Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Sensors

Improving the Sensitivity of a Dark-Resonance Atomic Magnetometer

Hao Zhai, Wei Li, G. F. Jin

Published Feb 18, 2025• 7 citations
Publisher

Abstract

The combination of unmanned aerial vehicles and atomic magnetometers can be used for detection applications such as mineral resource exploration, environmental protection, and earthquake monitoring, as well as the detection of sunken ships and unexploded ordnance. A dark-resonance atomic magnetometer offers the significant advantages of a fully optical probe and omnidirectional measurement with no dead zones, making it an ideal choice for airborne applications on unmanned aerial vehicles. Enhancing the sensitivity of such atomic magnetometers is an essential task. In this study, we sought to enhance the sensitivity of a dark-state resonance atomic magnetometer. Initially, through theoretical analysis, we compared the excitation effects of coherent population trapping (CPT) resonance on the D1 and D2 transitions of 133Cs thermal vapor. The results indicate that excitation via the D1 line yields an increase in resonance contrast and a reduction in linewidth when compared with excitation through the D2 line, aligning with theoretical predictions. Subsequently, considering the impact of various quantum system parameters on sensitivity, as well as their interdependent characteristics, two experimental setups were developed for empirical investigation. One setup focused on parameter optimization experiments, where we compared the linewidth and contrast of CPT resonances excited by both D1 and D2 transitions; this led to an optimization of atomic cell size, buffer gas pressure, and operating temperature, resulting in an ideal parameter range. The second setup was employed to validate these optimized parameters using a coupled dark-state atom magnetometer experiment, achieving approximately a 10-fold improvement in sensitivity.

DOI
10.3390/s25041229

Related papers

Nonlinear Zeeman Effect Suppression for CPT Atom Magnetometers

Qiuchang Jia, Feifan Yang, Xianyang Huo +2 more

Geomagnetic measurement relies on high-sensitivity sensors, where coherent population trapping (CPT) magnetometers show promise due to advantages such as no dead zone and miniaturization capability. However, their sensitivity in geomagnetic environments is limited by the nonlinear Zeeman effect. This article establishes a magnetic field measurement model that suppresses this effect by utilizing the linear relationship between the external magnetic field and the frequency difference of the two peaks resulting from the resplitting of the zeroth-order CPT resonance. Theoretical analysis confirms that, at geomagnetic field strength, the frequency difference maintains a strict linear proportionality of 55.713 kHz/mT, whereas traditional methods fail due to higher order energy shifts. To enhance the weak CPT resonance, a closed-loop control system based on spontaneous fluorescence feedback was implemented, stabilizing the excited-state population via real-time laser power adjustment. Experimental results show that under closed-loop operation, the CPT signal amplitude increases approximately threefold with no significant linewidth broadening, theoretically improving sensitivity by 1.1 times, and the resplit double-peak structure is clearly observed in a geomagnetic environment. This approach provides a viable strategy for improving the sensitivity and accuracy of CPT magnetometers in geomagnetic field measurements.

IEEE Transactions on Instrumentation and Measurement•Jan 1, 2026•0 citations

Atomic magnetometer with microfabricated vapor cells based on coherent population trapping*

Xiaojie Li, Yuejiang Shi, Hongbo Xue +2 more

An atomic magnetometer based on coherent population trapping (CPT) resonances in microfabricated vapor cells is demonstrated. Fabricated by the micro-electro-mechanical-system (MEMS) technology, the cells are filled with Rb and Ne at a controlled pressure. An experimental apparatus is built for characterizing properties of microfabricated vapor cells via the CPT effects. The typical CPT linewidth is measured to be about 3 kHz (1.46 kHz with approximately zero laser intensity) for the rubidium D1 line at about 90 °C. The effects of pressure, temperature and laser intensity on CPT linewidth are studied experimentally. A closed-loop atomic magnetometer is finally finished with a sensitivity of 210.5 pT/Hz1/2 at 1 Hz bandwidth. This work paves the way for developing an integrated chip-scale atomic magnetometer in the future.

Chinese Physics B•Oct 20, 2020•8 citations

Comparison of quantum CPT and EPR magnetometers

Daba A. Radnatarov, Valeriy Andryushkov, Sergey M Kobtsev

Experimentally compared for the first time is the sensitivity of two magnetometer types implemented on a common base of rubidium atomic clock with coherent population trapping (CPT). The first magnetometer used a magneto-sensitive optically excited CPT resonance, the other measured field strength through the electron paramagnetic resonance (EPR) excited with alternating magnetic field. We show advantages and limitations of these promising quantum sensing technologies. Sensitivity of both types was measured under resonance excitation on the D1 line of 87Rb. We demonstrate that the СРТ magnetometer sensitivity may exceed that of the EPR device by two orders of magnitude.

