Strong coupling appears when the coherent exchange rate between one emitter and one cavity mode exceeds both the cavity decay rate and the emitter decay rate. Because the exchange rate grows as the mode volume shrinks, the threshold can be expressed as a maximum volume for stated decay rates. This study computes the quantities that follow from stated assumptions for a single two-level emitter at 780 nm, dipole moment 3e-29 coulomb metre, cavity quality factor 20000 and emitter decay rate 1 GHz in angular-frequency units as stated, using the relations set out in the Methods. The headline results are cooperativity at V 1 lambda3 = 1.616, cooperativity at V 10 lambda3 = 0.1616, V for C1 in lambda3 = 1.616, V for C10 in lambda3 = 0.1616, V for C100 in lambda3 = 0.01616. Further computed values are g at V 1 lambda3 rad s = 4.952e+10, kappa rad s = 1.207e+11. The central question is stated as follows: What mode volume, in cubic wavelengths, is required for strong coupling and for a cooperativity of ten and of one hundred, for an emitter with a 1 GHz linewidth in a cavity of quality factor twenty thousand? The answer obtained here is conditional on the assumptions listed in the paper and in the deposited calculation; changing an assumption changes the numbers in the way the sensitivity discussion describes. Cooperativities from near unity to several hundred are reported across atom, ion, quantum-dot and colour-centre platforms, which makes the threshold volume a useful common yardstick. The work is a computation, not a laboratory measurement, and it is labelled accordingly. Where the computed result is unfavourable to the device or effect under study, that outcome is reported in the same terms as a favourable one, because a bound that only appears when it is welcome is not a bound at all. All numerical statements in this abstract are reproduced by the deposited script from the stated inputs.
Strong coupling appears when the coherent exchange rate between one emitter and one cavity mode exceeds both the cavity decay rate and the emitter decay rate. Because the exchange rate grows as the mode volume shrinks, the threshold can be expressed as a maximum volume for stated decay rates. This study computes the quantities that follow from stated assumptions for a single two-level emitter at 780 nm, dipole moment 3e-29 coulomb metre, cavity quality factor 20000 and emitter decay rate 1 GHz in angular-frequency units as stated, using the relations set out in the Methods. The headline results are cooperativity at V 1 lambda3 = 1.616, cooperativity at V 10 lambda3 = 0.1616, V for C1 in lambda3 = 1.616, V for C10 in lambda3 = 0.1616, V for C100 in lambda3 = 0.01616. Further computed values are g at V 1 lambda3 rad s = 4.952e+10, kappa rad s = 1.207e+11. The central question is stated as follows: What mode volume, in cubic wavelengths, is required for strong coupling and for a cooperativity of ten and of one hundred, for an emitter with a 1 GHz linewidth in a cavity of quality factor twenty thousand? The answer obtained here is conditional on the assumptions listed in the paper and in the deposited calculation; changing an assumption changes the numbers in the way the sensitivity discussion describes. Cooperativities from near unity to several hundred are reported across atom, ion, quantum-dot and colour-centre platforms, which makes the threshold volume a useful common yardstick. The work is a computation, not a laboratory measurement, and it is labelled accordingly. Where the computed result is unfavourable to the device or effect under study, that outcome is reported in the same terms as a favourable one, because a bound that only appears when it is welcome is not a bound at all. All numerical statements in this abstract are reproduced by the deposited script from the stated inputs.
When a cavity is strongly coupled to a two-level emitter, its energy levels cease to be equally spaced. A drive tuned to the first transition is then detuned from the second, so a second photon is largely excluded: the photon blockade. This study computes the quantities that follow from stated assumptions for a Jaynes-Cummings system with cavity decay corresponding to quality factor 20000 at 780 nm and coupling rates from 5 to 100 GHz in ordinary frequency units, using the relations set out in the Methods. The headline results are kappa GHz = 19.22, anharmonicity at g 20 GHz = 11.72, g2 at g 20 = 0.4021, g2 at g 5 = 0.915, g2 at g 100 = 0.0262. The central question is stated as follows: How large is the anharmonicity, and the resulting suppression of two-photon occupation, for coupling rates spanning the strong-coupling range, and at what coupling does the suppression reach a factor of one hundred? The answer obtained here is conditional on the assumptions listed in the paper and in the deposited calculation; changing an assumption changes the numbers in the way the sensitivity discussion describes. Blockade experiments report a second-order correlation well below one, often near 0.1 or lower, in systems where the anharmonicity exceeds the linewidth by a clear margin. The work is a computation, not a laboratory measurement, and it is labelled accordingly. Where the computed result is unfavourable to the device or effect under study, that outcome is reported in the same terms as a favourable one, because a bound that only appears when it is welcome is not a bound at all. All numerical statements in this abstract are reproduced by the deposited script from the stated inputs.
