Quantum computing is a relatively new computing paradigm that leverages entanglement to implement algorithms beyond the reach of classical hardware. Superconducting quantum circuits have emerged as a platform to build quantum processors, with demonstrations of quantum supremacy over classical supercomputers and quantum error correction beyond fault tolerance. However, current noisy devices require significant improvements to unlock the full potential of quantum algorithms.This thesis investigates intrinsic noise channels in superconducting circuits and the design of noise-resilient qubits. By characterizing high-quality superconducting resonators, we identify lossy dielectric materials at the interfaces as the dominant loss mechanism, which we mitigate via targeted surface treatments. Subsequently, we leverage Josephson junction nonlinearity to engineer noise-biased qubits utilizing the Kerr parametric oscillator (KPO). By analyzing the efficiency of strong, far-off-resonance driving to facilitate three- and four-wave mixing processes, we demonstrate high-fidelity operations on Fock, Kerr-cat, and dual-rail qubits. For the Kerr-cat qubit, we introduce a novel 2D architecture that enables strong light-matter coupling with suppressed Purcell decay, yielding millisecond-scale bit-flip lifetimes. Within this same architecture, we demonstrate a longitudinal qubit readout with a $99.6\%$ quantum nondemolition score, alongside a high-fidelity universal single-qubit gate set, all while maintaining bit-flip error suppression. Finally, we exploit the efficient wave-mixing of strongly coupled, far-detuned KPOs to realize a dynamically protected dual-rail qubit exhibiting both erasure bias and high-fidelity single-qubit gates.
Quantum computing is a relatively new computing paradigm that leverages entanglement to implement algorithms beyond the reach of classical hardware. Superconducting quantum circuits have emerged as a platform to build quantum processors, with demonstrations of quantum supremacy over classical supercomputers and quantum error correction beyond fault tolerance. However, current noisy devices require significant improvements to unlock the full potential of quantum algorithms.This thesis investigates intrinsic noise channels in superconducting circuits and the design of noise-resilient qubits. By characterizing high-quality superconducting resonators, we identify lossy dielectric materials at the interfaces as the dominant loss mechanism, which we mitigate via targeted surface treatments. Subsequently, we leverage Josephson junction nonlinearity to engineer noise-biased qubits utilizing the Kerr parametric oscillator (KPO). By analyzing the efficiency of strong, far-off-resonance driving to facilitate three- and four-wave mixing processes, we demonstrate high-fidelity operations on Fock, Kerr-cat, and dual-rail qubits. For the Kerr-cat qubit, we introduce a novel 2D architecture that enables strong light-matter coupling with suppressed Purcell decay, yielding millisecond-scale bit-flip lifetimes. Within this same architecture, we demonstrate a longitudinal qubit readout with a 99.6% quantum nondemolition score, alongside a high-fidelity universal single-qubit gate set, all while maintaining bit-flip error suppression. Finally, we exploit the efficient wave-mixing of strongly coupled, far-detuned KPOs to realize a dynamically protected dual-rail qubit exhibiting both erasure bias and high-fidelity single-qubit gates.
Quantum computing promises exponential advantages for simulating quantum systems and solving certain computational problems beyond the reach of classical computers, but the fragility of qubits and the resulting errors present a major challenge for scalable implementations. One promising approach is to engineer qubits whose physical noise processes are intrinsically biased, enabling more efficient quantum error correction. This dissertation investigates quantum computing with superconducting Kerr-cat qubits, a bosonic qubit architecture in which qubit states are encoded in coherent states of a nonlinear oscillator stabilized by a two-photon drive. This stabilization creates an effective double-well pseudo-potential that strongly suppresses bit-flip errors while enabling universal quantum control, leading to a noise-biased qubit. A superconducting device architecture based on SNAIL nonlinear oscillators is developed to realize Kerr-cat qubits with tunable parameters and high coherence, integrating readout resonators, dedicated filters, and microwave control lines for measurement and manipulation. Universal single-qubit gates are implemented using engineered single-photon and two-photon drives to deform the pseudo-potential, and a cat-quadrature readout method is employed to achieve high-fidelity quantum nondemolition measurement. The performance of the qubits is systematically characterized through lifetime measurements and benchmarking protocols, including quantum process tomography, gate set tomography, and dihedral randomized benchmarking, revealing a strongly biased noise structure with high performance. These results establish an experimental framework for the design, control, and characterization of Kerr-cat qubits and demonstrate their potential as hardware-efficient building blocks for scalable fault-tolerant quantum computing.
