Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1204.3548 · Applied Physics Letters

A hybrid superconductor-normal metal electron trap as a photon detector

S. V. Lotkhov, Alexander B Zorin

Published Jun 11, 2012• 9 citations
arXivHTMLPDF

Abstract

A single-electron trap built with two superconductor-insulator-normal metal tunnel junctions and coupled to a readout SINIS-type single-electron transistor A (SET A) was studied in a photon detection regime. As a source of photon irradiation, we used an operating second SINIS-type SET B positioned in the vicinity of the trap. In the experiment, the average hold time of the trap was found to be critically dependent on the voltage across SET B. Starting in a certain voltage range, a photon-assisted electron escape was observed at a rate roughly proportional to the emission rate of the photons with energies exceeding the superconducting gap of S-electrodes in the trap. The discussed mechanism of photon emission and detection is of interest for low-temperature noise spectrometry, and it can be of relevance for the ampere standard based on hybrid SINIS turnstiles.

DOI
10.1063/1.4729417

Related papers

Nonlocal Superconducting Single-Photon Detector

Federico Paolucci

We present and theoretically analyze the performance of a nonlocal superconducting single-photon detector. The device operates due to the energy-to-phase conversion mechanism, where the energy of the absorbed single photon is transformed in a variation of the superconducting phase. Within this scope, the detector is designed in the form of a double-loop superconductor--normal-metal--superconductor ($S$-$N$-$S$) Josephson interferometer, where the detection occurs in a long $S$-$N$-$S$ junction and the readout is operated by a short $S$-$N$-$S$ junction. The variation of the superconducting phase across the readout junction is measured by recording the quasiparticle current flowing through a tunnel-coupled superconducting probe. By exploiting realistic geometry and materials, the detector is able to reveal single photons of frequency down to 10 GHz when operated at 10 mK. Furthermore, the device provides a value of the signal-to-noise ratio of up ${10}^{4}$ in the range from 10 GHz to 10 THz by selection of the magnetic flux and the bias voltage. This device will hopefully find direct application as a single-photon detector in both basic science and quantum technology, while the energy-to-phase conversion mechanism could be the basis of nonlocal readout and memory architectures for superconducting qubits.

arXiv:2303.13928•Physical Review Applied•Jul 5, 2023•5 citations

Observation of microwave absorption and emission from incoherent electron tunneling through a normal-metal–insulator–superconductor junction

Shumpei Masuda, Kuan Yen Tan, Matti Partanen +5 more

We experimentally study nanoscale normal-metal-insulator-superconductor junctions coupled to a superconducting microwave resonator. We observe that bias-voltage-controllable single-electron tunneling through the junctions gives rise to a direct conversion between the electrostatic energy and that of microwave photons. The measured power spectral density of the microwave radiation emitted by the resonator exceeds at high bias voltages that of an equivalent single-mode radiation source at 2.5 K although the phonon and electron reservoirs are at subkelvin temperatures. Measurements of the generated power quantitatively agree with a theoretical model in a wide range of bias voltages. Thus, we have developed a microwave source which is compatible with low-temperature electronics and offers convenient in-situ electrical control of the incoherent photon emission rate with a predetermined frequency, without relying on intrinsic voltage fluctuations of heated normal-metal components or suffering from unwanted losses in room temperature cables. Importantly, our observation of negative generated power at relatively low bias voltages provides a novel type of verification of the working principles of the recently discovered quantum-circuit refrigerator.

Scientific Reports•Feb 26, 2018•21 citations

Detection of On-Chip Generated Weak Microwave Radiation Using Superconducting Normal-Metal SET

Behdad Jalali‐Jafari, S. V. Lotkhov, Alexander B Zorin

The present work addresses quantum interaction phenomena of microwave radiation with a single-electron tunneling system. For this study, an integrated circuit is implemented, combining on the same chip a Josephson junction (Al/AlO x /Al) oscillator and a single-electron transistor (SET) with the superconducting island (Al) and normal-conducting leads (AuPd). The transistor is demonstrated to operate as a very sensitive photon detector, sensing down to a few tens of photons per second in the microwave frequency range around f ∼ 100 GHz. On the other hand, the Josephson oscillator, realized as a two-junction SQUID and coupled to the detector via a coplanar transmission line (Al), is shown to provide a tunable source of microwave radiation: controllable variations in power or in frequency were accompanied by significant changes in the detector output, when applying magnetic flux or adjusting the voltage across the SQUID, respectively. It was also shown that the effect of substrate-mediated phonons, generated by our microwave source, on the detector output was negligibly small.

