Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1201.2392 · Nature Physics

A wideband, low-noise superconducting amplifier with high dynamic range

Byeong Ho Eom, Peter K. Day, Henry George LeDuc, Jonas Stasys Zmuidzinas

Published Jul 8, 2012• 441 citations
arXivHTMLPDF
DOI
10.1038/nphys2356

Related papers

A Wideband Superconducting Parametric Amplifier for Microwave Frequencies

Peter K. Day

NASA APRA Proposal•Jan 1, 2011•0 citations

A wideband cryogenic microwave low-noise amplifier

Boris I Ivanov, Dmitry I. Volkhin, Ilya L. Novikov +5 more

A broadband low-noise four-stage high-electron-mobility transistor amplifier was designed and characterized in a cryogen-free dilution refrigerator at the 3.8 K temperature stage. The obtained power dissipation of the amplifier is below 20 mW. In the frequency range from 6 to 12 GHz its gain exceeds 30 dB. The equivalent noise temperature of the amplifier is below 6 K for the presented frequency range. The amplifier is applicable for any type of cryogenic microwave measurements. As an example we demonstrate here the characterization of the superconducting X-mon qubit coupled to an on-chip coplanar waveguide resonator.

Beilstein Journal of Nanotechnology•Sep 30, 2020•8 citations

A Superconducting Amplifier

Science•Feb 13, 2003•0 citations

Wideband SQUID Amplifiers for Axion Search Experiments

Andrei N. Matlashov, Yannis Kyriakos Semertzidis

The microwave cavity experiment for the dark matter axion search is based on the theoretical prediction that axions could convert into microwave photons inside a High-Q cavity immersed in a strong magnetic field. In such experiments a weak, of order 10-22 W, quasi-monochromatic microwave signal should be detected by scanning it in a very wide frequency range. The best cryogenic semiconductor amplifiers have the lowest noise temperature plateau of about 1.0 K even at significantly lower ambient temperature. Superconducting quantum interference devices, or SQUIDs, can work as microwave amplifiers with temperature noise close to the standard quantum limit that is about 50 mK at 1 GHz [1]. Previously designed SQUID-based high frequency amplifiers have narrow bandwidth due to a microstrip resonant input coil. It requires serial replacements of SQUID preamplifiers in order to scan wide frequency range. This procedure is complex and time consuming because of a large mass of hardware should be cooled down below 100 mK. For suitable amplification at high frequency a SQUID should be designed with the smallest possible Josephson junction capacitance, reasonably low SQUID loop inductance, and maximal steepness of the transfer function. Sub-micron size cross-type Josephson junctions have a very low capacitance of about 0.04 pF that is one order smaller than a capacitance of Josephson junctions fabricated using conventional window-type technology. Such junctions initially were designed and used at IPHT for low-frequency SQUID current sensors [2]. Slightly modified current sensors were tested as amplifiers at frequency range 0.5 – 5 GHz. They showed high gain and both wideband and resonant performance. In this paper we describe wideband SQUID microwave amplifiers fabricated at IPHT using sub-micron size Josephson junctions with very low capacitance.

International Conference on High Energy Physics (ICHEP)•Aug 2, 2019•0 citations

Characterization of Low Noise Superconducting Microwave Amplifiers

Ted White, R. Barends, Joerg Bochmann +16 more

Bulletin of the American Physical Society•Feb 29, 2012•0 citations

Cryogenic Low Noise Amplifiers and Filters for Superconducting Qubit Readout

Boris I. Ivanov, Dmitry I. Volkhin, Ilya L. Novikov +1 more

We show an experimental study of superconducting X-mon qubit based on low noise wideband measurement setup. The setup includes wide stop-band low frequency filters with a stopband frequency up to 13 GHz, the broadband low-noise cryogenic microwave amplifier (cLNA) operating at 3.8 K. The obtained power dissipation of the cLNA is below 20 mW, the frequency operating ranges from 6 GHz to 12 GHz with a gain of 30 dB. The equivalent noise temperature of the amplifier is bellow 6 K for the presented frequency range. We demonstrate here the characterization of the superconducting X-mon qubit coupled to an on-chip coplanar waveguide resonator. We show standard qubit experiments: one and two-tones qubit spectroscopy, ac-Stark shift experiments for probing and excitation power sweeps.

International Conference of Young Specialists on Micro/Nanotechnologies and Electron Devices•Jun 1, 2020•1 citation
A broadband low-noise four-stage high-electron-mobility transistor amplifier was designed and characterized in a cryogen-free dilution refrigerator at the 3.8 K temperature stage. The obtained power dissipation of the amplifier is below 20 mW. In the frequency range from 6 to 12 GHz its gain exceeds 30 dB. The equivalent noise temperature of the amplifier is below 6 K for the presented frequency range. The amplifier is applicable for any type of cryogenic microwave measurements. As an example we demonstrate here the characterization of the superconducting X-mon qubit coupled to an on-chip coplanar waveguide resonator.
The microwave cavity experiment for the dark matter axion search is based on the theoretical prediction that axions could convert into microwave photons inside a High-Q cavity immersed in a strong magnetic field. In such experiments a weak, of order 10-22 W, quasi-monochromatic microwave signal should be detected by scanning it in a very wide frequency range. The best cryogenic semiconductor amplifiers have the lowest noise temperature plateau of about 1.0 K even at significantly lower ambient temperature. Superconducting quantum interference devices, or SQUIDs, can work as microwave amplifiers with temperature noise close to the standard quantum limit that is about 50 mK at 1 GHz [1]. Previously designed SQUID-based high frequency amplifiers have narrow bandwidth due to a microstrip resonant input coil. It requires serial replacements of SQUID preamplifiers in order to scan wide frequency range. This procedure is complex and time consuming because of a large mass of hardware should be cooled down below 100 mK. For suitable amplification at high frequency a SQUID should be designed with the smallest possible Josephson junction capacitance, reasonably low SQUID loop inductance, and maximal steepness of the transfer function. Sub-micron size cross-type Josephson junctions have a very low capacitance of about 0.04 pF that is one order smaller than a capacitance of Josephson junctions fabricated using conventional window-type technology. Such junctions initially were designed and used at IPHT for low-frequency SQUID current sensors [2]. Slightly modified current sensors were tested as amplifiers at frequency range 0.5 – 5 GHz. They showed high gain and both wideband and resonant performance. In this paper we describe wideband SQUID microwave amplifiers fabricated at IPHT using sub-micron size Josephson junctions with very low capacitance.
We show an experimental study of superconducting X-mon qubit based on low noise wideband measurement setup. The setup includes wide stop-band low frequency filters with a stopband frequency up to 13 GHz, the broadband low-noise cryogenic microwave amplifier (cLNA) operating at 3.8 K. The obtained power dissipation of the cLNA is below 20 mW, the frequency operating ranges from 6 GHz to 12 GHz with a gain of 30 dB. The equivalent noise temperature of the amplifier is bellow 6 K for the presented frequency range. We demonstrate here the characterization of the superconducting X-mon qubit coupled to an on-chip coplanar waveguide resonator. We show standard qubit experiments: one and two-tones qubit spectroscopy, ac-Stark shift experiments for probing and excitation power sweeps.