We investigate the spectro-temporal mode property of the photon pairs generated via interspatial-mode spontaneous four-wave mixing (FWM) in a few-mode fiber (FMF) that supports two linearly polarized spatial modes in the 1550 nm telecom band. The two pulsed pumps for the process are in distinct spatial modes, while the created signal and idler photon pairs are also occupying different spatial modes. By exploiting the unique inter-mode phase matching condition in the FMF, we can tailor the spectro-temporal mode structure of the photon pairs by changing the pulse duration (spectral bandwidth) of the two pumps. Especially, photon pairs with a nearly round-shaped factorable joint spectrum are experimentally realized. The techniques are valuable for generating and manipulating quantum states in multi-mode waveguides and exploiting the spatial degree of freedom in quantum information processing.
We investigate the spectro-temporal mode property of the photon pairs generated via interspatial-mode spontaneous four-wave mixing (FWM) in a few-mode fiber (FMF) that supports two linearly polarized spatial modes in the 1550 nm telecom band. The two pulsed pumps for the process are in distinct spatial modes, while the created signal and idler photon pairs are also occupying different spatial modes. By exploiting the unique inter-mode phase matching condition in the FMF, we can tailor the spectro-temporal mode structure of the photon pairs by changing the pulse duration (spectral bandwidth) of the two pumps. Especially, photon pairs with a nearly round-shaped factorable joint spectrum are experimentally realized. The techniques are valuable for generating and manipulating quantum states in multi-mode waveguides and exploiting the spatial degree of freedom in quantum information processing.
We study theoretically the joint spectral properties of photon-pairs produced through spontaneous four-wave mixing (SFWM) with two spectrally distinct pump pulses in optical fibers. We show that, due to the group velocity difference between the pulses, the signature of the interaction can be significantly different from spontaneous parametric down-conversion or SFWM with a single pump pulse. Specifically, we study the case where temporal walk-off between the pumps enables a gradual turn-on and turn-off of the interaction. By utilizing this property, we develop a new approach towards tailoring the spectral correlations within the generated photon pairs, demonstrating the ability to produce factorable photon-pair states, and hence heralded single photons in a pure wave-packet. We show that the use of two pumps is advantageous over single-pump SFWM approaches towards this goal: the usage of the dual-pump configuration enables, in principle, the creation of completely factorable states without any spectral filtering, even in media for which single-pump SFWM tailoring techniques are unsatisfactory, such as standard polarization-maintaining fiber.
Optical fiber-based sources of photon pairs with hybrid entanglement across multiple degrees of freedom are essential for a wide range of quantum technologies, while remaining compatible with existing communication networks. In this paper, we use a birefringent few-mode fiber to demonstrate an intermodal-vectorial four-wave mixing process that generates two pairs of spectrally overlapping signal-idler bands. Using phase-matching conditions, we show that the pairs of bands become spectrally indistinguishable when the group refractive indices of the signal and idler modes intersect at the pump wavelength. Our theoretical predictions are confirmed through experimental observations and corroborated by numerical simulations. Furthermore, we introduce the two-photon state associated with the overlapping bands, which simultaneously exhibits entanglement in a single degree of freedom and hybrid entanglement across multiple degrees of freedom. We also explain how the type and degree of entanglement can be controlled by tailoring the spectral overlap between the signal-idler bands. This study presents a promising scheme for a fiber-based source of photon pairs with entanglement spanning the spatial, polarization, and frequency degrees of freedom.
Intermodal four-wave mixing (FWM) process in few-mode fibers (FMFs) could be utilized for entangled photon-pair generation. Previous studies mainly performed in single-mode fibers suffered from the significant Raman scattering background from the glass fiber. Therefore, the instantaneous Raman and FWM effects would compete; this could be avoided in FMFs if the modal dispersion is larger than the Raman gain spectra. Utilizing two pumps in different modes in FMFs will generate photon pairs in various modes. Here, we study the effect of pump spectral separation on the intermodal FWM power and bandwidth using a seeding technique. It is concluded that the further the pumps and intermodal FWM idler and signal are from each other spectrally, the smaller the photon efficiency and larger the bandwidth. Experimental results for two FMFs of different differential mode group delay values are presented.
