Quantum computers based on superconducting circuits are approaching quantum supremacy, which means they have the potential to perform specific tasks significantly faster than even the most powerful classical supercomputers. As a crucial component in the measurement chain, parametric amplifiers based on Josephson junctions are promising tools for the readout of superconducting qubits in the microwave range. In this contribution, we present a novel Lie algebra approach for modeling a Josephson junction-embedded traveling-wave parametric amplifier, characterized by a lossy dielectric substrate and nonlinear dispersion, and investigate the generation of entangled signal-idler photon pairs in a two-mode squeezed state.
Quantum computers based on superconducting circuits are approaching quantum supremacy, which means they have the potential to perform specific tasks significantly faster than even the most powerful classical supercomputers. As a crucial component in the measurement chain, parametric amplifiers based on Josephson junctions are promising tools for the readout of superconducting qubits in the microwave range. In this contribution, we present a novel Lie algebra approach for modeling a Josephson junction-embedded traveling-wave parametric amplifier, characterized by a lossy dielectric substrate and nonlinear dispersion, and investigate the generation of entangled signal-idler photon pairs in a two-mode squeezed state.
Superconducting parametric amplifiers have great promise for quantum-limited readout of superconducting qubits and detectors. Until recently, most superconducting parametric amplifiers had been based on resonant structures, limiting their bandwidth and dynamic range. Broadband traveling-wave parametric amplifiers based both on the nonlinear kinetic inductance of superconducting thin films and on Josephson junctions are in development. By modifying the dispersion property of the amplifier circuit, referred to as dispersion engineering, the gain can be greatly enhanced and the size can be reduced. We present two theoretical frameworks for analyzing and understanding such parametric amplifiers: 1) generalized coupled-mode equations and 2) a finite difference time domain (FDTD) model combined with a small signal analysis. We show how these analytical and numerical tools may be used to understand device performance.
Detecting single-photon level signals—carriers of both classical and quantum information—is particularly challenging for low-energy microwave frequency excitations. Here we introduce a superconducting amplifier based on a Josephson junction transmission line. Unlike current standing-wave parametric amplifiers, this traveling wave architecture robustly achieves high gain over a bandwidth of several gigahertz with sufficient dynamic range to read out 20 superconducting qubits. To achieve this performance, we introduce a subwavelength resonant phase-matching technique that enables the creation of nonlinear microwave devices with unique dispersion relations. We benchmark the amplifier with weak measurements, obtaining a high quantum efficiency of 75% (70% including noise added by amplifiers following the Josephson amplifier). With a flexible design based on compact lumped elements, this Josephson amplifier has broad applicability to microwave metrology and quantum optics.
The development of large-scale superconducting quantum computers critically depends on the accurate readout of qubit states. To enable this, cryogenic parametric amplifiers have been proposed and developed, and have since found widespread use in small-signal detection applications. Among various amplifier architectures, Josephson traveling-wave parametric amplifiers (JTWPAs) are widely adopted due to their broad bandwidth, high saturation power, and compatibility with superconducting qubits. In this work, we present a design workflow of JTWPAs based on a co-simulation approach combining electromagnetic (EM) and circuit-level simulation. We apply this method to a uniform JTWPA, comparing our simulation results with experimental data. To mitigate the challenge of constructing lumped element circuit models usually used in conventional simulation method, we directly perform full EM analysis of the device to accurately determine its linear response. The extracted S parameters are then fed into a nonlinear harmonic balance simulator with Josephson junctions modeled as circuit elements. By doing so, the linear and gain properties of the JTWPA are extracted. Different factors that impact device performance including gain compression, phase matching, and fabrication imperfections are further investigated and modeled. A good agreement between simulation and measurements is identified, establishing the effectiveness of our approach in designing quantum parametric amplifiers.
Josephson Traveling Wave Parametric Amplifier (JTWPA) has the potential to offer quantum limited noise and a large bandwidth. This amplifier is based on parametric amplification of microwaves traveling through a transmission line with embedded non-linear elements. In this paper, starting from the fabrication of the JTWPA, based on Quantum Electrodynamics (QEDs), operating as a non-classical quantum source for generating a signal-idler entangled state, its characterization in terms of scattering parameters is presented. The cryogenic and room temperature experimental results are discussed. The good performance of the JTWPA in terms of wide bandwidth and increased transmitted power, makes it an ideal candidate for Microwave Quantum Radar (MQR) applications. Finally, the performance of a MQR based on the JTWPA developed at INRiM are reported, showing a radar maximum range equal to 82.2 m, that represents the greatest value compared to previously published works.
In this paper, we present a density operator description for a dissipative-dispersive Josephson traveling-wave parametric amplifier. A quantum master equation has been derived for the description of dissipation and thermal fluctuations that arise from lossy dielectric substrates. The formalism is especially effective in the dispersive case. Based on the equation of motion of the system density operator, we investigate the amplification performance by predicting the signal gain and the total photon number, considering amplifier phase-mismatch present in real devices. In addition to the gain investigation, we perform a two-mode squeezing analysis for such structures.
Bringing signals from quantum to classical, from few-photon to many-photon levels for further processing, is a common challenge in rising quantum technologies. These include quantum computing, quantum communication, quantum sensing, radio astronomy, and dark matter searches, typically operating at microwave frequencies and millikelvin temperatures. Superconducting parametric amplifiers, as the first piece in the readout chain, have become a cornerstone of these technologies, since they offer unrivaled noise performance near the quantum-mechanical limit and high gain to surpass the noise of subsequent amplifiers. A notable implementation is the Josephson traveling-wave parametric amplifier (TWPA), which stands out due to its bandwidth of several Gigahertz and high saturation power, often larger than -100 dBm. These key properties come at the cost of complexity in design and fabrication: TWPA metamaterials often contain several thousands of Josephson junctions. Designing high-gain TWPAs involves three major challenges: ensuring impedance-matching, phase-matching of parametric amplification, and suppressing unwanted processes, all achievable through sub-wavelength dispersion engineering. This thesis covers the circuit design and analysis, implementation, and experimental characterization of a dispersion-engineered TWPA based on radio-frequency superconducting interference devices (rf-SQUIDs). It focuses on a detailed investigation of dispersion-engineering techniques and their effects on amplifier performance, particularly through the use of time-domain circuit simulations to analyze the multimode dynamics of the circuit. The experimentally realized device features 18 dB of gain, an instantaneous bandwidth spanning from 2.2 to 6.7 GHz, a system noise of 2.5 quanta, and a saturation power of (−86.5 ± 4.0) dBm. With these characteristics, it is suitable for frequency-multiplexed readout of detector arrays or qubits. Its high saturation power, about 10 dB higher than other reported Josephson-junction-based TWPAs, allows increasing the number of qubits per readout line, or decreasing the intermodulation between frequency-multiplexed qubits, both crucial for scaling up quantum computation.