High-speed physical random number generation is essential for secure communication, high-speed encryption and stochastic photonic information processing. However, scaling optical random number generators toward massively parallel operation remains challenging, because multiple wavelength channels generated from a common physical entropy source often suffer from residual correlation and limited spectral scalability. Here, we propose and experimentally demonstrate a dual-output, multi-channel parallel physical true random number generator based on a randomdistributed-feedback Brillouin fiber laser. Cascaded stimulated Brillouin scattering, four-wave mixing, cross-phase modulation and self-phase modulation in a highly nonlinear fiber, together with near-zero-dispersion assisted phase matching provided by a dispersion-shifted fiber, generate broadband Brillouin optical frequency combs spanning approximately 100 nm at both output ports. Distributed Rayleigh backscattering in a long single-mode fiber introduces stochastic phase perturbations and optical path delays, effectively breaking the fixed coherent relationship between output1 and output 2. The two outputs simultaneously exhibit broadbandcomb spectra, withoptical signal-to-noise ratio values of approximately 20 dB observed for the comb lines. The temporalcross-correlation coefficient between the two outputs remains below 0.05, forming two decorrelated optical entropy sources. Using 40 GSa/s sampling, 8-bit quantization, delay-reverse XOR decorrelation, and 4-LSB extraction, eight representative comb-line channels from the two output ports pass the NIST SP 800-22 statistical test suite. Based on the adopted offline post-processing procedure, these channels correspond to an effective aggregate random-bit rate of 1.92 Tb/s. The broadband spectra contain more than 1100 spectrally observable comb lines at each output port, indicating substantial potential for wavelength-parallel scaling. Under anideal fully parallel acquisition and processing architecture, the corresponding theoretical upper-bound aggregate rate could exceed 352 Tb/s (2200 × 4bit × 40GSa/s).
High-speed physical random number generation is essential for secure communication, high-speed encryption and stochastic photonic information processing. However, scaling optical random number generators toward massively parallel operation remains challenging, because multiple wavelength channels generated from a common physical entropy source often suffer from residual correlation and limited spectral scalability. Here, we propose and experimentally demonstrate a dual-output, multi-channel parallel physical true random number generator based on a randomdistributed-feedback Brillouin fiber laser. Cascaded stimulated Brillouin scattering, four-wave mixing, cross-phase modulation and self-phase modulation in a highly nonlinear fiber, together with near-zero-dispersion assisted phase matching provided by a dispersion-shifted fiber, generate broadband Brillouin optical frequency combs spanning approximately 100 nm at both output ports. Distributed Rayleigh backscattering in a long single-mode fiber introduces stochastic phase perturbations and optical path delays, effectively breaking the fixed coherent relationship between output1 and output 2. The two outputs simultaneously exhibit broadbandcomb spectra, withoptical signal-to-noise ratio values of approximately 20 dB observed for the comb lines. The temporalcross-correlation coefficient between the two outputs remains below 0.05, forming two decorrelated optical entropy sources. Using 40 GSa/s sampling, 8-bit quantization, delay-reverse XOR decorrelation, and 4-LSB extraction, eight representative comb-line channels from the two output ports pass the NIST SP 800-22 statistical test suite. Based on the adopted offline post-processing procedure, these channels correspond to an effective aggregate random-bit rate of 1.92 Tb/s. The broadband spectra contain more than 1100 spectrally observable comb lines at each output port, indicating substantial potential for wavelength-parallel scaling. Under anideal fully parallel acquisition and processing architecture, the corresponding theoretical upper-bound aggregate rate could exceed 352 Tb/s (2200 × 4bit × 40GSa/s).
