Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0709.4097 · Physical Review Letters

Current to Frequency Conversion in a Josephson Circuit

François Nguyen, Nicolas Boulant, Grégoire Ithier, Patrice Bertet, H. Pothier, D. Vion, D. Esteve

Published Nov 1, 2007• 21 citations
arXivHTMLPDF

Abstract

The voltage oscillations which occur in an ideally current-biased Josephson junction were proposed to make a current standard for metrology. We demonstrate similar oscillations in a more complex Josephson circuit derived from the Cooper pair box: the quantronium. When a constant current I is injected in the gate capacitor of this device, oscillations develop at the frequency f(B)=I/2e, with e the electron charge. We detect these oscillations through the sidebands induced at multiples of f(B) in the spectrum of a microwave signal reflected on the circuit, up to currents I exceeding 100 pA. We discuss the potential interest of this current-to-frequency conversion experiment for metrology.

DOI
10.1103/physrevlett.99.187005

Related papers

Bloch Oscillations in a Josephson Circuit

Nicolas Boulant, Grégoire Ithier, François Nguyen +5 more

Bloch oscillations predicted to occur in current-biased single Josephson junctions have eluded direct observation up to now. Here, we demonstrate similar Bloch oscillations in a slightly richer Josephson circuit, the quantronium. The quantronium is a Bloch transistor with two small junctions in series, defining an island, in parallel with a larger junction. In the ground state, the microwave impedance of the device is modulated periodically with the charge on the gate capacitor coupled to the transistor island. When a current flows across this capacitor, the impedance modulation occurs at the Bloch frequency, which yields Bloch sidebands in the spectrum of a reflected continuous microwave signal. We have measured this spectrum, and compared it to predictions based on a simple model for the circuit. We discuss the interest of this experiment for metrology and for mesoscopic physics.

arXiv:cond-mat/0605061•May 2, 2006•5 citations

BLOCH OSCILLATIONS IN A JOSEPHSON CIRCUIT

Nicolas Boulant, Grégoire Ithier, François Nguyen +5 more

Bloch oscillations predicted to occur in current-biased single Josephson junctions have eluded direct observation up to now. Here, we demonstrate similar Bloch oscillations in a slightly richer Josephson circuit, the quantronium. The quantronium is a Bloch transistor with two small junctions in series, defining an island, in parallel with a larger junction. In the ground state, the microwave impedance of the device is modulated periodically with the charge on the gate capacitor coupled to the transistor island. When a current flows across this capacitor, the impedance modulation occurs at the Bloch frequency , which yields Bloch sidebands in the spectrum of a reflected continuous microwave signal. We have measured this spectrum, and compared it to predictions based on a simple model for the circuit. We discuss the interest of this experiment for metrology and for mesoscopic physics.

•May 2, 2006•0 citations

Frequency conversion in Josephson junctions with comparable intrinsic and thermal energies

A. V. Snezhko, Yu. Ya. Divin

We have studied Josephson junctions with intrinsic energy ħIc/2e (Ic being the critical current) comparable to thermal energy kT and examined their potential for electromagnetic signal conversion. In this case, moderate thermal fluctuations are sufficient to destroy Josephson oscillations but do not entirely suppress the Josephson dynamics. We have numerically calculated the DC I–V curves, their derivatives dnV/dIn, and the DC and harmonic voltage responses Vn of such Josephson junctions to the AC currents Iωsinωt. We have found that Josephson junction with γ = 2ekT/ħIc ≥ 0.5 is a nonlinear resistance at frequencies ω below characteristic Josephson frequency ωc = 2eIcRn/ħ and all current biases I0. Frequency conversion in such junctions occurs due to the classical mechanism on the nonlinearity of the DC I–V characteristics at low signal frequencies. With increasing the signal frequencies to the characteristic Josephson frequency ωc = 2eIcRn/ħ and higher, the Josephson mechanism by frequency modulation of the Josephson current gradually replaces the classical one. The classical conversion mechanism demonstrates higher conversion efficiencies than the Josephson mechanism, although it operates within a narrower bandwidth. At zero DC bias i0 and in the range of γ-values from 0.1 to 2, we have found odd harmonics Vn emerging from low signal currents. Zero-bias values of the third harmonic V3 maximize at 0.18IcRn for JJs with γ = 0.5 and Iω = 2.5Ic. Based on these findings and high-Tc Josephson junctions, a family of low-noise square-law detectors, harmonic multipliers, and linear heterodyne receivers can be developed for emerging terahertz applications.

