Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1305.3298 · Physical Review Letters

Enhanced Atom Interferometer Readout through the Application of Phase Shear

Alex Sugarbaker, Susannah M. Dickerson, Jason M. Hogan, David M. S. Johnson, Mark A. Kasevich

Published Sep 10, 2013• 132 citations
arXivHTMLPDF

Abstract

We present a method for determining the phase and contrast of a single shot of an atom interferometer. The application of a phase shear across the atom ensemble yields a spatially varying fringe pattern at each output port, which can be imaged directly. This method is broadly relevant to atom-interferometric precision measurement, as we demonstrate in a 10 m 87Rb atomic fountain by implementing an atom-interferometric gyrocompass with 10 mdeg precision.

DOI
10.1103/physrevlett.111.113002

Related papers

Enhanced Readout from Spatial Interference Fringes in a Point-Source Cold Atom Inertial Sensor

Jing Wang, Junze Tong, Wenbin Xie +3 more

When the initial size of an atom cloud in a cold atom interferometer is negligible compared to its size after free expansion, the interferometer is approximated to a point-source interferometer and is sensitive to rotational movements by introducing an additional phase shear in the interference sequence. This sensitivity on rotation enables a vertical atom-fountain interferometer to measure angular velocity in addition to gravitational acceleration, which it is conventionally used to measure. The accuracy and precision of the angular velocity measurement depends on proper extraction of frequency and phase from spatial interference patterns detected via the imaging of the atom cloud, which is usually affected by various systematic biases and noise. To improve the measurement, a pre-fitting process based on principal component analysis is applied to the recorded raw images. The contrast of interference patterns are enhanced by 7-12 dB when the processing is present, which leads to an enhancement in the precision of angular velocity measurements from 6.3 μrad/s to 3.3 μrad/s. This technique is applicable in various instruments that involve precise extraction of frequency and phase from a spatial interference pattern.

Sensors•May 25, 2023•3 citations

Method for phase extraction from atom interference fringes via orthogonal subspace projection

Jiaqi Lei, Junjie Jiang, Sitong Yan +8 more

We propose a method for extracting the phase from atom interference fringes based on orthogonal subspace projection. By projecting the shear interference fringes from an atom interferometer into an orthogonal subspace, this method characterizes and removes the atomic ensemble envelope, thereby isolating the interference phase information. We systematically investigate the phase extraction accuracy of this method under various conditions, including different atomic ensemble envelope shapes and fringe contrasts, and apply it to analyze experimental data from two practical atom interferometers. The study demonstrates that, compared to the conventional direct model fitting method, our approach more accurately extracts the interference phase under conditions involving nonideal and dynamically varying atomic ensemble envelopes as well as low-contrast fringes, thereby improving the accuracy and robustness of the atom interferometer. This makes it particularly valuable for application-oriented atom shear interferometers operating in complex environments.

AVS Quantum Science•Feb 26, 2026•0 citations

Absolute-phase-shift measurement in a phase-shear-readout atom interferometer

Sitong Yan, Junjie Jiang, Lin Zhou +7 more

We demonstrate that the shear phase introduced by a tilting Raman beam in a Mach-Zehnder atom interferometer actually shifts the absolute phase, and propose how this shift can be compensated for by reference to a special point of the interference fringe. In the experiment, we obtain shear interference fringes and achieve the extraction of absolute phase corresponding to gravity acceleration. To suppress the impact of position drift on measurement accuracy, we adopt a positive and negative tilt angle alternating measurement (PNTAM) method. After using this PNTAM method, when the position drift leads to a change of $2.2\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}3}\phantom{\rule{0.16em}{0ex}}\mathrm{g}$, the impact of this drift on the absolute measurement value is less than $1.9\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}4}\phantom{\rule{0.16em}{0ex}}\mathrm{g}$. This work expands the application range of the phase shear readout based atom interferometer from the current relative or differential gravity measurement to the field of absolute gravity measurement.