The exponential growth of data transmission and processing speeds in modern digital infrastructure requires entropy sources capable of producing large volumes of true randomness for information security. Chaotic emissions from semiconductor lasers are attractive in this context because of their fast dynamics and nonrepetitive behavior. Their spectral bandwidth, however, is typically limited to several tens of gigahertz, which constrains the achievable entropy rate and makes ultrafast random bit generation difficult without substantial post-processing. Here, we demonstrate a chaos-based entropy source that employs optical heterodyning between the chaotic emission from a semiconductor laser and an optical frequency comb, yielding a bandwidth exceeding 100 GHz and an experimentally verified single-channel entropy rate of 1.86 Tb/s. By directly extracting multiple bits from the digitized output of the entropy source, we achieve a single-channel random bit generation rate of 1.536 Tb/s, while four-channel parallelization reaches 6.144 Tb/s with no observable interchannel correlation. This linear scalability suggests that aggregate throughput could reach hundreds of terabits per second with additional parallel channels. The broadband, low-overhead photonic architecture presented here provides a viable route to real-time, ultrafast random bit generation with broad implications for secure communications, high-performance AI computing, and large-scale data analytics.
Physical random number generators based on chaotic microcombs, with their complex nonlinear dynamics and multi-channel parallel capability, have attracted considerable research attention. However, key technical challenges for chaotic microcombs are the high correlation between symmetric teeth and the low bandwidth of single-channel teeth, which seriously affect the speed and scalability of random number generation. We experimentally demonstrate a petabit-per-second (Pbit/s) parallel random number generation system based on intensity chaotic modulation and Rayleigh scattering. Through intensity modulation, the effective bandwidth of the single-channel entropy source is increased from 440MHz to 27.6GHz. Crucially, Rayleigh scattering further contributes through the random superposition of backscattered light, which introduces unpredictable fluctuations in intensity, phase, and polarization. This randomness suppresses inter-channel correlation among parallel entropy sources to ~0.02, ensuring their orthogonality. Moreover, by employing polarization-diverse coherent detection on a single-channel, four new low correlated sub-channels are extracted: X-/Y- intensity and phase. We achieve a single-channel bit rate of 14.336 Tbit/s and a total bit rate of 1.032 Pbit/s (over 72 parallel channels) with offline post-processing, representing the highest post-processing record reported in both the single-channel and the total system. Moreover, our scheme based on a single chaotic microcomb and fiber scattering link show fundamentally scalable. The total bit rate can be significantly pushed beyond the Pbit/s level by further expanding the usable comb channel and/or by deploying multiple fiber scattering links in parallel, paving a practical path toward higher throughput regimes.
High quality physical randomness is essential for secure information processing, random bit generation, and image encryption, while wavelength-parallel entropy generation provides an effective route to increasing the number of available physical random channels. In this work, we develop an all fiber, dual-end-pumped, dual section erbium-doped random fiber laser (ERFL) by combining distributed Rayleigh feedback with intracavity Sagnac spectral filtering. The laser generates 24 wavelength channels over an approximately 6.7-nm spectral range. Synchronously measured intensity fluctuations are evaluated across all 276 distinct channel pairs using the repeat-averaged absolute zero-delay Pearson correlation coefficient. The median coefficient is 0.0052, with 98.2% of the channel pairs at or below 0.02. Mutual-information analysis further supports weak nonlinear dependence between the wavelength channels. The intensity sequences obtained from different wavelength channels are further used to derive physical key material for authenticated image encryption and decryption. The representative ciphertext exhibits a near-uniform gray-level histogram and weak adjacent-pixel correlations, while authenticated decryption with the correct key recovers the original image exactly. These results demonstrate a 24-channel, low cross correlation, all fiber ERFL platform for wavelength-parallel physical entropy generation and information security applications.
