Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0904.1779

Slow light of a frequency modulated Gaussian pulse in cesium vapor

Wenzhuo Tang, Bin Luo, Yu Liu, Hong Mei Guo

Published Apr 11, 2009• 0 citations
arXivHTMLPDF

Related papers

Modulation of a double-line frequency up-conversion process in cesium vapor

Baodong Gai, Rui Cao, Xusheng Xia +7 more

Applied Physics B•May 28, 2016•19 citations

Optical delay with spectral hole burning in Doppler-broadened cesium vapor

Monte D. Anderson, Glen P. Perram

Optics Communications•Apr 9, 2012•6 citations

Slow Light of an Amplitude-Modulated Gaussian Pulse in Cesium Vapor

Wenzhuo Tang, Bin Luo, Yu Liu +1 more

Slow light of an amplitude-modulated Gaussian (AMG) pulse in cesium vapor is demonstrated and studied, since the appropriate amplitude modulation to a single pulse can enrich its spectrum and even enhance the bandwidth utilization efficiency of the slow light system. In a single- ¿ type electromagnetically induced transparency (EIT) system, the slowed AMG pulse experiences severe distortion, which is mainly owing to the frequency dependent transmission of medium. Additionally, due to its spectral distribution, the frequency dependent dispersion of the medium causes simultaneous slow and fast light for different spectral components and thus a certain dispersive distortion of the AMG pulse. Further, a post-processing method is proposed to recover the slowed (distorted) pulse, which indicates that, by introducing a linear optical system with desired gain spectrum, the optical pulse can be recovered in an ¿all-optical¿ way. Finally, we discuss the limitations of this compensation procedure in detail. Although this method is demonstrated in the cesium vapor using EIT, it is also applicable to a wide range of slow light systems.

arXiv:0901.2997•IEEE Journal of Quantum Electronics•Mar 1, 2010•1 citation

Slow Light in Atomic Vapors

Jacob B. Khurgin, R.S. Tucker

CRC Press eBooks•Oct 8, 2018•0 citations

Passive pulse train generation from a frequency modulated diode laser

J. Menders, Kyunam Choi, Eric J. Korevaar

By sweeping the frequency of a diode laser beam near the cesium resonance frequency, followed by propagation through a short length of cesium vapor, we obtained periodic peaks with peak-to-average ratios near 5 at pulse repetition rates up to a gigahertz. Light in the wings of a strong atomic absorption line of an alkali metal vapor encounters large group velocity dispersion. A frequency modulation in an off-resonance cw beam passing through the vapor consequently develops an amplitude modulation. For certain combinations of laser and vapor parameters, a sinusoidally frequency modulated beam can be made to develop peaks. We generated pulse trains in a frequency modulated single mode diode laser tuned to the cesium absorption line near 852 nm, which we observed by using a fast p-i-n photodiode and a sampling oscilloscope. The frequency of a diode laser was sinusoidally modulated with a sweep of about a gigahertz and a period of a few nansoseconds by introducing a small modulation into the laser pump current. We observed the formation of sharp peaks with a width of about one-tenth of the modulation period and a peak-to-background ratio of approximately 5.

Annual Meeting Optical Society of America•Jan 1, 1992•0 citations

Tunable Optical Delay in Doppler-Broadened Cesium Vapor

Monte D. Anderson

•Dec 1, 2010•0 citations
Slow light of an amplitude-modulated Gaussian (AMG) pulse in cesium vapor is demonstrated and studied, since the appropriate amplitude modulation to a single pulse can enrich its spectrum and even enhance the bandwidth utilization efficiency of the slow light system. In a single- ¿ type electromagnetically induced transparency (EIT) system, the slowed AMG pulse experiences severe distortion, which is mainly owing to the frequency dependent transmission of medium. Additionally, due to its spectral distribution, the frequency dependent dispersion of the medium causes simultaneous slow and fast light for different spectral components and thus a certain dispersive distortion of the AMG pulse. Further, a post-processing method is proposed to recover the slowed (distorted) pulse, which indicates that, by introducing a linear optical system with desired gain spectrum, the optical pulse can be recovered in an ¿all-optical¿ way. Finally, we discuss the limitations of this compensation procedure in detail. Although this method is demonstrated in the cesium vapor using EIT, it is also applicable to a wide range of slow light systems.
By sweeping the frequency of a diode laser beam near the cesium resonance frequency, followed by propagation through a short length of cesium vapor, we obtained periodic peaks with peak-to-average ratios near 5 at pulse repetition rates up to a gigahertz. Light in the wings of a strong atomic absorption line of an alkali metal vapor encounters large group velocity dispersion. A frequency modulation in an off-resonance cw beam passing through the vapor consequently develops an amplitude modulation. For certain combinations of laser and vapor parameters, a sinusoidally frequency modulated beam can be made to develop peaks. We generated pulse trains in a frequency modulated single mode diode laser tuned to the cesium absorption line near 852 nm, which we observed by using a fast p-i-n photodiode and a sampling oscilloscope. The frequency of a diode laser was sinusoidally modulated with a sweep of about a gigahertz and a period of a few nansoseconds by introducing a small modulation into the laser pump current. We observed the formation of sharp peaks with a width of about one-tenth of the modulation period and a peak-to-background ratio of approximately 5.