Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:quant-ph/0207055 · Journal of Modern Optics

Experimental investigation of a coherent quantum measurement of the degree of polarization of a single-mode light beam

Matthieu Legré, Mark Wegmüller, N. Gisin

Published Jan 1, 2003• 2 citations
arXivHTMLPDF

Abstract

A novel method for the direct measurement of the degree of polarization is described. It is one of the first practical implementations of a coherent quantum measurement, the projection on the singlet state. Our first results demonstrate the successful operation of the method. However, because of the nonlinear crystals used at present, its application is limited to spectral widths larger than about 8 nm.

DOI
10.1080/09500340308235513

Related papers

Quantum Measurement of the Degree of Polarization of a Light Beam

Matthieu Legré, Mark Wegmüller, Nicolas Gisin

We demonstrate a coherent quantum measurement for the determination of the degree of polarization (DOP). This method allows us to measure the DOP in the presence of fast polarization state fluctuations, difficult to achieve with the typically used polarimetric technique. A good precision of the DOP measurements is obtained using eight type II nonlinear crystals assembled for spatial walk-off compensation.

arXiv:quant-ph/0305019•Physical Review Letters•Oct 16, 2003•19 citations

Coherent quantum measurement for the direct determination of the degree of polarization and polarization mode dispersion compensation

Nicolas Gisin

An example of a coherent measurement for the direct evaluation of the degree of polarization of a single-mode optical beam is presented. It is applied to the case of great practical importance where depolarization is caused by polarization mode dispersion. It is demonstrated that coherent measurement has the potential of significantly increasing the information gain, compared to standard incoherent measurements.

arXiv:quant-ph/0010036•Journal of Modern Optics•Jul 1, 2001•12 citations

Measuring arbitrary-order coherences: Tomography of single-mode multiphoton polarization-entangled states

U. Schilling, Joachim von Zanthier, G. S. Agarwal

A scheme is discussed for measuring $N$th-order coherences of two orthogonally polarized light fields in a single spatial mode at very limited experimental cost. To implement the scheme, the only measurements needed are the $N$th-order intensity moments after the light beam has passed through two quarter-wave plates, one half-wave plate, and a polarizing beam splitter for specific settings of the wave plates. It is shown that this method can be applied for arbitrarily large $N$. A set of explicit values is given for the settings of the wave plates, constituting an optimal measurement of the $N$th-order coherences for any $N$. For Fock states the method introduced here corresponds to a full state tomography. Applications of the scheme to systems other than polarization optics are discussed.

arXiv:0908.1662•Physical Review A•Jan 26, 2010•30 citations

Exploiting Symmetry in the Production and Measurement of Photon Pairs

Rebecca Y. Saaltink

We present two projects that exploit symmetry to produce and measure photon pairs. In the first project, we propose a method for directly producing radially and azimuthally polarized photon pairs through spontaneous parametric downconversion (SPDC). This method constitutes a novel geometry for SPDC in which a radially polarized Bessel-Gauss pump beam is directed into a nonlinear crystal, with the central propagation direction parallel to the crystal axis. We model and plot the spatial and polarization distributions for Type-I and Type-II phasematching. In the second project, we demonstrate experimentally a method to measure the polarization state of single photons through direct measurements performed on optimal quantum clones. We produce these optimal quantum clones on a non-polarizing beam splitter and interfere the outputs of this beam splitter in a displaced Sagnac interferometer. By performing orthogonal polarization measurements on these two photons, we reconstruct the density matrix for input states H and R.

•Jan 1, 2017•0 citations

Integrated optical waveguides for quantum photon gates at a wavelength of 810 nm

V. M. Petrov, Mikhail V. Parfenov, Aleksandr V. Tronev +2 more

Subject of study. The optical losses in waveguides designed for creating quantum photon gates at a wavelength of 810 nm were investigated. Aim of study. The aim of the study was to create integrated optical single-mode waveguides for quantum photon gates at a wavelength of 810 nm and to estimate optical losses acceptable for maintaining the necessary degree of photon-pair entanglement. Method. The waveguides were manufactured through thermal diffusion of titanium ions into a substrate composed of an X-slice of nominally pure lithium niobate (LiNbO3). Optical losses were estimated by experimentally measuring the loss per unit length of the waveguide. Optical radiation was coupled into and out of the waveguide using fiber segments, with one end connected and the other cleaved. A drop of immersion liquid was applied between the cleaved fiber and waveguide end, and measurements were performed for both polarization modes. Main results. Six groups of samples were produced, each containing waveguides with strip widths of d=3.0, 2.0, and 1.5 µm. The measured optical losses in the manufactured waveguides indicated that those with a titanium strip width of d≈3 µm exhibited the lowest losses. The estimated minimum optical losses for transverse magnetic and transverse electric polarization were approximately 0.20–0.25 and 0.1 dB/cm, respectively. Practical significance. The waveguides manufactured with a strip width of approximately 3 µm can be used to create quantum photonic gates in an integrated optical design. The chosen wavelength of 810 nm offers potential for near-future development of photonic gates, as one of the most accessible methods for generating entangled photon pairs involves using a 405-nm laser followed by wavelength doubling through a nonlinear beta-barium borate crystal.

