Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Frontiers in Physics

Experiment and analysis of state preparation for atom interferometry

Xu Zhang, Qixue Li, Huankai Zhang, Ji-Xun Liu, Guo-Chao Wang, Xiaoxiao Ma, Lingxiao Zhu, Shuhua Yan

Published Mar 8, 2024• 2 citations
Publisher

Abstract

The state preparation is a crucial procedure in atom interferometry; however, there is a shortage of detailed experimental studies on determining the optimal method for achieving this. This paper investigates and compares two methods for state preparation: the combined use of microwave and Raman light (M-R) and the combined use of optical pumping, microwave, and Raman light (O-M-W). The experimental results demonstrate that the M-R method improves the efficiency of Raman transitions for atom interference, which is helpful in enhancing the contrast of the interference fringes. The O-M-R method increases the quantity of prepared atoms, thereby enhancing the signal-to-noise ratio of the detected signals. This work helps provide a useful experimental basis and reference for researchers to design a suitable state preparation scheme.

DOI
10.3389/fphy.2024.1377829

Related papers

Atom Optics for Multidimensional Raman Interferometry

Yingpeng Zhao, Yiyang Shao, Wenjian Tong +7 more

The coherent control of atomic wave packets in multiple momentum dimensions is a central challenge in Raman atom optics and a key requirement for multidimensional atom interferometry. In this paper, a momentum-basis theoretical framework is developed for two-dimensional Raman interactions. We formulate the atom-laser interaction for two-dimensional Raman beams and obtain the effective two-level ground-state Hamiltonian after adiabatic elimination of the excited states. The resulted Hamiltonian is constructed on the reachable momentum-state lattice and includes AC Stark shifts, intra-dimensional Raman couplings, and cross-dimensional Raman coupling terms, thereby describing multidimensional Raman dynamics beyond a simple superposition of independent single-dimensional models. The framework is used to analyze the principles and operating conditions of two-dimensional atom interferometry. Cross-dimensional Raman coupling and sequential reverse Raman transitions are identified as the main mechanisms that redistribute atoms into non-target momentum states and reduce the contrast of atomic interferometer fringe. Experimentally, Ramsey fringes are observed in a cold-atom fountain interferometer, with a contrast of $14.8\%$ at an interrogation time of $T=10~{\rm ms}$, in good agreement with the theoretical calculation. The conditions required for velocity-sensitive multidimensional atom interferometry are further clarified, including detuning control, velocity-class selection, and suppression of undesired inter-dimensional transitions. This work provides a theoretical and experimental basis for multidimensional Raman atom interferometry.

arXiv:2606.15215•Jun 13, 2026•0 citations

Building a sensitive atom interferometer for navigation

Xiaxi Cheng

The presented thesis describes the setting up of an inertial sensitive atom interferometer for navigation using Rubidium 87 atoms, which is able to perform horizontal acceleration measurement. An ultra-high vacuum interferometer chamber is designed and built. The cold atoms are prepared in a compact 2D MOT setup and loaded into the main MOT. These atoms are then cooled down to few K and prepared in a magnetically insensitive ground state using a sequence of optical and microwave pulses, after which atoms are selected in a narrow band of the velocity. A three-pulse Mach-Zehnder ( pi/2 -pi-pi/2) interferometer using stimulated Raman transitions is used to measure the horizontal acceleration. To improve the sensitivity to acceleration, the fringe contrast of the interferometer requires to be optimised. By investigating the intensity profile of the Raman beams using atoms, a procedure is developed to operate the interferometer in an improved condition, which is able to enhance the fringe contrast by a factor of 3. This procedure improves the shot-to-shot sensitivity of the interferometer below 5 um/s^2. In addition, the atom interferometer is compared with a classical state-of-the-art accelerometer.

