Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

ACS Photonics

A Sub-10 pT·Hz –1/2 Diamond Quantum Sensor with 1/ f Noise Suppression Using 561 nm Laser Excitation

Xiao Peng, Qihui Liu, Chengyu Yang, Xiaolong Luo, Yuqiang Hu, Yuetong Jin, Changbao Xu, Mingyong Xin, Guofeng Zhang, Baifu Zhang, Zhenyu Wu, Hao Chen

Published Mar 24, 2026• 4 citations
Publisher

Abstract

The nitrogen–vacancy center in diamond enables highly sensitive magnetic-field measurements. In this work, we demonstrate an excellent sensitivity of 7.9 pT·Hz –1/2 in the near-DC range of 1 to 1000 Hz. This performance is achieved using a 35 mW laser power and 1 mW microwave power enabled by 561 nm laser excitation and the resonant-antenna design. By leveraging dual resonance with intrinsic π shift for real-time common-mode rejection, this technique effectively suppresses low-frequency noise and pushes the 1/ f corner frequency down to 1 Hz, with a measured sensitivity at 1 Hz of 10.6 pT·Hz –1/2 . The magnetometer also exhibits excellent capability in detecting magnetic anomalies, promoting the practical use of diamond quantum sensors in biomedical, geophysical, and other real-world applications.

DOI
10.1021/acsphotonics.6c00035

Related papers

A Highly Sensitive Diamond NV Magnetometer Using Ramsey Interferometry with a Short Sensor-to-Sample Distance

Yuta Araki, Takeharu Sekiguchi, Yuji Hatano +11 more

In this study, we developed a diamond quantum magnetometer based on Ramsey interferometry with a short sensor-to-sample distance. Conventional biomagnetic sensors with ensemble nitrogen-vacancy centers using continuous-wave optically detected magnetic resonance and Ramsey methods typically rely on watt-level lasers to achieve high sensitivity, resulting in thermal issues. In contrast, by employing the light-trapping diamond waveguide technique in a high-pressure and high-temperature diamond sample treated with electron beam irradiation, we obtained a high photon conversion efficiency of 9.5%, enabling us to simultaneously achieve a high sensitivity of 2.93(7) pT/Hz^1/2 in the 100-400 Hz frequency range and a minimal temperature increase of only approximately 13 K at a low laser power of 210 mW. Using a dry phantom designed to mimic magnetoencephalography signals, we measured a weak magnetic field of 77.7(2) pT without signal averaging at a sensor-to-sample distance of 2.5 mm. This short-distance measurement prevents severe spatial signal attenuation, yielding a high signal-to-noise ratio. The development here is crucial for practical biomagnetic applications based on Ramsey interferometry.

quant-pharXiv:2603.13754•Mar 17, 2026

Highly sensitive diamond quantum sensor with large sensor volume toward magnetoencephalography

雄太 増山, Takayuki Iwasaki, 睦子 波多野 +4 more

Nitrogen-vacancy (NV) color centers in diamond are promising solid-state quantum sensors working at room temperature. The number of NV centers limits the magnetic sensitivity of the quantum magnetometer. Increasing the number of NV centers is a challenging task due to technical issues such as microwave power density, detection noise.Here, we developed the sensor system with a large detection volume which contains a lot of NV centers. The microwave circuit enhances microwave power density. Digital filter with frequency modulation of microwave allows us to detect the magnetic field with low noise. Consequently, we obtained a DC magnetic field sensitivity of 980 pT/√Hz.This work was supported by MEXT Quantum Leap Flagship Program (MEXT Q-LEAP) Grant Number JPMXS0118067395.

•Dec 4, 2019•0 citations

Real-Time Magnetic Field Sensing based on Microwave Frequency Modulated Photocurrent of Nitrogen-Vacancy Centers in Diamond

Xuan-Ming Shen, Qilong Wu, Huihui Yu +6 more

While photoelectric detection of magnetic resonance (PDMR) can be applied to miniaturize nitrogen-vacancy (NV) center-based quantum sensors, real demonstration of PDMR-based magnetic field sensing remains as a distinctive challenge. To tackle this challenge, in this article, we fabricate diamond samples with electrodes and microwave antenna on the surface, and realize PDMR by detecting photocurrent in picoampere range via various lock-in amplifying modes. We obtain a theoretical and experimental sensitivity 397 nT/Hz and 921 nT/Hz of magnetic field detection in DC-10 Hz range with a laser intensity and microwave frequency modulation mode, respectively, and demonstrate for the first time, a real-time tracking of alternating magnetic field with a standard deviation of 1.5 uT. Furthermore, we investigate systematically the dependence of the PDMR contrast, linewidth and the sensitivity on the laser and microwave power, and find a perfect agreement with a master equation-based theory. Thus, our results represent a critical step forward in transitioning PDMR from a spectroscopic technique to a practical sensing modality.

quant-pharXiv:2602.07926•Feb 10, 2026

Microfabricated Active Laser Noise Suppression Device for a High-Sensitivity Diamond Quantum Magnetometer