Novel Optical Systems, Methods, and Applications•Aug 21, 2020•0 citations

High contrast atomic magnetometer based on coherent population trapping

Ailin Yang, Guoqing Yang, Yunfei Xu +1 more

We present an experimental and theoretical investigation of the coherent population trapping (CPT) resonance excited on the D1 line of 87 Rb atoms by bichromatic linearly polarized laser light. The experimental results show that a lin ‖ lin transition scheme is a promising alternative to the conventional circular—circular transition scheme for an atomic magnetometer. Compared with the circular light transition scheme, linear light accounts for high-contrast transmission resonances, which makes this excitation scheme promising for high-sensitivity magnetometers. We also use linear light and circular light to detect changes of a standard magnetic field, separately.

Chinese Physics B•Feb 1, 2014•14 citations

Improving the sensitivity of an optically pumped rubidium atomic magnetometer by using of a repumping laser beam

Lulu Zhang, Le-Le Bai, Yu-Lin Yang +5 more

For the experimental implementation of an optically pumped atomic magnetometer, the magnetic resonance signal with a narrow linewidth and a high signal-to-noise ratio (SNR) is required for achieving a high sensitivity. Using 795-nm laser as both the pumping and the probe laser, we compare the magnetic resonance signals from different rubidium atomic vapor cells and investigate the variations of magnetic resonance signals with temperature. Optimized magnetic resonance signal is achieved with a paraffin-coated rubidium atomic vapor cell. Then the 780-nm laser at rubidium D2 line is introduced as a repumping laser, and we explore the changes of linewidth and SNR of the magnetic resonance signal under different power of the pumping laser and the repumping laser. Owing to the 780-nm repumping laser beam, the signal amplitude of rubidium-85 magnetic resonance signal is improved remarkably because more rubidium-85 atoms are spin- polarized by the 795-nm pumping laser beam. At the same time, the linewidth of rubidium-85 magnetic resonance signal is roughly not broadened anymore. We realize a closed-loop optically pumped rubidium-85 atomic magnetometer with a bandwidth of ~1.2 kHz, and the sensitivity is calibrated to be ~245.5 pT/Hz1/2 only with the 795-nm pumping laser beam. Owing to the employment of the 780-nm repumping laser beam, the sensitivity is improved to be ~26.4 pT/Hz1/2 which is improved roughly by one order of magnitude. We also calibrate the measurement accuracy and deviation of a commercial fluxgate magnetometer by using the enhanced rubidium magnetic resonance signal.

Acta Physica Sinica•Jan 1, 2021•5 citations

Coherent population trapping resonances in thermal ^85Rb vapor: D_1 versus D_2 line excitation

M. Stähler, R. Wynands, Svenja A. Knappe +4 more

We have compared coherent population trapping (CPT) resonances, both experimentally and theoretically, for excitation of the D(1) and D(2) transitions of thermal (85)Rb vapor. Excitation of the D(1) line results in greater resonance contrast than excitation of the D(2) line and in a reduction in the resonance width, in agreement with theoretical expectations. These results translate into a nearly tenfold improvement in performance for the application of CPT resonances to a frequency standard or a sensitive magnetometer when the D(1) line, rather than the D(2) line, is used.

