While single-shot detection of silicon spin qubits is now a laboratory routine, the need for quantum error correction in a large-scale quantum computing device demands a quantum non-demolition (QND) implementation. Unlike conventional counterparts, the QND spin readout imposes minimal disturbance to the probed spin polarization and can therefore be repeated to extinguish measurement errors. Here, we show that an electron spin qubit in silicon can be measured in a highly non-demolition manner by probing another electron spin in a neighboring dot Ising-coupled to the qubit spin. The high non-demolition fidelity (99% on average) enables over 20 readout repetitions of a single spin state, yielding an overall average measurement fidelity of up to 95% within 1.2 ms. We further demonstrate that our repetitive QND readout protocol can realize heralded high-fidelity (>99.6%) ground-state preparation. Our QND-based measurement and preparation, mediated by a second qubit of the same kind, will allow for a wide class of quantum information protocols with electron spins in silicon without compromising the architectural homogeneity.
We propose a protocol and physical implementation for partial Bell-state measurements of Fermionic qubits, allowing for deterministic quantum computing in solid-state systems without the need for two-qubit gates. Our scheme consists of two spin qubits in a double quantum dot where the two dots have different Zeeman splittings and resonant tunneling between the dots is only allowed when the spins are antiparallel. This converts spin parity into charge information by means of a projective measurement and can be implemented with established technologies. This measurement-based qubit scheme greatly simplifies the experimental realization of scalable quantum computers in electronic nanostructures.
The quantum controlled-NOT (CNOT) gate is a prototypical two-qubit quantum logic gate that provides the basic controlled logic for a set of gates for universal quantum computation. It has been shown that parity checking devices can be used to construct CNOT gates, and the fidelity of a CNOT operation is highly constrained by the fidelity of parity detection with this strategy. In this paper, a scheme to implement a CNOT operation on two stationary electron spins confined in quantum dots (QDs) inside double-sided optical microcavities is presented, based on the faithful parity detection achieved by a heralded and robust two-electron-spin quantum nondemolition (QND) parity detector. The QND parity detector is considerably different from previous implementations and experimentally more realizable, and works in the heralded and repeat-until-success fashion with robust fidelity, which enables our CNOT gate to be implemented deterministically with unity fidelity. Moreover, based on the features of the QND parity detector, a complete Bell-state analysis on two QD-confined electron spins can be realized without wrong judgment or any destruction of the analyzed entangled state. The efficiency of parity detection is also discussed by considering currently achievable system parameters.
Leveraging noise bias, where phase-flip errors dominate over bit-flips, can drastically reduce the hardware overhead of fault-tolerant quantum computation, but existing approaches require bias-preserving CNOT gates whose implementation remains experimentally challenging and is provably impossible for strictly two-dimensional systems. We show that high-fidelity quantum non-demolition (QND) multi-qubit Pauli
Z measurements provide an equally powerful yet more accessible primitive. We demonstrate that such measurements can fully replace bias-preserving CNOT gates for compiling all operations required by bias-tailored error correction, including stabilizer measurements for repetition codes, XZZX surface codes, and LDPC codes. We propose concrete physical implementations of this primitive for two platforms: solid-state nuclear spins coupled to electron spin ancillas, and dissipatively stabilized superconducting cat qubits. Through circuit-level numerical simulations, we show that an asymmetric XZZX surface code implemented with weight-four QND
Z measurements achieves a phase-flip threshold of
∼1.25% and provides a qubit overhead reduction of up to
6× compared to a bias-unaware surface code at noise bias
η=104. In the regime of very large bias, a repetition code with QND
Z measurements attains a threshold of
∼2.3% and achieves overhead comparable to that of a bias-preserving CNOT scheme, without requiring such a gate. Our results establish QND multi-
Z measurements as a practical and hardware-efficient route to fault-tolerant quantum computation for a broad class of biased-noise platforms.
A full-scale quantum computer requires physical qubits that can be controlled with high precision and accuracy. Unfortunately, few state-of-the-art qubits can perform all their elementary operations (preparation, measurement, single-qubit gates and two-qubit gates) with sufficient fidelity. In this thesis, we investigate alternative schemes for such operations in solid-state qubits. Specifically, two-qubit gates and measurements, which are often the noisiest of the four. \n \nWe first provide a preliminary introduction to quantum computing, and describe how quantum information can be encoded and manipulated in quantum systems. We include background information for the three different solid-state qubit architectures that feature in this thesis: spin qubits, superconducting qubits and Majorana qubits. \n \nFollowing this, we investigate a scheme for mediating a two-qubit interaction between spin qubits via a multielectron quantum dot. We study a multielectron dot in detail, and characterise its exchange interaction with a single spin. With the aid of a theoretical model, we show that the multielectron dot possesses an irregular triplet-preferring ground state, analogous to Hund's rule from atomic physics. Using these findings, we then demonstrate that the multielectron dot can be used to mediate a fast, long-range exchange interaction between two spin qubits. \n \nSubsequently, we examine two resonator-based measurement schemes for Majorana qubits. We first propose a readout technique based on a longitudinal qubit-resonator interaction. This leads to a measurement that is fast, high-fidelity and quantum non-demolition (QND). We then investigate a more conventional dispersive readout scheme. Not only does this yield a high quality measurement, but it can also offers a more protected readout mechanism in comparison to the dispersive readout of conventional superconducting qubits.
In this paper, we study the generation of entanglement by interaction-free measurements. Using Kwiat et al.'s interferometer, we construct a two-qubit quantum gate that changes one particle's trajectory according to the other particle's trajectory. We propose methods for generating the Bell state from an electron and a positron and from a pair of photons using this gate. We also show that, by using this gate, we can carry out the Bell measurement with a probability of 3/4 at the maximum and execute a controlled-NOT operation by the method proposed by Gottesman and Chuang with a probability of 9/16 at the maximum. We estimate the success probability for generating the Bell state by our procedure under imperfect interaction.