Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:cond-mat/0612692 · Physical Review B

Quantum measurement characteristics of a double-dot single electron transistor

HuJun Jiao, Xin-Qi Li, JunYan Luo

Published Apr 26, 2007• 19 citations
arXivHTMLPDF

Abstract

Owing to a few unique advantages, the double-dot single electron transistor has been proposed as an alternative detector for charge states. In this work, we present a further study for its signal-to-noise property, based on a full analysis of the setup configuration symmetry. It is found that the effectiveness of the double-dot detector can approach that of an ideal detector, if the symmetric capacitive coupling is taken into account. The quantum measurement efficiency is also analyzed by comparing the measurement time with the measurement-induced dephasing time.

DOI
10.1103/physrevb.75.155333

Related papers

Qubit detection with a T-shaped double quantum dot detector

JunYan Luo, HuJun Jiao, Jing Hu +3 more

We propose to continuously monitor a charge qubit by utilizing a T-shaped double quantum dot detector, in which the qubit and double dot are arranged in such a unique way that the detector turns out to be particularly susceptible to the charge states of the qubit. Special attention is paid to the regime where acquisition of qubit information and backaction upon the measured system exhibit nontrivial correlation. The intrinsic dynamics of the qubit gives rise to dynamical blockade of tunneling events through the detector, resulting in a super-Poissonian noise. However, such a pronounced enhancement of the detector's shot noise does not necessarily produce a rising dephasing rate. In contrast, an inhibition of dephasing is entailed by the reduction of information acquisition in the dynamically blockaded regimes. We further reveal the important impact of the charge fluctuations on the measurement characteristics. Noticeably, under the condition of symmetric junction capacitances the noise pedestal of the circuit current is completely suppressed, leading to a divergent signal-to-noise ratio, and eventually to a violation of the Korotkov-Averin bound in quantum measurement. Our study offers the possibility for a double dot detector to reach the quantum limited effectiveness in a transparent manner.

arXiv:1501.00570•Physical Review B•Jul 7, 2015•5 citations

Controlled Dephasing and Measurement Efficiency via Quantum Dot Detector

Gyong Luck Khym, Youngnae Lee, Kicheon Kang

We study charge detection and controlled dephasing of a mesoscopic system via a quantum dot detector (QDD), where the mesoscopic system and the QDD are capacitively coupled. The QDD is considered to have coherent resonant tunnelling via a single level. It is found that the dephasing rate is proportional to the square of the conductance of the QDD for the Breit-Wigner model, showing that the dephasing is completely different from the shot noise of the detector. The measurement rate, on the other hand, shows a dip near the resonance. Our findings are peculiar especially for a symmetric detector in the following aspect: The dephasing rate is maximum at resonance of the QDD where the detector conductance is insensitive to the charge state of the mesoscopic system. As a result, the efficiency of the detector shows a dip and vanishes at resonance, in contrast to the single-channel symmetric non-resonant detector that has always a maximum efficiency. We find that this difference originates from a very general property of the scattering matrix: The abrupt phase change exists in the scattering amplitudes in the presence of the symmetry, which is insensitive to the detector current but {\em stores} the information of the quantum state of the mesoscopic system.

arXiv:cond-mat/0601535•Journal of the Physical Society of Japan•Jun 8, 2006•10 citations

Quantum Chip with the Optimized Tunnel Structure for Measuring a Charge Qubit Based on a Double Quantum Dot

Alexander V. Tsukanov, I. Yu. Kateev

Abstract A circuit of a measuring chip for determining an arbitrary pure state of a charge qubit is proposed. The strength of the current flowing through a single-electron transistor in the steady-state mode depends on the state of the qubit. To enhance the sensitivity of the transistor, its working part is built from three quantum dots (QDs) with the energy levels forming a symmetric configuration. The parameters of the system are calculated using a microscopic model of two-dimensional QDs. The time dependences of the population of the structure’s states are obtained and the current strength, sensitivity, and measuring contrast as functions of the geometric parameters of the system are determined. The effect of dissipative processes related to the acoustic phonons on the measurements is investigated and the rates of electron relaxation and dephasing in a two-level system are calculated.

Russian Microelectronics•Mar 1, 2020•6 citations

Theory of a double-dot charge detector

Tamás Geszti, József Zsolt Bernád

A double-quantum-dot charge detector, with one dot Coulomb coupled to the electron to be detected and the other modulated by a time-dependent plunger voltage, is analyzed in a minimal model. The signal and noise of the detector are calculated by a standard master equation and MacDonald formula technique. We find a dip in the noise spectrum at the double Rabi frequency of the double dot, defining the bandwidth available for detecting charges in motion.

arXiv:cond-mat/0602199•Physical Review B•Jun 23, 2006•9 citations

Double quantum dot coupled to a radio-frequency single-electron transistor: Quantum measurement and back action

Madhu Thalakulam

The radio-frequency superconducting single electron transistor (RF-SET) is a highly sensitive and fast electrometer operating near the quantum limit. The back-action current noise of the SET induces voltage fluctuations on the system it is coupled to, dephasing its charge states. Here we propose to study the back action of the RF-SET by means of a double quantum dot (DQD) and, an RF-SET electrostatically coupled to one of the two dots. The inelastic current through the DQD is very sensitive to the spectral density of the voltage fluctuations in the nearby environment. By properly choosing the dot size and inter-dot tunnel barrier thickness, one can cause inelastic process to dominate the transport processes. A measurement of the inelastic current through the double dot system can then be used to calculate the spectral density of noise associated with the RF-SET and hence its back action. The design, fabrication and characterization of an RF-SET/DQD system is discussed in this work. Real-time studies of electron dynamics in coupled dots are also addressed.

