Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

AIP Advances

A 1.4 GHz radio frequency source with low phase noise and fast modulation for cold atom experiments

朱明毅 Zhu Mingyi, 冯佩军 Feng Peijun, Xinyun Huang, De-Quan Kong, Xinwei Jiang, Dandan Qin, Yuhong Lin, Tan Rao, Xiao Qiang Jiang

Published Aug 1, 2026• 0 citations
Publisher

Abstract

We present a radio frequency source based on the AD9914 direct digital synthesizer chip, with a frequency range up to 1.4 GHz. The phase noise at an output frequency of 1 GHz is lower than −110 dBc/Hz at a 10 kHz offset. Through an optimized design of a field-programmable gate array, we have achieved the theoretical maximum modulation rate of AD9914 and developed multiple functional modules for cold atom experiments to implement modulation of frequency, phase, and amplitude. The modulation update rate reaches 146 MHz. The phase modulation response latency is 158 ns, and the amplitude modulation response latency is 95.1 ns. We have applied the RF source to a sideband Pound–Drever–Hall locking experiment and achieved frequency stabilization, demonstrating its suitability for cold atom experiments that require precise and complex laser control.

DOI
10.1063/5.0331604

Related papers

Dynamical low-noise microwave source for cold-atom experiments

Bernd Meyer-Hoppe, Maximilian Baron, Christophe Cassens +4 more

The generation and manipulation of ultracold atomic ensembles in the quantum regime require the application of dynamically controllable microwave fields with ultra-low noise performance. Here, we present a low-phase-noise microwave source with two independently controllable output paths. Both paths generate frequencies in the range of 6.835 GHz ± 25 MHz for hyperfine transitions in 87Rb. The presented microwave source combines two commercially available frequency synthesizers: an ultra-low-noise oscillator at 7 GHz and a direct digital synthesizer for radio frequencies. We demonstrate a low integrated phase noise of 480 µrad in the range of 10 Hz to 100 kHz and fast updates of frequency, amplitude, and phase in sub-µs time scales. The highly dynamic control enables the generation of shaped pulse forms and the deployment of composite pulses to suppress the influence of various noise sources.

arXiv:2003.10989•Review of Scientific Instruments•Jul 1, 2023•12 citations

Note: A versatile radio-frequency source for cold atom experiments

Na Li, Yu-Ping Wu, Hao Min +2 more

A radio-frequency (RF) source designed for cold atom experiments is presented. The source uses AD9858, a direct digital synthesizer, to generate the sine wave directly, up to 400 MHz, with sub-Hz resolution. An amplitude control circuit consisting of wideband variable gain amplifier and high speed digital to analog converter is integrated into the source, capable of 70 dB off isolation and 4 ns on-off keying. A field programmable gate array is used to implement a versatile frequency and amplitude co-sweep logic. Owing to modular design, the RF sources have been used on many cold atom experiments to generate various complicated RF sequences, enriching the operation schemes of cold atoms, which cannot be done by standard RF source instruments.

Review of Scientific Instruments•Aug 1, 2016•6 citations

A low phase noise microwave source for atomic spin squeezing experiments in 87Rb

Zilong Chen, Justin G. Bohnet, Joshua M. Weiner +1 more

We describe and characterize a simple, low cost, low phase noise microwave source that operates near 6.800 GHz for agile, coherent manipulation of ensembles of (87)Rb. Low phase noise is achieved by directly multiplying a low phase noise 100 MHz crystal to 6.8 GHz using a nonlinear transmission line and filtering the output with custom band-pass filters. The fixed frequency signal is single sideband modulated with a direct digital synthesis frequency source to provide the desired phase, amplitude, and frequency control. Before modulation, the source has a single sideband phase noise near -140 dBc/Hz in the range of 10 kHz-1 MHz offset from the carrier frequency and -130 dBc/Hz after modulation. The resulting source is estimated to contribute added spin-noise variance 16 dB below the quantum projection noise level during quantum nondemolition measurements of the clock transition in an ensemble 7 × 10(5) (87)Rb atoms.

