Atom interferometers using Bose-Einstein condensate that is confined in a waveguide and manipulated by optical pulses have been limited by their short coherence times. We present a theoretical model that offers a physically simple explanation for the loss of contrast and propose the method for increasing the fringe contrast by recombining the atoms at a different time. A simple, quantitatively accurate, analytical expression for the optimized recombination time is presented and used to place limits on the physical parameters for which the contrast may be recovered.
Atom interferometers using Bose-Einstein condensate that is confined in a waveguide and manipulated by optical pulses have been limited by their short coherence times. We present a theoretical model that offers a physically simple explanation for the loss of contrast and propose the method for increasing the fringe contrast by recombining the atoms at a different time. A simple, quantitatively accurate, analytical expression for the optimized recombination time is presented and used to place limits on the physical parameters for which the contrast may be recovered.
Atom interferometers and gyroscopes are highly sensitive atom-optical devices which are capable to measure inertial, gravitational, electric, and magnetic fields and to sense rotations. Theoretically, the signal-to-noise ratio of atomic gyroscopes is about a hundred billion times more than that of their optical counterparts for the same particle flux and the enclosed area. Ultra cold atoms from a Bose-Einstein condensate (BEC) can easily be controlled and coherently manipulated on small chips by laser pulses. Atom-optical devices will therefore play a significant role in fundamental research, precision measurements, and navigation systems. In BEC-based atom interferometers, a BEC in a trap is split by using laser pulses, the split clouds are allowed to evolve, they are reflected, and then recombined by laser pulses to observe interference. The split clouds accumulate spatial phase because of the trap and the nonlinearity caused by atom-atom interactions. A velocity mismatch due to reflection laser pulses also introduces a phase gradient across each cloud. These factors contribute to spatial relative phase between the clouds at recombination, causing the loss of contrast of the interference fringes. The main objective of this dissertation is to study the dynamics of a split condensate in atom Michelson interferometers, investigate the effect of trap frequencies, nonlinearity, and the velocity mismatch on the contrast, and to obtain the best theoretical limit of performance in terms of the experimental parameters: trap frequencies, number of atoms, and the velocity imparted to the clouds by the splitting laser pulses.
An atom interferometer is a sensitive device that has potential for many useful applications. Atoms are sensitive to electromagnetic fields due to their electric and magnetic moments and their mass allows them to be deflected in a gravitational field, thereby making them attractive for measuring inertial forces. The narrow momentum distribution of Bose-Einstein condensate (BEC) is a great asset in realizing portable atom interferometers. An example is a guided-wave atom interferometer that uses a confining potential to guide the motion of the condensate. Despite the promise of guided-wave atom interferometry with BEC, spatial phase and phase diffusion limit the contrast of the interference fringes. The control of these phases is required for successful development of a BEC-based guided-wave atom interferometer. This thesis analyses the guided-wave atom interferometer, where an atomic BEC cloud at the center of a confining potential is split into two clouds that move along different arms of the interferometer. The clouds accumulate relative phase due to the environment, spatially inhomogeneous trapping potential and atom-atom interactions within the condensate. At the end of the interferometric cycle, the clouds are recombined producing a cloud at rest and moving clouds. The number of atoms in the clouds that emerge depends on the relative phase accumulated by the clouds during propagation. This is investigated by deriving an expression for the probability of finding any given number of atoms in the clouds that emerge after recombination. Characteristic features like mean, standard deviation and cross-correlation function of the probability density distribution are calculated and the contrast of the interference fringes is optimized. This thesis found that optimum contrast is achieved through the control of total population of atoms in the condensate, trap frequencies, s-wave scattering length, and the duration of the interferometric cycle.
The role of source cloud spatial coherence in a Mach-Zehnder-type atom interferometer is experimentally investigated. The visibility and contrast of a Bose-Einstein condensate (BEC) and three thermal sources with varying spatial coherence are compared as a function of interferometer time. At short times, the fringe visibility of a BEC source approaches 100 nearly independent of $\ensuremath{\pi}$ pulse efficiency, while thermal sources have fringe visibilities limited to the $\ensuremath{\pi}$ pulse efficiency. More importantly for precision measurement systems, the BEC source maintains interference at interferometer times significantly beyond the thermal source.
Interferometry with trapped atomic Bose-Einstein condensates (BECs) requires the development of techniques to recombine the two paths of the interferometer and map the accumulated phase difference to a measurable atom number difference. We have implemented and compared two recombining procedures in a double-well-based BEC interferometer. The first procedure utilizes the bosonic Josephson effect and controlled tunneling of atoms through the potential barrier, similar to laser light in an optical fiber coupler. The second one relies on the interference of the reflected and transmitted parts of the BEC wave function when impinging on the potential barrier, analogous to light impinging on a half-silvered mirror. Both schemes were implemented successfully, yielding an interferometric contrast of $\ensuremath{\sim}20$% and 42% respectively. Building efficient matter-wave recombiners represents an important step towards the coherent manipulation of external quantum superposition states of BECs.
Precision interferometry with atomic wavepackets confined in a one-dimensional optical lattice is an emergent paradigm in quantum sensing of forces and fields, with applications in gravimetry, accelerometry, geophysics, and fundamental physics tests. We report on the realization of a lattice-trapped interferometer where the two arms are sourced from a weakly-interacting ytterbium Bose-Einstein condensate, coherently split and trapped by pulsed optical standing waves before recombination. We directly observe atomic interactions through contrast changes and phase shifts of the interferometer. By changing either the atom number or the sample volume to vary the density, we demonstrate control over interactions and optimize interferometer performance. Our observations are effectively captured by a mean-field theoretical model of the system. This work experimentally probes the boundary where improved performance from source brightening through higher phase space density transitions into a regime beyond single-atom physics in lattice-trapped atom interferometry, and opens a door to incorporating many-body effects for metrological advances in such platforms.
This chapter describes the Bose--Einstein condensate (BEC) interferometry. We first introduce the optical interferometer, briefly discussing the role of fringe contrast in observing interference patterns. Next, we examine a BEC interferometer in a Michelson geometry that consists of a BEC in a trapping potential well. The BEC cloud in the potential well is put into a linear superposition of two clouds that travel along different paths in the trap and are recombined using the same light beams. By studying the population of atoms in the different motional states of the BEC clouds that emerge after recombination, we obtain information about the relative phase shift accumulated by the two traveling superposed condensates during the interferometry. We then characterize the atom distribution that is found in the output of the interferometer by finding the probability density distribution and calculating the features of the probability density such as the mean, the variance, and the interference fringe contrast. Finally, we parameterize the effect of two-body collisional interactions on the observed interference fringes in a way that can be directly controlled in an experiment.