Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:quant-ph/0403234 · Physical Review A

Pulsed squeezed vacuum measurements without homodyning

Jérôme Wenger, Jaromír Fiurášek, Rosa Tualle-Brouri, Nicolas J. Cerf, Philippe Grangier

Published Nov 11, 2004• 47 citations
arXivHTMLPDF

Abstract

Following a recent theoretical proposal [J. Fiur\'a\ifmmode \check{s}\else \v{s}\fi{}ek and N. J. Cerf, Phys. Rev. Lett. 93, 063601 (2004)], we experimentally implement a scheme to measure the squeezing and purity of a single-mode squeezed vacuum state without an interferometric homodyne detection. The suggested setup is based on only a tunable beam splitter and a direct single-photon detector to fully characterize the generated Gaussian states. We discuss the experimental implementation of this procedure and compare it to other reference methods. A detailed exploitation of our results highlights some practical limitations of this method. This experimental work is followed by a detailed numerical analysis to derive the conditions required for the procedure to succeed. In particular, it is found that an overall single-photon detection efficiency of about 50% is needed, which is difficult to achieve in the present experiment.

DOI
10.1103/physreva.70.053812

Related papers

Proposal for a Loophole-Free Bell Test Using Homodyne Detection

Raúl García−Patrón, Jaromír Fiurášek, Nicolas J. Cerf +3 more

We propose a feasible optical setup allowing for a loophole-free Bell test with efficient homodyne detection. A non-Gaussian entangled state is generated from a two-mode squeezed vacuum by subtracting a single photon from each mode, using beam splitters and standard low-efficiency single-photon detectors. A Bell violation exceeding 1% is achievable with 6 dB squeezed light and a homodyne efficiency around 95%. A detailed feasibility analysis, based upon the recent experimental generation of single-mode non-Gaussian states, suggests that this method opens a promising avenue towards a complete experimental Bell test.

arXiv:quant-ph/0403191•Physical Review Letters•Sep 23, 2004•311 citations

How to Measure Squeezing and Entanglement of Gaussian States without Homodyning

Jaromír Fiurášek, Nicolas J. Cerf

We propose a scheme for measuring the squeezing, purity, and entanglement of Gaussian states of light that does not require homodyne detection. The suggested setup needs only beam splitters and single-photon detectors. Two-mode entanglement can be detected from coincidences between photodetectors placed on the two beams.

arXiv:quant-ph/0311119•Physical Review Letters•Aug 6, 2004•72 citations

Proposal for loophole-free Bell test using homodyne detection

R. García-Patrón

We propose a feasible optical setup allowing for a loophole‐free Bell test with efficient homodyne detection. A non‐Gaussian entangled state is generated from a two‐mode squeezed vacuum by subtracting a single photon from each mode, using beam splitters and standard low‐efficiency single‐photon detectors. A Bell violation exceeding 1% is achievable with 6 dB of squeezing, a photodetector efficiency around 10%, and an homodyne efficiency around 95%. A feasibility analysis, based upon the recent generation of single‐mode non‐Gaussian states via photon subtraction, suggests that this method opens a promising avenue towards a complete experimental Bell test.

AIP conference proceedings•Jan 1, 2004•14 citations

Loophole-free test of quantum nonlocality using high-efficiency homodyne detectors

Raúl García−Patrón, Jaromír Fiurášek, Nicolas J. Cerf

We provide a detailed analysis of the recently proposed setup for a loophole-free test of Bell inequality violation using conditionally generated non-Gaussian states of light and balanced homodyning. In the proposed scheme, a two-mode squeezed vacuum state is de-Gaussified by subtracting a single photon from each mode with the use of an unbalanced beam splitter and a standard low-efficiency single-photon detector. We thoroughly discuss the tolerance of the achievable Bell violation in the various experimentally relevant parameters such as the detector efficiencies, the electronic noise, the mixedness of the initial Gaussian state, and the probability of false triggers. We also consider several alternative schemes involving squeezed states, linear optical elements, conditional photon subtraction, and homodyne detection.

arXiv:quant-ph/0407181•Physical Review A•Feb 11, 2005•54 citations

Parity detection in quantum optical metrology without number-resolving detectors

William N Plick, Petr M. Anisimov, Jonathan P Dowling +2 more

We present a method of directly obtaining the parity of a Gaussian state of light without recourse to photon-number counting. The scheme uses only a simple balanced homodyne technique, and intensity correlation. Thus interferometric schemes utilizing coherent or squeezed light, and parity detection may be practically implemented for an arbitrary photon flux. Specifically we investigate a two-mode, squeezed-light, Mach-Zehnder interferometer and show how the parity of the output state may be obtained. We also show that the detection may be described independent of the parity operator, and that this "parity-by-proxy" measurement has the same signal as traditional parity.

arXiv:1007.4176•New Journal of Physics•Nov 11, 2010•86 citations

Tunable passive squeezing of squeezed light through unbalanced double homodyne detection

