Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:quant-ph/9603016 · Journal of Mathematical Physics

Correlation properties of quantum measurements

Paul Busch, Pekka J. Lahti

Published Jun 1, 1996• 12 citations
arXivHTMLPDF

Abstract

The kind of information provided by a measurement is determined in terms of the correlation established between observables of the apparatus and the measured system. Using the framework of quantum measurement theory, necessary and sufficient conditions for a measurement interaction to produce strong correlations are given and are found to be related to properties of the final object and apparatus states. These general results are illustrated with reference to the standard model of the quantum theory measurement.

DOI
10.1063/1.531530

Related papers

On the general quantum theory of measurement

Arthur I. Fine

We use the term ‘measurement’ to refer to the interaction between an object and an apparatus on the basis of which information concerning the initial state of the object may be obtained from information on the resulting state of the apparatus. The quantum theory of measurement is a quantum theoretic investigation of such interactions in order to analyse the correlations between object and apparatus that measurement must establish. Although there is a sizeable literature on quantum measurements there appear to be just two sorts of interactions that have been employed. There are the ‘disturbing’ interactions consistent with the analysis of Landau and Peierls (8) as developed by Pauli (11) and by Landau and Lifshitz (7), and there are the ‘non-disturbing’ interactions explicitly set out by von Neumann ((10), chs. 5, 6), and that dominate the literature. In this paper we shall investigate the most general types of interactions that could possibly constitute measurements and provide a precise mathematical characterization (section 2). We shall then examine an interesting subclass, corresponding to Landau's ideas, that contains both of the above sorts of measurements (section 3). Finally, we shall discuss von Neumann measurements explicitly and explore the purported limitations suggested by Wigner(12) and Araki and Yanase (2). We hope, in this way, to provide a comprehensive basis for discussions of quantum measurements.

Mathematical Proceedings of the Cambridge Philosophical Society•Jan 1, 1969•28 citations

Measurement models and instruments

Teiko Heinosaari, Mário Ziman

Until now we have treated measurement apparatuses as devices taking quantum systems as their inputs and producing measurement outcomes as outputs. At this level of description, measurement apparatuses are fully described by observables, as discussed in Chapter 3. The measurement outcome distribution is determined by the particular input state and the observable describing the measurement device. In this chapter we explore a mathematical framework suitable for the description of measurement apparatuses for which, in addition to the measurement outcomes, the measured systems are available after the measurement is performed. In such cases we may try to obtain more information on the system by measuring some other observable, or, perhaps by filtering out some preferred output states we may use our measurement apparatus as a preparator. Clearly, in this kind of situation we need a description of measurement apparatuses that is more detailed than that of observables. Therefore, two more refined concepts, measurement models and instruments , will be investigated in this chapter. There is no customary name for a measurement model. As used here, it was first formalized in a general way by Ozawa [106], [107] who referred to the measurement process . A comprehensive general reference on quantum measurements is the monograph by Busch et al. [35], where measurement models are called premeasurements . Some other authors use the term indirect measurements . Three levels of description of measurements It is convenient to think of three levels of description when considering measurements.

Cambridge University Press eBooks•Dec 15, 2011•0 citations

Unitary measurements of discrete quantities in quantum mechanics

Enrico G. Beltrametti, Gianni Cassinelli, PEKKA J. LAHTI

The pure measurements of discrete physical quantities are characterized within quantum theory of measurement and their unitary representations are given. Probabilistic aspects of measurements related to the so-called strong correlation conditions and a probabilistic characterization of the first kind measurements are examined. The problem of the objectification of the measurement result is analyzed in terms of a classical behavior of the measuring apparatus. As a by-product a generalization of the Wigner–Araki–Yanase theorem is given.

Journal of Mathematical Physics•Jan 1, 1990•52 citations

Persistence of Information in the Quantum Measurement Problem.

Shantena Augusto Sabbadini

The quantum measurement problem has to do with the compatibility of two different prescriptions for the end state of a quantum measurement process: (1) a superposition representing an entangled state of object system and apparatus; (2) a mixture of correlated states of object system and apparatus. The first prescription is a consequence of the linearity of time evolution in quantum mechanics; the second one (corresponding to what is usually called the 'collapse of the wave function') is a basic feature of the axiomatic structure of the theory. This paper proves that the two prescriptions are exactly equivalent whenever information about the results of the measurement persists, i.e. whenever there is some kind of record or trace of the results (all the measurements we are ordinarily concerned with fulfill this requirement). Experimental evidence is cited suggesting that indeed we should expect the equivalence of prescriptions (1) and (2) to hold when and only when information about measurement results persists. Finally the notion of 'element of reality' introduced by Einstein, Podolsky and Rosen is discussed in the context of this description of the measurement process, and a brief remark is offered about the 'classical' nature of the world we experience.

Physics Essays•Mar 1, 2006•2 citations

Quantum Measured Information

Yi-Xin Chen

A framework for a quantum information theory is introduced that is based on the measure of quantum information associated with probability distribution predicted by quantum measuring of state. The entanglement between states of measured system and "pointer" states of measuring apparatus, which is generated by dynamical process of quantum measurement, plays a dominant role in expressing quantum characteristics of information theory. The quantum mutual information of transmission and reception of quantum states along a noisy quantum channel is given by the change of quantum measured information. In our approach, it is not necessary to purify the transmitted state by means of the reference system. It is also clarified that there exist relations between the approach given in this letter and those given by other authors.

arXiv:quant-ph/9906037•Jun 12, 1999•2 citations

Insolubility of the Quantum Measurement Problem

Arthur I. Fine

The problem of whether a measurement interaction can leave the joint object-apparatus system in a mixture of states, in each state of which the apparatus's observable displays a definite value, is set within the most general quantum-theoretic framework for treating measurements. It is shown that the question posed by this problem admits only a negative answer. Some schemes for approximating the true object-apparatus state by means of such mixtures are examined. It is argued that such schemes constitute fundamental changes in the interpretation of quantum theory.

