Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1210.2351 · Physical Review B

Slow noise processes in superconducting resonators

Jonathan Burnett, T. Lindström, M. Oxborrow, Y. Harada, Y. Sekine, P. J. Meeson, Alexander Ya. Tzalenchuk

Published Apr 5, 2013• 29 citations
arXivHTMLPDF

Abstract

Slow noise processes, with characteristic timescales $\ensuremath{\sim}$1 s, have been studied in planar superconducting resonators. A frequency-locked loop is employed to track deviations of the resonator center frequency with high precision and bandwidth. Comparative measurements are made in varying microwave drive and temperature, and between bare resonators and those with an additional dielectric layer. All resonators are found to exhibit flicker frequency noise which increases with decreasing microwave drive. We also show that an increase in temperature results in a saturation of flicker noise in resonators with an additional dielectric layer, while bare resonators stop exhibiting flicker noise, instead showing a random frequency walk process.

DOI
10.1103/physrevb.87.140501

Related papers

PC2: Identifying noise processes in superconducting resonators

Jonathan Burnett, T. Lindström, Ilana Wisby +6 more

Extensive studies of dielectric loss due to two level fluctuators (TLFs) in superconducting resonators have provided routes for low loss resonators. The research is motivated not only by the use of resonators as detectors and in quantum information processing, but more generally due to TLFs being a source of noise and decoherence in all quantum devices. In this work a frequency locked loop was used to measure frequency fluctuations at timescales in excess of 104 seconds, thereby accurately probing the TLF induced low- frequency noise of the resonator. Our measurement method lead to very high statistical confidence even for very long timescales, and here we can therefore present results explicitly identifying power dependent flicker frequency noise (S = 1/fawhere a=1) persisting down to the mHz level.

IEEE International Superconductive Electronics Conference (ISEC)•Jul 1, 2013•1 citation

Stability of superconducting resonators: Motional narrowing and the role of Landau-Zener driving of two-level defects

David Niepce, Jonathan Burnett, Marina Kudra +2 more

Frequency instability of superconducting resonators and qubits leads to dephasing and time-varying energy loss and hinders quantum processor tune-up. Its main source is dielectric noise originating in surface oxides. Thorough noise studies are needed to develop a comprehensive understanding and mitigation strategy of these fluctuations. We use a frequency-locked loop to track the resonant frequency jitter of three different resonator types—one niobium nitride superinductor, one aluminum coplanar waveguide, and one aluminum cavity—and we observe notably similar random telegraph signal fluctuations. At low microwave drive power, the resonators exhibit multiple, unstable frequency positions, which, for increasing power, coalesce into one frequency due to motional narrowing caused by sympathetic driving of two-level system defects by the resonator. In all three devices, we identify a dominant fluctuator whose switching amplitude (separation between states) saturates with increasing drive power, but whose characteristic switching rate follows the power law dependence of quasi-classical Landau-Zener transitions.

arXiv:2008.07038•Science Advances•Sep 24, 2021•28 citations

Noise in NbTiN, Al, and Ta Superconducting Resonators on Silicon and Sapphire Substrates

R. Barends, H. L. Hortensius, T. Zijlstra +4 more

We present measurements of the frequency noise and resonance frequency temperature dependence in planar superconducting resonators on both silicon and sapphire substrates. We show, by covering the resonators with sputtered SiOxlayers of different thicknesses, that the temperature dependence of the resonance frequency scales linearly with thickness, whereas the observed increase in noise is independent of thickness. The frequency noise decreases when increasing the width of the coplanar waveguide in NbTiN on hydrogen passivated silicon devices, most effectively by widening the gap. We find up to an order of magnitude more noise when using sapphire instead of silicon as substrate. The complete set of data points towards the noise being strongly affected by superconductor-dielectric interfaces.

IEEE Transactions on Applied Superconductivity•Jun 1, 2009•45 citations

Contribution of dielectrics to frequency and noise of NbTiN superconducting resonators

R. Barends, H. L. Hortensius, T. Zijlstra +4 more

We study NbTiN resonators by measurements of the temperature dependent resonance frequency and frequency noise. Additionally, resonators are studied covered with SiOx dielectric layers of various thicknesses. The resonance frequency develops a nonmonotonic temperature dependence with increasing SiOx layer thickness. The increase in the noise is independent of the SiOx thickness, demonstrating that the noise is not dominantly related to the low temperature resonance frequency deviations.

arXiv:0804.3499•Applied Physics Letters•Jun 2, 2008•108 citations

Temperature dependence of the frequency and noise of superconducting coplanar waveguide resonators

Shwetank Kumar, Jiansong Gao, Jonas Zmuidzinas +3 more

We present measurements of the temperature and power dependence of the resonance frequency and frequency noise of superconducting niobium thin-film coplanar waveguide resonators carried out at temperatures well below the superconducting transition (Tc=9.2K). The noise decreases by nearly two orders of magnitude as the temperature is increased from 120to1200mK, while the variation of the resonance frequency with temperature over this range agrees well with the standard two-level system (TLS) model for amorphous dielectrics. These results support the hypothesis that TLSs are responsible for the noise in superconducting microresonators and have important implications for resonator applications such as qubits and photon detectors.