High quality physical randomness is essential for secure information processing, random bit generation, and image encryption, while wavelength-parallel entropy generation provides an effective route to increasing the number of available physical random channels. In this work, we develop an all fiber, dual-end-pumped, dual section erbium-doped random fiber laser (ERFL) by combining distributed Rayleigh feedback with intracavity Sagnac spectral filtering. The laser generates 24 wavelength channels over an approximately 6.7-nm spectral range. Synchronously measured intensity fluctuations are evaluated across all 276 distinct channel pairs using the repeat-averaged absolute zero-delay Pearson correlation coefficient. The median coefficient is 0.0052, with 98.2% of the channel pairs at or below 0.02. Mutual-information analysis further supports weak nonlinear dependence between the wavelength channels. The intensity sequences obtained from different wavelength channels are further used to derive physical key material for authenticated image encryption and decryption. The representative ciphertext exhibits a near-uniform gray-level histogram and weak adjacent-pixel correlations, while authenticated decryption with the correct key recovers the original image exactly. These results demonstrate a 24-channel, low cross correlation, all fiber ERFL platform for wavelength-parallel physical entropy generation and information security applications.
Abstract Correlations existing among spectral components in multi‐wavelength lasers have remained a fundamental constraint impeding their development as chaotic comb entropy sources for parallel random bit generation. Herein, spectrotemporally uncorrelated multi‐order Stokes/anti‐Stokes emissions are achieved by exploiting cascaded stimulated Brillouin scattering and quasi‐phase‐matched four‐wave mixing in a random fiber laser. The proposed configuration introduces random instabilities arising from random mode resonance while enabling disordered energy redistribution across different lasing lines, which thereby effectively eliminates the inherent correlation between multiple Stokes/anti‐Stokes emission lines, realizing a spectrotemporally uncorrelated chaotic frequency comb. Parallel fast random bit generation is fulfilled using 31 channels, with a single‐channel bit rate of 35‐Gbps and a total bit rate of 1.085‐Tbps. This work, in a simple and efficient way, breaks the spectrotemporally correlation barrier for utilizing a multi‐wavelength laser to achieve a high‐quality chaotic laser source, opening new avenues for achieving greatly accelerated random bit generation through parallelization and offering potential benefits for future developments in secure communication and high‐performance computing systems.
Physical random numbers (PRNs) own various advantageous characteristics, including unpredictability, non-repeatability, higher security and reliability. Meanwhile, laser chaos has attracted great attention in the field of PRN. In terms of single channel PRN, laser chaos schemes can achieve a much higher bit-rate than traditional quantum PRN schemes. So far, various laser chaos PRN schemes have been discussed in order to enhance the performance of single channel laser chaos PRN. However, considering the limited bandwidth of laser chaos, especially the bandwidth of digital electronic circuit, the development potential of single channel PRN should be limited and may fall into the trap of high performance and expensive cost. Recently, the applications of multi-channel parallel PRN schemes have been developed. These parallel types may balance the high performance of PRN in a low cost. Recent progress indicates that chaotic micro-comb may have good potential. The micro-comb exhibits highly nonlinear and complex dynamic characteristics, and each comb tooth may show chaotic oscillation. The wavelength division multiplexing technology enables large-scale optical parallel output, providing the possiblity for large-scale parallel PRN generation. However, most of these PRN schemes are offline rather than true online and real-time random numbers. Thus, the development of real, online real-time parallel PRN solutions has great interest and research value in related fields. Herein we experimentally demonstrat an ultra-high-speed parallel real-time physical random number generator, which is achieved though the combination of chaotic micro-comb of chip-scale Si3N4 ultra-high Q micro-resonator and a high-speed field programmable gate array (FPGA). The results show that the Si3N4 ultra-high Q micro-resonator generates a micro-comb with hundreds of channels, each channel can route into an optically chaotic state, and become an excellent physical entropy source. Using FPGA onboard multi-bit analog-to-digital converter, the filtered optical chaos signal from the micro-comb is discretely sampled and quantized, and resulting in an 8-bit binary bitstream. Taking real-time self-delayed exclusive or (XOR) processing of bitstream and preserving 4 least significant bits, the qualified physical random bitstream with real-time 5 Gbits/s rate is realized experimentally. Considering that there are 294 chaotic comb teeths, our approach anticipates a throughput of 1.74 Tbits/s of real-time physical random bits. Our results could offer a new integrated and ultra-high-speed option for real-time physical random number sources.