Journal of Applied Physics•Jul 8, 2025•0 citations

Josephson frequency conversion in the range 145–1600 GHz with Nb–Nb superconducting point contacts used as oscillator-mixer

G. Vernet, Robert Adde

The Josephson frequency conversion in the millimeter and submillimeter wave region is studied with superconducting Nb–Nb point-contact junctions at 4.2 °K, using the contact both as the local oscillator and the mixer with intermediate frequencies of 0.1, 0.3, and 9.2 GHz. The point contact is in a nonresonant structure and fed by a constant current source: neither a strong rf coupling of the contact with a cavity nor a stabilizing shunt resistance was proved necessary. The direct observation of frequency conversion was performed with a microwave receiver at 9.2 GHz in a range of Josephson frequencies between 145 and 1600 GHz. The experiments with intermediate frequencies fi of 0.1 and 0.3 GHz indicate that conventional frequency conversion does not occur but that the observed signals are related to noise effects. An analysis of the frequency conversion mechanism in a Josephson junction operated as an oscillator-mixer is proposed which includes the noise effects and also the feedback effects induced in a junction driven by a constant current source. The results show that low-frequency current components are induced in the junction, which can give large spurious signals when small i.f. are used.

Journal of Applied Physics•Jun 1, 1974•13 citations

Analog-computer studies of mixing and parametric effects in Josephson junctions

C.A. Hamilton

Analog-computer studies are made on a variety of mixing and parametric effects in Josephson junctions. The predictions of the constant-voltage model are compared with the more general behavior of a junction in a resistive circuit. A simple approximate method is developed for calculating frequency conversion efficiency and the matching condition for a junction operating in the oscillator mixer mode. A similar calculation is made for the second mode of operation, in which an external local oscillator is used. In either of these modes, frequency conversion gain is possible even in a purely resistive circuit. The conditions for parametric amplification without frequency conversion are also studied and it is found that gain occurs only when the self-oscillation frequency is near the signal frequency.

Journal of Applied Physics•May 1, 1973•28 citations

Frequency conversion with superconducting point contacts operating as oscillator-mixers and its application to the measurement of the linewidth of the Josephson current at very high frequency

G. Vernet, Robert Adde

The Josephson frequency conversion in the millimeter and submillimeter wave region is studied with superconducting Nb-Nb point contact junctions at 4.2 K, using the contact both as the local oscillator and the mixer with intermediate frequencies of 0.1 and 9.2 GHz. Frequency conversion signals are only detected in the latter case with a microwave receiver at 9.2 GHz in a range of Josephson frequencies between 145 and 1 600 GHz. The experiments with intermediate frequency fi of 0.1 GHz indicate for this small value of f i that the observed signals are not related to frequency conversion but noise effects. An analysis of the frequency conversion mechanism in a Josephson junction operated as an oscillator-mixer is proposed which includes the noise effects and also the feedback effects induced in a junction driven by a constant current source. We have then investigated the noise properties up to 450 GHz of superconducting point-contacts using the junction as an oscillator-mixer where the Josephson current is mixed with harmonics of an externally applied signal. The emitted intermediate frequency is detected at 9.2 GHz and its linewidth is measured. In the very high frequency range the dc quasiparticle current dominates in a Josephson weak-link and we compare the corresponding theoretical linewidth calculated by Scalapino with our experimental results.

