The energy cost of measurement is an important fundamental question, and may have profound implications for quantum technologies. In the context of Maxwell's demon, it is often stated that measurement has no minimum energy cost, while information has a work value. However, as we elucidate, the first of these statements does not refer to the cost paid by the measuring device. Here we show that it is only when a measuring device has access to a zero-temperature reservoir-that is, never-that measurement requires no energy. To obtain a given amount of information, all measuring devices must pay a cost equal to that which a heat engine would pay to obtain the equivalent work value of that information.
The energy cost of measurement is an important fundamental question, and may have profound implications for quantum technologies. In the context of Maxwell's demon, it is often stated that measurement has no minimum energy cost, while information has a work value. However, as we elucidate, the first of these statements does not refer to the cost paid by the measuring device. Here we show that it is only when a measuring device has access to a zero-temperature reservoir-that is, never-that measurement requires no energy. To obtain a given amount of information, all measuring devices must pay a cost equal to that which a heat engine would pay to obtain the equivalent work value of that information.
Quantum measurement of a system can change its mean energy as well as entropy. A selective measurement (classical or quantum) can be used as a 'Maxwell's demon' to power a single-temperature heat engine by decreasing the entropy. Quantum mechanically, so can a non-selective measurement, despite increasing the entropy of a thermal state. The maximal amount of work extractable following the measurement is given by the change in free energy: W (non-)sel max = Δ E meas − T Bath Δ S (non-)sel meas . This follows from the 'generalized 2nd law for nonequilibrium initial state' (Hasegawa et al 2010 Phys. Lett. A 374 1001–4), an elementary reduction of which to the standard law is given here. It is shown that W sel max − W non-sel max is equal to the work required for resetting the memory of the measuring device and that no such resetting is needed in the non-selective case. Consequently, a single-bath engine powered by either kind of measurement works at a net loss of T Bath Δ S non-sel meas per cycle. By replacing the measurement by a reversible 'pre-measurement' and allowing a work source to couple to the system and memory , the cycle can be rendered completely reversible.
Information engines, sometimes referred to as Maxwell Demon engines, utilize information obtained through measurement to control the conversion of energy into useful work. Discussions around such devices often assume the measurement step to be instantaneous, assessing its cost by Landauer's information erasure within the measurement device. While this simplified perspective is sufficient for classical feedback-controlled engines, for nanoengines that often operate in the quantum realm, the overall performance may be significantly affected by the measurement duration (which may be comparable to the engine's cycle time) and cost (energy needed to create the system-meter correlation). In this study, we employ a generalized von Neumann measurement model to highlight that obtaining a finite amount of information requires a finite measurement time and incurs an energetic cost. We investigate the crucial role of these factors in determining the engine's performance, particularly in terms of efficiency and power output. Furthermore, for the information engine model under consideration, we establish a precise relationship between the acquired information in the measurement process and the maximum energy extractable through the measurement. We also discuss ways to extend our considerations using these concepts, such as in measurement-enhanced photochemical reactions.
Information is usually treated as something we use to describe the physical world. In modern physics, however, there is growing evidence that information itself behaves like a physical resource, subject to the same laws that govern energy, heat, and matter. This paper develops that perspective through a concrete experimental proposal we call Quantum Maxwell Demon Arrays (QMDA)—systems that use measurement and feedback at the quantum scale to convert information about a system into controlled physical work. Building on established results such as the Landauer bound and the Szilard engine, we show that information acquired through measurement can be converted into usable free energy, provided that its physical costs and constraints are properly accounted for. In QMDA, measurements are not passive observations but active physical interactions whose outcomes can be stored, processed, and exploited thermodynamically. Organized into arrays, these measurement–feedback units act collectively, allowing information flow itself to shape energy extraction, entropy production, and system control. We demonstrate how QMDA can serve as experimental probes of information thermodynamics, enabling direct tests of how information constrains and enables physical processes in quantum regimes. This framework clarifies the status of measurement as a physical operation rather than a subjective act of interpretation, and it suggests new pathways toward ultra-efficient computation, precision sensing, and energy management within known thermodynamic limits. More broadly, this work supports the view that information is not merely a bookkeeping device for observers, but a fundamental ingredient of physical dynamics—one that can be quantified, manipulated, and transformed into free energy under well-defined physical rules.
