Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1009.1746 · Applied Physics Letters

An in situ tunable radio-frequency quantum point contact

T. Müller, Bruno Küng, S. Hellmüller, P. Studerus, K. Ensslin, Thomas Ihn, M. Reinwald, W. Wegscheider

Published Nov 15, 2010• 26 citations
arXivHTMLPDF

Abstract

Incorporating a variable capacitance diode into a radio-frequency (rf) matching circuit allows us to in situ tune the resonance frequency of a rf quantum point contact, increasing the versatility of the latter as a fast charge sensor of a proximal quantum circuit. The performance of this method is compared in detail to conventional low-frequency charge detection. The approach is also applicable to other rf-detection schemes, such as rf single electron transistor circuits.

DOI
10.1063/1.3517483

Related papers

A circuit analysis of an in situ tunable radio-frequency quantum point contact

T. Müller, T. Choi, S. Hellmüller +3 more

A detailed analysis of the tunability of a radio-frequency quantum point contact setup using a C - LCR circuit is presented. We calculate how the series capacitance influences resonance frequency and charge-detector resistance for which matching is achieved as well as the voltage and power delivered to the load. Furthermore, we compute the noise contributions in the system and compare our findings with measurements taken with an etched quantum point contact. While our considerations mostly focus on our specific choice of matching circuit, the discussion of the influence of source-to-load power transfer on the signal-to-noise ratio is valid generally.

arXiv:1303.0507•Review of Scientific Instruments•Aug 1, 2013•11 citations

Fast single-charge sensing with a rf quantum point contact

D. J. Reilly, Charles M. Marcus, Micah P. Hanson +1 more

We report high-bandwidth charge sensing measurements using a GaAs quantum point contact embedded in a radio frequency impedance matching circuit (rf-QPC). With the rf-QPC biased near pinch-off where it is most sensitive to charge, we demonstrate a conductance sensitivity of 5×10−6e2∕hHz−1∕2 with a bandwidth of 8MHz. Single-shot readout of a proximal few-electron double quantum dot is investigated in a mode where the rf-QPC back action is rapidly switched.

arXiv:0707.2946•Applied Physics Letters•Oct 15, 2007•299 citations

Single shot charge detection using a radio-frequency quantum point contact

Maja C. Cassidy, Andrew S. Dzurak, R. G. Clark +4 more

We report on charge sensing measurements of a GaAs semiconductor quantum dot device using a radio frequency quantum point contact (rf-QPC). The rf-QPC is fully characterized at 4K and millikelvin temperatures and found to have a bandwidth exceeding 20MHz. For single shot charge sensing, we achieve a charge sensitivity of ∼2×10−4e∕Hz referred to the neighboring dot’s charge. The rf-QPC compares favorably with rf single electron transistor electrometers and promises to be an extremely useful tool for characterizing and measuring semiconductor quantum systems on fast time scales.

arXiv:0907.1010•Applied Physics Letters•Nov 26, 2007•89 citations

Radio-frequency point-contact electrometer

Hua Qin, David A. Williams

We fabricate and characterize a radio-frequency semiconductor point-contact (rf-PC) electrometer analogous to radio-frequency single-electron transistors (rf-SETs) [see Schoelkopf et al., Science 280, 1238 (1998)]. The point contact is formed by surface Schottky gates in a two-dimensional electron gas in an AlGaAs∕GaAs heterostructure. In the present setup, the PC is operating as a simple voltage-controlled resistor rather than a quantum point contact and demonstrates a charge sensitivity of about 2×10−1e∕Hz at a bandwidth of 30kHz without the use of a cryogenic rf preamplifier. Since the impedance of a typical point-contact device is much lower than the impedance of the typical SET, a semiconductor-based rf-PC, equipped with practical cryogenic rf preamplifiers, could realize an ultrafast and ultrasensitive electrometer.

arXiv:0708.2473•Applied Physics Letters•May 15, 2006•28 citations

Low-temperature tunable radio-frequency resonator for sensitive dispersive readout of nanoelectronic devices

David J. Ibberson, Lisa A. Ibberson, Geoff Smithson +3 more

We present a sensitive, tunable radio-frequency resonator designed to detect reactive changes in nanoelectronic devices down to dilution refrigerator temperatures. The resonator incorporates GaAs varicap diodes to allow electrical tuning of the resonant frequency and the coupling to the input line. We find a resonant frequency tuning range of 8.4 MHz at 55 mK that increases to 29 MHz at 1.5 K. To assess the impact on performance of different tuning conditions, we connect a quantum dot in a silicon nanowire field-effect transistor to the resonator and measure changes in the device capacitance caused by cyclic electron tunneling. At 250 mK, we obtain an equivalent charge sensitivity of 43 μe/Hz when the resonator and the line are impedance-matched and show that this sensitivity can be further improved to 31 μe/Hz by re-tuning the resonator. We understand this improvement by using an equivalent circuit model and demonstrate that for maximum sensitivity to capacitance changes, in addition to impedance matching, a high-quality resonator with low parasitic capacitance is desired.

