Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1203.4442

Superconducting Resonators with Parasitic Electromagnetic Environments

J. M. Hornibrook, E.E. Mitchell, D. J. Reilly

Published Mar 20, 2012• 7 citations
arXivHTMLPDF

Abstract

Parasitic electromagnetic fields are shown to strongly suppress the quality (Q)-factor of superconducting coplanar waveguide resonators via non-local dissipation in the macroscopic environment. Numerical simulation and low temperature measurements demonstrate how this parasitic loss can be reduced, establishing a Lorentzian lineshape in the resonator frequency response and yielding a loaded Q-factor of 2.4 x 10^5 for niobium devices on sapphire substrates. In addition, we report the dependence of the Q and resonance frequency shift Delta f_0 with input power and temperature in the limit where loss from two-level systems in the dielectric dominate.

DOI
10.48550/arxiv.1203.4442

Related papers

Parasitic Losses in Nb Superconducting Resonators

J. M. Hornibrook, E.E. Mitchell, Chris Lewis +1 more

Microwave losses in niobium (Nb) superconducting resonators are investigated at milli-Kelvin temperatures and with low drive power. In addition to the well-known suppression in Q-factor that arises from coupling between the resonator and two-level defects in the dielectric substrate, we report strong dependence of the measured Q-factor and resonance line-shape on the electromagnetic environment. Methods to suppress parasitic coupling between the resonator and its environment are discussed.

Physics Procedia•Jan 1, 2012•4 citations

Suppressing Dissipative Paths in Superconducting Coplanar Waveguide Resonators

J. M. Hornibrook, E.E. Mitchell, D. J. Reilly

The electromagnetic environment can have a significant effect on the resonant line-shape and loadedQ-factor of superconducting coplanar waveguides in the low temperature (<; 100 mK) and low microwave power regime. Here, electromagnetic simulations are used to visualize the electric field strength throughout the resonator environment, highlighting situations in which parasitic modes lead to increased dissipation. Methods used to suppress parasitic coupling include increasing the density of wire bonds and vias, reducing the width of the transmission line (whilst maintaining the characteristic impedance at 50 Ω) and establishing strong grounding to the sample enclosure. The effect of reducing the parasitic coupling on the microwave transmission spectrum is reported.

IEEE Transactions on Applied Superconductivity•Apr 5, 2013•7 citations

Characterizing Niobium Nitride-Based Superconducting Coplanar Waveguide Resonators for Microwave Hybrid Circuit Quantum Electrodynamics

Paniz Foshat, Paul Baity, Sergey Danilin +8 more

The high critical magnetic field and relatively high critical temperature of niobium nitride (NbN) make it a promising material for applications in superconducting quantum technology. However, NbN-based superconducting circuits are sensitive to decoherence sources such as two-level system (TLS) defects. Here, we numerically and experimentally investigate NbN superconducting microwave coplanar waveguide resonator arrays with a 100 nm thickness, capacitively coupled to a common coplanar waveguide on a silicon chip. We observe that the resonators' internal quality factor ($Q_{i}$) decreases from$Q_{i}\sim 1.07\times 10^{6}$in a high power regime to$Q_{i}\sim 1.36\times 10^{5}$in the single photon regime. Data from this study is consistent with the TLS theory, which describes the TLS interactions in resonator substrates and interfaces. Moreover, we study the temperature ($T$) dependence of$Q_{i}$and resonance frequency$f_{r}$of coplanar waveguide resonators to characterize the quasiparticle density. We observe that the increase in kinetic inductance at higher temperatures is the main reason for the frequency shift. Finally, we measure$f_{r}$and$Q_{i}$in response to in-plane magnetic fields ($B_{||}$). We verify that$Q_{i}$stays well above$10^{4}$up to$B_{||}$= 240 mT in the photon number$< \! n_{ph} \! >$= 1.8 at$T$= 100 mK. Our results could enable the development of robust microwave superconducting circuits for circuit quantum electrodynamics at high magnetic fields required for hybrid superconducting-semiconducting quantum circuits.

arXiv:2306.02356•IEEE Transactions on Applied Superconductivity•Jan 22, 2025•18 citations

