Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Lecture notes in electrical engineering

A Superconducting Qubit Network as a Sensitive Microwave Photon Detector

Valentina Di Meo, G. Brida, F. Chiarello, Alessandro D’Elia, Emanuele Enrico, Ilya Eremin, Luca Fasolo, M. V. Fistul, Claudio Gatti, Patrick Navez, A. Rettaroli, B. Ruggiero, P. Silvestrini, Paolo Vanacore, Alexandre M. Zagoskin, Mikhail Lisitskiy

Published Jan 1, 2026• 0 citations
Publisher
DOI
10.1007/978-3-032-17305-8_10

Related papers

Microwave photon detector using a superconducting quantum circuit

K. Inomata, Lin Zhirong, Kazuki Koshino +4 more

IEICE Technical Report; IEICE Tech. Rep.•Oct 19, 2016•0 citations

A Superconducting Single Microwave Photon Detector Enabled by Dissipation Engineering - Experiment

Emmanuel Flurin, Raphaël Lescanne, S. Deléglise +1 more

Bulletin of the American Physical Society•Mar 7, 2019•0 citations

Coherent Quantum Network of Superconducting Qubits as a Highly Sensitive Detector of Microwave Photons for Searching of Galactic Axions

Claudio D. Gatti, M. Affronte, Alexander G. Balanov +30 more

We propose a novel approach to detect a low power microwave signal with a frequency of the order of several GHz based on a coherent collective response of quantum states occurring in a superconducting qubits network (SQN). An SQN composes of a large number of superconducting qubits embedded in a low-dissipative superconducting resonator. Our theory predicts that an SQN interacting with the off-resonance microwave radiation, demonstrates the collective alternating current Stark effect that can be measured even in the limit of single photon counting. A design of the layout of three terminals SQN detectors containing 10 flux qubits weakly coupled to a low-dissipative R-resonator and T-transmission line was developed. The samples were fabricated by Al-based technology with Nb resonator. The SQN detector was tested in terms of microwave measurements of scattering parameters and two-tone spectroscopy. A substantial shift of the frequency position of the transmission coefficient drop induced by a second tone pump signal was observed, and this effect clearly manifests a nonlinear multiphoton interaction between the second-tone microwave pump signal and an array of qubits.

IEEE Transactions on Applied Superconductivity•Apr 6, 2023•4 citations

Superconducting Qubit Network as a Single Microwave Photon Detector for Galactic Axion Search

Emanuele Enrico, C. Bonavolontà, G. Brida +13 more

Experimental search of galactic axions requires detection of single photons in the microwave range. We work on a novel approach to detect single microwave photons based on a coherent collective response of quantum states occurring in a superconducting qubit network (SQN) embedded in a lowdissipative superconducting resonator. We propose a two resonators detector configuration with two parallel resonators without common part and with separated input and output terminals. The device consists of a low-dissipative resonator with embedded SQN in which microwave photons arrive (“signal resonator”), and a transmission line for measuring the frequency dependent transmission coefficient demonstrating resonant drops at the qubit frequencies (“readout resonator”). In comparison with T-type three terminal device recently proposed and investigated by us, the device with two resonators with separated input and output terminals doesn't contain common part of both resonators and exclude an unwanted noise from measurement readout circuits to the signal resonator. A layout of two resonators four terminal SQN detectors containing 5 flux qubits weakly coupled to a low-dissipative signal and readout resonator was developed and optimized. The samples were fabricated by Manhattan Al-based technology with Nb resonator circuits. The SQN detector was experimentally tested in terms of microwave measurements of scattering parameters of both resonators, and crosstalk properties. Comparison of experimental data with results of the simulations permits one to conclude that the electromagnetic conditions of the fundamental resonant peak of 8.5 GHz of both resonators aren't affected by the crosstalk phenomenon and their performances provided by the design remain not altered for correct device operation

IEEE Transactions on Applied Superconductivity•Dec 8, 2023•1 citation

Microwave Single-Photon Detection Using Superconducting Quantum Circuits

Ivan Iakoupov, Yuichiro Matsuzaki, William J. Munro +1 more

The Japan Society of Applied Physics•Jul 10, 2019•0 citations

Noise Mitigation in Single Microwave Photon Counting by Cascaded Quantum Measurements