Applied Sciences•Jan 27, 2016•8 citations

Microwave SINIS Detectors

Michael A. Tarasov, Aleksandra A. Gunbina, Artem M. Chekushkin +3 more

This review presents the main characteristics and mechanisms of operation of superconductor–insulator–normal metal–insulator–superconductor (SINIS) microwave detectors. An analysis of the detectors’ performance against a quantum detector and a photon counter is given. Methods for cooling a superconductor using normal metal traps and the role of electron cooling in optimizing the current response to terahertz radiation are discussed. Fabrication methods using shadow evaporation as well as magnetron sputtering are described.

Applied Sciences•Oct 18, 2022•11 citations

Two-junction superconductor-normal metal single-electron trap in a combined on-chip RC environment

S. V. Lotkhov, Alexander B Zorin

Dissipative properties of the electromagnetic environment as well as on-chip RC filtering are shown to suppress random state switchings in the two-junction superconductor(S) - normal metal(N) electron trap. In our experiments, a local high-ohmic resistor increased the hold time of the trap by up to two orders of magnitude. A strong effect of on-chip noise filtering was observed for different on-chip geometries. The obtained results are promising for realization of the current standard on the basis of the S-N hybrid turnstile.

arXiv:1106.6005•Journal of Physics Conference Series•Dec 17, 2012•3 citations

Photon-activated electron hopping in a single-electron trap enhanced by Josephson radiation

S. V. Lotkhov, Behdad Jalali‐Jafari, Alexander B Zorin

Using a Josephson junction interferometer (DC SQUID) as a microwave source for irradiating a single-electron trap, both devices fabricated on the same chip, we study the process of photon-assisted tunneling as an effective mechanism of single photon detection. High sensitivity down to a very small oscillation amplitude vJ∼10 nV≪Eact≲hfJ and down to low photon absorption rates Γph ∼ (1–50) Hz, as well as a clear threshold type of operation with an activation energy Eact ∼ 400 μeV, is demonstrated for the trap with respect to the microwave photons of frequency fJ ∼ (100–200) GHz. Tunable generation is demonstrated with respect to the power and frequency of the microwave signal produced by the SQUID source biased within the subgap voltage range. A much weaker effect is observed at the higher junction voltages along the quasiparticle branch of the I–V curve; this response mostly appears due to the recombination phonons.