Physical Review A•Dec 19, 2023•2 citations

Measurement of a Li7 tune-out wavelength by phase-patterned atom interferometry

Eric Copenhaver, Kayleigh Cassella, Robert Berghaus +1 more

Atom interferometers typically use the total populations at the interferometer's output ports as the signal, but useful information can be encoded into spatial phase patterns. An interferometer translates the phase pattern into a measurable pattern in the atomic density that we use to perform a direct precision measurement of the $^{7}\mathrm{Li}$ tune-out wavelength near 671 nm. Expressed as a detuning from the $|2{S}_{1/2},F=2\ensuremath{\rangle}\ensuremath{\rightarrow}|2{P}_{1/2},{F}^{\ensuremath{'}}=2\ensuremath{\rangle}$ transition, we find 3329.5(1.4) MHz for the tensor-shifted tune out of the $|2{S}_{1/2},F=2,{m}_{F}=0\ensuremath{\rangle}$ state with ${\ensuremath{\sigma}}^{\ifmmode\pm\else\textpm\fi{}}$ light polarization and 3310.6(4.9) MHz for the tune out of the scalar polarizability. This technique may be generalized for directly sensing spatially varying phase profiles.

arXiv:1904.08974•Physical Review A•Dec 2, 2019•14 citations

Readout-delay-free Bragg atom interferometry using overlapped spatial fringes

P. B. Wigley, Kyle S. Hardman, Christian Freier +5 more

A method for mitigating the readout delay characteristic of Bragg-based atom interferometry is presented, utilizing an asymmetric Mach-Zehnder interferometer sequence to generate spatial fringes that are read out while still overlapped. The time of flight after the final beamsplitter is engineered to facilitate constructive overlap of the fringes on the output states. A noise analysis performed using a precision atom interferometer is presented, comparing the traditional separated symmetric scheme with that of the separated and overlapped asymmetric scheme showing no significant increase in short-term phase noise.

arXiv:1812.09076•Physical Review A•Feb 11, 2019•12 citations

Investigating operation of atom interferometers in dynamic inertial conditions

David Sedlak

This thesis investigates the operation of atom interferometers in dynamic inertial conditions. As such, the cross-coupling effect of an accelerating sensor head on the output of an interferometer has been simulated, showing a contrast drop to 59% for T = 80 ms and 49% for T = 40 ms if the centre-of-mass of the atoms is within the waist radius of the Raman laser beam. Two ways to combat dynamic conditions are presented. Firstly, a model that is able to simulate phase shear fringes using fluorescence coupled with camera imaging is presented, helping to pave way towards extracting contrast and interferometer phase in one experimental shot. Secondly, a preliminary investigation of multi-modal measurements of gravity, magnetic field and magnetic field gradient is presented. Atom shot noise uncertainties for a T = 50 ms interferometer with 10\(^6\) atoms are estimated as 3 \(\times\) 10\(^-\)\(^8\) ms\(^-\)\(^2\) per shot for gravity and 4 \(\times\) 10\(^-\)\(^6\) Gm\(^-\)\(^1\) per shot for magnetic field gradient. Experimentally, gravity gradiometer based on atom interferometry has been built. It is capable of producing over 10\(^8\) atoms in the MOT, with cloud temperatures of 7.3 \(\pm\) 0.2 \(\mu\)K for the top chamber and 7.4 \(\pm\) 1.7 \(\mu\)K for the bottom chamber following molasses and state preparation. Interferometry is demonstrated, able to obtain short T gravity fringes without vibration isolation platform. Implementation steps required for phase shear readout are investigated, implementing a beam tilting Raman telescope, camera imaging and building an analysis technique using principal component analysis. The system is integrated with a classical accelerometer and tiltmeter (as well as a linear rail) and is able to obtain Rabi oscillations while moving.