Physical review. D. Particles, fields, gravitation, and cosmology/Physical review. D. Particles and fields•Dec 15, 1970•145 citations
The kind of information provided by a measurement is determined in terms of the correlation established between observables of the apparatus and the measured system. Using the framework of quantum measurement theory, necessary and sufficient conditions for a measurement interaction to produce strong correlations are given and are found to be related to properties of the final object and apparatus states. These general results are illustrated with reference to the standard model of the quantum theory measurement.
We use the term ‘measurement’ to refer to the interaction between an object and an apparatus on the basis of which information concerning the initial state of the object may be obtained from information on the resulting state of the apparatus. The quantum theory of measurement is a quantum theoretic investigation of such interactions in order to analyse the correlations between object and apparatus that measurement must establish. Although there is a sizeable literature on quantum measurements there appear to be just two sorts of interactions that have been employed. There are the ‘disturbing’ interactions consistent with the analysis of Landau and Peierls (8) as developed by Pauli (11) and by Landau and Lifshitz (7), and there are the ‘non-disturbing’ interactions explicitly set out by von Neumann ((10), chs. 5, 6), and that dominate the literature. In this paper we shall investigate the most general types of interactions that could possibly constitute measurements and provide a precise mathematical characterization (section 2). We shall then examine an interesting subclass, corresponding to Landau's ideas, that contains both of the above sorts of measurements (section 3). Finally, we shall discuss von Neumann measurements explicitly and explore the purported limitations suggested by Wigner(12) and Araki and Yanase (2). We hope, in this way, to provide a comprehensive basis for discussions of quantum measurements.
Until now we have treated measurement apparatuses as devices taking quantum systems as their inputs and producing measurement outcomes as outputs. At this level of description, measurement apparatuses are fully described by observables, as discussed in Chapter 3. The measurement outcome distribution is determined by the particular input state and the observable describing the measurement device. In this chapter we explore a mathematical framework suitable for the description of measurement apparatuses for which, in addition to the measurement outcomes, the measured systems are available after the measurement is performed. In such cases we may try to obtain more information on the system by measuring some other observable, or, perhaps by filtering out some preferred output states we may use our measurement apparatus as a preparator. Clearly, in this kind of situation we need a description of measurement apparatuses that is more detailed than that of observables. Therefore, two more refined concepts, measurement models and instruments , will be investigated in this chapter. There is no customary name for a measurement model. As used here, it was first formalized in a general way by Ozawa [106], [107] who referred to the measurement process . A comprehensive general reference on quantum measurements is the monograph by Busch et al. [35], where measurement models are called premeasurements . Some other authors use the term indirect measurements . Three levels of description of measurements It is convenient to think of three levels of description when considering measurements.
The pure measurements of discrete physical quantities are characterized within quantum theory of measurement and their unitary representations are given. Probabilistic aspects of measurements related to the so-called strong correlation conditions and a probabilistic characterization of the first kind measurements are examined. The problem of the objectification of the measurement result is analyzed in terms of a classical behavior of the measuring apparatus. As a by-product a generalization of the Wigner–Araki–Yanase theorem is given.
The quantum measurement problem has to do with the compatibility of two different prescriptions for the end state of a quantum measurement process: (1) a superposition representing an entangled state of object system and apparatus; (2) a mixture of correlated states of object system and apparatus. The first prescription is a consequence of the linearity of time evolution in quantum mechanics; the second one (corresponding to what is usually called the 'collapse of the wave function') is a basic feature of the axiomatic structure of the theory. This paper proves that the two prescriptions are exactly equivalent whenever information about the results of the measurement persists, i.e. whenever there is some kind of record or trace of the results (all the measurements we are ordinarily concerned with fulfill this requirement). Experimental evidence is cited suggesting that indeed we should expect the equivalence of prescriptions (1) and (2) to hold when and only when information about measurement results persists. Finally the notion of 'element of reality' introduced by Einstein, Podolsky and Rosen is discussed in the context of this description of the measurement process, and a brief remark is offered about the 'classical' nature of the world we experience.
A framework for a quantum information theory is introduced that is based on the measure of quantum information associated with probability distribution predicted by quantum measuring of state. The entanglement between states of measured system and "pointer" states of measuring apparatus, which is generated by dynamical process of quantum measurement, plays a dominant role in expressing quantum characteristics of information theory. The quantum mutual information of transmission and reception of quantum states along a noisy quantum channel is given by the change of quantum measured information. In our approach, it is not necessary to purify the transmitted state by means of the reference system. It is also clarified that there exist relations between the approach given in this letter and those given by other authors.
The problem of whether a measurement interaction can leave the joint object-apparatus system in a mixture of states, in each state of which the apparatus's observable displays a definite value, is set within the most general quantum-theoretic framework for treating measurements. It is shown that the question posed by this problem admits only a negative answer. Some schemes for approximating the true object-apparatus state by means of such mixtures are examined. It is argued that such schemes constitute fundamental changes in the interpretation of quantum theory.