arXiv:1204.4215•Review of Scientific Instruments•Apr 1, 2012•23 citations

A compact and fast radio-frequency source for efficient Raman sideband cooling

Liren Pang, Zhiyu Ma, Biao Wang +7 more

A compact and fast radio-frequency (RF) source developed for Raman sideband cooling (RSBC) in trapped ion and cold atom experiments is presented. The source is based on direct digital synthesizer, advanced real-time infrastructure for quantum physics, and field programmable gate array. The source has a frequency switching speed of 40 ns and can output continuous μs-level time sequences for RSBC. The maximum output frequency of the source is 1.4 GHz. The RF source is capable of pre-writing data for eight channels. As a demonstration, the RF source is applied to our 25Mg+-27Al+ ion pair optical clock experiment. In order to cool down the ion pair to the vibrational ground state, two-order RSBC is applied to the 25Mg+ ion. As a result, the ion pair motions in the three X, Y, and Z directions are all cooled to the vibrational ground state efficiently, demonstrating the feasibility of this technique. The developed RF source can be widely implemented for other cold atom experiments.

Review of Scientific Instruments•Dec 1, 2024•3 citations

Compact field programmable gate array-based pulse-sequencer and radio-frequency generator for experiments with trapped atoms

Thaned Pruttivarasin, Hidetoshi Katori

We present a compact field-programmable gate array (FPGA) based pulse sequencer and radio-frequency (RF) generator suitable for experiments with cold trapped ions and atoms. The unit is capable of outputting a pulse sequence with at least 32 transistor-transistor logic (TTL) channels with a timing resolution of 40 ns and contains a built-in 100 MHz frequency counter for counting electrical pulses from a photo-multiplier tube. There are 16 independent direct-digital-synthesizers RF sources with fast (rise-time of ∼60 ns) amplitude switching and sub-mHz frequency tuning from 0 to 800 MHz.

arXiv:1507.03122•Review of Scientific Instruments•Nov 1, 2015•34 citations

Design of a Board-Level Integrated Multi-Channel Radio Frequency Source for the Transportable 40Ca+ Ion Optical Clock

Bin Wang, Yuanhang Yang, Huaqing Zhang +5 more

As one of the most precise timekeeping instruments ever developed, the optical clock will be used as the measuring equipment for the next generation of second definition. The demand for the miniaturization of optical clocks is progressively urgent. In this paper, a multi-channel radio frequency (RF) module with a 20% volume of the commercial module is designed and implemented for the transportable 40Ca+ ion optical clock. Based on the double-crystal oscillator interlocking technique, a 1 GHz low-phase noise reference source is developed for direct digital synthesis. Through the simulation and optimization of the signal link design, the frequency range of the low phase-noise RF signal can reach 0–400 MHz with a 4 μHz resolution. Through two-stage power amplifying with different kinds of filters, it can achieve an output power of up to +33 dBm (2 W) at 100 MHz with a 25 dB phase noise lower than the commercial module at 1 Hz, and its third harmonic suppression ratio has been reduced by more than 20 dB at the frequency point of 300 MHz. This multi-channel RF module is used for the power stability and timing control test of a 729 nm clock laser to meet the requirements of the transportable 40Ca+ optical clock. Additionally, this module can also be applied to other quantum systems such as the quantum absolute gravimeter, quantum gyroscopes, and quantum computers.