Revue de Physique Appliquée•Jan 1, 1974•3 citations
The voltage oscillations which occur in an ideally current-biased Josephson junction were proposed to make a current standard for metrology. We demonstrate similar oscillations in a more complex Josephson circuit derived from the Cooper pair box: the quantronium. When a constant current I is injected in the gate capacitor of this device, oscillations develop at the frequency f(B)=I/2e, with e the electron charge. We detect these oscillations through the sidebands induced at multiples of f(B) in the spectrum of a microwave signal reflected on the circuit, up to currents I exceeding 100 pA. We discuss the potential interest of this current-to-frequency conversion experiment for metrology.
Bloch oscillations predicted to occur in current-biased single Josephson junctions have eluded direct observation up to now. Here, we demonstrate similar Bloch oscillations in a slightly richer Josephson circuit, the quantronium. The quantronium is a Bloch transistor with two small junctions in series, defining an island, in parallel with a larger junction. In the ground state, the microwave impedance of the device is modulated periodically with the charge on the gate capacitor coupled to the transistor island. When a current flows across this capacitor, the impedance modulation occurs at the Bloch frequency, which yields Bloch sidebands in the spectrum of a reflected continuous microwave signal. We have measured this spectrum, and compared it to predictions based on a simple model for the circuit. We discuss the interest of this experiment for metrology and for mesoscopic physics.
Bloch oscillations predicted to occur in current-biased single Josephson junctions have eluded direct observation up to now. Here, we demonstrate similar Bloch oscillations in a slightly richer Josephson circuit, the quantronium. The quantronium is a Bloch transistor with two small junctions in series, defining an island, in parallel with a larger junction. In the ground state, the microwave impedance of the device is modulated periodically with the charge on the gate capacitor coupled to the transistor island. When a current flows across this capacitor, the impedance modulation occurs at the Bloch frequency , which yields Bloch sidebands in the spectrum of a reflected continuous microwave signal. We have measured this spectrum, and compared it to predictions based on a simple model for the circuit. We discuss the interest of this experiment for metrology and for mesoscopic physics.
We have studied Josephson junctions with intrinsic energy ħIc/2e (Ic being the critical current) comparable to thermal energy kT and examined their potential for electromagnetic signal conversion. In this case, moderate thermal fluctuations are sufficient to destroy Josephson oscillations but do not entirely suppress the Josephson dynamics. We have numerically calculated the DC I–V curves, their derivatives dnV/dIn, and the DC and harmonic voltage responses Vn of such Josephson junctions to the AC currents Iωsinωt. We have found that Josephson junction with γ = 2ekT/ħIc ≥ 0.5 is a nonlinear resistance at frequencies ω below characteristic Josephson frequency ωc = 2eIcRn/ħ and all current biases I0. Frequency conversion in such junctions occurs due to the classical mechanism on the nonlinearity of the DC I–V characteristics at low signal frequencies. With increasing the signal frequencies to the characteristic Josephson frequency ωc = 2eIcRn/ħ and higher, the Josephson mechanism by frequency modulation of the Josephson current gradually replaces the classical one. The classical conversion mechanism demonstrates higher conversion efficiencies than the Josephson mechanism, although it operates within a narrower bandwidth. At zero DC bias i0 and in the range of γ-values from 0.1 to 2, we have found odd harmonics Vn emerging from low signal currents. Zero-bias values of the third harmonic V3 maximize at 0.18IcRn for JJs with γ = 0.5 and Iω = 2.5Ic. Based on these findings and high-Tc Josephson junctions, a family of low-noise square-law detectors, harmonic multipliers, and linear heterodyne receivers can be developed for emerging terahertz applications.
The Josephson frequency conversion in the millimeter and submillimeter wave region is studied with superconducting Nb–Nb point-contact junctions at 4.2 °K, using the contact both as the local oscillator and the mixer with intermediate frequencies of 0.1, 0.3, and 9.2 GHz. The point contact is in a nonresonant structure and fed by a constant current source: neither a strong rf coupling of the contact with a cavity nor a stabilizing shunt resistance was proved necessary. The direct observation of frequency conversion was performed with a microwave receiver at 9.2 GHz in a range of Josephson frequencies between 145 and 1600 GHz. The experiments with intermediate frequencies fi of 0.1 and 0.3 GHz indicate that conventional frequency conversion does not occur but that the observed signals are related to noise effects. An analysis of the frequency conversion mechanism in a Josephson junction operated as an oscillator-mixer is proposed which includes the noise effects and also the feedback effects induced in a junction driven by a constant current source. The results show that low-frequency current components are induced in the junction, which can give large spurious signals when small i.f. are used.
Analog-computer studies are made on a variety of mixing and parametric effects in Josephson junctions. The predictions of the constant-voltage model are compared with the more general behavior of a junction in a resistive circuit. A simple approximate method is developed for calculating frequency conversion efficiency and the matching condition for a junction operating in the oscillator mixer mode. A similar calculation is made for the second mode of operation, in which an external local oscillator is used. In either of these modes, frequency conversion gain is possible even in a purely resistive circuit. The conditions for parametric amplification without frequency conversion are also studied and it is found that gain occurs only when the self-oscillation frequency is near the signal frequency.
The Josephson frequency conversion in the millimeter and submillimeter wave region is studied with superconducting Nb-Nb point contact junctions at 4.2 K, using the contact both as the local oscillator and the mixer with intermediate frequencies of 0.1 and 9.2 GHz. Frequency conversion signals are only detected in the latter case with a microwave receiver at 9.2 GHz in a range of Josephson frequencies between 145 and 1 600 GHz. The experiments with intermediate frequency fi of 0.1 GHz indicate for this small value of f i that the observed signals are not related to frequency conversion but noise effects. An analysis of the frequency conversion mechanism in a Josephson junction operated as an oscillator-mixer is proposed which includes the noise effects and also the feedback effects induced in a junction driven by a constant current source. We have then investigated the noise properties up to 450 GHz of superconducting point-contacts using the junction as an oscillator-mixer where the Josephson current is mixed with harmonics of an externally applied signal. The emitted intermediate frequency is detected at 9.2 GHz and its linewidth is measured. In the very high frequency range the dc quasiparticle current dominates in a Josephson weak-link and we compare the corresponding theoretical linewidth calculated by Scalapino with our experimental results.