Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1209.6550 · Physical Review Letters

Electrical Readout for Coherent Phenomena Involving Rydberg Atoms in Thermal Vapor Cells

Daniel Barredo, Harald Kübler, Renate Daschner, R. Löw, Tilman Pfau

Published Mar 21, 2013• 55 citations
arXivHTMLPDF

Abstract

We present a very sensitive and scalable method to measure the population of highly excited Rydberg states in a thermal vapor cell of rubidium atoms. We detect the Rydberg ionization current in a 5 mm electrically contacted cell. The measured current is found to be in qualitatively good agreement with a theory for the Rydberg population based on a master equation for the three-level problem, including an ionization channel and the full Doppler distributions at the corresponding temperatures. The signal-to-noise ratio of the current detection is substantially better than that of purely optical techniques.

DOI
10.1103/physrevlett.110.123002

Related papers

Four-wave mixing involving Rydberg states in thermal vapor

A. Kölle, G. Epple, Harald Kübler +2 more

We present experimental results on nondegenerate four-wave mixing in a thermal vapor cell of rubidium atoms via highly excited Rydberg states. We observe sub-Doppler spectral features and a large sensitivity of the mixed light mode to small electric fields due to the large polarizabilities of the involved Rydberg state. We observe a saturation of the optical response due to the nonlinear four-level physics. The strong interaction between Rydberg atoms and the associated Rydberg blockade could potentially increase the nonlinearity dramatically.

Physical Review A•Jun 21, 2012•59 citations

Sensitivity comparison of Rydberg atom-based radio frequency electric field detection: Ionization current versus optical readout

Dangka Shylla, Rajavardhan Talashila, Alexandra B. Artusio‐Glimpse +7 more

We investigate a technique for detecting radio frequency (RF) electric fields in a cesium (Cs) vapor cell at room temperature by collecting charges from ionized Rydberg atoms and compare its performance with the established method of electromagnetically induced transparency (EIT). By applying a known RF field, we measure the response from both the electrical (ionization current-based) and optical (EIT-based) readouts. The ionization current-based method yields a sensitivity of 22 μ V m−1 Hz−1/2, while the EIT-based method achieves 3.7 μ V m−1 Hz−1/2. The sensitivity of the ionization current-based method is limited by the 2.2 k Ω resistance between the collection electrodes, attributed to a thin Cs film on the inner surfaces of the vapor cell. Controlling or eliminating the Cs layer can significantly improve the sensitivity of this ionization approach.

arXiv:2509.15463•AVS Quantum Science•Jan 27, 2026•0 citations

Vapor cell Rydberg atom electrometry with time-separated fields

Michael V. Romalis, Wiedemann, Joe, Shaobo Zhang +1 more

Rydberg atoms have large transition electric dipole moments and high sensitivity to electric fields. We describe a new method for microwave field sensing in a vapor cell consisting of separate excitation, quantum evolution between two Rydberg levels in the dark and state-dependent detection with probe laser transmission. Using microwave pulse techniques we study homogeneous and inhomogeneous relaxation of the coherence between Rydberg levels and demonstrate detection of a 10 GHz signal with electric field sensitivity of 10 nV/cm/Hz$^{1/2}$.

arXiv:2406.05106•Jun 7, 2024•7 citations

Microwave electric field measurement using frequency modulation spectroscopy in Rydberg atoms vapor cells

Santosh Kumar, Haoquan Fan, Akbar Jahangiri Jozani +2 more

We recently proposed a method to detect weak microwave electric field ~8µV/cm with sensitivity ~ 30 µV cm−1Hz−1/2 [Nat. Phys. 8, 819 (2012)]. This technique is based on Rydberg atoms using the concept of electromagnetically induced transparency in room temperature vapor cells. Here we show that frequency modulation spectroscopy with active control of residual amplitude modulation improves the read out signal-to-noise. The method has the potential for high sensitivity and can be self-calibrated.

International conference on fiber optics and photonics•Jan 1, 2016•0 citations

Electron Beam Profiling via Rydberg Electromagnetically Induced Transparency in Rubidium Vapor with Crossed Laser beams

Rob Behary, Kevin Su, Nicolas DeStefano +9 more

We present an all-optical detection approach to determine the position and spatial profile of an electron beam based on quantum properties of alkali metal atoms. To measure the electric field, produced by an electron beam, we excite thermal rubidium atoms to a highly excited Rydberg state via a two-photon ladder transition and detect Stark shifts of Rydberg states by monitoring frequencies of the corresponding electromagnetically induced transparency (EIT) transmission peaks. We addressed several technical challenges in this approach. First, we use crossed laser beams to obtain spatial information about the electron beam position and geometry. Second, by pulsing the electron beam and using phase-sensitive optical detection, we separate the true electron beam electric signature from the parasitic electric fields due to photoelectric charges on the windows. Finally, we use a principle component analysis to further improve signal quality. We test this method to detect the current and to reconstruct a 2D profile of a 20 keV electron beam with currents ranging from 25 - 100 uA. While this technique provides less spatial resolution than fluorescence-based measurements, thanks to their speed and limited optical access requirements it can be useful for real-time non-invasive diagnostics of charged particle beams at accelerator facilities.