Study of loss in superconducting coplanar waveguide resonators

Jeremy Sage, Vladimir Bolkhovsky, William D. Oliver +2 more

Superconducting coplanar waveguide (SCPW) resonators have a wide range of applications due to the combination of their planar geometry and high quality factors relative to normal metals. However, their performance is sensitive to both the details of their geometry and the materials and processes that are used in their fabrication. In this paper, we study the dependence of SCPW resonator performance on materials and geometry as a function of temperature and excitation power. We measure quality factors greater than 2 × 106 at high excitation power and 6 × 105 at a power comparable to that generated by a single microwave photon circulating in the resonator. We examine the limits to the high excitation power performance of the resonators and find it to be consistent with a model of radiation loss. We further observe that while in all cases the quality factors are degraded as the temperature and power are reduced due to dielectric loss, the size of this effect is dependent on resonator materials and geometry. Finally, we demonstrate that the dielectric loss can be controlled in principle using a separate excitation near the resonance frequencies of the resonator.

arXiv:1010.6063•Journal of Applied Physics•Mar 15, 2011•221 citations

Effects of device geometry and material properties on dielectric losses in superconducting coplanar-waveguide resonators

Valtteri Lahtinen, Mikko Möttönen

Superconducting coplanar-waveguide (CPW) resonators are one of the key devices in circuit quantum electrodynamics (cQED). Their performance can be limited by dielectric losses in the substrate and in the material interfaces. Reliable modeling is required to aid in the design of low-loss CPW structures for cQED. We analyze the geometric dependence of the dielectric losses in CPW structures using finite-element modeling of the participation ratios of the lossy regions. In a practical scenario, uncertainties in the the dielectric constants and loss tangents of these regions introduce uncertainties in the theoretically predicted participation ratios. We present a method for combining loss simulations with measurements of two-level-system-limited quality factors and resonance frequencies of CPW resonators. Namely, we solve an inverse problem to find model parameters producing the measured values. High quality factors are obtainable by properly designing the cross-sectional geometries of the CPW structures, but more accurate modeling and design methods for low-loss CPW resonators are called for major future improvements. Our nonlinear optimization methodology for solving the aforementioned inverse problem is a step in this direction.

arXiv:2002.12801•Journal of Physics Condensed Matter•Jun 2, 2020•19 citations

Experiments to develop High Q and tunable superconducting coplanar resonators applicable for quantum bit technology

J E Healey

Measurements are made on superconducting Niobium on Sapphire and oxidized Silicon microwave coplanar resonators for quantum bit experiments. Device geometry and materials are investigated and quality factors in excess of a million have been observed. The resonant frequency as a function of temperature of a coplanar resonator is characterised in terms of the change in the number density of superconducting electrons. At lower temperatures, the resonant frequency no longer follows this function, and evidence is shown that this is associated with the resonant coupling of the resonant frequency with two level systems in the substrate. At T<2.2 K the resonant frequency scales logarithmically with the temperature, indicating that two level systems distributed in the volume of the Silicon Dioxide affect the electric permittivity. Applying higher input microwave power levels is shown to saturate these two level systems, essentially decoupling them from the CPR resonance. This is observed as an increase in resonant frequency and Q factor. The resonant frequency is also shown to have a high sensitivity to a magnetic field applied perpendicular to the plane of the coplanar resonator, with a quadratic dependence for the fundamental, second and third harmonics. Frequency shift of hundreds of linewidths are obtained. Coplanar resonator are fabricated and measured with current control lines built on chip, and these have shown to produce frequency shifts of tens of Kilohertz.

