Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:quant-ph/0608018 · Annual Symposium on Foundations of Computer Science

Postselection threshold against biased noise

Ben W. Reichardt

Published Jan 1, 2006• 4 citations
arXivHTMLPDF

Abstract

The highest current estimates for the amount of noise a quantum computer can tolerate are based on fault-tolerance schemes relying heavily on postselecting on no detected errors. However, there has been no proof that these schemes give even a positive tolerable noise threshold. A technique to prove a positive threshold, for probabilistic noise models, is presented. The main idea is to maintain strong control over the distribution of errors in the quantum state at all times. This distribution has correlations which conceivably could grow out of control with postselection. But in fact, the error distribution can be written as a mixture of nearby distributions each satisfying strong independence properties, so there are no correlations for postselection to amplify

DOI
10.1109/focs.2006.64

Related papers

Accuracy threshold for postselected quantum computation

Panos Aliferis, Daniel Gottesman, John P. Preskill

We prove an accuracy threshold theorem for fault-tolerant quantum computation based on error detection and postselection. Our proof provides a rigorous foundation for the scheme suggested by Knill, in which preparation circuits for ancilla states are protected by a concatenated error-detecting code and the preparation is aborted if an error is detected. The proof applies to independent stochastic noise but (in contrast to proofs of the quantum accuracy threshold theorem based on concatenated error-correcting codes) not to strongly-correlated adversarial noise. Our rigorously established lower bound on the accuracy threshold, $1.04\times 10^{-3}$, is well below Knill's numerical estimates.

arXiv:quant-ph/0703264•Quantum Information and Computation•Mar 1, 2008•125 citations

Error-detection-based quantum fault tolerance against discrete Pauli noise

Reichardt, Ben W.

A quantum computer -- i.e., a computer capable of manipulating data in quantum superposition -- would find applications including factoring, quantum simulation and tests of basic quantum theory. Since quantum superpositions are fragile, the major hurdle in building such a computer is overcoming noise. Developed over the last couple of years, new schemes for achieving fault tolerance based on error detection, rather than error correction, appear to tolerate as much as 3-6% noise per gate -- an order of magnitude better than previous procedures. But proof techniques could not show that these promising fault-tolerance schemes tolerated any noise at all. With an analysis based on decomposing complicated probability distributions into mixtures of simpler ones, we rigorously prove the existence of constant tolerable noise rates ("noise thresholds") for error-detection-based schemes. Numerical calculations indicate that the actual noise threshold this method yields is lower-bounded by 0.1% noise per gate.

arXiv:quant-ph/0612004•Nov 30, 2006•39 citations

Fault-tolerance threshold for a distance-three quantum code

Ben W. Reichardt

The quantum error threshold is the highest (model-dependent) noise rate which we can tolerate and still quantum-compute to arbitrary accuracy. Although noise thresholds are frequently estimated for the Steane seven-qubit, distance-three quantum code, there has been no proof that a constant threshold even exists for distance-three codes. We prove the existence of a constant threshold. The proven threshold is well below estimates, based on simulations and analytic models, of the true threshold, but at least it is now known to be positive.

arXiv:quant-ph/0509203•Sep 28, 2005•23 citations

Fault-Tolerant Postselected Quantum Computation: Threshold Analysis

Emanuel H. Knill

The schemes for fault-tolerant postselected quantum computation given in [Knill, Fault-Tolerant Postselected Quantum Computation: Schemes, http://arxiv.org/abs/quant-ph/0402171] are analyzed to determine their error-tolerance. The analysis is based on computer-assisted heuristics. It indicates that if classical and quantum communication delays are negligible, then scalable qubit-based quantum computation is possible with errors above 1% per elementary quantum gate.

arXiv:quant-ph/0404104•Apr 19, 2004•128 citations

The Role of Correlated Noise in Quantum Computing

Daan Staudt

This paper aims to give an overview of the current state of fault-tolerant quantum computing, by surveying a number of results in the field. We show that thresholds can be obtained for a simple noise model as first proved in [AB97, Kit97, KLZ98], by presenting a proof for statistically independent noise, following the presentation of Aliferis, Gottesman and Preskill [AGP06]. We also present a result by Terhal and Burkard [TB05] and later improved upon by Aliferis, Gottesman and Preskill [AGP06] that shows a threshold can still be obtained for local non-Markovian noise, where we allow the noise to be weakly correlated in space and time. We then turn to negative results, presenting work by Ben-Aroya and Ta-Shma [BT11] who showed conditional errors cannot be perfectly corrected. We end our survey by briefly mentioning some more speculative objections, as put forth by Kalai [Kal08, Kal09, Kal11].