I dispute the conventional claim that the second law of thermodynamics is saved from a “Maxwell’s demon” by the entropy cost of information erasure and show that instead it is measurement that incurs the entropy cost. Thus, Brillouin, who identified measurement as savior of the second law, was essentially correct, and putative refutations of his view, such as Bennett’s claim to measure without entropy cost, are seen to fail when the applicable physics is taken into account. I argue that the tradition of attributing the defeat of Maxwell’s demon to erasure rather than to measurement arose from unphysical classical idealizations that do not hold for real gas molecules, as well as a physically ungrounded recasting of physical thermodynamical processes into computational and information-theoretic conceptualizations. I argue that the fundamental principle that saves the second law is the quantum uncertainty principle applying to the need to localize physical states to precise values of observables in order to effect the desired disequilibria aimed at violating the second law. I obtain the specific entropy cost for localizing a molecule in the Szilard engine and show that it coincides with the quantity attributed to Landauer’s principle. I also note that an experiment characterized as upholding an entropy cost of erasure in a “quantum Maxwell’s demon” actually demonstrates an entropy cost of measurement.
Quantum measurements are an essential ingredient in numerous protocols and quantum technologies.As a characteristic trait, quantum measurements are typically employed a vast number of times to allow for higher accuracy, better control or just increased performance of quantum devices.In this thesis, we pursue a resource-theoretic approach to quantum measurements, aiming at the quantification of their energetic cost.While there exists a plethora of literature on this topic already, we develop a general framework that allows us to unify several of these previous results and to improve them systematically.We highlight an issue common to most of these previous works, where a notion of quantum measurement is employed which is not detailed enough to be applicable to several realistic and important applications for quantum measurement.More concretely, previous work typically involves a state transformation concept, similar to thermodynamic considerations, where only a specific initial and final state of the measured system are specified to characterise the process.For real applications however, quantum measurement devices are typically required to perform the measurement for all possible initial states of the measured system.In this thesis we analyse this requirement and obtain as a consequence much stronger energy constraints on quantum measurements than previously known.For particular forms of measurement, namely dephasing channels, projective quantum instruments, and projection valued measures, we even determine the exact energy costs in contrast to the common lower bound statements in previous literature.Remarkably, the exact cost of projective quantum instruments constitutes the strongest energy constraint on quantum measurement known so far.We demonstrate the implications of these results in two important applications, where quantum measurements play a significant role, namely quantum Zeno stabilisation and quantum error correction.The exact energetic requirements we compute for these two protocols show that any restriction on the amount of available energy immediately places fundamental constraints on the performance of these protocols.
We introduce a quantum measurement process that is capable of characterizing an unknown state of a system almost without disturbing or collapsing it. The underlying idea is to extract information of a system from the thermodynamic quantities like work(s) and heat in a process, thereby uncovering a fundamental correspondence between information and thermodynamics. We establish an improved notion of information isolation and show that a process is isolated if it respects the first law of quantum thermodynamics for a given set of conserved quantities or charges. The measurement process involves a global unitary evolution of the system, an apparatus, and a battery which supplies work(s). The global unitary respects the first law. The full information about the system is accessed by counting the charge-wise work costs to implement the reduced evolution on the system and the apparatus. After the work costs are determined, the process is undone where a state of the system is retrieved arbitrarily close to the original initial state. The measurement process is also capable of characterizing an unknown quantum operation. Fundamentally, our findings make an important step towards resolving the paradoxes arising from the quantum measurement problem, such as the Wigner's friend paradox, and the issue related to the objective reality of quantum states. We discuss the technological implications of the almost collapse-free measurement process.