This thesis explores novel strategies for advancing superconducting quantum computing through a series of experimental investigations and device innovations. Grounded in the development of circuit quantum electrodynamics, the work addresses the challenges posed by the limitations of coherent control, coherence time and scaling of superconducting qubits. Focusing on transmon qubits, the thesis first reviews the foundational principles of circuit quantum electrodynamics and the critical role of the transmon in achieving robust qubit performance. Three experimental studies form the core of this work. The first study demonstrates a universal quantum gate set for strongly coupled transmons. By exploiting the residual ZZ interaction, the work introduces a novel two-axis gate protocol for single-qubit operations and implements both CZ and CNOT gates with high fidelities, highlighting the potential for fast, low-error quantum operations in the strong coupling regime. The second study investigates a dual-rail qubit architecture using parametrically coupled transmons, showcasing a hardware-efficient approach to quantum error correction. This experiment converts single-photon loss errors into detectable erasures and leverages mid-circuit detection to enhance qubit coherence, thereby advancing fault-tolerant quantum computing schemes in the NISQ era. The final study focuses on the development of merged-element transmons (MET) and their FinMET variants. By integrating the Josephson junction and shunt capacitor into a single trilayer device, these innovations achieve a dramatic reduction in device footprint while addressing loss channels through advanced materials engineering, ultimately paving the way for scalable, high-coherence quantum circuits. Collectively, these contributions demonstrate significant progress in quantum gate design, error mitigation, and qubit architecture, offering promising routes toward the realization of largescale, fault-tolerant quantum computers
Cat qubits exhibit a strong noise bias, meaning that errors are predominantly confined to a single error channel, which can be corrected using a simple one-dimensional error correction code. As a result, cat qubits quadratically reduce the number of physical qubits required to realise a fully protected logical qubit compared with conventional surface codes. Recently a Kerr cat qubit was for the first time controlled with four-wave mixing in a SNAIL device. In this project we propose a circuit architecture adapted for four-wave mixing in the form of a capacitively shunted Josephson junction array which we call Kerr Josephson junction array oscillator (KJJA-oscillator). The device is fixed in frequency and not flux tunable, making it resilient to flux noise. Moreover the device strongly suppresses high order non-linearities, and therefore offers low intrinsic dephasing. The mathematical description of the KJJA-oscillator is developed, from which two KJJA-oscillators is designed. With four wave mixing the squeezing term of the Kerr Hamiltonian is realised with two separate drives slightly detuned from the cavity. This makes it possible to place cavities in the full frequency range of the signal generator. The Kerr is chosen as a neutral value in the trade-off between fast operations and long coherence times, based of previous results in the literature. The fabricated chip is characterised and found to exhibit low coherence times, most likely due to low fabrication quality. There is no known direct readout mechanism for four-wave mixing known to the author, instead an ancillary transmon was used to perform parity measurements. To showcase the readout mechanism Wigner-tomography of the vacuum state was measured. Due to the time constraints of the thesis there was not time to stabilise cats and show noise biasing properties. The chip will in the future be used to show how noise biasing scales with increasing cat state size and for demonstration of a universal single gate set.
