Design blueprint derived from the source paper (DOI 10.5281/zenodo.24138664): This paper designs an optical receiver whose readout noise is reduced below the ordinary shot-noise level by squeezed vacuum injection, and computes the benefit for a channel in which a torsion background modulates the phase of a probe beam. Status: DESIGN BLUEPRINT — SIMULATED, NOT MEASURED — NOT BUILT. All numbers are simulated values from the source paper's computation, deposited with this blueprint as compute.py and results.json. AI-use disclosure: Dave, an AI research system, assisted with the computation and drafting under the author's direction; author of record William Alexander Aldred.
Design blueprint derived from the source paper (DOI 10.5281/zenodo.24138664): This paper designs an optical receiver whose readout noise is reduced below the ordinary shot-noise level by squeezed vacuum injection, and computes the benefit for a channel in which a torsion background modulates the phase of a probe beam. Status: DESIGN BLUEPRINT — SIMULATED, NOT MEASURED — NOT BUILT. All numbers are simulated values from the source paper's computation, deposited with this blueprint as compute.py and results.json. AI-use disclosure: Dave, an AI research system, assisted with the computation and drafting under the author's direction; author of record William Alexander Aldred.
This paper designs an optical receiver whose readout noise is reduced below the ordinary shot-noise level by squeezed vacuum injection, and computes the benefit for a channel in which a torsion background modulates the phase of a probe beam. With 10 dB of squeezing the phase readout noise falls to 1.37e-09 rad per root hertz, an improvement factor of 3.16 over the unsqueezed value at the same optical power. The receiver cavity sets a detection bandwidth of 33.3 kHz. The trade between squeezing depth, optical loss and bandwidth is worked through quantitatively, and the loss budget at which squeezing stops helping is identified. All results are computed from the stated assumptions; the receiver has not been built or measured.
Squeezed states of light are a valuable resource for reducing quantum noise in precision measurements. Injection of squeezed vacuum states has emerged as an important technique for reducing quantum shot noise, which is a fundamental limitation to the sensitivity of interferometric gravitational wave detectors. Realizing the most benefit from squeezed-state injection requires lowering optical losses and also minimizing squeezed quadrature fluctuations—or phase noise—to ensure that the large noise in the anti-squeezed quadrature does not contaminate the measurement quadrature. Here, we present an audio band squeezed vacuum source with 1.3+0.7−0.5 mrad of phase noise. This is a nearly tenfold improvement over previously reported measurements, improving prospects for squeezing enhancements in current and future gravitational wave detectors.
During the recent years an international network of interferometric gravitational wave (GW) detectors has been commissioned and searches for various classes of GWsignals are ongoing.Although the observatories are beginning to reach astrophysically interesting sensitivity levels, extensive upgrades are aimed for the next decade bringing us into the era of gravitational wave astronomy.One approach to enhance the detector sensitivity is the injection of squeezed vacuum states of light replacing the vacuum fluctuations entering the detector through its antisymmetric port.In this thesis the unprecedented generation of squeezed vacuum states with a noise power 6.5 dB below vacuum noise within the entire detection bandwidth of ground-based GW-detectors (10 Hz -10 kHz) was experimentally demonstrated at a wavelength of 1064 nm.For the first time a coherent control scheme was employed for comprehensive phase control of the experimental setup.This scheme is directly applicable to future GW-detector topologies.In addition, parasitic interference induced by scattered light was found to be a dominant noise source degrading squeezed states in the audio band.The compatibility of squeezed field injection into a detuned operated dual-recycled Michelson interferometer was demonstrated in a table top experiment.A detected non-classical sensitivity improvement of up to 3.0 dB within the entire detection bandwidth (5 -15 MHz) was accomplished by optimal preparation of the injected squeezing by means of a detuned locked filter cavity.In a further experiment strongly squeezed vacuum states were generated in the MHz-regime.With a maximum measured quantum noise reduction of 11.5 dB below the shot noise limit a new benchmark was set.This was achieved by suppression of phase noise and a remarkable reduction of optical loss in the experimental setup.Based on the squeezed light sources developed in this thesis and the experimental results achieved, a conceptual design of a compact squeezed light source was devised, allowing for a high duty cycle sensitivity improvement of GW-detectors.