arXiv:1807.07842•Applied Physics Letters•Mar 25, 2019•15 citations

Fast sensing of double-dot charge arrangement and spin state with a radio-frequency sensor quantum dot

Christian Barthel, Morten Kjærgaard, James Medford +4 more

Single-shot measurement of the charge arrangement and spin state of a double quantum dot are reported with measurement times down to 100 ns. Sensing uses radio-frequency reflectometry of a proximal quantum dot in the Coulomb blockade regime. The sensor quantum dot is up to 30 times more sensitive than a comparable quantum point-contact sensor and yields three times greater signal to noise in rf single-shot measurements. Numerical modeling is qualitatively consistent with experiment and shows that the improved sensitivity of the sensor quantum dot results from reduced lifetime broadening and screening.

arXiv:1001.3585•Physical Review B•Apr 19, 2010•194 citations
Incorporating a variable capacitance diode into a radio-frequency (rf) matching circuit allows us to in situ tune the resonance frequency of a rf quantum point contact, increasing the versatility of the latter as a fast charge sensor of a proximal quantum circuit. The performance of this method is compared in detail to conventional low-frequency charge detection. The approach is also applicable to other rf-detection schemes, such as rf single electron transistor circuits.
A detailed analysis of the tunability of a radio-frequency quantum point contact setup using a C - LCR circuit is presented. We calculate how the series capacitance influences resonance frequency and charge-detector resistance for which matching is achieved as well as the voltage and power delivered to the load. Furthermore, we compute the noise contributions in the system and compare our findings with measurements taken with an etched quantum point contact. While our considerations mostly focus on our specific choice of matching circuit, the discussion of the influence of source-to-load power transfer on the signal-to-noise ratio is valid generally.
We report on charge sensing measurements of a GaAs semiconductor quantum dot device using a radio frequency quantum point contact (rf-QPC). The rf-QPC is fully characterized at 4K and millikelvin temperatures and found to have a bandwidth exceeding 20MHz. For single shot charge sensing, we achieve a charge sensitivity of ∼2×10−4e∕Hz referred to the neighboring dot’s charge. The rf-QPC compares favorably with rf single electron transistor electrometers and promises to be an extremely useful tool for characterizing and measuring semiconductor quantum systems on fast time scales.
We fabricate and characterize a radio-frequency semiconductor point-contact (rf-PC) electrometer analogous to radio-frequency single-electron transistors (rf-SETs) [see Schoelkopf et al., Science 280, 1238 (1998)]. The point contact is formed by surface Schottky gates in a two-dimensional electron gas in an AlGaAs∕GaAs heterostructure. In the present setup, the PC is operating as a simple voltage-controlled resistor rather than a quantum point contact and demonstrates a charge sensitivity of about 2×10−1e∕Hz at a bandwidth of 30kHz without the use of a cryogenic rf preamplifier. Since the impedance of a typical point-contact device is much lower than the impedance of the typical SET, a semiconductor-based rf-PC, equipped with practical cryogenic rf preamplifiers, could realize an ultrafast and ultrasensitive electrometer.
We present a sensitive, tunable radio-frequency resonator designed to detect reactive changes in nanoelectronic devices down to dilution refrigerator temperatures. The resonator incorporates GaAs varicap diodes to allow electrical tuning of the resonant frequency and the coupling to the input line. We find a resonant frequency tuning range of 8.4 MHz at 55 mK that increases to 29 MHz at 1.5 K. To assess the impact on performance of different tuning conditions, we connect a quantum dot in a silicon nanowire field-effect transistor to the resonator and measure changes in the device capacitance caused by cyclic electron tunneling. At 250 mK, we obtain an equivalent charge sensitivity of 43 μe/Hz when the resonator and the line are impedance-matched and show that this sensitivity can be further improved to 31 μe/Hz by re-tuning the resonator. We understand this improvement by using an equivalent circuit model and demonstrate that for maximum sensitivity to capacitance changes, in addition to impedance matching, a high-quality resonator with low parasitic capacitance is desired.
Single-shot measurement of the charge arrangement and spin state of a double quantum dot are reported with measurement times down to 100 ns. Sensing uses radio-frequency reflectometry of a proximal quantum dot in the Coulomb blockade regime. The sensor quantum dot is up to 30 times more sensitive than a comparable quantum point-contact sensor and yields three times greater signal to noise in rf single-shot measurements. Numerical modeling is qualitatively consistent with experiment and shows that the improved sensitivity of the sensor quantum dot results from reduced lifetime broadening and screening.