Sensors•Feb 10, 2025•0 citations
We present a radio frequency source based on the AD9914 direct digital synthesizer chip, with a frequency range up to 1.4 GHz. The phase noise at an output frequency of 1 GHz is lower than −110 dBc/Hz at a 10 kHz offset. Through an optimized design of a field-programmable gate array, we have achieved the theoretical maximum modulation rate of AD9914 and developed multiple functional modules for cold atom experiments to implement modulation of frequency, phase, and amplitude. The modulation update rate reaches 146 MHz. The phase modulation response latency is 158 ns, and the amplitude modulation response latency is 95.1 ns. We have applied the RF source to a sideband Pound–Drever–Hall locking experiment and achieved frequency stabilization, demonstrating its suitability for cold atom experiments that require precise and complex laser control.
The generation and manipulation of ultracold atomic ensembles in the quantum regime require the application of dynamically controllable microwave fields with ultra-low noise performance. Here, we present a low-phase-noise microwave source with two independently controllable output paths. Both paths generate frequencies in the range of 6.835 GHz ± 25 MHz for hyperfine transitions in 87Rb. The presented microwave source combines two commercially available frequency synthesizers: an ultra-low-noise oscillator at 7 GHz and a direct digital synthesizer for radio frequencies. We demonstrate a low integrated phase noise of 480 µrad in the range of 10 Hz to 100 kHz and fast updates of frequency, amplitude, and phase in sub-µs time scales. The highly dynamic control enables the generation of shaped pulse forms and the deployment of composite pulses to suppress the influence of various noise sources.
A radio-frequency (RF) source designed for cold atom experiments is presented. The source uses AD9858, a direct digital synthesizer, to generate the sine wave directly, up to 400 MHz, with sub-Hz resolution. An amplitude control circuit consisting of wideband variable gain amplifier and high speed digital to analog converter is integrated into the source, capable of 70 dB off isolation and 4 ns on-off keying. A field programmable gate array is used to implement a versatile frequency and amplitude co-sweep logic. Owing to modular design, the RF sources have been used on many cold atom experiments to generate various complicated RF sequences, enriching the operation schemes of cold atoms, which cannot be done by standard RF source instruments.
We describe and characterize a simple, low cost, low phase noise microwave source that operates near 6.800 GHz for agile, coherent manipulation of ensembles of (87)Rb. Low phase noise is achieved by directly multiplying a low phase noise 100 MHz crystal to 6.8 GHz using a nonlinear transmission line and filtering the output with custom band-pass filters. The fixed frequency signal is single sideband modulated with a direct digital synthesis frequency source to provide the desired phase, amplitude, and frequency control. Before modulation, the source has a single sideband phase noise near -140 dBc/Hz in the range of 10 kHz-1 MHz offset from the carrier frequency and -130 dBc/Hz after modulation. The resulting source is estimated to contribute added spin-noise variance 16 dB below the quantum projection noise level during quantum nondemolition measurements of the clock transition in an ensemble 7 × 10(5) (87)Rb atoms.
A compact and fast radio-frequency (RF) source developed for Raman sideband cooling (RSBC) in trapped ion and cold atom experiments is presented. The source is based on direct digital synthesizer, advanced real-time infrastructure for quantum physics, and field programmable gate array. The source has a frequency switching speed of 40 ns and can output continuous μs-level time sequences for RSBC. The maximum output frequency of the source is 1.4 GHz. The RF source is capable of pre-writing data for eight channels. As a demonstration, the RF source is applied to our 25Mg+-27Al+ ion pair optical clock experiment. In order to cool down the ion pair to the vibrational ground state, two-order RSBC is applied to the 25Mg+ ion. As a result, the ion pair motions in the three X, Y, and Z directions are all cooled to the vibrational ground state efficiently, demonstrating the feasibility of this technique. The developed RF source can be widely implemented for other cold atom experiments.
We present a compact field-programmable gate array (FPGA) based pulse sequencer and radio-frequency (RF) generator suitable for experiments with cold trapped ions and atoms. The unit is capable of outputting a pulse sequence with at least 32 transistor-transistor logic (TTL) channels with a timing resolution of 40 ns and contains a built-in 100 MHz frequency counter for counting electrical pulses from a photo-multiplier tube. There are 16 independent direct-digital-synthesizers RF sources with fast (rise-time of ∼60 ns) amplitude switching and sub-mHz frequency tuning from 0 to 800 MHz.
As one of the most precise timekeeping instruments ever developed, the optical clock will be used as the measuring equipment for the next generation of second definition. The demand for the miniaturization of optical clocks is progressively urgent. In this paper, a multi-channel radio frequency (RF) module with a 20% volume of the commercial module is designed and implemented for the transportable 40Ca+ ion optical clock. Based on the double-crystal oscillator interlocking technique, a 1 GHz low-phase noise reference source is developed for direct digital synthesis. Through the simulation and optimization of the signal link design, the frequency range of the low phase-noise RF signal can reach 0–400 MHz with a 4 μHz resolution. Through two-stage power amplifying with different kinds of filters, it can achieve an output power of up to +33 dBm (2 W) at 100 MHz with a 25 dB phase noise lower than the commercial module at 1 Hz, and its third harmonic suppression ratio has been reduced by more than 20 dB at the frequency point of 300 MHz. This multi-channel RF module is used for the power stability and timing control test of a 729 nm clock laser to meet the requirements of the transportable 40Ca+ optical clock. Additionally, this module can also be applied to other quantum systems such as the quantum absolute gravimeter, quantum gyroscopes, and quantum computers.