Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:cond-mat/0505647 · Physical Review Letters

Counting Statistics and Detector Properties of Quantum Point Contacts

D. V. Averin, Eugene V. Sukhorukov

Published Sep 15, 2005• 80 citations
arXivHTMLPDF

Abstract

Quantum detector properties of the quantum point contact (QPC) are analyzed for an arbitrary electron transparency and coupling strength to the measured system and are shown to be determined by the electron counting statistics. Conditions of the quantum-limited operation of the QPC detector, which prevent information loss through the scattering time and scattering phases, are found for arbitrary coupling. We show that the phase information can be restored and used for the quantum-limited detection by inclusion of the QPC detector in the electronic Mach-Zehnder interferometer.

DOI
10.1103/physrevlett.95.126803

Related papers

Quantum measurement of an electron in a disordered potential: Delocalization versus measurement voltages

Xue-Ning Hu, Xin-Qi Li

Quantum point contact (QPC), one of the typical mesoscopic transport devices, has been suggested to be an efficient detector for quantum measurement. In the context of two-state charge qubit, our previous studies showed that the QPC's measurement back-action cannot be described by the conventional Lindblad quantum master equation. In this work, we study the measurement problem of a multistate system, say, an electron in disordered potential, subject to the quantum measurement of the mesoscopic detector QPC. The effect of measurement back-action and the detector's readout current are analyzed, where particular attention is focused on some new features and the underlying physics associated with the measurement-induced delocalization versus the measurement voltages.

arXiv:cond-mat/0603255•Physical Review B•Jan 19, 2006•4 citations

Quantum measurement of single electron state by a quantum point contact

Xue-Ning Hu, Xin-Qi Li, 中国科学院半导体研究所 超晶格和微结构国家重点实验室,北京 100083

Closely related to the quantum information processing in solid states, we study the quantum measurement of single electron state by a mesoscopic charge-sensitive detector, namely the quantum point contact (QPC). We find that the conventional Lindblad-type master equation is not appropriate for describing the underlying measurement dynamics. The treatment developed in this work properly accounts for the energy-exchange between the detector and the measured system, and its role on the detailed-balance relation. A valid description for the QPC measurement dynamics is provided which may have impact on the study of quantum measurement and quantum feedback control in solid states.

Acta Physica Sinica•Jan 1, 2006•2 citations

Entanglement of a double dot with a quantum point contact

Michael Steiner, R. W. Rendell

Entanglement between a particle and a detector is known to be inherent in the measurement process. Gurvitz recently analyzed the coupling of an electron in a double dot (DD) to a quantum point contact (QPC) detector. In this paper we examine the dynamics of entanglement that result between the DD and QPC. The rate of entanglement is optimized as a function of coupling when the electron is initially in one of the dots. It decreases asymptotically towards zero with increased coupling. The opposite behavior is observed when the DD is initially in a superposition: the rate of entanglement increases unboundedly as the coupling is increased. The possibility that there are conditions for which measurement occurs versus entanglement is considered.

arXiv:quant-ph/0009047•Physical Review A•Apr 13, 2001•2 citations

Anomalous conditional counting statistics in an electron-spin-resonance quantum dot measured by a quantum point contact

Yi Ding, Yiying Yan, Jing Hu +2 more

A detailed understanding of the full measurement statistics in experiments is the basis for thorough device characterization and advanced applications such as quantum metrology. In this spirit, we investigate the conditional counting statistics of an electron-spin-resonance pumped quantum dot (QD), which is tunnel-coupled to a side electrode and continuously monitored by a quantum point contact (QPC). For such a noninvasive detector, we find that the spin current through the QD and its related cumulants exhibit intriguing features and system parameter dependences when conditioned on the QPC current, which are in strong contrast to the unconditional cumulants. By turning the perspective around and considering the counting statistics of the QPC current conditioned on the QD current, we reveal an anomalous conditional QPC current noise, which is surprisingly suppressed for increasing coupling to the environment. Our results show that information backaction can substantially render statistical transport fluctuations. This unique advantage of the conditional counting statistics in probing the underlying correlations between system and detector, even for noninvasive measurements, can thus be employed for improving measurement protocols in quantum metrology.