Niels Tripier-Mondancin, David Barral, Ganaël Roeland +3 more

The full characterization of quantum states of light is a central task in quantum optics and information science. Double homodyne detection provides a powerful method for the direct measurement of the Husimi Q quasi-probability distribution, offering a complete state representation in a simple experimental setting and a limited time frame. Here, we demonstrate that double homodyne detection can serve as more than a passive characterization tool. By intentionally unbalancing the input beamsplitter that splits the quantum signal, we show that the detection scheme itself performs an effective squeezing or anti-squeezing transformation on the state being measured. The resulting measurement directly samples the Q function of the input state as if it were acted upon by a squeezing operator whose strength is a tunable experimental parameter: the beamsplitter's reflectivity. We experimentally realize this technique using a robust polarization-encoded double homodyne detection to characterize a squeezed vacuum state. Our results demonstrate the controlled deformation of the measured Q function's phase-space distribution, confirming that unbalanced double homodyne detection is a versatile tool for simultaneous quantum state manipulation and characterization.

quant-pharXiv:2512.08540•Optica Quantum•Dec 10, 2025•1 citation
Following a recent theoretical proposal [J. Fiur'a\ifmmode \check{s}\else \v{s}\fi{}ek and N. J. Cerf, Phys. Rev. Lett. 93, 063601 (2004)], we experimentally implement a scheme to measure the squeezing and purity of a single-mode squeezed vacuum state without an interferometric homodyne detection. The suggested setup is based on only a tunable beam splitter and a direct single-photon detector to fully characterize the generated Gaussian states. We discuss the experimental implementation of this procedure and compare it to other reference methods. A detailed exploitation of our results highlights some practical limitations of this method. This experimental work is followed by a detailed numerical analysis to derive the conditions required for the procedure to succeed. In particular, it is found that an overall single-photon detection efficiency of about 50% is needed, which is difficult to achieve in the present experiment.
We propose a feasible optical setup allowing for a loophole-free Bell test with efficient homodyne detection. A non-Gaussian entangled state is generated from a two-mode squeezed vacuum by subtracting a single photon from each mode, using beam splitters and standard low-efficiency single-photon detectors. A Bell violation exceeding 1% is achievable with 6 dB squeezed light and a homodyne efficiency around 95%. A detailed feasibility analysis, based upon the recent experimental generation of single-mode non-Gaussian states, suggests that this method opens a promising avenue towards a complete experimental Bell test.
We propose a feasible optical setup allowing for a loophole‐free Bell test with efficient homodyne detection. A non‐Gaussian entangled state is generated from a two‐mode squeezed vacuum by subtracting a single photon from each mode, using beam splitters and standard low‐efficiency single‐photon detectors. A Bell violation exceeding 1% is achievable with 6 dB of squeezing, a photodetector efficiency around 10%, and an homodyne efficiency around 95%. A feasibility analysis, based upon the recent generation of single‐mode non‐Gaussian states via photon subtraction, suggests that this method opens a promising avenue towards a complete experimental Bell test.
We provide a detailed analysis of the recently proposed setup for a loophole-free test of Bell inequality violation using conditionally generated non-Gaussian states of light and balanced homodyning. In the proposed scheme, a two-mode squeezed vacuum state is de-Gaussified by subtracting a single photon from each mode with the use of an unbalanced beam splitter and a standard low-efficiency single-photon detector. We thoroughly discuss the tolerance of the achievable Bell violation in the various experimentally relevant parameters such as the detector efficiencies, the electronic noise, the mixedness of the initial Gaussian state, and the probability of false triggers. We also consider several alternative schemes involving squeezed states, linear optical elements, conditional photon subtraction, and homodyne detection.
We present a method of directly obtaining the parity of a Gaussian state of light without recourse to photon-number counting. The scheme uses only a simple balanced homodyne technique, and intensity correlation. Thus interferometric schemes utilizing coherent or squeezed light, and parity detection may be practically implemented for an arbitrary photon flux. Specifically we investigate a two-mode, squeezed-light, Mach-Zehnder interferometer and show how the parity of the output state may be obtained. We also show that the detection may be described independent of the parity operator, and that this "parity-by-proxy" measurement has the same signal as traditional parity.
The full characterization of quantum states of light is a central task in quantum optics and information science. Double homodyne detection provides a powerful method for the direct measurement of the Husimi Q quasi-probability distribution, offering a complete state representation in a simple experimental setting and a limited time frame. Here, we demonstrate that double homodyne detection can serve as more than a passive characterization tool. By intentionally unbalancing the input beamsplitter that splits the quantum signal, we show that the detection scheme itself performs an effective squeezing or anti-squeezing transformation on the state being measured. The resulting measurement directly samples the Q function of the input state as if it were acted upon by a squeezing operator whose strength is a tunable experimental parameter: the beamsplitter's reflectivity. We experimentally realize this technique using a robust polarization-encoded double homodyne detection to characterize a squeezed vacuum state. Our results demonstrate the controlled deformation of the measured Q function's phase-space distribution, confirming that unbalanced double homodyne detection is a versatile tool for simultaneous quantum state manipulation and characterization.