Alexandre S. May, Leo Sutevski, Jeanne Solard +8 more

Single-photon detection in the microwave domain has recently emerged as a powerful tool for quantum sensing, offering a path beyond the standard quantum limit of linear amplification since their sensitivity is set by their dark-count rate rather than by the vacuum fluctuations of the detected field. Superconducting qubit-based single microwave photon detectors (SMPDs) encode the absorption of itinerant photons into discrete quantum states via engineered, non-destructive interactions. A previously demonstrated implementation based on four-wave mixing achieved high efficiency, but remained limited by residual qubit excitation and thermal noise at the detector input. Here, we propose and demonstrate a new SMPD that relies on two cascaded four-wave mixing processes. The information on photon detection is encoded on two spatially separated qubits, which mitigates noise due to uncorrelated qubit errors. Furthermore, increasing the detection frequency up to 11.7 GHz reduces input thermal noise. These combined advances lead to a record-low power sensitivity of $2.4 \cdot 10^{-23}\mathrm{W}/\sqrt{\mathrm{Hz}}$ over a bandwidth of $230\ \mathrm{kHz}$.

quant-pharXiv:2502.14804•Feb 21, 2025•7 citations
We propose a novel approach to detect a low power microwave signal with a frequency of the order of several GHz based on a coherent collective response of quantum states occurring in a superconducting qubits network (SQN). An SQN composes of a large number of superconducting qubits embedded in a low-dissipative superconducting resonator. Our theory predicts that an SQN interacting with the off-resonance microwave radiation, demonstrates the collective alternating current Stark effect that can be measured even in the limit of single photon counting. A design of the layout of three terminals SQN detectors containing 10 flux qubits weakly coupled to a low-dissipative R-resonator and T-transmission line was developed. The samples were fabricated by Al-based technology with Nb resonator. The SQN detector was tested in terms of microwave measurements of scattering parameters and two-tone spectroscopy. A substantial shift of the frequency position of the transmission coefficient drop induced by a second tone pump signal was observed, and this effect clearly manifests a nonlinear multiphoton interaction between the second-tone microwave pump signal and an array of qubits.
Experimental search of galactic axions requires detection of single photons in the microwave range. We work on a novel approach to detect single microwave photons based on a coherent collective response of quantum states occurring in a superconducting qubit network (SQN) embedded in a lowdissipative superconducting resonator. We propose a two resonators detector configuration with two parallel resonators without common part and with separated input and output terminals. The device consists of a low-dissipative resonator with embedded SQN in which microwave photons arrive (“signal resonator”), and a transmission line for measuring the frequency dependent transmission coefficient demonstrating resonant drops at the qubit frequencies (“readout resonator”). In comparison with T-type three terminal device recently proposed and investigated by us, the device with two resonators with separated input and output terminals doesn't contain common part of both resonators and exclude an unwanted noise from measurement readout circuits to the signal resonator. A layout of two resonators four terminal SQN detectors containing 5 flux qubits weakly coupled to a low-dissipative signal and readout resonator was developed and optimized. The samples were fabricated by Manhattan Al-based technology with Nb resonator circuits. The SQN detector was experimentally tested in terms of microwave measurements of scattering parameters of both resonators, and crosstalk properties. Comparison of experimental data with results of the simulations permits one to conclude that the electromagnetic conditions of the fundamental resonant peak of 8.5 GHz of both resonators aren't affected by the crosstalk phenomenon and their performances provided by the design remain not altered for correct device operation
Single-photon detection in the microwave domain has recently emerged as a powerful tool for quantum sensing, offering a path beyond the standard quantum limit of linear amplification since their sensitivity is set by their dark-count rate rather than by the vacuum fluctuations of the detected field. Superconducting qubit-based single microwave photon detectors (SMPDs) encode the absorption of itinerant photons into discrete quantum states via engineered, non-destructive interactions. A previously demonstrated implementation based on four-wave mixing achieved high efficiency, but remained limited by residual qubit excitation and thermal noise at the detector input. Here, we propose and demonstrate a new SMPD that relies on two cascaded four-wave mixing processes. The information on photon detection is encoded on two spatially separated qubits, which mitigates noise due to uncorrelated qubit errors. Furthermore, increasing the detection frequency up to 11.7 GHz reduces input thermal noise. These combined advances lead to a record-low power sensitivity of 2.4⋅10−23W/Hz2.4 \cdot 10^{-23}\mathrm{W}/\sqrt{\mathrm{Hz}}2.4⋅10−23W/Hz​ over a bandwidth of 230 kHz230\ \mathrm{kHz}230 kHz.