We present clear numerical evidence for the coexistence of metallic and insulating dynamical mean-field theory (DMFT) solutions in a half-filled single-band Hubbard model at finite temperature. The quantum Monte Carlo (QMC) method is used to solve the DMFT equation. We discuss important technical aspects of the DMFT-QMC method, which should be properly dealt with in order to obtain reliable DMFT solutions at low temperatures. Among these technical aspects are the critical slowing down near the boundaries of the coexistence region, the convergence criteria for the DMFT iterations, and the correct interpolation of the discretized Green's functions.
We present clear numerical evidence for the coexistence of metallic and insulating dynamical mean-field theory (DMFT) solutions in a half-filled single-band Hubbard model at finite temperature. The quantum Monte Carlo (QMC) method is used to solve the DMFT equation. We discuss important technical aspects of the DMFT-QMC method, which should be properly dealt with in order to obtain reliable DMFT solutions at low temperatures. Among these technical aspects are the critical slowing down near the boundaries of the coexistence region, the convergence criteria for the DMFT iterations, and the correct interpolation of the discretized Green's functions.
In this paper, I discuss the finite-temperature metal-insulator transition of the paramagnetic Hubbard model within dynamical mean-field theory. I show that coexisting solutions, the hallmark of such a transition, can be obtained in a consistent way both from quantum Monte Carlo (QMC) simulations and from the exact diagonalization method. I pay special attention to discretization errors within the QMC method. These errors explain why it is difficult to obtain the solutions from the QMC method close to the boundaries of the coexistence region.
We employ dynamical mean-field theory (DMFT) with a quantum Monte Carlo atomic solver to investigate the finite-temperature Mott transition in the Hubbard model with nearest-neighbor hopping on a triangular lattice at half-filling. We estimate the value of the critical interaction to be ${U}_{c}=12.0\ifmmode\pm\else\textpm\fi{}0.5$ in units of the hopping amplitude t through the evolution of the magnetic moment, spectral function, internal energy, and specific heat as the interaction U and temperature T are varied. This work also presents a comparison between DMFT and finite-size determinant quantum Monte Carlo calculations and a discussion of the advantages and limitations of both methods.
We investigate Hubbard-type models by means of the dynamical mean-field theory (DMFT) combined with the continuous-time quantum Monte Carlo (CTQMC) method. In this thesis, a great deal of effort has been devoted to investigating diverse facets of Mott physics. Interesting phenomena in strongly correlated electron systems emerge mostly when various energy scales compete with each other. We introduce additional degrees of freedom to the standard Hubbard model. The additional degrees of freedom include a staggered lattice potential, two orbitals, bilayer structure, and superconductivity. Depending on the model system, we extend the single-site DMFT to the multi-orbital one or employ cluster extension of the DMFT. In addition, two complementary versions of CTQMC, weak and strong coupling algorithm, are adopted as an impurity solver.\nWe first consider a Mott transition of the Hubbard model in infinite dimensions. The DMFT is employed in combination with the CTQMC method for an accurate description at low temperatures. Through the use of the double occupancy and the energy density, which are directly measured via the CTQMC method, we construct the phase diagram. We pay particular attention to the construction of the first-order phase transition line (PTL) in the coexistence region of metallic and insulating phases. The resulting PTL is found to exhibit reasonable agreement with earlier finite-temperature results. We also show, by including systematically low-temperature data, that the PTL, which is obtained independently of the previous zero-temperature results, approaches monotonically the transition point reported in earlier zero-temperature studies.\nWe next investigate paramagnetic metal-insulator transitions in the infinite-dimensional ionic Hubbard model at finite temperatures. By means of the DMFT with an impurity solver of the CTQMC, we show that an increase in the interaction strength brings about a crossover from a band insulating phase to a metallic one, followed by a first-order transition to the Mott insulating phase. The first-order transition turns into a crossover above a certain critical temperature, which becomes higher as the strength of the staggered lattice potential is increased. Further, analysis of the temperature dependence of the energy density discloses that the intermediate metallic phase is a Fermi liquid. It is also found that the metallic phase is stable against strong staggered potentials even at very low temperatures. \nFinite-temperature phase transitions are also examined in the two-orbital Hubbard model with Ising-type Hunds coupling. We adopt the multi-orbital extension of the DMFT combined with the strong coupling CTQMC. It is found that there emerges a peculiar reverse-sloped first-order Mott transition between the orbital-selective Mott phase and the Mott insulator phase. It turns out that the increase of Hunds coupling lowers the critical temperature of the reverse-sloped Mott transition. Beyond a certain critical value of Hunds coupling the first-order transition becomes a finite-temperature crossover.\nBilayer effects in the Hubbard model are also studied in the dynamical cluster approximation (DCA) combined with the weak coupling algorithm of CTQMC. In the magnetic phase diagrams obtained in earlier studies, there still remain several controversial issues, particularly for weak on-site Coulomb interactions. In this study, we adopt eight-site clusters which preserve the underlying lattice symmetry. Magnetic properties and associated metal-insulator transitions are examined at low temperatures, and their implications to the ground-state phase diagram are also discussed.\nFinally, we discuss the BCS+U model which is a natural generalization of Gutzwiller-projected BCS model. For this study, we use the DCA combined with the weak coupling CTQMC and verify the reliability of our calculation by changing the cluster size. Our main focus is on the correlation effects of the phenomenological d-wave superconductor. The transition between the superconductor and the Mott insulator is observed as we change the interaction strength or doping concentration. We discuss the change in the spectral properties of the system during the transition.