•Jul 15, 2025•0 citations
We present a method for determining the phase and contrast of a single shot of an atom interferometer. The application of a phase shear across the atom ensemble yields a spatially varying fringe pattern at each output port, which can be imaged directly. This method is broadly relevant to atom-interferometric precision measurement, as we demonstrate in a 10 m 87Rb atomic fountain by implementing an atom-interferometric gyrocompass with 10 mdeg precision.
When the initial size of an atom cloud in a cold atom interferometer is negligible compared to its size after free expansion, the interferometer is approximated to a point-source interferometer and is sensitive to rotational movements by introducing an additional phase shear in the interference sequence. This sensitivity on rotation enables a vertical atom-fountain interferometer to measure angular velocity in addition to gravitational acceleration, which it is conventionally used to measure. The accuracy and precision of the angular velocity measurement depends on proper extraction of frequency and phase from spatial interference patterns detected via the imaging of the atom cloud, which is usually affected by various systematic biases and noise. To improve the measurement, a pre-fitting process based on principal component analysis is applied to the recorded raw images. The contrast of interference patterns are enhanced by 7-12 dB when the processing is present, which leads to an enhancement in the precision of angular velocity measurements from 6.3 μrad/s to 3.3 μrad/s. This technique is applicable in various instruments that involve precise extraction of frequency and phase from a spatial interference pattern.
We propose a method for extracting the phase from atom interference fringes based on orthogonal subspace projection. By projecting the shear interference fringes from an atom interferometer into an orthogonal subspace, this method characterizes and removes the atomic ensemble envelope, thereby isolating the interference phase information. We systematically investigate the phase extraction accuracy of this method under various conditions, including different atomic ensemble envelope shapes and fringe contrasts, and apply it to analyze experimental data from two practical atom interferometers. The study demonstrates that, compared to the conventional direct model fitting method, our approach more accurately extracts the interference phase under conditions involving nonideal and dynamically varying atomic ensemble envelopes as well as low-contrast fringes, thereby improving the accuracy and robustness of the atom interferometer. This makes it particularly valuable for application-oriented atom shear interferometers operating in complex environments.
We demonstrate that the shear phase introduced by a tilting Raman beam in a Mach-Zehnder atom interferometer actually shifts the absolute phase, and propose how this shift can be compensated for by reference to a special point of the interference fringe. In the experiment, we obtain shear interference fringes and achieve the extraction of absolute phase corresponding to gravity acceleration. To suppress the impact of position drift on measurement accuracy, we adopt a positive and negative tilt angle alternating measurement (PNTAM) method. After using this PNTAM method, when the position drift leads to a change of $2.2\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}3}\phantom{\rule{0.16em}{0ex}}\mathrm{g}$, the impact of this drift on the absolute measurement value is less than $1.9\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}4}\phantom{\rule{0.16em}{0ex}}\mathrm{g}$. This work expands the application range of the phase shear readout based atom interferometer from the current relative or differential gravity measurement to the field of absolute gravity measurement.
Atom interferometers typically use the total populations at the interferometer's output ports as the signal, but useful information can be encoded into spatial phase patterns. An interferometer translates the phase pattern into a measurable pattern in the atomic density that we use to perform a direct precision measurement of the 7Li^{7}\mathrm{Li}7Li tune-out wavelength near 671 nm. Expressed as a detuning from the $|2{S}_{1/2},F=2\ensuremath{\rangle}\ensuremath{\rightarrow}|2{P}_{1/2},{F}^{\ensuremath{'}}=2\ensuremath{\rangle}$ transition, we find 3329.5(1.4) MHz for the tensor-shifted tune out of the $|2{S}_{1/2},F=2,{m}_{F}=0\ensuremath{\rangle}$ state with ${\ensuremath{\sigma}}^{\ifmmode\pm\else\textpm\fi{}}$ light polarization and 3310.6(4.9) MHz for the tune out of the scalar polarizability. This technique may be generalized for directly sensing spatially varying phase profiles.
A method for mitigating the readout delay characteristic of Bragg-based atom interferometry is presented, utilizing an asymmetric Mach-Zehnder interferometer sequence to generate spatial fringes that are read out while still overlapped. The time of flight after the final beamsplitter is engineered to facilitate constructive overlap of the fringes on the output states. A noise analysis performed using a precision atom interferometer is presented, comparing the traditional separated symmetric scheme with that of the separated and overlapped asymmetric scheme showing no significant increase in short-term phase noise.
This thesis investigates the operation of atom interferometers in dynamic inertial conditions. As such, the cross-coupling effect of an accelerating sensor head on the output of an interferometer has been simulated, showing a contrast drop to 59% for T = 80 ms and 49% for T = 40 ms if the centre-of-mass of the atoms is within the waist radius of the Raman laser beam. Two ways to combat dynamic conditions are presented. Firstly, a model that is able to simulate phase shear fringes using fluorescence coupled with camera imaging is presented, helping to pave way towards extracting contrast and interferometer phase in one experimental shot. Secondly, a preliminary investigation of multi-modal measurements of gravity, magnetic field and magnetic field gradient is presented. Atom shot noise uncertainties for a T = 50 ms interferometer with 106^66 atoms are estimated as 3 ×\times× 10−^-−8^88 ms−^-−2^22 per shot for gravity and 4 ×\times× 10−^-−6^66 Gm−^-−1^11 per shot for magnetic field gradient. Experimentally, gravity gradiometer based on atom interferometry has been built. It is capable of producing over 108^88 atoms in the MOT, with cloud temperatures of 7.3 ±\pm± 0.2 μ\muμK for the top chamber and 7.4 ±\pm± 1.7 μ\muμK for the bottom chamber following molasses and state preparation. Interferometry is demonstrated, able to obtain short T gravity fringes without vibration isolation platform. Implementation steps required for phase shear readout are investigated, implementing a beam tilting Raman telescope, camera imaging and building an analysis technique using principal component analysis. The system is integrated with a classical accelerometer and tiltmeter (as well as a linear rail) and is able to obtain Rabi oscillations while moving.