Journal of Optical Technology•Jun 1, 2024•0 citations

Experimental determination of the degree of polarization of quantum states

Christian Kothe, Lars S. Madsen, Ulrik L. Andersen +1 more

We demonstrate experimental excitation-manifold-resolved polarization characterization of quantum states of light ranging from the few-photon to the many-photon level. In contrast to the traditional characterization of polarization that is based on the Stokes parameters, we experimentally determine the Stokes vector of each excitation manifold separately. Only for states with a given photon number do the methods coincide. For states with an indeterminate photon number, for example Gaussian states, the employed method gives a richer and more accurate description. We apply the method both in theory and in experiment to some common states to demonstrate its advantages.

arXiv:1207.6366•Physical Review A•Apr 15, 2013•12 citations
A novel method for the direct measurement of the degree of polarization is described. It is one of the first practical implementations of a coherent quantum measurement, the projection on the singlet state. Our first results demonstrate the successful operation of the method. However, because of the nonlinear crystals used at present, its application is limited to spectral widths larger than about 8 nm.
A scheme is discussed for measuring NNNth-order coherences of two orthogonally polarized light fields in a single spatial mode at very limited experimental cost. To implement the scheme, the only measurements needed are the NNNth-order intensity moments after the light beam has passed through two quarter-wave plates, one half-wave plate, and a polarizing beam splitter for specific settings of the wave plates. It is shown that this method can be applied for arbitrarily large NNN. A set of explicit values is given for the settings of the wave plates, constituting an optimal measurement of the NNNth-order coherences for any NNN. For Fock states the method introduced here corresponds to a full state tomography. Applications of the scheme to systems other than polarization optics are discussed.
We present two projects that exploit symmetry to produce and measure photon pairs. In the first project, we propose a method for directly producing radially and azimuthally polarized photon pairs through spontaneous parametric downconversion (SPDC). This method constitutes a novel geometry for SPDC in which a radially polarized Bessel-Gauss pump beam is directed into a nonlinear crystal, with the central propagation direction parallel to the crystal axis. We model and plot the spatial and polarization distributions for Type-I and Type-II phasematching. In the second project, we demonstrate experimentally a method to measure the polarization state of single photons through direct measurements performed on optimal quantum clones. We produce these optimal quantum clones on a non-polarizing beam splitter and interfere the outputs of this beam splitter in a displaced Sagnac interferometer. By performing orthogonal polarization measurements on these two photons, we reconstruct the density matrix for input states H and R.
Subject of study. The optical losses in waveguides designed for creating quantum photon gates at a wavelength of 810 nm were investigated. Aim of study. The aim of the study was to create integrated optical single-mode waveguides for quantum photon gates at a wavelength of 810 nm and to estimate optical losses acceptable for maintaining the necessary degree of photon-pair entanglement. Method. The waveguides were manufactured through thermal diffusion of titanium ions into a substrate composed of an X-slice of nominally pure lithium niobate (LiNbO3). Optical losses were estimated by experimentally measuring the loss per unit length of the waveguide. Optical radiation was coupled into and out of the waveguide using fiber segments, with one end connected and the other cleaved. A drop of immersion liquid was applied between the cleaved fiber and waveguide end, and measurements were performed for both polarization modes. Main results. Six groups of samples were produced, each containing waveguides with strip widths of d=3.0, 2.0, and 1.5 µm. The measured optical losses in the manufactured waveguides indicated that those with a titanium strip width of d≈3 µm exhibited the lowest losses. The estimated minimum optical losses for transverse magnetic and transverse electric polarization were approximately 0.20–0.25 and 0.1 dB/cm, respectively. Practical significance. The waveguides manufactured with a strip width of approximately 3 µm can be used to create quantum photonic gates in an integrated optical design. The chosen wavelength of 810 nm offers potential for near-future development of photonic gates, as one of the most accessible methods for generating entangled photon pairs involves using a 405-nm laser followed by wavelength doubling through a nonlinear beta-barium borate crystal.
We demonstrate experimental excitation-manifold-resolved polarization characterization of quantum states of light ranging from the few-photon to the many-photon level. In contrast to the traditional characterization of polarization that is based on the Stokes parameters, we experimentally determine the Stokes vector of each excitation manifold separately. Only for states with a given photon number do the methods coincide. For states with an indeterminate photon number, for example Gaussian states, the employed method gives a richer and more accurate description. We apply the method both in theory and in experiment to some common states to demonstrate its advantages.