I discuss the design, fabrication and measurement at millikelvin-temperatures of Al/AlO
x/Al Josephson junction-based transmon qubits coupled to superconducting thin-film lumped element microwave resonators made of aluminum on sapphire. The resonators had a center frequency of around
6GHz, and a total quality factor ranging from 15,000 to 70,000 for the various devices. The area of the transmon junctions was about
150nm×150nm and with Josephson energy
EJ such that
10GHz≤EJ/h≤30GHz. The charging energy of the transmons arising mostly from the large interdigital shunt capacitance, was
Ec/h≈300MHz. I present microwave spectroscopy of the devices in the strongly dispersive regime of circuit quantum electrodynamics. In this limit the ac Stark shift due to a single photon in the resonator is greater than the linewidth of the qubit transition. When the resonator is driven coherently using a coupler tone, the transmon spectrum reveals individual ``photon number'' peaks, each corresponding to a single additional photon in the resonator. Using a weighted average of the peak heights in the qubit spectrum, I calculated the average number of photons
nˉ in the resonator. I also observed a nonlinear variation of
nˉ with the applied power of the coupler tone
Prf. I studied this nonlinearity using numerical simulations and found good qualitative agreement with data. In the absence of a coherent drive on the resonator, a thermal population of
5.474GHz photons in the resonator, at an effective temperature of
120mK resulted in a weak
n=1 thermal photon peak in the qubit spectrum. In the presence of independent coupler and probe tones, the
n=1 thermal photon peak revealed an Autler-Townes splitting. The observed effect was explained accurately using the four lowest levels of the dispersively dressed Jaynes-Cummings transmon-resonator system, and numerical simulations of the steady-state master equation for the coupled system. I also present time-domain measurements on transmons coupled to lumped-element resonators. From
T1 and Rabi oscillation measurements, I found that my early transmon devices (called design LEv5) had lifetimes (
T1∼1μs) limited by strong coupling to the
50Ω transmission line. This coupling was characterized by the the rate of change of the Rabi oscillation frequency with the change in the drive voltage (
dfRabi/dV) -- also termed the Rabi coupling to the drive. I studied the design of the transmon-resonator system using circuit analysis and microwave simulations with the aim being to reduce the Rabi coupling to the drive. By increasing the resonance frequency of the resonator
ωr/2π from 5.4
GHz to 7.2
GHz, lowering the coupling of the resonator to the transmission line and thereby increasing the external quality factor
Qe from 20,000 to 70,000, and reducing the transmon-resonator coupling
g/2π from 70
MHz to 40
MHz, I reduced the Rabi coupling to the drive by an order of magnitude (
∼ factor of 20). The
T1∼4μs of devices in the new design (LEv6) was longer than that of the early devices, but still much shorter than the lifetimes predicted from Rabi coupling, suggesting the presence of alternative sources of noise causing qubit relaxation. Microwave simulations and circuit analysis in the presence of a dielectric loss tangent
tanδ≃5×10−6 agree reasonably well with the measured
T1 values, suggesting that surface dielectric loss may be causing relaxation of transmons in the new designs.
In a quantum computer, the information carriers, which are bits in ordinary computers, are implemented as devices that exhibit coherent superpositions of physical states and entanglement. Such components, known as quantum bits or qubits, can be realized with various different types of two-state quantum systems. Quantum computers will be built for computational speed, with hoped for applications especially in cryptography and in other tasks where classical computers remain inefficient. Circuit quantum electrodynamics (cQED) is a quantum-computer architecture which employs superconducting electronic components and microwave photon fields as building blocks. Compared to cavity quantum electrodynamics (CQED), where atoms are trapped in physical cavities, cQED is more attractive in that its qubits are tunable and conveniently integrable with the electronics already in use. This architecture has shown some of the most promising qubit designs, despite their coherence times reaching tens of microseconds, are still below the state of the art with spin qubits, which reach milliseconds. Coherence times are historically the most relevant parameters describing the fitness of a qubit, although these days not necessarily the limiting factor. This thesis presents a comprehensive set of theoretical and experimental methods for measuring the characteristic parameters of superconducting qubits. We especially study transmission-line-shunted plasma oscillation qubits, or transmons, and presents experimental results for a single sample. Transmon capacitively couples a superconducting quantum interference device (SQUID) with a coplanar waveguide (CPW) resonator, often with added frequency tunability utilizing an external magnet. The number of superconducting charge carriers tunnelled through a junction in the SQUID are used as qubit degrees of freedom. Readout of the qubit state is carried out by measuring transmission through the CPW. A cryogenic setup is employed with measurement and driving pulses delivered from microwave sources. Steady-state spectroscopy is employed to determine the resonance frequencies of the qubit and the resonator, qubit-resonator coupling constants, and the energy parameters of the qubit. Pulse-modulated measurements are employed to determine the coherence times of the qubit. The related analysis- and simulation programs and scripts are collected togithub.com/patomaki.