Josephson junctions are a fundamental building block of superconducting quantum circuits. They provide the nonlinearity required to realize quantum bits and enable a wide range of nonlinear phenomena central to quantum technologies. This thesis explores two superconducting systems in which this nonlinearity plays a central role. In the first part, we investigate a superconducting resonator terminated by a superconducting quantum interference device (SQUID), an arrangement of two Josephson junctions connected in parallel. The SQUID provides a tunable Kerr nonlinearity and allows the resonator to be driven parametrically. Under the combined action of the parametric drive, Kerr nonlinearity, and dissipation to the environment, the state of the resonator can undergo abrupt changes as the pump frequency or amplitude is varied. We interpret these changes within the framework of dissipative phase transitions (DPTs). By implementing a finite-component thermodynamic limit, we experimentally and theoretically investigate both first- and second-order DPTs in this system. We characterize their steady-state and dynamical signatures, including squeezing below vacuum, phase coexistence, hysteresis, spontaneous symmetry breaking, and critical slowing down. Finally, we exploit the enhanced susceptibility near the second-order critical point to implement a frequency-estimation protocol. We show that the estimation precision scales quadratically with the effective system size, demonstrating that finite-component DPTs can provide a quantum advantage in a sensing protocol. In the second part, we investigate a novel architecture for the readout of superconducting qubits. Conventional dispersive readout relies on a transverse interaction between a transmon and a resonator, which can lead to Purcell decay and measurement-induced state transitions, ultimately limiting the readout fidelity. To overcome these limitations, we implement a nonlinear coupling by galvanically connecting the transmon and resonator through a Josephson junction. This interaction provides a strong cross-Kerr coupling for clear state discrimination, but also introduces a detrimental transverse interaction. We experimentally show that the exchange part of the transverse interaction can be suppressed by adding a capacitor in parallel with the coupling junction while preserving the strong cross-Kerr coupling. In addition, we show that the same circuit acts as an intrinsic Purcell filter, protecting the qubit against Purcell decay. The coupling junction also induces a Kerr nonlinearity in the resonator, which we exploit to implement a bifurcation readout with a 99.4 % fidelity in a 68 ns integration time. This performance is achieved without a dedicated Purcell filter or a near-quantum-limited amplifier. Overall, this thesis demonstrates the engineering of nonlinear superconducting circuits to investigate dissipative phase transitions, exploit criticality for enhanced quantum sensing, and develop a novel qubit readout architecture enabling fast, high-fidelity measurement.
A mission to demonstrate quantum advantages and fault-tolerant quantum computing has drawn significant attention to the engineering challenges related to the design, construction, and operation of large-scale quantum computers. Among various quantum computing platforms, superconducting quantum circuits, which utilize artificially engineered macroscopic atoms - superconducting qubits, have achieved remarkable milestones in large-scale quantum information processors. However, even with state-of-the-art superconducting quantum circuits, executing a practical quantum algorithm still remains challenging due to finite coherence times and noisy quantum gate errors. To resolve noisy and short quantum coherent hardware, discrepancies between the design and the fabricated hardware need to be elucidated. In this thesis, we reexamine the fundamental premises to characterize superconducting quantum circuits, starting from the calculation of the physical properties of superconducting materials. By employing the finite surface impedance of superconducting materials, we reconstruct and improve conventional circuit quantization methods to accurately reflect the nonlinear frequency responses in the Hamiltonian of quantum circuits. Consequently, engineering of key circuit components becomes available with high-precision. Then, we present novel engineering schemes for realizing scalable, space-efficient, and high-coherence circuit components, including Purcell filters and superconducting transmon qubits. The works in this thesis offer a valuable approach toward the realization of scalable quantum computing architectures through the integration of nonlinear superconducting characteristics.
Quantum error correction using erasure qubits offers higher fault-tolerant thresholds and improved scaling by converting dominant physical errors into detectable erasures. In superconducting circuits, erasure qubits can be constructed using the dual-rail approach, which, however, requires additional qubit-count overhead and tailored coupling elements. Here, we demonstrate a hardware-efficient scheme that operates transmon qutrits as erasure qubits, which is compatible with standard superconducting circuit-QED hardware. The logical states ∣0L⟩ and ∣1L⟩ are represented by the ground and second excited states, while the dominant relaxation errors can be detected via an ancilla qubit using a microwave-activated two-qutrit SWAP gate. We demonstrate a logical qubit T1 lifetime exceeding 500μs, post-selected with repeated mid-circuit erasure detection, which is ten times longer than the T1 time of the transmon physical qubit. Coherence times beyond 300μs are achieved using dynamical decoupling. Single-qubit gate operations reach average Clifford gate infidelity on the order of 10−4. We further demonstrate dual-purposing an ancilla qubit for both erasure detection and parity checking, showing heralded generation of Bell states between erasure qubits. These results suggest that mainstream architectures of transmon qubit arrays may already be capable of implementing erasure-based QEC strategies for hardware-efficient fault-tolerant quantum computing.