Current interferometric gravitational wave detectors were designed to be limited, in much of their sensitive \nband, by quantum noise in the form of shot noise (at high frequency) or quantum radiation pressure noise \n(at low frequency). In the current observation run (O3), a squeezed light source has been used to \nmanipulate quantum noise and surpass the limits imposed by the circulating laser power by injecting nonclassical states of the electromagnetic field, called squeezed vacuum states, in the interferometer's dark \nport. Recent O3 results show that this technique was able to reduce the shot noise contribution to the \nnoise spectral density by about one half. To surpass the so called standard quantum limit across the entire \nsensitivity band, an even more complex variation of this technique will be implemented, which requires the \nuse of a so called “filter cavity” to reflect the squeezed quantum field and rotate the squeezing angle as a \nfunction of frequency. \nThe performance of this techniques is however severely limited by light losses. One big contributor to \noptical losses is the mismatch between the squeezed vacuum beam, the beam circulating into the \ninterferometer and, in the near future, the filter cavity fundamental transverse spatial mode. \nTo be able to monitor and actively correct mode mismatch, an accurate, online sensing technique is \nneeded. A possible solution consists in the introduction of an Electro-Optic Lens (EOL) that can induce \nradio-frequency sidebands in the Laguerre-Gauss 10 (LG10) transverse mode of the beam. If the \nmodulation frequency is tuned in a way that one sideband is at the cavity LG10 frequency, then the \nresonance breaks the symmetry of the two sidebands and converts phase modulation into amplitude \nmodulation, making it possible to retrieve an error signal directly from the cavity reflected electric field \nwith the same single-element photodetector used for the Pound Drever Hall (PDH) locking technique. This \nerror signal carries information about the magnitude and nature of the mismatch, providing all is needed to \ninform a dedicated feedback loop with a suitable actuator to maintain the mismatch at or below the 1% \nlevel. \nThe goal of this thesis is to demonstrate the technique on a dedicated bench-top experiment employing an \nEOL prototype device. The EOL alignment and working point, as well as the cavity lock parameters were \noptimized in an already existing setup. Simulations and theoretical calculations of the cavity reflected field \nwere performed to evaluate the system non-idealities: both Electro-Optic Modulator (for PDH technique) \nand EOL modulations effects and interactions, as well as some system imperfections were considered. The \nsimulations confirm that this technique requires a stable cavity lock condition, and for this reason an \naccurate study and optimization of the feedback loop parameters was done. In conclusion, a \ncharacterization of the EOL error signal response to different mismatch conditions are presented.
We study the photon counting noise in optical interferometers used for gravitational wave detection. In order to reduce quantum noise a squeezed vacuum state is injected into the usually unused input port. Here, we specifically investigate the so-called “dark port case,” when the beam splitter is oriented close to 90° to the incoming laser beam, such that nearly all photons go to one output port of the interferometer, and only a small fraction of photons is seen in the other port (“dark port”). For this case it had been suggested that signal amplification is possible without concurrent noise amplification [R. Barak and Y. Ben-Aryeh, J. Opt. Soc. Am. B 25 , 361 (2008)]. We show that by injection of a squeezed vacuum state into the second input port, counting noise is reduced for large values of the squeezing factor, however the signal is not amplified. Signal strength only depends on the intensity of the laser beam.
This research focuses on advanced noise suppression technologies for high-precision measurement systems, particularly addressing the limitations of classical noise reducing approaches. The noise level of laser sources is a crucial factor that directly affects the measurement sensitivity in applications such as gravitational wave detection and biomedical imaging. Classical feedback control technologies are effective but often encounter a bottleneck resulting from the classical noise suppression limits. To cope with these challenges, a novel method integrating quantum squeezed light with classical feedback control systems to reduce intensity noise is proposed in this work. By employing an amplitude-squeezed light field, a quantum-enhanced feedback control model is developed, thereby theoretically examining the influence of both the feedback loop gain and the degree of squeezing on the noise suppression performance. The results show that the injection of squeezed light significantly reduces the intensity noise, approaching the shot noise limit (SNL), thereby improving the system sensitivity beyond the classical noise reduction boundaries. Specifically, –10 dB squeezed state injection into the feedback system yields an additional noise suppression of approximately 8.97 dB, exceeding what is achievable using classical feedback alone. This demonstrates that the potential of the proposed method can enhance measurement precision close to the quantum noise limits without increasing the laser power. The analysis highlights the asymmetric noise suppression effects between the inner feedback loop and outer feedback loop. Although the outer loop benefits significantly from the squeezed light injection and achieves noise levels that are unattainable by classical feedback methods, the inner loop shows relatively minor improvements. This asymmetry is attributed to the inherent characteristics of quantum squeezing and the limitations of the feedback loop design. Further investigation into the individual noise components reveals that the primary contributors to the intensity noise include input noise, photodetector noise, and beam splitter-induced vacuum fluctuations. The injection of squeezed light effectively mitigates these vacuum fluctuations, which are typically a major noise source in high-precision laser systems. Theoretical research results show that the use of squeezed light in feedback control systems can effectively enhance noise suppression, equivalent to a nine fold increase in detected optical power, without the physical drawbacks of increasing laser power such as thermal noise. In conclusion, this study provides a theoretical validation of combining quantum squeezed states with classical feedback control to exceed classical noise suppression limits. The integration of a –10 dB squeezed state demonstrates a significant noise reduction, showing that this hybrid approach could revolutionize noise management in precision measurement applications. The results pave the way for further exploring quantum-enhanced control technologies in fields such as gravitational wave detection, quantum communication, and advanced optical sensing, providing a pathway for improving sensitivity and noise suppression without increasing additional power requirements.