This article presents a cryogenic CMOS receiver operating across 4.7–7.9 GHz for frequency-division multiplexing (FDM) quantum state readout. The designed receiver employs a double quadrature (DQ) architecture and a hybrid poly-phase filter (PPF) is proposed to achieve an impressive image rejection ratio (IRR) to meet the 99.99% higher fidelity requirements in quantum error correction (QEC). In addition, gain tuning at different stages of the low noise amplifier (LNA) facilitates a broadband gain and flatness, while the subsequent receiver chains of a broadband mixer and an improved four-input intermediate frequency amplifier (IF-AMP) provide further gain compensation. Fabricated with a standard 55-nm CMOS technology, the LNA achieves a measured power gain of 27.4 dB, with a −3-dB bandwidth (BW) of 5.2 GHz at 6 K. The measured cryogenic noise figure (NF) ranges from 0.79 to 1 dB consuming merely 5.5 mW from a 1.2-V supply. Overall receiver measurements demonstrate a peak gain of 48.2 dB, a −5-dB flatness of 3.2 GHz, and an IRR that exceeds 40 dB at 6 K. These results demonstrate the receiver’s capacity for high-fidelity qubits’ state readout.
This article presents a cryogenic quantum interface chipset at 3.5 K for superconducting transmon qubit operations. The chipset comprises a phase-detection readout and a phase-shifter-based polar-modulation controller with flexible scalability. With the proposed phase-detection readout scheme, a 9-bit time-to-digital converter (TDC)-based state detector is used to read out the qubit state by detecting the phase difference between the stimulus signal and the reflected signal. A low-IF N-path filter-based receiver and a multi-tone transmitter are co-designed to enable frequency-division multiplexing (FDM) dispersive readout of multiple qubits. A phase-shifter-based polar-modulation XY-driver is developed with support for fast phase quantum gate operation and derivative-removal-by-adiabatic-gate (DRAG) pulse generation. The Z-driver is realized using a static digital-to-analog converter (DAC) array and a 10-bit dynamic DAC for power efficiency. Fabricated in a 28-nm bulk CMOS process, the chipset occupies a die area of 4.6 mm2. The readout RX achieves a noise temperature of 40 K with a gain of 45–83 dB and a bandwidth of 1.2 GHz. The readout RX consumes 32% less power than state-of-the-art designs. The measured total readout power for simultaneous detection of two qubits is 12.2 mW, which is the lowest among readouts with a similar integration level. In addition, the controller achieves a spurious-free dynamic range (SFDR) of 49 dB for a 1-GS/s Z-driver and an SNR of 42 dB for a 1-GS/s XY-driver. The XY-driver consumes 4.3 mW per qubit under active control. Verified with practical transmon qubits, the readout fidelity exceeds 92.6%, approaching that of commercial instruments. A Rabi experiment at 5.61/6.36 MHz, a Ramsey experiment at 4.1 MHz, and a T1 experiment at
9.98 μs are also successfully observed using the proposed chipset at 3.5 K.
In this paper, we propose a cryogenic fully-integrated 4channel Frequency-Division-Multiplexing (FDM) transmon qubit state readout ASIC, with a power consumption of
4.32mW(1.08mW/qubit). To the author's knowledge, it achieves the lowest power consumption compared to other qubit state readout receiver. By adopting ultra-narrow band zero-IF topology aided by 18-tap Analog Finite Impulse Response low pass filter (AFIR-LPF) with 40 dB stop-band rejection, the chip is able to detect four qubits simultaneously in our test system and achieves at least 92 % readout fidelity in four qubits FDM readout measurement.