This work is motivated by the fact that the investigation of non-equilibrium phenomena in strongly correlated electron systems has developed into one of the most active and exciting branches of condensed matter physics as it provides rich new insights that could not be obtained from the study of equilibrium situations. However, a theoretical description of those phenomena is missing. Therefore, in this thesis, we develop a numerical method that can be used to study two minimal models -- the Hubbard model and the Anderson impurity model with general parameter range and time dependence. We begin by introducing the theoretical framework and the general features of the Hubbard model. We then describe the dynamical mean field theory (DMFT), which was first invented by Georges in 1992. It provides a feasible way to approach strongly correlated electron systems and reduces the complexity of the calculations via a mapping of lattice models onto quantum impurity models subject to a self-consistency condition. We employ the non-equilibrium extension of DMFT and map the Hubbard model to the single impurity Anderson model (SIAM). Since the fundamental component of the DMFT method is a solver of the single impurity Anderson model, we continue with a description of the formalism to study the real-time dynamics of the impurity model staring at its thermal equilibrium state. We utilize the non-equilibrium strong-coupling perturbation theory and derive semi-analytical approximation methods such as the non-crossing approximation (NCA) and the one-crossing approximation (OCA). We then use the Quantum Monte-Carlo method (QMC) as a numerically exact method and present proper measurements of local observables, current and Green's functions. We perform simulations of the current after a quantum quench from equilibrium by rapidly applying a bias voltage in a wide range of initial temperatures. The current exhibits short equilibrium times and saturates upon the decrease of temperature at all times, indicating Kondo behavior both in the transient regime and in the steady state. However, this bare QMC solver suffers from a dynamical sign problem for long time propagations. To overcome the limitations of this bare treatment, we introduce the ``Inchworm algorithm'', based on iteratively reusing the information obtained in previous steps to extend the propagation to longer times and stabilize the calculations. We show that this algorithm greatly reduces the required order for each simulation and re-scales the exponential challenge to quadratic in time. We introduce a method to compute Green's functions, spectral functions, and currents for inchworm Monte Carlo and show how systematic error assessments in real time can be obtained. We illustrate the capabilities of the algorithm with a study of the behavior of quantum impurities after an instantaneous voltage quench from a thermal equilibrium state. We conclude with the applications of the unbiased inchworm impurity solver to DMFT calculations. We employ the methods for a study of the one-band paramagnetic Hubbard model on the Bethe lattice in equilibrium, where the DMFT approximation becomes exact. We begin with a brief introduction of the Mott metal insulator phase diagram. We present the results of both real time Green's functions and spectral functions from our nonequilibrium calculations. We observe the metal-insulator crossover as the on-site interaction is increased and the formation of a quasi-particle peak as the temperature is lowered. We also illustrate the convergence of our algorithms in different aspects.
Correlated electrons in a binary alloy ${A}_{x}{B}_{1\ensuremath{-}x}$ are investigated within the Hubbard model and dynamical mean-field theory (DMFT). The random energies ${\ensuremath{\epsilon}}_{i}$ have a bimodal probability distribution and an energy separation $\ensuremath{\Delta}.$ We solve the DMFT equations by the numerical renormalization-group method at zero temperature and calculate the spectral density as a function of disorder strength $\ensuremath{\Delta}$ and interaction U at different fillings. For filling factors $\ensuremath{\nu}=x$ or 1+x the lower or upper alloy subband is half filled and the system becomes a Mott insulator at strong interactions, with a correlation gap at the Fermi level. At the metal-insulator transition hysteresis is observed. We also analyze the effective theory in the $\stackrel{\ensuremath{\rightarrow}}{\ensuremath{\Delta}}\ensuremath{\infty}$ limit and find good agreement between analytical and numerical results for the critical interaction Uc at which the metal-insulator transition occurs.
We develop a precise and reliable numerical method for the calculation of electronic properties of the two orbital Hubbard model in a square lattice at half filling, based on the Dynamical Mean Field Theory (DMFT). We use the Density Matrix Renormalization Group (DMRG) as the impurity solver for the DMFT's selfconsistent equations to obtain accurate values for the Green's functions on the real axis. This way, reliable densities of states are obtained that do not need to resort to analytical continuation methods as those using quantum Monte Carlo techniques. Large system sizes can be achieved with increasing accuracy.