A photon reflected from a cavity that contains a coupled emitter acquires a phase that depends on the emitter state. That conditional phase is the working principle of a photon router and of several photon-photon gate proposals, and its usefulness is set by the cooperativity. This study computes the quantities that follow from stated assumptions for a one-sided cavity coupled to a two-level emitter, probed on resonance by a narrowband single photon, using the relations set out in the Methods. The headline results are fidelity at C 5 = 0.9091, fidelity at C 20 = 0.9756, fidelity at C 100 = 0.995, reflection at C 5 = 0.8182, loss at C 20 = 0.09518. The central question is stated as follows: For cooperativities from one half to one hundred, what reflection amplitudes, conditional phase error and routing fidelity follow in the standard input-output model? The answer obtained here is conditional on the assumptions listed in the paper and in the deposited calculation; changing an assumption changes the numbers in the way the sensitivity discussion describes. Conditional phase shifts approaching pi and gate fidelities limited mainly by cooperativity are the standard theoretical expectations for this geometry, with experiments reporting smaller shifts where cooperativity is modest. The work is a computation, not a laboratory measurement, and it is labelled accordingly. Where the computed result is unfavourable to the device or effect under study, that outcome is reported in the same terms as a favourable one, because a bound that only appears when it is welcome is not a bound at all. All numerical statements in this abstract are reproduced by the deposited script from the stated inputs.
Linking a superconducting circuit to an optical fibre requires converting a microwave photon into an optical photon. In an electro-optic or optomechanical converter the efficiency is set by two cooperativities, one on each side of the device, and by how well they are matched. This study computes the quantities that follow from stated assumptions for a bidirectional converter with internal efficiency formula stated in the text, external coupling 0.9 on each side, and a thermal occupation of 0.1 microwave photons, using the relations set out in the Methods. The headline results are eta at C 10 10 = 0.907, eta external at C 10 10 = 0.7347, eta at C 10 100 = 0.3246, eta at C 1 1 = 0.4444, eta at C 100 100 = 0.9901. The central question is stated as follows: What conversion efficiency and added noise follow for cooperativity pairs from below unity to one hundred, and how much efficiency is lost when the two cooperativities differ by a factor of ten? The answer obtained here is conditional on the assumptions listed in the paper and in the deposited calculation; changing an assumption changes the numbers in the way the sensitivity discussion describes. Reported conversion efficiencies span many orders of magnitude, from very small values in early devices to tens of percent in the most advanced, with added noise often the stricter criterion. The work is a computation, not a laboratory measurement, and it is labelled accordingly. Where the computed result is unfavourable to the device or effect under study, that outcome is reported in the same terms as a favourable one, because a bound that only appears when it is welcome is not a bound at all. All numerical statements in this abstract are reproduced by the deposited script from the stated inputs.
Cavity-embedded quantum emitters show strong modifications of free space radiation properties such as an enhanced decay known as the Purcell effect. The central parameter is the cooperativity C, the ratio of the square of the coherent cavity coupling strength over the product of cavity and emitter decay rates. For a single emitter, C is independent of the transition dipole moment and dictated by geometric cavity properties such as finesse and mode waist. In a recent work [Phys. Rev. Lett. 119, 093601 (2017)], we have shown that collective excitations in ensembles of dipole-dipole coupled quantum emitters show a disentanglement between the coherent coupling to the cavity mode and spontaneous free space decay. This leads to a strong enhancement of the cavity cooperativity around certain collective subradiant antiresonances. Here, we present a quantum Langevin equations approach aimed at providing results beyond the classical coupled dipoles model. We show that the subradiantly enhanced cooperativity imprints its effects onto the cavity output field quantum correlations while also strongly increasing the cavity-emitter system's collective Kerr nonlinear effect.