•Dec 16, 2010•1 citation
Parasitic electromagnetic fields are shown to strongly suppress the quality (Q)-factor of superconducting coplanar waveguide resonators via non-local dissipation in the macroscopic environment. Numerical simulation and low temperature measurements demonstrate how this parasitic loss can be reduced, establishing a Lorentzian lineshape in the resonator frequency response and yielding a loaded Q-factor of 2.4 x 10^5 for niobium devices on sapphire substrates. In addition, we report the dependence of the Q and resonance frequency shift Delta f_0 with input power and temperature in the limit where loss from two-level systems in the dielectric dominate.
The electromagnetic environment can have a significant effect on the resonant line-shape and loadedQ-factor of superconducting coplanar waveguides in the low temperature (<; 100 mK) and low microwave power regime. Here, electromagnetic simulations are used to visualize the electric field strength throughout the resonator environment, highlighting situations in which parasitic modes lead to increased dissipation. Methods used to suppress parasitic coupling include increasing the density of wire bonds and vias, reducing the width of the transmission line (whilst maintaining the characteristic impedance at 50 Ω) and establishing strong grounding to the sample enclosure. The effect of reducing the parasitic coupling on the microwave transmission spectrum is reported.
The high critical magnetic field and relatively high critical temperature of niobium nitride (NbN) make it a promising material for applications in superconducting quantum technology. However, NbN-based superconducting circuits are sensitive to decoherence sources such as two-level system (TLS) defects. Here, we numerically and experimentally investigate NbN superconducting microwave coplanar waveguide resonator arrays with a 100 nm thickness, capacitively coupled to a common coplanar waveguide on a silicon chip. We observe that the resonators' internal quality factor (QiQ_{i}Qi​) decreases fromQi∼1.07×106Q_{i}\sim 1.07\times 10^{6}Qi​∼1.07×106in a high power regime toQi∼1.36×105Q_{i}\sim 1.36\times 10^{5}Qi​∼1.36×105in the single photon regime. Data from this study is consistent with the TLS theory, which describes the TLS interactions in resonator substrates and interfaces. Moreover, we study the temperature (TTT) dependence ofQiQ_{i}Qi​and resonance frequencyfrf_{r}fr​of coplanar waveguide resonators to characterize the quasiparticle density. We observe that the increase in kinetic inductance at higher temperatures is the main reason for the frequency shift. Finally, we measurefrf_{r}fr​andQiQ_{i}Qi​in response to in-plane magnetic fields (B∣∣B_{||}B∣∣​). We verify thatQiQ_{i}Qi​stays well above10410^{4}104up toB∣∣B_{||}B∣∣​= 240 mT in the photon number< ⁣nph ⁣>< \! n_{ph} \! ><nph​>= 1.8 atTTT= 100 mK. Our results could enable the development of robust microwave superconducting circuits for circuit quantum electrodynamics at high magnetic fields required for hybrid superconducting-semiconducting quantum circuits.
Superconducting coplanar waveguide (SCPW) resonators have a wide range of applications due to the combination of their planar geometry and high quality factors relative to normal metals. However, their performance is sensitive to both the details of their geometry and the materials and processes that are used in their fabrication. In this paper, we study the dependence of SCPW resonator performance on materials and geometry as a function of temperature and excitation power. We measure quality factors greater than 2 × 106 at high excitation power and 6 × 105 at a power comparable to that generated by a single microwave photon circulating in the resonator. We examine the limits to the high excitation power performance of the resonators and find it to be consistent with a model of radiation loss. We further observe that while in all cases the quality factors are degraded as the temperature and power are reduced due to dielectric loss, the size of this effect is dependent on resonator materials and geometry. Finally, we demonstrate that the dielectric loss can be controlled in principle using a separate excitation near the resonance frequencies of the resonator.
Superconducting coplanar-waveguide (CPW) resonators are one of the key devices in circuit quantum electrodynamics (cQED). Their performance can be limited by dielectric losses in the substrate and in the material interfaces. Reliable modeling is required to aid in the design of low-loss CPW structures for cQED. We analyze the geometric dependence of the dielectric losses in CPW structures using finite-element modeling of the participation ratios of the lossy regions. In a practical scenario, uncertainties in the the dielectric constants and loss tangents of these regions introduce uncertainties in the theoretically predicted participation ratios. We present a method for combining loss simulations with measurements of two-level-system-limited quality factors and resonance frequencies of CPW resonators. Namely, we solve an inverse problem to find model parameters producing the measured values. High quality factors are obtainable by properly designing the cross-sectional geometries of the CPW structures, but more accurate modeling and design methods for low-loss CPW resonators are called for major future improvements. Our nonlinear optimization methodology for solving the aforementioned inverse problem is a step in this direction.
Measurements are made on superconducting Niobium on Sapphire and oxidized Silicon microwave coplanar resonators for quantum bit experiments. Device geometry and materials are investigated and quality factors in excess of a million have been observed. The resonant frequency as a function of temperature of a coplanar resonator is characterised in terms of the change in the number density of superconducting electrons. At lower temperatures, the resonant frequency no longer follows this function, and evidence is shown that this is associated with the resonant coupling of the resonant frequency with two level systems in the substrate. At T<2.2 K the resonant frequency scales logarithmically with the temperature, indicating that two level systems distributed in the volume of the Silicon Dioxide affect the electric permittivity. Applying higher input microwave power levels is shown to saturate these two level systems, essentially decoupling them from the CPR resonance. This is observed as an increase in resonant frequency and Q factor. The resonant frequency is also shown to have a high sensitivity to a magnetic field applied perpendicular to the plane of the coplanar resonator, with a quadratic dependence for the fundamental, second and third harmonics. Frequency shift of hundreds of linewidths are obtained. Coplanar resonator are fabricated and measured with current control lines built on chip, and these have shown to produce frequency shifts of tens of Kilohertz.