any bias or magnetic field, but just needs to stay cooled for permanent storage of the logical bit. Straightforward integration with rapid single flux quantum logic is possible.
The talk is based on an overview which was published recently (1). For this reason, only an abstract is given here, which includes Later results not contained in the aforementioned overview. The presently-known Josephson memory cells store information as persistent currents in superconducting loops, or what is equivalent as a magnetic flux in the area of the ring. This method of storage is nonvolatile and has no power consumption in the storing state. In a superconducting ring system, the magnetic flux is quantized, and cells have been built which operate either with only one flux quantum, or with many of them. For the Latter cells with many flux quanta (ring cells), quite a number of designs exist. They have one or two Josephson junctions in the ring, which allow writing. An external junction which is controlled by the ring current serves for non-destructive reading of the information. The smallest cell realized had an area of 900 ?m2 with a 2 ?m minimum line width. Switching speed was ? 80 ps. Cells which store information as a single-flux quantum (single flux-quantum cells = SFQ cells) in the ring, usually contain two Josephson junctions used for reading and writing. Read-out in most of these cells is destructive, but methods of reading non-destructively have also been proposed. The smallest device made had an area of ? 150 ?m2 with a minimum line width of 2 ?m. The read signal had a rise time ? 100 ps.
The design and experimental results for a novel type of Josephson memory cell are presented. The cell has a simpler construction than the conventional Henkels-type, using a one-junction SQUID (superconducting quantum interference device) capacitively coupled to a single junction. Binary data are stored as single flux quanta and are destructively read out by sensing a pulse caused by a vortex-mode transition. Computer simulations suggest that the read operation could be performed with a bias margin for the sense junction of +or-28% and that the rise time of the sense current in a 16-bit memory cell would be as fast as 30 ps, despite having to sense a vortex-mode transition. Results are presented for a memory cell fabricated with Nb-AlO/sub x/-Nb junctions.>
Abstract Storage of a single magnetic flux quantum in a superconducting loop containing a Josephson junction represents a promising unit cell configuration for construction of a cryogenic memory of superconducting digital circuits. However, application of a DC bias current is required for operation of such a memory cell to maintain trapping of the flux quantum in the storage loop. In this work, we present a superconducting memory cell that uses a superconducting-magnetic π junction. The cell characteristics show flux quantum hysteresis centering at the zero-bias current. We develop a fabrication process that combines superconductor–ferromagnet–superconductor (SFS) junctions with superconductor–normal metal–superconductor (SNS) junctions. The critical current density of the SFS junctions shows a 0–π oscillation as a function of the ferromagnetic layer thickness. The formation of the π junction is confirmed further by the flux modulation curves of a superconducting quantum interference device made from SNS junctions with an additional SFS junction.
A new design concept for the Josephson-junction random access memory (RAM) has been developed. In contrast to previous RAMs based on single flux quantization (SFQ), in our system READ and WRITE operations employ ballistic transfer of SFQ pulses along bit lines (either Josephson transmission lines, or passive superconducting microstrip lines, or their combination). The basic memory cells are the single-junction SQUIDs, connected serially by the bit lines and inductively coupled to word lines. READ and WRITE operations are performed by sending SFQ pulses in appropriate directions along bit lines, and DC currents of appropriate polarity into word lines. This approach allows design of very dense memories with n/spl les/2 Josephson junctions per bit, memory cell area smaller than 80 /spl lambda//sup 2/ (where /spl lambda/ is the minimum feature size), and the critical parameter margin well above /spl plusmn/20%. In this paper we present the general structure of the RSFQ RAM, as well as design and results of testing of the basic memory cell and decoder circuitry using Hypres' 3.5-/spl mu/m, 1-kA/cm/sup 2/ Nb-trilayer technology.>