A single two-level emitter coupled to a single mode of an electromagnetic resonator constitutes the most fundamental instance of light--matter interaction. Realizations of this type of system are investigated in the field of cavity quantum electrodynamics (cavity QED). Particularly important are schemes in which the coupling is strong enough to exceed the spontaneous emission rate as well as cavity damping. In this case, the coherent exchange of excitation between source and photon is the dominating process, providing the unique possibility to deterministically control the quantum evolution of the system. Great progress has recently been accomplished, technologically as well as conceptually, and the focus section in this issue of Journal of Optics B: Quantum and Semiclassical Optics features five articles highlighting important recent developments in the field. Strong coupling between single atoms and the electromagnetic cavity field have been achieved in two distinct regimes, the optical and the microwave region. The latter is represented by the micromaser, a high-Q microwave cavity pumped by a beam of highly excited Rydberg atoms. It has proved to be an almost ideal system for the generation of non-classical field states. A constraint in these experiments is the fact that the field inside the cavity can only be examined indirectly, by analysing the occupation of atoms leaving the cavity. While only two atomic states were previously identified for this purpose, V A Reshetov shows in his article (pages 119--126) that more information on the field may be extracted by taking advantage of the Zeeman substructure of the atomic levels. In the optical domain of cavity QED, by contrast, the state of the resonator field may be probed directly by measuring the light leaking from the cavity using photodetectors. In order to minimize damping, high-quality cavities must be employed. In most optical experiments these are Fabry--Perot resonators with ultra-high reflectivity mirrors, with losses as low as a few parts per million being state of the art. At the same time, the coupling of atoms and photons is enhanced by reducing the length of the cavity, so that strong coupling conditions are reached. A very attractive application of this type of cavity QED setup is the possibility of exerting control over the quantum dynamics of the system. An impressive example is the implementation of quantum feedback, reported in the paper by W P Smith and L A Orozco (pages 127--134). Using information gained from detecting a single photon escaping from the cavity, active feedback is applied to halt the dynamical evolution of the system. This is the first time active feedback has been used to modify the quantum evolution of a system at the single-photon level. The authors discuss how detunings between the subsystems affect the quantum feedback, an issue particularly relevant for ensembles of atoms with a spread in detuning. Perfect quantum feedback in this case requires the use of additional parameters to control the system. The majority of optical cavity QED experiments performed so far have used as a medium atoms traversing the cavity on random trajectories, such as, for example, thermal atomic beams. In this case, the observation of quantum effects is degraded in two ways. The Doppler effect and the finite transit time lead to line broadening, while the spatial structure of the cavity mode results in atoms in different locations experiencing different coupling with the photonic field. J E Reiner et al (pages 135--142) investigate the impact of these effects on quantum fluctuations in their cavity QED system. In order to overcome line broadening, they have developed a continuous cold atomic beam, extracted from a magneto-optical trap. An even better control of broadening effects and fluctuating coupling strength is provided by trapping the atoms inside the cavity and cooling them to temperatures at which their position spread is smaller than the optical wavelength. Much recent activity has been devoted to developing such an ultimate cavity QED system. A Vukics et al (pages 143--153) present a theoretical proposal for dynamically trapping and cooling atoms inside a cavity. By driving the atoms with a standing wave injected from the side of the cavity and by weakly exciting the cavity field itself, they predict three-dimensional trapping of the atom for periods around 1 second, an extremely long time on the typical scale of cavity QED dynamics. The essential component of their scheme is the interference between the two driving fields, determining the temperature of the particle and the stable trapping positions. In the quest for better confinement of radiation, lately, an appealing alternative to the Fabry--Perot cavity has been investigated -- the optical microsphere resonator. A sphere with a diameter of a few tens of microns, it supports so-called whispering gallery modes near its circumference, for which quality factors up to 10 10 have been measured. In order to exploit the correspondingly low field damping rates for cavity QED, a method must be found to couple atomic or solid state emitters to these modes. S Göotzinger et al (pages 154--158) report the coupling of single nanocrystals on the surface of a microsphere through the evanescent field of the mode. Selective excitation of a single nano-emitter was accomplished with a scanning confocal microscope. The system is a promising candidate for cavity QED with single-quantum emitters. The ability to fully control the quantum dynamics of atoms and light is beginning to spawn early applications. The most notable example is quantum information processing. This requires the coherent manipulation of single-quantum systems, which is ideally provided by cavity QED interaction in the strong-coupling limit. The development of practical devices will be among the principal future tasks for research in the field. This will include physical systems, which have not been covered in this issue, such as semiconductors, quantum dots as emitters, or photonic crystals as resonator structures. Cavity QED is therefore guaranteed to remain a vigorous field in the years to come.
By embedding a single quantum emitter inside a nanoresonator that strongly localizes optical field, it is possible to achieve a very strong light-matter interaction. The strength of this interaction is characterized by the coherent emitter-field coupling strength (g), which increases with reduction in the optical mode volume and which also sets the limit on the operational speed of such a system. With InAs quantum dots inside GaAs photonic crystal cavities, coupling strengths of 40 GHz can be reached (much greater than the record values in atom-cavity QED systems), while nanometallic cavities could increase them over 100 GHz, as a result of the further reduction in the mode volume. Such a quantum dot-nanocavity platform is of interest for various quantum technologies, as well as in optical switching/computing.