•Sep 1, 2019•2 citations

The Effect of Imperfect Raman Pulses on the Atomic Interference Signal

M.M. Zhao, Y.J. Tan, C.G. Shao

Imperfect Raman pulses can lead to the formation of multiple interfering paths and affect the output of an atom interferometer in high-precision measurement.We study the effect of the imperfect Raman pulses on the interferometric fringe contrast and the phase shift in the three-pulse atom interferometer by using the evolution operator method.Analytical expressions expanded to the second-order fluctuation of imperfect pulses are derived, in which the effect of coupling the imperfect pulses with laser detuning and pulse duration is also considered.The result indicates that the second-order fluctuation of imperfect pulses is dominant, however, it can be nearly ignored in the current requirements of atomic experiments.Even so, theoretical analysis is very necessary as it may be helpful in proposing some schemes to improve the interference efficiency for future high-precision measurements with atomic interferometry.

Acta Physica Polonica A•Aug 1, 2022•0 citations

Preliminary progress of the state preparation with a new optical pumping method in a cesium atomic fountain clock

Lei Han, Fang Fang, Yani Zuo +5 more

In this paper, a new optical pumping method, redistributing the atom populations among the Zeeman magnetic sublevels of the ground state |F=3> is proposed as the state preparation process to improve the signal to noise ratio (SNR) of the atomic fountain clock with a larger atom population on the |F=3, mF=0>clock state. A preliminary experimental result of state preparation efficiency exceeding 60% is obtained on the NIM6 cesium (Cs) fountain clock.

Quantum Optics and Photon Counting•Apr 14, 2021•0 citations

Enhancement of fidelity and robustness of atomic beam splitters and mirrors in atom interferometry with stimulated Raman adiabatic passage

Yvrui Chen, Zheng-Hong Li, Lin Zeng +1 more

The precision of atom interferometry is affected by system errors due to the laser parameters and atomic velocity. We propose the method of the Stimulated Raman Adiabatic Passage(STIRAP) to enhance the accuracy of the atom interferometry and its tolerance for the environment. We calculate the fidelity of the target atomic state for the cases of the STIRAP technique, rectangular pulse and Gaussian pulse. It is shown that the fidelity of the atomic state obtained with the STIRAP technique is higher than that with rectangular pulse and Gaussian pulse. In addition, higher interference fringe contrast of the atom interferometry can be obtained with the pulse sequence consisting of STIRAP than the rectangular pulse sequence and Gaussian pulse sequence. This scheme may have promising applications in precise measurements with atom interferometry.

Journal of Modern Optics•Jul 25, 2025•0 citations

Optical state selection process with optical pumping in a cesium atomic fountain clock*

Lei Han, Fang Fang, Weiliang Chen +5 more

We propose and realize a new optical state selection method on a cesium atomic fountain clock by applying a two-laser 3–3′ optical pumping configuration to spin polarize atoms. The atoms are prepared in |F = 3, mF = 0〉 clock state with optical pumping directly after being launched up, followed by a pushing beam to push away the atoms remaining in the |F = 4〉 state. With a state selection efficiency exceeding 92%, this optical method can substitute the traditional microwave state selection, and helps to develop a more compact physical package. A Ramsey fringe has been achieved with this optical state selection method, and a contrast of 90% is obtained with a full width half maximum of 0.92 Hz. The short-term frequency stability of 6.8 × 10−14 (τ/s)−1/2 is acquired. In addition, the number of detected atoms is increased by a factor of 1.7 with the optical state selection.

