Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:quant-ph/0209083

Dynamical maps and measurements

Aik-meng Kuah, E. C. G. Sudarshan

Published Sep 13, 2002• 3 citations
arXivHTMLPDF

Abstract

We show how a set of POVMs, expressed as a set of $μ$ linear maps, can be performed with a unitary transformation followed by a von-Neumann measurement with an ancillary system of no more than $μN^2$ dimensions. This result shows that all generalized linear transformations and measurements on density matrices can be performed by unitary transformations and von-Neumann measurements by coupling a suitably large ancillary system.

DOI
10.48550/arxiv.quant-ph/0209083

Related papers

Quantum measurements

E. Desurvire

This chapter is concerned with the measure of quantum states . This requires one to introduce the subtle notion of quantum measurement , an operation that has no counterpart in the classical domain. To this effect, we first need to develop some new tools, starting with Dirac notation , a formalism that is not only very elegant but is relatively simple to handle. The introduction of Dirac notation makes it possible to become familiar with the inner product for quantum states, as well as different properties for operators and states concerning projection , change of basis , unitary transformations , matrix elements , similarity transformations , eigenvalues and eigenstates , spectral decomposition and diagonal representation , matrix trace and density operator or matrix . The concept of density matrix makes it possible to provide a very first and brief hint of the analog of Shannon's entropy in the quantum world, referred to as von Neumann's entropy , to be further developed in Chapter 21. Once we have all the required tools, we can focus on quantum measurement and analyze three different types referred to as basis-state measurements , projection or von Neumann measurements , and POVM measurements. In particular, POVM measurements are shown to possess a remarkable property of unambiguous quantum state discrimination (UQSD), after which it is possible to derive “absolutely certain” information from unknown system states. The more complex case of quantum measurements in composite systems described by joint or tensor states is then considered.

Cambridge University Press eBooks•Feb 19, 2009•0 citations

Entanglement Assisted Quantum Communication Schemes

Z. Kurucz

Positive operator valued measurements (POVMs) are the most general measurements that can be performed on quantum systems.A POVM is described by set of positive operators instead of orthogonal projections, and it can always be traced back to joint von Neumann measurements on the system and on an ancilla attached to it (Busch et. al, 1991;Peres, 1993).* Note on nomenclature: subscript letters denote the appropriate state spaces for vectors and density operators throughout the document.The same symbol with different subscripts intends to mean that the same quantum information is represented on different systems.

•Nov 23, 2007•0 citations

The von Neumann model of measurement in quantum mechanics

Pier A. Mello

We describe how to obtain information on a quantum-mechanical system by coupling it to a probe and detecting some property of the latter, using a model introduced by von Neumann, which describes the interaction of the system proper with the probe in a dynamical way. We first discuss single measurements, where the system proper is coupled to one probe with arbitrary coupling strength. The goal is to obtain information on the system detecting the probe position. We find the reduced density operator of the system, and show how Lüders rule emerges as the limiting case of strong coupling. The von Neumann model is then generalized to two probes that interact successively with the system proper. Now we find information on the system by detecting the position-position and momentum-position correlations of the two probes. The so-called "Wigner's formula" emerges in the strong-coupling limit, while "Kirkwood's quasi-probability distribution" is found as the weak-coupling limit of the above formalism. We show that successive measurements can be used to develop a state-reconstruction scheme. Finally, we find a generalized transform of the state and the observables based on the notion of successive measurements.

arXiv:1311.7649•AIP conference proceedings•Jan 1, 2014•15 citations

Dynamical model for positive-operator-valued measures

Antonella De Pasquale, Caterina Foti, Alessandro Cuccoli +2 more

We tackle the dynamical description of the quantum measurement process by explicitly addressing the interaction between the system under investigation and the measurement apparatus, the latter ultimately considered as a macroscopic quantum object. We consider arbitrary positive-operator-valued measures (POVMs) such that the orthogonality constraint on the measurement operators is relaxed. We show that, as with the well-known von Neumann scheme for projective measurements, it is possible to build up a dynamical model holding a unitary propagator characterized by a single time-independent Hamiltonian. This is achieved by modifying the standard model so as to compensate for the possible lack of orthogonality among the measurement operators of arbitrary POVMs.

arXiv:1902.03628•Physical Review A•Jul 26, 2019•4 citations

A MATHEMATICAL REALIZATION OF VON NEUMANN’S MEASUREMENT SCHEME

Masanari Asano, Masanori Ohya, Yuta Yamamori

In this chapter, we give a mathematical representation of von Neumann’s view on quantum measurement process, in which, a system to be measured interacts with infinite chain of measurement apparatus [1]. For the system, the measurement apparatus is an environment, and increase of degree of freedom in the environment is the cause of quantum decoherence of the system. We clearly represent this essential aspect in the background of quantum measurement by using lifting maps [3, 2]. A sequence of lifting maps realizes a unitary time evolution consistent with von Neumann’s scheme.

Lecture notes series, Institute For Mathematical Sciences•Aug 25, 2017•0 citations

Quantum states, maps, measurements and entanglement

Aik-meng Kuah

The structure of the set of density matrices, its linear transformations, generalized linear measurements, and entanglement are studied. The set of density matrices is shown to be a convex and stratified set with simplex and group symmetries. Generalized measurements for density matrices are shown to be reducible to one unitary transformation and one von Neumann measurement carried out with an ancillary system of fixed size. Linear maps of density matrices are considered and the volume of the set of maps is derived. Positive but not completely positive maps are studied in consideration of obtaining a test for entanglement in density matrices. Using the Jamiolkowski representation and Schmidt decomposition of the map eigen matrices, several properties of these maps are shown. An algebraic approach to constructing these positive but not completely positive maps is partially formulated. The positivity of the linear map describing the evolution of an open system and its dependence on the initialized to a zero-discord state, the evolution is shown to be given by a completely positive map. In quantum process tomography, the results obtained from a open system that is initially prepared using von Neumann measurements is shown to be described by a bi-linear map, not a linear map. A method for quantum process tomography is derived for qubit bi-linear maps. The difference between preparing states for an experiment by measurement and by stochastic process is analyzed, and it is shown that the two different methods will give fundamentally different outcomes.