Nan Wang, Yichen Liu, Yongquan Su +15 more

Nitrogen vacancy (NV) centers in diamonds have emerged as one of the most promising candidates for magnetic field sensing. However, the laser intensity fluctuation is coupled to the diamond fluorescence; thus, the sensitivity is severely affected by the noise and stability of the laser. Integrating both the diamond quantum sensor and laser noise suppression device is a crucial step toward miniaturization and practical applications. Here, we present a piezoelectric-driven device to dynamically adjust the laser noise cancelation with dimensions of 5 × 5 × 1.5 mm 3 based on a grating interferometer. This device incorporates a grating structure to produce diffracted reference light with high-accuracy intensity modulation, actively tracking the fluorescence signal for differential common-mode rejection (CMR), effectively eliminating laser noise in the system, whereby the sensitivity of magnetic field detection is increased by a factor of 34, reaching 160 pT · Hz –1/2, and beneficial to the long-term stability. The compact design of this laser noise suppressor, in combination with a miniaturized diamond magnetometer, demonstrates its potential for high-precision magnetic field detection ability and strong portability.

ACS Photonics•Jan 18, 2025•7 citations

Using NV centers in diamond to detect DC to very-low frequency magnetic fields

Valts Krumins, Ivars Krastins, Oskars Rudzitis +3 more

In this work we present a compact and portable tabletop magnetometer that utilizes negatively charged nitrogen-vacancy (NV) centers in diamond. The magnetometer is operated using a dual microwave resonance detection approach in combination with an optically detected magnetic resonance (ODMR) technique (mitigating drifts in results due to changes of the diamond temperature), capable of simultaneously exciting and registering two ODMR transitions. The experimentally measured magnetic field noise-floor is $\approx 2.3~\textrm{nT}\sqrt{\textrm{Hz}}$ while the calculated shot-noise-limited magnetic field sensitivity is $\approx 585~\textrm{pT}\sqrt{\textrm{Hz}}$ when excited with a continuous wave laser at 0.5~W. These results pave the way for realizing a simple set-up magnetometer for precise single axis magnetic field measurements for example for accurate electric current measurements for stabilization purposes and magnetic communication applications.

quant-pharXiv:2512.24273•Dec 31, 2025

Towards high-sensitivity magnetometry with nitrogen-vacancy centers in diamond using the singlet infrared absorption

Ali Tayefeh Younesi, Muhib Omar, Arne Wickenbrock +2 more

The negatively charged nitrogen vacancy center in diamond is widely used for quantum sensing due to the sensitivity of the spin triplet in the electronic ground state to external perturbations such as strain and electromagnetic fields, which makes it an excellent probe for changes in these perturbations. The spin state can be measured through optically detected magnetic resonance, which is most commonly achieved by detecting the photoluminescence after exciting the spin-triplet transition. Recently, methods have been proposed and demonstrated that use the absorption of the infrared singlet transition at 1042 nm instead. These methods, however, require cryogenic temperatures or external cavities to enhance the absorption signal. Here, we report on our efforts to optimize the magnetometer sensitivity at room temperature and without cavities. We reach a sensitivity of 18 pT / Hz , surpassing previously reported values, and a calculated shot-noise limit of 5 pT / Hz . We also report on a defect that is native to diamond grown by chemical vapor deposition and thus absent in high-pressure high-temperature diamond, the excitation of which impacts the measured singlet absorption signal.