Superconducting quantum chips commonly utilize quarter-wavelength (λ/4) transmission line resonators as readout circuits. An analytical model for the accurate determination of resonance frequencies and coupling Q-factors of feedline-coupled superconducting resonators is introduced. The model leverages four-port microwave network analysis, integrating boundary conditions and conformal mapping techniques to compute even- and odd-mode impedances in edge-coupled coplanar waveguide (CPW) structures. Its versatility allows application to both planar and 3-D heterogeneous architectures, making it a powerful tool for resonator design. To validate the model, a test chip with λ/4 resonators of varying geometries is fabricated and measured in a cryogenic environment. Comparisons with finite element method (FEM) simulations and experimental measurements confirm the model's accuracy, with resonance frequencies and coupling Q-factors aligning closely across configurations. This proposed model facilitates the design of superconducting resonators in readout circuits for more effective, scalable, and adaptable quantum computing architectures.
The fragile nature of quantum circuits is a major bottleneck to scalable quantum applications. Operating at cryogenic temperatures, quantum circuits are highly vulnerable to amplifier backaction and external noise. Non-reciprocal microwave devices such as circulators and isolators are used for this purpose. These devices have a considerable footprint in cryostats, limiting the scalability of quantum circuits. As a proof-of-concept, here we report a compact microwave diode architecture, which exploits the non-linearity of a superconducting flux qubit. At the qubit degeneracy point we experimentally demonstrate a significant difference between the power levels transmitted in opposite directions. The observations align with the proposed theoretical model. At - 99 dBm input power, and near the qubit-resonator avoided crossing region, we report the transmission rectification ratio exceeding 90% for a 50 MHz wide frequency range from 6.81 GHz to 6.86 GHz, and over 60% for the 250 MHz range from 6.67 GHz to 6.91 GHz. The presented architecture is compact, and easily scalable towards multiple readout channels, potentially opening up diverse opportunities in quantum information, microwave read-out and optomechanics.
So called quantum supremacy has been demonstrated by at least two groups utilising < 100 physical superconducting qubits cooled to milli-kelvin temperatures. It is acknowledged that scaling these efforts to fault-tolerant, general purpose quantum computers will require very many more logical qubits, each formed from several physical ones. Addressing and control of these qubits is an area of active research, but it is likely that increased cooling capacities, particularly at the lowest temperatures, will be a requirement for the realisation of systems beyond noisy intermediate-scale quantum processors. Here we demonstrate a method by which significantly increased cooling power at temperatures ∼ 200 mK can be generated without impacting on the performance of an adjacent stage providing cooling power at temperatures ∼ 20 mK.
Superconducting quantum bits (qubits) are a leading candidate towards realizing a processor that is able to outperform existing classical computers at select tasks. One particular qubit architecture, the transmon, boasts long coherence times compared to required gate lengths and flexibility with respect to circuit couplings as these 'artificial atoms' are photolithographically defined. These attributes allow qubits to be leveraged for other tasks as well — such as efficiently detecting itinerant microwave photons. Such a device may prove useful for remote entanglement protocols, quantum optics experiments in the microwave regime, and as a detector for low-mass dark matter.Through a blend of circuit quantum electrodynamics (cQED) and waveguide quantum electrodynamics (wQED) theories, high detector performance was achieved even when the photon arrival time was not known. Utilizing an ensemble (N = 4) of identical transmon absorbers, photon mediated interactions along a common waveguide enable absorbed itinerant photons to be trapped for longer than the inverse of the bandwidth of an individual qubit. This extended trapping time allows for sufficient integration of the dispersively shifted readout resonator to resolve deviations from vacuum with high fidelity.