We have studied Josephson junctions with intrinsic energy ħIc/2e (Ic being the critical current) comparable to thermal energy kT and examined their potential for electromagnetic signal conversion. In this case, moderate thermal fluctuations are sufficient to destroy Josephson oscillations but do not entirely suppress the Josephson dynamics. We have numerically calculated the DC I–V curves, their derivatives dnV/dIn, and the DC and harmonic voltage responses Vn of such Josephson junctions to the AC currents Iωsinωt. We have found that Josephson junction with γ = 2ekT/ħIc ≥ 0.5 is a nonlinear resistance at frequencies ω below characteristic Josephson frequency ωc = 2eIcRn/ħ and all current biases I0. Frequency conversion in such junctions occurs due to the classical mechanism on the nonlinearity of the DC I–V characteristics at low signal frequencies. With increasing the signal frequencies to the characteristic Josephson frequency ωc = 2eIcRn/ħ and higher, the Josephson mechanism by frequency modulation of the Josephson current gradually replaces the classical one. The classical conversion mechanism demonstrates higher conversion efficiencies than the Josephson mechanism, although it operates within a narrower bandwidth. At zero DC bias i0 and in the range of γ-values from 0.1 to 2, we have found odd harmonics Vn emerging from low signal currents. Zero-bias values of the third harmonic V3 maximize at 0.18IcRn for JJs with γ = 0.5 and Iω = 2.5Ic. Based on these findings and high-Tc Josephson junctions, a family of low-noise square-law detectors, harmonic multipliers, and linear heterodyne receivers can be developed for emerging terahertz applications.
We have studied Josephson junctions with intrinsic energy ħIc/2e (Ic being the critical current) comparable to thermal energy kT and examined their potential for electromagnetic signal conversion. In this case, moderate thermal fluctuations are sufficient to destroy Josephson oscillations but do not entirely suppress the Josephson dynamics. We have numerically calculated the DC I–V curves, their derivatives dnV/dIn, and the DC and harmonic voltage responses Vn of such Josephson junctions to the AC currents Iωsinωt. We have found that Josephson junction with γ = 2ekT/ħIc ≥ 0.5 is a nonlinear resistance at frequencies ω below characteristic Josephson frequency ωc = 2eIcRn/ħ and all current biases I0. Frequency conversion in such junctions occurs due to the classical mechanism on the nonlinearity of the DC I–V characteristics at low signal frequencies. With increasing the signal frequencies to the characteristic Josephson frequency ωc = 2eIcRn/ħ and higher, the Josephson mechanism by frequency modulation of the Josephson current gradually replaces the classical one. The classical conversion mechanism demonstrates higher conversion efficiencies than the Josephson mechanism, although it operates within a narrower bandwidth. At zero DC bias i0 and in the range of γ-values from 0.1 to 2, we have found odd harmonics Vn emerging from low signal currents. Zero-bias values of the third harmonic V3 maximize at 0.18IcRn for JJs with γ = 0.5 and Iω = 2.5Ic. Based on these findings and high-Tc Josephson junctions, a family of low-noise square-law detectors, harmonic multipliers, and linear heterodyne receivers can be developed for emerging terahertz applications.
Detection mechanisms in Josephson junctions with energies Ej comparable to thermal energies kT have been studied. The responses ΔV of YBa2Cu3O7−x bicrystal junctions to monochromatic radiation with frequencies f ranging from 94 GHz to 3.1 THz can be described in terms of classical rectification on a static nonlinear V–I curve at low frequencies and frequency modulation of the ac Josephson current at high frequencies, with an interplay between these mechanisms at intermediate frequencies. An electrical noise-equivalent power of (9 ± 3) × 10−15 W/Hz1/2, a responsivity of (3.4 ± 0.5) × 105 V/W, and a dynamic power range of 5 × 104 have been demonstrated for the square-law classical detection of 94 GHz radiation with the junctions at 50 K. The effect of background radiation on the V–I curves of YBa2Cu3O7−x bicrystal junctions was found to have an optical noise-equivalent temperature of ≤30 mK/Hz1/2. The main contribution to the effect comes from the interplay between the classical and Josephson detection mechanisms. The spectral and power dependencies of the responses ΔV of Josephson junctions have been numerically simulated within the resistively shunted junction model at various values of kT/Ej, and the results are in acceptable agreement with the experimental data.
For a current-driven Josephson junction shunted by an Ohmic resistance, the dc voltage response and impedance to external high-frequency currents is calculated with a second-order perturbation method based on the unperturbed solution for the time evolution of the voltage as given by Aslamazov and Larkin. The response is proportional to signal power and has three characteristic-frequency regions depending on whether the internal self-generated Josephson frequency, ω0, is larger than, equal to, or smaller than the signal frequency, ω. For ω0< or >ω the response could be expressed by easily observable parameters of the dc voltage-current characteristics. This permits comparison of the predictions with experimental results obtained on point-contact junctions whose dc characteristics were only approximately represented by the simple model chosen for analysis. For ω0≪ω the response is found to be proportional to (i) the slope of the dc characteristic, (ii) the inverse square of the applied frequency, (iii) the inverse battery current in terms of the critical current, and (iv) the voltage amplitude of the inherent Josephson oscillations. For ω0≫ω ``classical'' detection proportional to curvature is obtained. For ω0∼ω resonance detection occurs, which depends to a considerable degree on fluctuations of the average contact voltage. These predictions are in reasonable agreement with experiments in which point-contact junctions were illuminated with klystron radiation at 10 and 90 GHz. Evidence is presented that the voltage fluctuations limiting the resonance response are the result of noise generated in the junction. Comparison of the noise-equivalent power expected from the simple model with measured results suggests that parasitic elements, such as shunt capacity, are not negligible at 90 GHz.