arXiv:1602.02303•Applied Physics Letters•Apr 25, 2016•3 citations
A single-electron trap built with two superconductor-insulator-normal metal tunnel junctions and coupled to a readout SINIS-type single-electron transistor A (SET A) was studied in a photon detection regime. As a source of photon irradiation, we used an operating second SINIS-type SET B positioned in the vicinity of the trap. In the experiment, the average hold time of the trap was found to be critically dependent on the voltage across SET B. Starting in a certain voltage range, a photon-assisted electron escape was observed at a rate roughly proportional to the emission rate of the photons with energies exceeding the superconducting gap of S-electrodes in the trap. The discussed mechanism of photon emission and detection is of interest for low-temperature noise spectrometry, and it can be of relevance for the ampere standard based on hybrid SINIS turnstiles.
We present and theoretically analyze the performance of a nonlocal superconducting single-photon detector. The device operates due to the energy-to-phase conversion mechanism, where the energy of the absorbed single photon is transformed in a variation of the superconducting phase. Within this scope, the detector is designed in the form of a double-loop superconductor--normal-metal--superconductor (SSS-NNN-SSS) Josephson interferometer, where the detection occurs in a long SSS-NNN-SSS junction and the readout is operated by a short SSS-NNN-SSS junction. The variation of the superconducting phase across the readout junction is measured by recording the quasiparticle current flowing through a tunnel-coupled superconducting probe. By exploiting realistic geometry and materials, the detector is able to reveal single photons of frequency down to 10 GHz when operated at 10 mK. Furthermore, the device provides a value of the signal-to-noise ratio of up 104{10}^{4}104 in the range from 10 GHz to 10 THz by selection of the magnetic flux and the bias voltage. This device will hopefully find direct application as a single-photon detector in both basic science and quantum technology, while the energy-to-phase conversion mechanism could be the basis of nonlocal readout and memory architectures for superconducting qubits.
We experimentally study nanoscale normal-metal-insulator-superconductor junctions coupled to a superconducting microwave resonator. We observe that bias-voltage-controllable single-electron tunneling through the junctions gives rise to a direct conversion between the electrostatic energy and that of microwave photons. The measured power spectral density of the microwave radiation emitted by the resonator exceeds at high bias voltages that of an equivalent single-mode radiation source at 2.5 K although the phonon and electron reservoirs are at subkelvin temperatures. Measurements of the generated power quantitatively agree with a theoretical model in a wide range of bias voltages. Thus, we have developed a microwave source which is compatible with low-temperature electronics and offers convenient in-situ electrical control of the incoherent photon emission rate with a predetermined frequency, without relying on intrinsic voltage fluctuations of heated normal-metal components or suffering from unwanted losses in room temperature cables. Importantly, our observation of negative generated power at relatively low bias voltages provides a novel type of verification of the working principles of the recently discovered quantum-circuit refrigerator.
The present work addresses quantum interaction phenomena of microwave radiation with a single-electron tunneling system. For this study, an integrated circuit is implemented, combining on the same chip a Josephson junction (Al/AlO x /Al) oscillator and a single-electron transistor (SET) with the superconducting island (Al) and normal-conducting leads (AuPd). The transistor is demonstrated to operate as a very sensitive photon detector, sensing down to a few tens of photons per second in the microwave frequency range around f ∼ 100 GHz. On the other hand, the Josephson oscillator, realized as a two-junction SQUID and coupled to the detector via a coplanar transmission line (Al), is shown to provide a tunable source of microwave radiation: controllable variations in power or in frequency were accompanied by significant changes in the detector output, when applying magnetic flux or adjusting the voltage across the SQUID, respectively. It was also shown that the effect of substrate-mediated phonons, generated by our microwave source, on the detector output was negligibly small.
This review presents the main characteristics and mechanisms of operation of superconductor–insulator–normal metal–insulator–superconductor (SINIS) microwave detectors. An analysis of the detectors’ performance against a quantum detector and a photon counter is given. Methods for cooling a superconductor using normal metal traps and the role of electron cooling in optimizing the current response to terahertz radiation are discussed. Fabrication methods using shadow evaporation as well as magnetron sputtering are described.
Dissipative properties of the electromagnetic environment as well as on-chip RC filtering are shown to suppress random state switchings in the two-junction superconductor(S) - normal metal(N) electron trap. In our experiments, a local high-ohmic resistor increased the hold time of the trap by up to two orders of magnitude. A strong effect of on-chip noise filtering was observed for different on-chip geometries. The obtained results are promising for realization of the current standard on the basis of the S-N hybrid turnstile.
Using a Josephson junction interferometer (DC SQUID) as a microwave source for irradiating a single-electron trap, both devices fabricated on the same chip, we study the process of photon-assisted tunneling as an effective mechanism of single photon detection. High sensitivity down to a very small oscillation amplitude vJ∼10 nV≪Eact≲hfJ and down to low photon absorption rates Γph ∼ (1–50) Hz, as well as a clear threshold type of operation with an activation energy Eact ∼ 400 μeV, is demonstrated for the trap with respect to the microwave photons of frequency fJ ∼ (100–200) GHz. Tunable generation is demonstrated with respect to the power and frequency of the microwave signal produced by the SQUID source biased within the subgap voltage range. A much weaker effect is observed at the higher junction voltages along the quasiparticle branch of the I–V curve; this response mostly appears due to the recombination phonons.