arXiv:1111.1417•Nov 6, 2011•6 citations

New methods in quantum error correction and fault-tolerant quantum computing

Christopher Chamberland

Quantum computers have the potential to solve several interesting problems in polynomial \ntime for which no polynomial time classical algorithms have been found. However, \none of the major challenges in building quantum devices is that quantum systems are very \nsensitive to noise arising from undesired interactions with the environment. Noise can lead \nto errors which can corrupt the results of the computation. Quantum error correction is \none way to mitigate the effects of noise arising in quantum devices. \nWith a plethora of quantum error correcting codes that can be used in various settings, \none of the main challenges of quantum error correction is understanding how well various \ncodes perform under more realistic noise models that can be observed in experiments. \nThis thesis proposes a new decoding algorithm which can optimize threshold values of \nerror correcting codes under different noise models. The algorithm can be applied to \nany Markovian noise model. Further, it is shown that for certain noise models, logical \nClifford corrections can further improve a code's threshold value if the code obeys certain \nsymmetries. \n \nSince gates and measurements cannot in general be performed with perfect precision, \nthe operations required to perform quantum error correction can introduce more errors \ninto the system thus negating the benefits of error correction. Fault-tolerant quantum \ncomputing is a way to perform quantum error correction with imperfect operations while \nretaining the ability to suppress errors as long as the noise is below a code's threshold. \nOne of the main challenges in performing fault-tolerant error correction is the high resource \nrequirements that are needed to obtain very low logical noise rates. With the use of \nflag qubits, this thesis develops new fault-tolerant error correction protocols that are applicable \nto arbitrary distance codes. Various code families are shown to satisfy the requirements \nof flag fault-tolerant error correction. We also provide circuits using a constant number of \nqubits for these codes. It is shown that the proposed flag fault-tolerant method uses fewer \nqubits than previous fault-tolerant error correction protocols. \n \nIt is often the case that the noise afflicting a quantum device cannot be fully characterized. \nFurther, even with some knowledge of the noise, it can be very challenging to use \nanalytic decoding methods to improve the performance of a fault-tolerant scheme. This \nthesis presents decoding schemes using several state of the art machine learning techniques \nwith a focus on fault-tolerant quantum error correction in regimes that are relevant to near \nterm experiments. It is shown that even in low noise rate regimes and with no knowledge \nof the noise, noise can be further suppressed for small distance codes. Limitations of machine \nlearning decoders as well as the classical resources required to perform active error \ncorrection are discussed. \n \nIn many cases, gate times can be much shorter than typical measurement times of \nquantum states. Further, classical decoding of the syndrome information used in quantum \nerror correction to compute recovery operators can also be much slower than gate times. \nFor these reasons, schemes where error correction can be implemented in a frame (known \nas the Pauli frame) have been developed to avoid active error correction. In this thesis, we \ngeneralize previous Pauli frame schemes and show how Clifford frame error correction can \nbe implemented with minimal overhead. Clifford frame error correction is necessary if the \nlogical component of recovery operators were chosen from the Clifford group, but could \nalso be used in randomized benchmarking schemes.