arXiv:2601.02549•Jan 5, 2026•1 citation

GHz Rabi Flopping to Rydberg States in Hot Atomic Vapor Cells

Bernhard Huber, T. Baluktsian, Michael Schlagmüller +4 more

We report on the observation of Rabi oscillations to a Rydberg state on a time scale below 1 ns in thermal rubidium vapor. We use a bandwidth-limited pulsed excitation and observe up to 6 full Rabi cycles within a pulse duration of ∼4 ns. We find good agreement between the experiment and numerical simulations based on a surprisingly simple model. This result shows that fully coherent dynamics with Rydberg states can be achieved even in thermal atomic vapor, thus suggesting small vapor cells as a platform for room-temperature quantum devices. Furthermore, the result implies that previous coherent dynamics in single-atom Rydberg gates can be accelerated by 3 orders of magnitude.

arXiv:1110.2112•Physical Review Letters•Dec 5, 2011•66 citations
We present a very sensitive and scalable method to measure the population of highly excited Rydberg states in a thermal vapor cell of rubidium atoms. We detect the Rydberg ionization current in a 5 mm electrically contacted cell. The measured current is found to be in qualitatively good agreement with a theory for the Rydberg population based on a master equation for the three-level problem, including an ionization channel and the full Doppler distributions at the corresponding temperatures. The signal-to-noise ratio of the current detection is substantially better than that of purely optical techniques.
We present experimental results on nondegenerate four-wave mixing in a thermal vapor cell of rubidium atoms via highly excited Rydberg states. We observe sub-Doppler spectral features and a large sensitivity of the mixed light mode to small electric fields due to the large polarizabilities of the involved Rydberg state. We observe a saturation of the optical response due to the nonlinear four-level physics. The strong interaction between Rydberg atoms and the associated Rydberg blockade could potentially increase the nonlinearity dramatically.
We investigate a technique for detecting radio frequency (RF) electric fields in a cesium (Cs) vapor cell at room temperature by collecting charges from ionized Rydberg atoms and compare its performance with the established method of electromagnetically induced transparency (EIT). By applying a known RF field, we measure the response from both the electrical (ionization current-based) and optical (EIT-based) readouts. The ionization current-based method yields a sensitivity of 22 μ V m−1 Hz−1/2, while the EIT-based method achieves 3.7 μ V m−1 Hz−1/2. The sensitivity of the ionization current-based method is limited by the 2.2 k Ω resistance between the collection electrodes, attributed to a thin Cs film on the inner surfaces of the vapor cell. Controlling or eliminating the Cs layer can significantly improve the sensitivity of this ionization approach.
Rydberg atoms have large transition electric dipole moments and high sensitivity to electric fields. We describe a new method for microwave field sensing in a vapor cell consisting of separate excitation, quantum evolution between two Rydberg levels in the dark and state-dependent detection with probe laser transmission. Using microwave pulse techniques we study homogeneous and inhomogeneous relaxation of the coherence between Rydberg levels and demonstrate detection of a 10 GHz signal with electric field sensitivity of 10 nV/cm/Hz1/2^{1/2}1/2.
We recently proposed a method to detect weak microwave electric field ~8µV/cm with sensitivity ~ 30 µV cm−1Hz−1/2 [Nat. Phys. 8, 819 (2012)]. This technique is based on Rydberg atoms using the concept of electromagnetically induced transparency in room temperature vapor cells. Here we show that frequency modulation spectroscopy with active control of residual amplitude modulation improves the read out signal-to-noise. The method has the potential for high sensitivity and can be self-calibrated.
We present an all-optical detection approach to determine the position and spatial profile of an electron beam based on quantum properties of alkali metal atoms. To measure the electric field, produced by an electron beam, we excite thermal rubidium atoms to a highly excited Rydberg state via a two-photon ladder transition and detect Stark shifts of Rydberg states by monitoring frequencies of the corresponding electromagnetically induced transparency (EIT) transmission peaks. We addressed several technical challenges in this approach. First, we use crossed laser beams to obtain spatial information about the electron beam position and geometry. Second, by pulsing the electron beam and using phase-sensitive optical detection, we separate the true electron beam electric signature from the parasitic electric fields due to photoelectric charges on the windows. Finally, we use a principle component analysis to further improve signal quality. We test this method to detect the current and to reconstruct a 2D profile of a 20 keV electron beam with currents ranging from 25 - 100 uA. While this technique provides less spatial resolution than fluorescence-based measurements, thanks to their speed and limited optical access requirements it can be useful for real-time non-invasive diagnostics of charged particle beams at accelerator facilities.
We report on the observation of Rabi oscillations to a Rydberg state on a time scale below 1 ns in thermal rubidium vapor. We use a bandwidth-limited pulsed excitation and observe up to 6 full Rabi cycles within a pulse duration of ∼4 ns. We find good agreement between the experiment and numerical simulations based on a surprisingly simple model. This result shows that fully coherent dynamics with Rydberg states can be achieved even in thermal atomic vapor, thus suggesting small vapor cells as a platform for room-temperature quantum devices. Furthermore, the result implies that previous coherent dynamics in single-atom Rydberg gates can be accelerated by 3 orders of magnitude.