Optics Letters•Aug 15, 2002•161 citations
The combination of unmanned aerial vehicles and atomic magnetometers can be used for detection applications such as mineral resource exploration, environmental protection, and earthquake monitoring, as well as the detection of sunken ships and unexploded ordnance. A dark-resonance atomic magnetometer offers the significant advantages of a fully optical probe and omnidirectional measurement with no dead zones, making it an ideal choice for airborne applications on unmanned aerial vehicles. Enhancing the sensitivity of such atomic magnetometers is an essential task. In this study, we sought to enhance the sensitivity of a dark-state resonance atomic magnetometer. Initially, through theoretical analysis, we compared the excitation effects of coherent population trapping (CPT) resonance on the D1 and D2 transitions of 133Cs thermal vapor. The results indicate that excitation via the D1 line yields an increase in resonance contrast and a reduction in linewidth when compared with excitation through the D2 line, aligning with theoretical predictions. Subsequently, considering the impact of various quantum system parameters on sensitivity, as well as their interdependent characteristics, two experimental setups were developed for empirical investigation. One setup focused on parameter optimization experiments, where we compared the linewidth and contrast of CPT resonances excited by both D1 and D2 transitions; this led to an optimization of atomic cell size, buffer gas pressure, and operating temperature, resulting in an ideal parameter range. The second setup was employed to validate these optimized parameters using a coupled dark-state atom magnetometer experiment, achieving approximately a 10-fold improvement in sensitivity.
Geomagnetic measurement relies on high-sensitivity sensors, where coherent population trapping (CPT) magnetometers show promise due to advantages such as no dead zone and miniaturization capability. However, their sensitivity in geomagnetic environments is limited by the nonlinear Zeeman effect. This article establishes a magnetic field measurement model that suppresses this effect by utilizing the linear relationship between the external magnetic field and the frequency difference of the two peaks resulting from the resplitting of the zeroth-order CPT resonance. Theoretical analysis confirms that, at geomagnetic field strength, the frequency difference maintains a strict linear proportionality of 55.713 kHz/mT, whereas traditional methods fail due to higher order energy shifts. To enhance the weak CPT resonance, a closed-loop control system based on spontaneous fluorescence feedback was implemented, stabilizing the excited-state population via real-time laser power adjustment. Experimental results show that under closed-loop operation, the CPT signal amplitude increases approximately threefold with no significant linewidth broadening, theoretically improving sensitivity by 1.1 times, and the resplit double-peak structure is clearly observed in a geomagnetic environment. This approach provides a viable strategy for improving the sensitivity and accuracy of CPT magnetometers in geomagnetic field measurements.
An atomic magnetometer based on coherent population trapping (CPT) resonances in microfabricated vapor cells is demonstrated. Fabricated by the micro-electro-mechanical-system (MEMS) technology, the cells are filled with Rb and Ne at a controlled pressure. An experimental apparatus is built for characterizing properties of microfabricated vapor cells via the CPT effects. The typical CPT linewidth is measured to be about 3 kHz (1.46 kHz with approximately zero laser intensity) for the rubidium D1 line at about 90 °C. The effects of pressure, temperature and laser intensity on CPT linewidth are studied experimentally. A closed-loop atomic magnetometer is finally finished with a sensitivity of 210.5 pT/Hz1/2 at 1 Hz bandwidth. This work paves the way for developing an integrated chip-scale atomic magnetometer in the future.
Experimentally compared for the first time is the sensitivity of two magnetometer types implemented on a common base of rubidium atomic clock with coherent population trapping (CPT). The first magnetometer used a magneto-sensitive optically excited CPT resonance, the other measured field strength through the electron paramagnetic resonance (EPR) excited with alternating magnetic field. We show advantages and limitations of these promising quantum sensing technologies. Sensitivity of both types was measured under resonance excitation on the D1 line of 87Rb. We demonstrate that the СРТ magnetometer sensitivity may exceed that of the EPR device by two orders of magnitude.
We present an experimental and theoretical investigation of the coherent population trapping (CPT) resonance excited on the D1 line of 87 Rb atoms by bichromatic linearly polarized laser light. The experimental results show that a lin ‖ lin transition scheme is a promising alternative to the conventional circular—circular transition scheme for an atomic magnetometer. Compared with the circular light transition scheme, linear light accounts for high-contrast transmission resonances, which makes this excitation scheme promising for high-sensitivity magnetometers. We also use linear light and circular light to detect changes of a standard magnetic field, separately.
For the experimental implementation of an optically pumped atomic magnetometer, the magnetic resonance signal with a narrow linewidth and a high signal-to-noise ratio (SNR) is required for achieving a high sensitivity. Using 795-nm laser as both the pumping and the probe laser, we compare the magnetic resonance signals from different rubidium atomic vapor cells and investigate the variations of magnetic resonance signals with temperature. Optimized magnetic resonance signal is achieved with a paraffin-coated rubidium atomic vapor cell. Then the 780-nm laser at rubidium D2 line is introduced as a repumping laser, and we explore the changes of linewidth and SNR of the magnetic resonance signal under different power of the pumping laser and the repumping laser. Owing to the 780-nm repumping laser beam, the signal amplitude of rubidium-85 magnetic resonance signal is improved remarkably because more rubidium-85 atoms are spin- polarized by the 795-nm pumping laser beam. At the same time, the linewidth of rubidium-85 magnetic resonance signal is roughly not broadened anymore. We realize a closed-loop optically pumped rubidium-85 atomic magnetometer with a bandwidth of ~1.2 kHz, and the sensitivity is calibrated to be ~245.5 pT/Hz1/2 only with the 795-nm pumping laser beam. Owing to the employment of the 780-nm repumping laser beam, the sensitivity is improved to be ~26.4 pT/Hz1/2 which is improved roughly by one order of magnitude. We also calibrate the measurement accuracy and deviation of a commercial fluxgate magnetometer by using the enhanced rubidium magnetic resonance signal.
We have compared coherent population trapping (CPT) resonances, both experimentally and theoretically, for excitation of the D(1) and D(2) transitions of thermal (85)Rb vapor. Excitation of the D(1) line results in greater resonance contrast than excitation of the D(2) line and in a reduction in the resonance width, in agreement with theoretical expectations. These results translate into a nearly tenfold improvement in performance for the application of CPT resonances to a frequency standard or a sensitive magnetometer when the D(1) line, rather than the D(2) line, is used.