•Oct 22, 2018•0 citations
The highest current estimates for the amount of noise a quantum computer can tolerate are based on fault-tolerance schemes relying heavily on postselecting on no detected errors. However, there has been no proof that these schemes give even a positive tolerable noise threshold. A technique to prove a positive threshold, for probabilistic noise models, is presented. The main idea is to maintain strong control over the distribution of errors in the quantum state at all times. This distribution has correlations which conceivably could grow out of control with postselection. But in fact, the error distribution can be written as a mixture of nearby distributions each satisfying strong independence properties, so there are no correlations for postselection to amplify
We prove an accuracy threshold theorem for fault-tolerant quantum computation based on error detection and postselection. Our proof provides a rigorous foundation for the scheme suggested by Knill, in which preparation circuits for ancilla states are protected by a concatenated error-detecting code and the preparation is aborted if an error is detected. The proof applies to independent stochastic noise but (in contrast to proofs of the quantum accuracy threshold theorem based on concatenated error-correcting codes) not to strongly-correlated adversarial noise. Our rigorously established lower bound on the accuracy threshold, 1.04×10−31.04\times 10^{-3}1.04×10−3, is well below Knill's numerical estimates.
A quantum computer -- i.e., a computer capable of manipulating data in quantum superposition -- would find applications including factoring, quantum simulation and tests of basic quantum theory. Since quantum superpositions are fragile, the major hurdle in building such a computer is overcoming noise. Developed over the last couple of years, new schemes for achieving fault tolerance based on error detection, rather than error correction, appear to tolerate as much as 3-6% noise per gate -- an order of magnitude better than previous procedures. But proof techniques could not show that these promising fault-tolerance schemes tolerated any noise at all. With an analysis based on decomposing complicated probability distributions into mixtures of simpler ones, we rigorously prove the existence of constant tolerable noise rates ("noise thresholds") for error-detection-based schemes. Numerical calculations indicate that the actual noise threshold this method yields is lower-bounded by 0.1% noise per gate.
The quantum error threshold is the highest (model-dependent) noise rate which we can tolerate and still quantum-compute to arbitrary accuracy. Although noise thresholds are frequently estimated for the Steane seven-qubit, distance-three quantum code, there has been no proof that a constant threshold even exists for distance-three codes. We prove the existence of a constant threshold. The proven threshold is well below estimates, based on simulations and analytic models, of the true threshold, but at least it is now known to be positive.
This paper aims to give an overview of the current state of fault-tolerant quantum computing, by surveying a number of results in the field. We show that thresholds can be obtained for a simple noise model as first proved in [AB97, Kit97, KLZ98], by presenting a proof for statistically independent noise, following the presentation of Aliferis, Gottesman and Preskill [AGP06]. We also present a result by Terhal and Burkard [TB05] and later improved upon by Aliferis, Gottesman and Preskill [AGP06] that shows a threshold can still be obtained for local non-Markovian noise, where we allow the noise to be weakly correlated in space and time. We then turn to negative results, presenting work by Ben-Aroya and Ta-Shma [BT11] who showed conditional errors cannot be perfectly corrected. We end our survey by briefly mentioning some more speculative objections, as put forth by Kalai [Kal08, Kal09, Kal11].
Quantum computers have the potential to solve several interesting problems in polynomial \ntime for which no polynomial time classical algorithms have been found. However, \none of the major challenges in building quantum devices is that quantum systems are very \nsensitive to noise arising from undesired interactions with the environment. Noise can lead \nto errors which can corrupt the results of the computation. Quantum error correction is \none way to mitigate the effects of noise arising in quantum devices. \nWith a plethora of quantum error correcting codes that can be used in various settings, \none of the main challenges of quantum error correction is understanding how well various \ncodes perform under more realistic noise models that can be observed in experiments. \nThis thesis proposes a new decoding algorithm which can optimize threshold values of \nerror correcting codes under different noise models. The algorithm can be applied to \nany Markovian noise model. Further, it is shown that for certain noise models, logical \nClifford corrections can further improve a code's threshold value if the code obeys certain \nsymmetries. \n \nSince gates and measurements cannot in general be performed with perfect precision, \nthe operations required to perform quantum error correction can introduce more errors \ninto the system thus negating the benefits of error correction. Fault-tolerant quantum \ncomputing is a way to perform quantum error correction with imperfect operations while \nretaining the ability to suppress errors as long as the noise is below a code's threshold. \nOne of the main challenges in performing fault-tolerant error correction is the high resource \nrequirements that are needed to obtain very low logical noise rates. With the use of \nflag qubits, this thesis develops new fault-tolerant error correction protocols that are applicable \nto arbitrary distance codes. Various code families are shown to satisfy the requirements \nof flag fault-tolerant error correction. We also provide circuits using a constant number of \nqubits for these codes. It is shown that the proposed flag fault-tolerant method uses fewer \nqubits than previous fault-tolerant error correction protocols. \n \nIt is often the case that the noise afflicting a quantum device cannot be fully characterized. \nFurther, even with some knowledge of the noise, it can be very challenging to use \nanalytic decoding methods to improve the performance of a fault-tolerant scheme. This \nthesis presents decoding schemes using several state of the art machine learning techniques \nwith a focus on fault-tolerant quantum error correction in regimes that are relevant to near \nterm experiments. It is shown that even in low noise rate regimes and with no knowledge \nof the noise, noise can be further suppressed for small distance codes. Limitations of machine \nlearning decoders as well as the classical resources required to perform active error \ncorrection are discussed. \n \nIn many cases, gate times can be much shorter than typical measurement times of \nquantum states. Further, classical decoding of the syndrome information used in quantum \nerror correction to compute recovery operators can also be much slower than gate times. \nFor these reasons, schemes where error correction can be implemented in a frame (known \nas the Pauli frame) have been developed to avoid active error correction. In this thesis, we \ngeneralize previous Pauli frame schemes and show how Clifford frame error correction can \nbe implemented with minimal overhead. Clifford frame error correction is necessary if the \nlogical component of recovery operators were chosen from the Clifford group, but could \nalso be used in randomized benchmarking schemes.