Large-scale silicon qubit control requires closer integration of control electronics to qubits at the mK stage of the dilution refrigerator to address the wiring bottleneck. We present a mK demultiplexer chip that uses only two input analog voltages and digital control signals, to provide both DC bias and high-speed voltage pulsing for up to 64 qubit terminals. Integrated with a foundry qubit chip on the same PCB and controlled by a 4 K cryo-CMOS controller, mK cryogenic measurements show multi-terminal characterization of a qubit device.
Large-scale silicon qubit control requires closer integration of control electronics to qubits at the mK stage of the dilution refrigerator to address the wiring bottleneck. We present a mK demultiplexer chip that uses only two input analog voltages and digital control signals, to provide both DC bias and high-speed voltage pulsing for up to 64 qubit terminals. Integrated with a foundry qubit chip on the same PCB and controlled by a 4 K cryo-CMOS controller, mK cryogenic measurements show multi-terminal characterization of a qubit device.
The rapidly growing number of qubits in semiconductor quantum computers requires a scalable control interface, including the efficient generation of DC bias voltages for gate electrodes. To avoid unrealistically complex wiring between any room-temperature electronics and the cryogenic qubits, this paper presents an integrated cryogenic solution for the bias-voltage generation and distribution for large-scale semiconductor spin-qubit quantum processors. A dedicated cryo-CMOS demultiplexer and a cryo-CMOS DC DAC have been developed in a 22-nm FinFET process to control a co-developed 2D-array designed with 648 Single Hole Transistors (SHTs). Thanks to the dissipation below 120μW, the whole system operates at temperatures below 70mK in a custom-built electrical/mechanical infrastructure embedded in a standard singlepulse- tube dilution refrigerator. The bias voltages generated by the cryo-CMOS DAC are demultiplexed to sample-and-hold (S/H) structures, allowing to store 96 unique bias voltages over a 3V range with a voltage drift between 60μV/s and 18 mV/s. This work demonstrates a tight integration at mK-temperatures of cryo- CMOS bias generation and distribution with a dedicated large-scale quantum device. This showcases how this approach simplifies the wiring to the electronics, thus facilitating the scaling up of quantum processors towards the large number of qubits required for a practical quantum computer.
Spin quantum bits (qubits) in semiconductor silicon quantum dots are one of the most promising candidates for large-scale quantum processor units, since they potentially have higher scalability through advanced semiconductor integration technologies. However, spin qubits require many control signals such as bias voltages, pulses and high-frequency microwaves, which is a major barrier to scale-up of qubits. In current small-scale quantum computer setup, the spin qubits inside the 100 mK cold finger of dilution refrigerator have been controlled by external room temperature instruments via long cables as shown in the left image of Fig. 1. This setup, consisting of fully analog signal transmission between qubits and external instruments, degrades the signal integrity and causes heat injection via cables, making it unsuitable for scalable qubits. Thus, cryogenic CMOS controller solutions have been widely developed to control the qubits from inside the refrigerator by installing the signal generation circuits on 4 K plate as depicted in the middle image of Fig. 1 [1]. This allows for the connection from the external devices to the refrigerator to be made with only digital wirings, which reduces number of cables and heat inflow. However, the distance between the 4 K plate and the 100 mK cold finger is still more than 2 m, degrading the integrity of wideband signals such as pulses.
This article presents a fully integrated Cryo-CMOS system on chip (SoC) for quantum computing. The proposed SoC integrates a radio frequency (RF) pulse modulator for qubit state manipulation, a multi-tone signal generator and a coherent receiver for qubit state readout, and 22 DACs for high-speed voltage pulsing of qubit gates. By adopting frequency division multiplexing and direct digital synthesis (DDS), the RF pulse modulator can control up to 16 qubits over a single RF line, and the readout receiver can detect the state of up to six qubits simultaneously. The proposed SoC also integrates a microcontroller for low latency on-chip signal processing and increased flexibility in implementing quantum instruction sets. A detailed analysis of qubit-state readout fidelity and the impact of finite DAC resolution on two-qubit gate fidelity is also included in this article, together with an electrical specification summary. The SoC is implemented in Intel’s 22 nm FFL fin field-effect transistor (FinFET) process, and it is characterized both at room and 4 K temperatures. The performance of each specific block is measured, with the readout characterized in a loop-back configuration. Generation of the control signals required for a full Rabi oscillation experiment is also demonstrated. This article also describes the cryogenic thermalization techniques used to integrate the SoC in the dilution refrigerator and shows temperature measurements during operation.
A fault tolerant scalable quantum computer requires more than 1000 Qubits to perform real time state correction and to improve the Qubit coherence time. The dense wiring connections required between the quantum processor placed at a 100 mK temperature and the room temperature control and readout electronics serve as a limiting factor in this system. Qubit control and readout electronics operating at 4 K temperature, placed closer to a quantum processor inside the dilution refrigerator avoids the dense wiring connections to room temperature electronics, and hence, serve as a potential solution to realize a scalable quantum computer. However, with no CMOS process technology models available at cryogenic temperatures, the design of a fully integrated, ultra-low power Qubit control and readout electronics at a sub-1 mW power consumption proves to be extremely challenging. In recent years, there has been a huge rise in interest among the research communities to understand and solve the device and circuit level challenges at deep cryogenic temperatures. This paper presents an overview of the recently published active and passive device nonidealities, circuit design challenges and solutions, and the future research directions in the Qubit control and readout electronics operating at deep cryogenic temperatures.
Abstract Large-scale superconducting quantum computing systems entail high-fidelity control and readout of large numbers of qubits at millikelvin temperatures, resulting in a massive input-output bottleneck. Cryo-electronics, based on complementary metal-oxide-semiconductor (CMOS) technology, may offer a scalable and versatile solution to overcome this bottleneck. However, detrimental effects due to cross-coupling between the electronic and thermal noise generated during cryo-electronics operation and the qubits need to be avoided. Here we present an ultra-low power radio-frequency (RF) multiplexing cryo-electronics solution operating below 15 mK that allows for control and interfacing of superconducting qubits with minimal cross-coupling. We benchmark its performance by interfacing it with a superconducting qubit and observe that the qubit’s relaxation times (T1) are unaffected, while the coherence times (T2) are only minimally affected in both static and dynamic operation. Using the multiplexer, single qubit gate fidelities above 99.9%, i.e., well above the threshold for surface-code based quantum error-correction, can be achieved with appropriate thermal filtering. In addition, we demonstrate the capability of time-division-multiplexed qubit control by dynamically windowing calibrated qubit control pulses. Our results show that cryo-CMOS multiplexers could be used to significantly reduce the wiring resources for large-scale qubit device characterization, large-scale quantum processor control and quantum error correction protocols.
Large-scale quantum computing holds promise for exponentially faster computation speed to address currently unsolvable problems. Nevertheless, biasing, driving and reading numerous physical qubits operating at cryogenic temperature remains an on-going challenge. In particular, the integration of cryogenic control and readout ICs appears mandatory to overcome the wiring bottleneck [1]–[3]. In this regard, the promising higher operating temperature (up to 1K) of silicon semiconductor qubits offers a more substantial cryogenic power budget, which could enable addressing larger qubit arrays with integrated cryogenic CMOS electronics. In the context of 100,000 qubits at 1K, the maximum power consumption allowed by cooling capability is about 1W within a compact footprint of just a few cm2, defining targets of2/qubit footprint. Focusing on the readout IC, the semiconductor-qubit coherence time also imposes a typical3.