Physical review. B./Physical review. B•Mar 18, 2024•4 citations

Measurement of two-qubit states with quantum point contacts coupled by a quantum dot

Tetsufumi Tanamoto, Xuedong Hu

We solve the master equations of two charge qubits measured by two serially coupled quantum point contacts (QPCs). We describe two-qubit dynamics by comparing entangled states with product states, and show that the QPC current can be used for reading out results of quantum calculations and providing evidences of two-qubit entanglement. We also calculate the concurrence of the two qubits as a function of dephasing rate that originates from the measurement. We conclude that coupled charge qubits can be effectively detected by a QPC-based detector.

arXiv:cond-mat/0310293•Journal of Physics Condensed Matter•Oct 14, 2005•7 citations

Quantum-limited charge detection with two quantum point contacts

Kang-Ho Lee, Kicheon Kang

We present a scheme for tuning two quantum point contacts as a quantum-limited charge detector. Based on the scattering matrix approach, we analyze a general condition of quantum-limited detection with a single-channel quantum detector possessing time-reversal symmetry. From this analysis we find that quantum-limited detection can be easily realized with two quantum point contacts connected in series, which is not possible if only a single quantum point contact is used. We also discuss the sensitivity enhancement due to multiple reflections of the two point contacts.

arXiv:1101.4784•Physical Review B•Jul 7, 2011•2 citations
Quantum detector properties of the quantum point contact (QPC) are analyzed for an arbitrary electron transparency and coupling strength to the measured system and are shown to be determined by the electron counting statistics. Conditions of the quantum-limited operation of the QPC detector, which prevent information loss through the scattering time and scattering phases, are found for arbitrary coupling. We show that the phase information can be restored and used for the quantum-limited detection by inclusion of the QPC detector in the electronic Mach-Zehnder interferometer.
Quantum point contact (QPC), one of the typical mesoscopic transport devices, has been suggested to be an efficient detector for quantum measurement. In the context of two-state charge qubit, our previous studies showed that the QPC's measurement back-action cannot be described by the conventional Lindblad quantum master equation. In this work, we study the measurement problem of a multistate system, say, an electron in disordered potential, subject to the quantum measurement of the mesoscopic detector QPC. The effect of measurement back-action and the detector's readout current are analyzed, where particular attention is focused on some new features and the underlying physics associated with the measurement-induced delocalization versus the measurement voltages.
Closely related to the quantum information processing in solid states, we study the quantum measurement of single electron state by a mesoscopic charge-sensitive detector, namely the quantum point contact (QPC). We find that the conventional Lindblad-type master equation is not appropriate for describing the underlying measurement dynamics. The treatment developed in this work properly accounts for the energy-exchange between the detector and the measured system, and its role on the detailed-balance relation. A valid description for the QPC measurement dynamics is provided which may have impact on the study of quantum measurement and quantum feedback control in solid states.
Entanglement between a particle and a detector is known to be inherent in the measurement process. Gurvitz recently analyzed the coupling of an electron in a double dot (DD) to a quantum point contact (QPC) detector. In this paper we examine the dynamics of entanglement that result between the DD and QPC. The rate of entanglement is optimized as a function of coupling when the electron is initially in one of the dots. It decreases asymptotically towards zero with increased coupling. The opposite behavior is observed when the DD is initially in a superposition: the rate of entanglement increases unboundedly as the coupling is increased. The possibility that there are conditions for which measurement occurs versus entanglement is considered.
A detailed understanding of the full measurement statistics in experiments is the basis for thorough device characterization and advanced applications such as quantum metrology. In this spirit, we investigate the conditional counting statistics of an electron-spin-resonance pumped quantum dot (QD), which is tunnel-coupled to a side electrode and continuously monitored by a quantum point contact (QPC). For such a noninvasive detector, we find that the spin current through the QD and its related cumulants exhibit intriguing features and system parameter dependences when conditioned on the QPC current, which are in strong contrast to the unconditional cumulants. By turning the perspective around and considering the counting statistics of the QPC current conditioned on the QD current, we reveal an anomalous conditional QPC current noise, which is surprisingly suppressed for increasing coupling to the environment. Our results show that information backaction can substantially render statistical transport fluctuations. This unique advantage of the conditional counting statistics in probing the underlying correlations between system and detector, even for noninvasive measurements, can thus be employed for improving measurement protocols in quantum metrology.
We solve the master equations of two charge qubits measured by two serially coupled quantum point contacts (QPCs). We describe two-qubit dynamics by comparing entangled states with product states, and show that the QPC current can be used for reading out results of quantum calculations and providing evidences of two-qubit entanglement. We also calculate the concurrence of the two qubits as a function of dephasing rate that originates from the measurement. We conclude that coupled charge qubits can be effectively detected by a QPC-based detector.
We present a scheme for tuning two quantum point contacts as a quantum-limited charge detector. Based on the scattering matrix approach, we analyze a general condition of quantum-limited detection with a single-channel quantum detector possessing time-reversal symmetry. From this analysis we find that quantum-limited detection can be easily realized with two quantum point contacts connected in series, which is not possible if only a single quantum point contact is used. We also discuss the sensitivity enhancement due to multiple reflections of the two point contacts.