Abstract The spatial degree of freedom has enabled a wide range of applications in quantum information processing (QIP), such as increasing the capacity of quantum channels and realizing novel QIP protocols. In such applications, generating and manipulating quantum states in different spatial modes is one of the primary tasks. In this paper, by utilizing a telecom-band panda-type mode-maintaining few-mode fiber (MM-FMF) with a Sagnac loop configuration, we generate polarization-entangled photon pairs in higher-order spatial modes, namely the LP 11 modes, via intermodal spontaneous four-wave mixing process. The polarization- and spatial-mode-maintaining capabilities of the MM-FMF, combined with the automatic phase-stabilization of the Sagnac loop, provide a robust architecture for entanglement generation. We verify the polarization entanglement by two-photon interference measurements, yielding raw visibilities exceeding 76%. The visibilities are mainly limited by spontaneous Raman scattering noise, which could be reduced by cooling the fiber. The photon pairs directly emerging from MM-FMF are in a well-defined spatial mode, which greatly facilitates further manipulation and transmission of the entanglement. Our work demonstrates that the MM-FMF is a robust platform for developing devices and protocols exploiting the spatial degree of freedom in QIP applications.
\n Temporal modes (TM) of light are a promising resource for quantum information as they span a discrete infinite dimensional encoding basis [1]. Additionally, TM are compatible with standard fibered communication as they share the same polarization, carrier frequency and transverse spatial mode properties. Single photons in specific TM can be obtained by Spontaneous Parametric Down Conversion (SPDC) and Spontaneous Four-Wave-Mixing (SFWM) sources. The Joint Spectral Amplitude (JSA), derived from energy and momentum conservation constraints describes the two-photon state and the signal and idler spectral distribution. The Schmidt decomposition of the JSA function : F = n √ λ n S n (ω s)I n (ω i) where the ({S n }) and ({I n }) are the TM basis of the signal and idler photons is sometimes reduced to one non zero term [2] where both signal and idler photons are generated in a single TM, giving rise to a fac-torable state of the pair. This can be achieved if a group velocity matching condition is satisfied (either β 1 (ω p) = β 1 (ω s) or β 1 (ω p) = β 1 (ω i) or 2 β 1 (ω p) = β 1 (ω s) + β 1 (ω i) in the case of SFWM with β 1 the inverse group velocity). Such single TM states are very useful for scalable heralded photon sources [3]. On the contrary, having several non-zero terms in the Schmidt decomposition depicts spectral correlations between the signal and idler which can also be required for others applications. Here we show experimentally in a stimulated regime how the shape of the JSA can be changed for photon pairs produced by FWM in a gas-filled inhibited-coupling (IC) fiber. IC fibers exhibit a discontinuous multiband dispersion where the position of the discontinuities are dictated by the strut thickness [4]. Such exotic dispersion opens new possibilities for the FWM phase matching fulfillment, and thus for tailoring the JSA. With the ability to have the pump and the generated signal and idler photons lying in different dispersion band, group-velocity matching can be easily obtained. We use stimulated emission tomography, which consists in seeding the FWM process with a tunable continuous wave laser, to reconstruct the 2D JSI (= |JSA| 2) as a function of signal and idler wavelengths. With a femtosecond pulsed pump at 1030 nm and a seed laser at telecom wavelength, Figure 1: Simulated JSI for different configurations of length, gas pressure and pump wavelength. Starting from the conditions of (a) P =3bar λp =1085 nm L = 1m, (b-d) correspond to the change of one parameter (b) L = 30 cm (c) P = 2.6 bar (d) λp =985 nm we chose two optimized fibers denoted A and B with struts thickness t=600 nm and inner-diameter d=40 µm and t=1250 nm; d=49 µm (Fig 2). These two fiber designs allow a multi-band FWM. Indeed the signal (fiber A), or both the signal and idler (fiber B) are generated in a different band from the pump. Xenon gas has been chosen because i) no Raman-Scattering can take place in a noble gas, which eliminates the usual main source of noise in fibered photon-pair generation and ii) it exhibits high non-linearity (in the order of 10 −21 m 2 /W at 10 bar). For a given fiber design, pump wavelength, gas pressure and fiber length are three adjustable parameters that can be tuned to access various JSA shapes as can be seen on the simulations in Fig.1. Both single TM or, opposingly, multi-TM can be obtained. Changing the gas pressure impacts the medium dispersion, which results in shifting the JSA and modifying its shape (Fig 1). As a first experimental demonstration in such gas-filled IC fibers, we experimentally reconstruct the JSI for two different fibers (Fig 2) with signal and idler wavelength respectively in the 771 nm and 1550 nm ranges. showing that two very different Schmidt decompositions can be obtained: a quasi factorable state and a correlated state. Figure 2: Fiber cross-section, experimental JSI and corresponding Schmidt decomposition for a 8 tubes IC-fiber and a kagome-IC fiber denoted A and B. In JSI of A the red dashed-lines define the measurement range. The pixelated structure of the JSI of B is due to an insufficient number of measures and will be improved. We have made a new proposal of using multi-dispersion band medium in order to engineer photon-pair time-frequency correlations. For the first time to our knowledge, we implement this technique using gas-filled inhibited-coupling fiber. More configurations are currently being investigated in order to demonstrate the real time tuning possibility in such a medium.\n