•May 1, 2007•1 citation
We show how a set of POVMs, expressed as a set of μμμ linear maps, can be performed with a unitary transformation followed by a von-Neumann measurement with an ancillary system of no more than μN2μN^2μN2 dimensions. This result shows that all generalized linear transformations and measurements on density matrices can be performed by unitary transformations and von-Neumann measurements by coupling a suitably large ancillary system.
This chapter is concerned with the measure of quantum states . This requires one to introduce the subtle notion of quantum measurement , an operation that has no counterpart in the classical domain. To this effect, we first need to develop some new tools, starting with Dirac notation , a formalism that is not only very elegant but is relatively simple to handle. The introduction of Dirac notation makes it possible to become familiar with the inner product for quantum states, as well as different properties for operators and states concerning projection , change of basis , unitary transformations , matrix elements , similarity transformations , eigenvalues and eigenstates , spectral decomposition and diagonal representation , matrix trace and density operator or matrix . The concept of density matrix makes it possible to provide a very first and brief hint of the analog of Shannon's entropy in the quantum world, referred to as von Neumann's entropy , to be further developed in Chapter 21. Once we have all the required tools, we can focus on quantum measurement and analyze three different types referred to as basis-state measurements , projection or von Neumann measurements , and POVM measurements. In particular, POVM measurements are shown to possess a remarkable property of unambiguous quantum state discrimination (UQSD), after which it is possible to derive “absolutely certain” information from unknown system states. The more complex case of quantum measurements in composite systems described by joint or tensor states is then considered.
Positive operator valued measurements (POVMs) are the most general measurements that can be performed on quantum systems.A POVM is described by set of positive operators instead of orthogonal projections, and it can always be traced back to joint von Neumann measurements on the system and on an ancilla attached to it (Busch et. al, 1991;Peres, 1993).* Note on nomenclature: subscript letters denote the appropriate state spaces for vectors and density operators throughout the document.The same symbol with different subscripts intends to mean that the same quantum information is represented on different systems.
We describe how to obtain information on a quantum-mechanical system by coupling it to a probe and detecting some property of the latter, using a model introduced by von Neumann, which describes the interaction of the system proper with the probe in a dynamical way. We first discuss single measurements, where the system proper is coupled to one probe with arbitrary coupling strength. The goal is to obtain information on the system detecting the probe position. We find the reduced density operator of the system, and show how Lüders rule emerges as the limiting case of strong coupling. The von Neumann model is then generalized to two probes that interact successively with the system proper. Now we find information on the system by detecting the position-position and momentum-position correlations of the two probes. The so-called "Wigner's formula" emerges in the strong-coupling limit, while "Kirkwood's quasi-probability distribution" is found as the weak-coupling limit of the above formalism. We show that successive measurements can be used to develop a state-reconstruction scheme. Finally, we find a generalized transform of the state and the observables based on the notion of successive measurements.
We tackle the dynamical description of the quantum measurement process by explicitly addressing the interaction between the system under investigation and the measurement apparatus, the latter ultimately considered as a macroscopic quantum object. We consider arbitrary positive-operator-valued measures (POVMs) such that the orthogonality constraint on the measurement operators is relaxed. We show that, as with the well-known von Neumann scheme for projective measurements, it is possible to build up a dynamical model holding a unitary propagator characterized by a single time-independent Hamiltonian. This is achieved by modifying the standard model so as to compensate for the possible lack of orthogonality among the measurement operators of arbitrary POVMs.
In this chapter, we give a mathematical representation of von Neumann’s view on quantum measurement process, in which, a system to be measured interacts with infinite chain of measurement apparatus [1]. For the system, the measurement apparatus is an environment, and increase of degree of freedom in the environment is the cause of quantum decoherence of the system. We clearly represent this essential aspect in the background of quantum measurement by using lifting maps [3, 2]. A sequence of lifting maps realizes a unitary time evolution consistent with von Neumann’s scheme.
The structure of the set of density matrices, its linear transformations, generalized linear measurements, and entanglement are studied. The set of density matrices is shown to be a convex and stratified set with simplex and group symmetries. Generalized measurements for density matrices are shown to be reducible to one unitary transformation and one von Neumann measurement carried out with an ancillary system of fixed size. Linear maps of density matrices are considered and the volume of the set of maps is derived. Positive but not completely positive maps are studied in consideration of obtaining a test for entanglement in density matrices. Using the Jamiolkowski representation and Schmidt decomposition of the map eigen matrices, several properties of these maps are shown. An algebraic approach to constructing these positive but not completely positive maps is partially formulated. The positivity of the linear map describing the evolution of an open system and its dependence on the initialized to a zero-discord state, the evolution is shown to be given by a completely positive map. In quantum process tomography, the results obtained from a open system that is initially prepared using von Neumann measurements is shown to be described by a bi-linear map, not a linear map. A method for quantum process tomography is derived for qubit bi-linear maps. The difference between preparing states for an experiment by measurement and by stochastic process is analyzed, and it is shown that the two different methods will give fundamentally different outcomes.