arXiv:0802.4268•Applied Physics Letters•Mar 24, 2008•81 citations

Accurate Real-Time Monitoring of Quality Factor and Center Frequency of Superconducting Resonators

Sebastian E. de Graaf, Andrey V. Danilov, Sergey Kubatkin

In this paper, we track both center frequency and quality factor of a superconducting microwave resonator with very high precision using a modified Pound-Drever-Hall frequency locking scheme. The quality factor measurements can be done with high enough bandwidth to study different processes in a superconducting resonator in real time. With this added functionality, the frequency readout remains unaffected, with typical accuracy around 10-30 Hz/√(Hz), whereas the cavity loss rate can be determined to within 0.1% on a millisecond time scale (34 dB/√(Hz)). As we demonstrate, this can be particularly useful for electron spin resonance measurements, where we achieve a minimum number of detectable spins coupled to the resonator N = 5 ·105spins/√(Hz), based on quality factor measurements. It also enables the study of fast dynamic processes, for example, vortex dynamics, in these devices on a short time scale.

IEEE Transactions on Applied Superconductivity•Apr 9, 2014•9 citations
Slow noise processes, with characteristic timescales \ensuremath∼\ensuremath{\sim}\ensuremath∼1 s, have been studied in planar superconducting resonators. A frequency-locked loop is employed to track deviations of the resonator center frequency with high precision and bandwidth. Comparative measurements are made in varying microwave drive and temperature, and between bare resonators and those with an additional dielectric layer. All resonators are found to exhibit flicker frequency noise which increases with decreasing microwave drive. We also show that an increase in temperature results in a saturation of flicker noise in resonators with an additional dielectric layer, while bare resonators stop exhibiting flicker noise, instead showing a random frequency walk process.
Extensive studies of dielectric loss due to two level fluctuators (TLFs) in superconducting resonators have provided routes for low loss resonators. The research is motivated not only by the use of resonators as detectors and in quantum information processing, but more generally due to TLFs being a source of noise and decoherence in all quantum devices. In this work a frequency locked loop was used to measure frequency fluctuations at timescales in excess of 104 seconds, thereby accurately probing the TLF induced low- frequency noise of the resonator. Our measurement method lead to very high statistical confidence even for very long timescales, and here we can therefore present results explicitly identifying power dependent flicker frequency noise (S = 1/fawhere a=1) persisting down to the mHz level.
Frequency instability of superconducting resonators and qubits leads to dephasing and time-varying energy loss and hinders quantum processor tune-up. Its main source is dielectric noise originating in surface oxides. Thorough noise studies are needed to develop a comprehensive understanding and mitigation strategy of these fluctuations. We use a frequency-locked loop to track the resonant frequency jitter of three different resonator types—one niobium nitride superinductor, one aluminum coplanar waveguide, and one aluminum cavity—and we observe notably similar random telegraph signal fluctuations. At low microwave drive power, the resonators exhibit multiple, unstable frequency positions, which, for increasing power, coalesce into one frequency due to motional narrowing caused by sympathetic driving of two-level system defects by the resonator. In all three devices, we identify a dominant fluctuator whose switching amplitude (separation between states) saturates with increasing drive power, but whose characteristic switching rate follows the power law dependence of quasi-classical Landau-Zener transitions.
We present measurements of the frequency noise and resonance frequency temperature dependence in planar superconducting resonators on both silicon and sapphire substrates. We show, by covering the resonators with sputtered SiOxlayers of different thicknesses, that the temperature dependence of the resonance frequency scales linearly with thickness, whereas the observed increase in noise is independent of thickness. The frequency noise decreases when increasing the width of the coplanar waveguide in NbTiN on hydrogen passivated silicon devices, most effectively by widening the gap. We find up to an order of magnitude more noise when using sapphire instead of silicon as substrate. The complete set of data points towards the noise being strongly affected by superconductor-dielectric interfaces.
We present measurements of the temperature and power dependence of the resonance frequency and frequency noise of superconducting niobium thin-film coplanar waveguide resonators carried out at temperatures well below the superconducting transition (Tc=9.2K). The noise decreases by nearly two orders of magnitude as the temperature is increased from 120to1200mK, while the variation of the resonance frequency with temperature over this range agrees well with the standard two-level system (TLS) model for amorphous dielectrics. These results support the hypothesis that TLSs are responsible for the noise in superconducting microresonators and have important implications for resonator applications such as qubits and photon detectors.
In this paper, we track both center frequency and quality factor of a superconducting microwave resonator with very high precision using a modified Pound-Drever-Hall frequency locking scheme. The quality factor measurements can be done with high enough bandwidth to study different processes in a superconducting resonator in real time. With this added functionality, the frequency readout remains unaffected, with typical accuracy around 10-30 Hz/√(Hz), whereas the cavity loss rate can be determined to within 0.1% on a millisecond time scale (34 dB/√(Hz)). As we demonstrate, this can be particularly useful for electron spin resonance measurements, where we achieve a minimum number of detectable spins coupled to the resonator N = 5 ·105spins/√(Hz), based on quality factor measurements. It also enables the study of fast dynamic processes, for example, vortex dynamics, in these devices on a short time scale.