•Jan 1, 2004•0 citations

Resonant Cooper-Pair Tunneling: Quantum Noise and Measurement Characteristics

Aashish A. Clerk, S. M. Girvin, A. K. Nguyen +1 more

We study the quantum charge noise and measurement properties of the double Cooper-pair resonance point in a superconducting single-electron transistor (SSET) coupled to a Josephson charge qubit. Using a density-matrix approach for the coupled system, we obtain a full description of the measurement backaction; for weak coupling, this is used to extract the quantum charge noise. Unlike the case of a nonsuperconducting SET, the backaction here can induce population inversion in the qubit. We find that the Cooper-pair resonance process allows for a much better measurement than a similar nonsuperconducting SET, and can approach the quantum limit of efficiency.

arXiv:cond-mat/0203338•Physical Review Letters•Oct 8, 2002•90 citations
Owing to a few unique advantages, the double-dot single electron transistor has been proposed as an alternative detector for charge states. In this work, we present a further study for its signal-to-noise property, based on a full analysis of the setup configuration symmetry. It is found that the effectiveness of the double-dot detector can approach that of an ideal detector, if the symmetric capacitive coupling is taken into account. The quantum measurement efficiency is also analyzed by comparing the measurement time with the measurement-induced dephasing time.
We propose to continuously monitor a charge qubit by utilizing a T-shaped double quantum dot detector, in which the qubit and double dot are arranged in such a unique way that the detector turns out to be particularly susceptible to the charge states of the qubit. Special attention is paid to the regime where acquisition of qubit information and backaction upon the measured system exhibit nontrivial correlation. The intrinsic dynamics of the qubit gives rise to dynamical blockade of tunneling events through the detector, resulting in a super-Poissonian noise. However, such a pronounced enhancement of the detector's shot noise does not necessarily produce a rising dephasing rate. In contrast, an inhibition of dephasing is entailed by the reduction of information acquisition in the dynamically blockaded regimes. We further reveal the important impact of the charge fluctuations on the measurement characteristics. Noticeably, under the condition of symmetric junction capacitances the noise pedestal of the circuit current is completely suppressed, leading to a divergent signal-to-noise ratio, and eventually to a violation of the Korotkov-Averin bound in quantum measurement. Our study offers the possibility for a double dot detector to reach the quantum limited effectiveness in a transparent manner.
We study charge detection and controlled dephasing of a mesoscopic system via a quantum dot detector (QDD), where the mesoscopic system and the QDD are capacitively coupled. The QDD is considered to have coherent resonant tunnelling via a single level. It is found that the dephasing rate is proportional to the square of the conductance of the QDD for the Breit-Wigner model, showing that the dephasing is completely different from the shot noise of the detector. The measurement rate, on the other hand, shows a dip near the resonance. Our findings are peculiar especially for a symmetric detector in the following aspect: The dephasing rate is maximum at resonance of the QDD where the detector conductance is insensitive to the charge state of the mesoscopic system. As a result, the efficiency of the detector shows a dip and vanishes at resonance, in contrast to the single-channel symmetric non-resonant detector that has always a maximum efficiency. We find that this difference originates from a very general property of the scattering matrix: The abrupt phase change exists in the scattering amplitudes in the presence of the symmetry, which is insensitive to the detector current but {\em stores} the information of the quantum state of the mesoscopic system.
Abstract A circuit of a measuring chip for determining an arbitrary pure state of a charge qubit is proposed. The strength of the current flowing through a single-electron transistor in the steady-state mode depends on the state of the qubit. To enhance the sensitivity of the transistor, its working part is built from three quantum dots (QDs) with the energy levels forming a symmetric configuration. The parameters of the system are calculated using a microscopic model of two-dimensional QDs. The time dependences of the population of the structure’s states are obtained and the current strength, sensitivity, and measuring contrast as functions of the geometric parameters of the system are determined. The effect of dissipative processes related to the acoustic phonons on the measurements is investigated and the rates of electron relaxation and dephasing in a two-level system are calculated.
The radio-frequency superconducting single electron transistor (RF-SET) is a highly sensitive and fast electrometer operating near the quantum limit. The back-action current noise of the SET induces voltage fluctuations on the system it is coupled to, dephasing its charge states. Here we propose to study the back action of the RF-SET by means of a double quantum dot (DQD) and, an RF-SET electrostatically coupled to one of the two dots. The inelastic current through the DQD is very sensitive to the spectral density of the voltage fluctuations in the nearby environment. By properly choosing the dot size and inter-dot tunnel barrier thickness, one can cause inelastic process to dominate the transport processes. A measurement of the inelastic current through the double dot system can then be used to calculate the spectral density of noise associated with the RF-SET and hence its back action. The design, fabrication and characterization of an RF-SET/DQD system is discussed in this work. Real-time studies of electron dynamics in coupled dots are also addressed.
We study the quantum charge noise and measurement properties of the double Cooper-pair resonance point in a superconducting single-electron transistor (SSET) coupled to a Josephson charge qubit. Using a density-matrix approach for the coupled system, we obtain a full description of the measurement backaction; for weak coupling, this is used to extract the quantum charge noise. Unlike the case of a nonsuperconducting SET, the backaction here can induce population inversion in the qubit. We find that the Cooper-pair resonance process allows for a much better measurement than a similar nonsuperconducting SET, and can approach the quantum limit of efficiency.