Quantum error correction (QEC) is in demand for a fault-tolerant quantum computer. Currently, the QEC cycle is bottlenecked by the quantum bit (qubit) readout. To this end, RF dispersive reflectometry with frequency division multiplexing (FDM) is preferred due to its high fidelity and scalability. However, for a low noise temperature
Tnoise, cryogenic low noise amplifiers (cryo-LNAs) of classic LNA-first reflectometers require high transconductance efficiency (
gm2/Id). These open-loop cryo-LNAs also present limited linearity under large output voltage, resulting in errors of FDM readout. In this work, a new approach, a mixer-first cryogenic CMOS (Cryo-CMOS) reflectometer, is explored for its potential advantages in noise and linearity. A passive, low-loss mixer directly down-converts the RF reflection from the qubits (5.5–8 GHz) at 4 K to IF/baseband (5–250 MHz). Then, an IF/baseband amplifier, employing a MOSFET pair of$W/L = 2{\,}\times {\,}800~\mu $m/100 nm and current density of$5~\mu
A/\mu $m, achieves$2.8\times
higherg_{m}^{2}/I_{d}
thanCryo−CMOSLNAsforlownoise.Afterclosed−loopamplificationwithhighlinearity,thebasebandissampledbya500MSPS,12−bittime−interleaved(TI)analog−to−digitalconverter(ADC).Finally,thequbitstateisdiscriminatedbyanon−chipFDMdemodulationalgorithm.Fabricatedbya28−nmbulkCMOSprocess,themixer−firstreflectometerat4KachievesaminimumT_{noise} =19
Katf_{LO} =7.3
GHzwitha42−dBRXgain,whichishighlycompetitivetootherLNA−firstreflectometers.Inaddition,thankstotheco−optimizationofsingle−sideband(SSB)transmitter(TX),mixer−firstRXandon−chipdemodulation,underabasebandamplitudeofV_{pp}\sim 0.8$V, excellent spur-free dynamic range (SFDR) of SFDR > 45 dB and third-order intermodulation rejection of IMD
3>50dB are recorded. Lastly, the simultaneous FDM readout of two transmon qubits has also been demonstrated with fidelity 95.3% and 92.3% for qubit1 states$|0\rangle {\,}\& {\,}|1\rangle
,andfidelity96.1|0\rangle {\,}\& {\,}|1\rangle $, respectively.
In this paper, a broadband driver module is realized for control of a single transmon Qubit. The driver module comprises a IQ up-conversion mixer designed for operation at 4 K, implemented using a 28-nm CMOS process as a prototype for multi-Qubit control. The RF port of the driver module offers the conversion gain of 0.3 ± 3 dB at 4 K over the frequency range of 4 to 10 GHz, with a total DC power consumption of 11 mW. The power handling capability larger than −35 dBm enables to effective driving of the Qubit. The driver module performance is demonstrated through the successful control of a single Qubit. Furthermore, the fidelity of 99.32% is measured by injecting a 4.34-GHz π-pulse signal with a duration of 20 ns, determined through Rabi oscillation experiments.
This work introduces a broadband cryogenic receiver for scalable multiplexed readout of qubits. The receiver utilizes a double quadrature architecture with amplitude and phase error suppression. The hybrid poly-phase filter (PPF) is applied in the architecture to further reduce the input amplitude and phase errors at the radio frequency (RF) end, enhancing the circuit's overall error vector magnitude (EVM). To address the issue of wide bandwidth (BW) for qubit expansion, a low noise amplifier (LNA) with broadband input and noise matching and an improved four-input intermediate frequency amplifier (IF-AMP) with a resistance feedback structure are proposed, achieving a broadband gain response with high flatness. The chip has been designed in standard 55 nm CMOS technology. The LNA achieves a measured power gain of 27.4 dB at 5 GHz with a -3 dB BW of 5.2 GHz at 6 K. Across the entire band of interest, the measured noise figure (NF) deviates by just 0.15 dB from the minimum noise figure (NFmin) and less than 2 dB at 300K, while the measured cryogenic NF falls within the range of 0.79-1 dB. The LNA consumes only 5.5 mW from a 1.2 V supply. Simulation results of the designed receiver indicate that it delivers an average gain of 49.5 dB with a -3 dB BW of 2.4 GHz and an image rejection ratio (IRR) exceeding 40 dB at 300 K.