The terahertz region of the electromagnetic spectrum [0.3-10THz] has, so far, not been exploited fully due to the lack of suitable sources and detectors. Indeed, THz frequency lies between the frequency range of traditional electronics and photonics where the existing technology cannot be simply extended. SIS Niobium tunnel junctions that are currently used as mixing element in heterodyne receivers are intrinsically limited in frequency by the energy gap of Nb and operate only at low temperature (4.2K). An alternative to these devices consists of using High-Tc superconducting receivers. Over the past years, we have developed a new approach based on ion irradiation to make Josephson nano-junctions and SQUIDs with YBCO thin films [1,2]. In this talk, we will present a study of the high-frequency mixing properties of such junctions up to 400 GHz [3]. Conversion gain has been measured at frequencies spanning the range below and above the characteristic frequency fc = (2e/h)IcRn of the junctions. The transition between two distinct mixing regimes has been clearly evidenced, in good agreement with the prediction of the three ports model.[1] N. Bergeal et al., Appl. Phys. Lett. 87, 102502 (2005)[2] N. Bergeal et al., Appl. Phys. Lett. 89, 1112515 (2006)[3] Luo et al, arXiv:1203.1734 (2012)
In this report, Josephson junction detectors for millimeter and submillimeter waves are surveyed. Emphasis is placed on heterodyne detectors (mixers). Others are briefly referred to, such as video detectors, bolometers, quasiparticle mixers and parametric amplifiers. Also, three kinds of Josephson junctions for detector use are mentioned and brief comments are given on them. These are tunnel junctions, thin film microbridges and point contacts.Thermally cyclable oxide barrier tunnel junctions have been obtained and used as low noise quasiparticle mixers at 115GHz. They have lower noise temperatures compared to Josephson effect mixers, but the receiver noise temperatures are not lowered owing to their lower conversion efficiencies. Thin film microbridges suffer from low junction resistances and also from heating effects caused by d.c. bias supply and r.f. incident power. There seems to exist many problems to be overcome in order to make good submillimeter wave detectors by tunnel junctions or microbridges.Point contacts are now widely used as sensitive detectors for millimeter and submillimeter waves. Although there exist difficulties for making rugged and thermally cyclable point contacts, the techniques for making them have made considerable progress, and a new construction of detector mount has appeared, which brought a low noise mixer at 115GHz thermally cyclable.It is shown that the sensitivity of video detectors decreases as proportional to the inverse square of frequency. So, for submillimeter waves, video detectors are inferior to superconducting bolometers.Recent progress in heterodyne detectors (fundamental and harmonic mixers) are touched on. They are superior to Shottky diode mixers in that they have much smaller NEP's and much higher conversion efficiencies (especially in harmonic mixers), and also in that they operate with much smaller LO power. Experimental curves of IF output power v.s. bias voltage are given for harmonic mixers with harmonic number N=7 and N=10. It is noted that harmonic mixers with even harmonic number are preferable, because they can operate at zero bias voltage. Among them, low even numbers 2 or 4 are recommended in regards to good conversion efficiency.By using Josephson junctions, a peculiar parametric operation is possible, namely doubly degenerate mode. This mode operates under zero d.c. bias by choosing pump frequency as 2ωp=ωs+ωi, ωp-ωs-ωi. Zero bias operation allows the adoption of microbridge arrays. A parametric amplifier with 160 microbridge arrays was built at 33GHz, and showed amplifier gain of 15dB and noise temperature of 20K.
Abstract Analytical and numerical calculations of limiting characteristics of electromagnetic radiation detectors based on Josephson junctions are carried out. Josephson junctions are described by a simple resistively shunted model and their Josephson energy is considered to be comparable to the energy of thermal fluctuations. The operation modes of such junctions as a classical detector using ac rectification on a static nonlinear current–voltage characteristic are established. The results of numerical and analytical calculations are compared, and it is shown that the classical detection mode can be analyzed and optimized using the derived analytical expressions for the main limiting characteristics. The study demonstrates the possibility of achieving a limiting sensitivity up to 2 × 10–15 W/Hz1/2, a dynamic power range of 105–106, and a spectral range up to 1.4 THz, in a temperature range 50–77 K using new Josephson thin-film junctions consisting of high-temperature YBa2Cu3O7 – x superconductors with mutually tilted c axes.
The Josephson frequency conversion in the millimeter and submillimeter wave region is studied with superconducting Nb-Nb point contact junctions at 4.2 K, using the contact both as the local oscillator and the mixer with intermediate frequencies of 0.1 and 9.2 GHz. Frequency conversion signals are only detected in the latter case with a microwave receiver at 9.2 GHz in a range of Josephson frequencies between 145 and 1 600 GHz. The experiments with intermediate frequency fi of 0.1 GHz indicate for this small value of f i that the observed signals are not related to frequency conversion but noise effects. An analysis of the frequency conversion mechanism in a Josephson junction operated as an oscillator-mixer is proposed which includes the noise effects and also the feedback effects induced in a junction driven by a constant current source. We have then investigated the noise properties up to 450 GHz of superconducting point-contacts using the junction as an oscillator-mixer where the Josephson current is mixed with harmonics of an externally applied signal. The emitted intermediate frequency is detected at 9.2 GHz and its linewidth is measured. In the very high frequency range the dc quasiparticle current dominates in a Josephson weak-link and we compare the corresponding theoretical linewidth calculated by Scalapino with our experimental results.