arXiv:2410.20876•Physical Review Applied•May 7, 2025•16 citations
The nitrogen–vacancy center in diamond enables highly sensitive magnetic-field measurements. In this work, we demonstrate an excellent sensitivity of 7.9 pT·Hz –1/2 in the near-DC range of 1 to 1000 Hz. This performance is achieved using a 35 mW laser power and 1 mW microwave power enabled by 561 nm laser excitation and the resonant-antenna design. By leveraging dual resonance with intrinsic π shift for real-time common-mode rejection, this technique effectively suppresses low-frequency noise and pushes the 1/ f corner frequency down to 1 Hz, with a measured sensitivity at 1 Hz of 10.6 pT·Hz –1/2 . The magnetometer also exhibits excellent capability in detecting magnetic anomalies, promoting the practical use of diamond quantum sensors in biomedical, geophysical, and other real-world applications.
In this study, we developed a diamond quantum magnetometer based on Ramsey interferometry with a short sensor-to-sample distance. Conventional biomagnetic sensors with ensemble nitrogen-vacancy centers using continuous-wave optically detected magnetic resonance and Ramsey methods typically rely on watt-level lasers to achieve high sensitivity, resulting in thermal issues. In contrast, by employing the light-trapping diamond waveguide technique in a high-pressure and high-temperature diamond sample treated with electron beam irradiation, we obtained a high photon conversion efficiency of 9.5%, enabling us to simultaneously achieve a high sensitivity of 2.93(7) pT/Hz^1/2 in the 100-400 Hz frequency range and a minimal temperature increase of only approximately 13 K at a low laser power of 210 mW. Using a dry phantom designed to mimic magnetoencephalography signals, we measured a weak magnetic field of 77.7(2) pT without signal averaging at a sensor-to-sample distance of 2.5 mm. This short-distance measurement prevents severe spatial signal attenuation, yielding a high signal-to-noise ratio. The development here is crucial for practical biomagnetic applications based on Ramsey interferometry.
Nitrogen-vacancy (NV) color centers in diamond are promising solid-state quantum sensors working at room temperature. The number of NV centers limits the magnetic sensitivity of the quantum magnetometer. Increasing the number of NV centers is a challenging task due to technical issues such as microwave power density, detection noise.Here, we developed the sensor system with a large detection volume which contains a lot of NV centers. The microwave circuit enhances microwave power density. Digital filter with frequency modulation of microwave allows us to detect the magnetic field with low noise. Consequently, we obtained a DC magnetic field sensitivity of 980 pT/√Hz.This work was supported by MEXT Quantum Leap Flagship Program (MEXT Q-LEAP) Grant Number JPMXS0118067395.
While photoelectric detection of magnetic resonance (PDMR) can be applied to miniaturize nitrogen-vacancy (NV) center-based quantum sensors, real demonstration of PDMR-based magnetic field sensing remains as a distinctive challenge. To tackle this challenge, in this article, we fabricate diamond samples with electrodes and microwave antenna on the surface, and realize PDMR by detecting photocurrent in picoampere range via various lock-in amplifying modes. We obtain a theoretical and experimental sensitivity 397 nT/Hz and 921 nT/Hz of magnetic field detection in DC-10 Hz range with a laser intensity and microwave frequency modulation mode, respectively, and demonstrate for the first time, a real-time tracking of alternating magnetic field with a standard deviation of 1.5 uT. Furthermore, we investigate systematically the dependence of the PDMR contrast, linewidth and the sensitivity on the laser and microwave power, and find a perfect agreement with a master equation-based theory. Thus, our results represent a critical step forward in transitioning PDMR from a spectroscopic technique to a practical sensing modality.
Nitrogen vacancy (NV) centers in diamonds have emerged as one of the most promising candidates for magnetic field sensing. However, the laser intensity fluctuation is coupled to the diamond fluorescence; thus, the sensitivity is severely affected by the noise and stability of the laser. Integrating both the diamond quantum sensor and laser noise suppression device is a crucial step toward miniaturization and practical applications. Here, we present a piezoelectric-driven device to dynamically adjust the laser noise cancelation with dimensions of 5 × 5 × 1.5 mm 3 based on a grating interferometer. This device incorporates a grating structure to produce diffracted reference light with high-accuracy intensity modulation, actively tracking the fluorescence signal for differential common-mode rejection (CMR), effectively eliminating laser noise in the system, whereby the sensitivity of magnetic field detection is increased by a factor of 34, reaching 160 pT · Hz –1/2, and beneficial to the long-term stability. The compact design of this laser noise suppressor, in combination with a miniaturized diamond magnetometer, demonstrates its potential for high-precision magnetic field detection ability and strong portability.
In this work we present a compact and portable tabletop magnetometer that utilizes negatively charged nitrogen-vacancy (NV) centers in diamond. The magnetometer is operated using a dual microwave resonance detection approach in combination with an optically detected magnetic resonance (ODMR) technique (mitigating drifts in results due to changes of the diamond temperature), capable of simultaneously exciting and registering two ODMR transitions. The experimentally measured magnetic field noise-floor is ≈2.3 nTHz\approx 2.3~\textrm{nT}\sqrt{\textrm{Hz}}≈2.3 nTHz​ while the calculated shot-noise-limited magnetic field sensitivity is ≈585 pTHz\approx 585~\textrm{pT}\sqrt{\textrm{Hz}}≈585 pTHz​ when excited with a continuous wave laser at 0.5~W. These results pave the way for realizing a simple set-up magnetometer for precise single axis magnetic field measurements for example for accurate electric current measurements for stabilization purposes and magnetic communication applications.
The negatively charged nitrogen vacancy center in diamond is widely used for quantum sensing due to the sensitivity of the spin triplet in the electronic ground state to external perturbations such as strain and electromagnetic fields, which makes it an excellent probe for changes in these perturbations. The spin state can be measured through optically detected magnetic resonance, which is most commonly achieved by detecting the photoluminescence after exciting the spin-triplet transition. Recently, methods have been proposed and demonstrated that use the absorption of the infrared singlet transition at 1042 nm instead. These methods, however, require cryogenic temperatures or external cavities to enhance the absorption signal. Here, we report on our efforts to optimize the magnetometer sensitivity at room temperature and without cavities. We reach a sensitivity of 18 pT / Hz , surpassing previously reported values, and a calculated shot-noise limit of 5 pT / Hz . We also report on a defect that is native to diamond grown by chemical vapor deposition and thus absent in high-pressure high-temperature diamond, the excitation of which impacts the measured singlet absorption signal.