Chinese Physics B•May 29, 2021•3 citations
The state preparation is a crucial procedure in atom interferometry; however, there is a shortage of detailed experimental studies on determining the optimal method for achieving this. This paper investigates and compares two methods for state preparation: the combined use of microwave and Raman light (M-R) and the combined use of optical pumping, microwave, and Raman light (O-M-W). The experimental results demonstrate that the M-R method improves the efficiency of Raman transitions for atom interference, which is helpful in enhancing the contrast of the interference fringes. The O-M-R method increases the quantity of prepared atoms, thereby enhancing the signal-to-noise ratio of the detected signals. This work helps provide a useful experimental basis and reference for researchers to design a suitable state preparation scheme.
The coherent control of atomic wave packets in multiple momentum dimensions is a central challenge in Raman atom optics and a key requirement for multidimensional atom interferometry. In this paper, a momentum-basis theoretical framework is developed for two-dimensional Raman interactions. We formulate the atom-laser interaction for two-dimensional Raman beams and obtain the effective two-level ground-state Hamiltonian after adiabatic elimination of the excited states. The resulted Hamiltonian is constructed on the reachable momentum-state lattice and includes AC Stark shifts, intra-dimensional Raman couplings, and cross-dimensional Raman coupling terms, thereby describing multidimensional Raman dynamics beyond a simple superposition of independent single-dimensional models. The framework is used to analyze the principles and operating conditions of two-dimensional atom interferometry. Cross-dimensional Raman coupling and sequential reverse Raman transitions are identified as the main mechanisms that redistribute atoms into non-target momentum states and reduce the contrast of atomic interferometer fringe. Experimentally, Ramsey fringes are observed in a cold-atom fountain interferometer, with a contrast of 14.8%14.8\%14.8% at an interrogation time of T=10 msT=10~{\rm ms}T=10 ms, in good agreement with the theoretical calculation. The conditions required for velocity-sensitive multidimensional atom interferometry are further clarified, including detuning control, velocity-class selection, and suppression of undesired inter-dimensional transitions. This work provides a theoretical and experimental basis for multidimensional Raman atom interferometry.
The presented thesis describes the setting up of an inertial sensitive atom interferometer for navigation using Rubidium 87 atoms, which is able to perform horizontal acceleration measurement. An ultra-high vacuum interferometer chamber is designed and built. The cold atoms are prepared in a compact 2D MOT setup and loaded into the main MOT. These atoms are then cooled down to few K and prepared in a magnetically insensitive ground state using a sequence of optical and microwave pulses, after which atoms are selected in a narrow band of the velocity. A three-pulse Mach-Zehnder ( pi/2 -pi-pi/2) interferometer using stimulated Raman transitions is used to measure the horizontal acceleration. To improve the sensitivity to acceleration, the fringe contrast of the interferometer requires to be optimised. By investigating the intensity profile of the Raman beams using atoms, a procedure is developed to operate the interferometer in an improved condition, which is able to enhance the fringe contrast by a factor of 3. This procedure improves the shot-to-shot sensitivity of the interferometer below 5 um/s^2. In addition, the atom interferometer is compared with a classical state-of-the-art accelerometer.
Imperfect Raman pulses can lead to the formation of multiple interfering paths and affect the output of an atom interferometer in high-precision measurement.We study the effect of the imperfect Raman pulses on the interferometric fringe contrast and the phase shift in the three-pulse atom interferometer by using the evolution operator method.Analytical expressions expanded to the second-order fluctuation of imperfect pulses are derived, in which the effect of coupling the imperfect pulses with laser detuning and pulse duration is also considered.The result indicates that the second-order fluctuation of imperfect pulses is dominant, however, it can be nearly ignored in the current requirements of atomic experiments.Even so, theoretical analysis is very necessary as it may be helpful in proposing some schemes to improve the interference efficiency for future high-precision measurements with atomic interferometry.
The precision of atom interferometry is affected by system errors due to the laser parameters and atomic velocity. We propose the method of the Stimulated Raman Adiabatic Passage(STIRAP) to enhance the accuracy of the atom interferometry and its tolerance for the environment. We calculate the fidelity of the target atomic state for the cases of the STIRAP technique, rectangular pulse and Gaussian pulse. It is shown that the fidelity of the atomic state obtained with the STIRAP technique is higher than that with rectangular pulse and Gaussian pulse. In addition, higher interference fringe contrast of the atom interferometry can be obtained with the pulse sequence consisting of STIRAP than the rectangular pulse sequence and Gaussian pulse sequence. This scheme may have promising applications in precise measurements with atom interferometry.
We propose and realize a new optical state selection method on a cesium atomic fountain clock by applying a two-laser 3–3′ optical pumping configuration to spin polarize atoms. The atoms are prepared in |F = 3, mF = 0〉 clock state with optical pumping directly after being launched up, followed by a pushing beam to push away the atoms remaining in the |F = 4〉 state. With a state selection efficiency exceeding 92%, this optical method can substitute the traditional microwave state selection, and helps to develop a more compact physical package. A Ramsey fringe has been achieved with this optical state selection method, and a contrast of 90% is obtained with a full width half maximum of 0.92 Hz. The short-term frequency stability of 6.8 × 10−14 (τ/s)−1/2 is acquired. In addition, the number of detected atoms is increased by a factor of 1.7 with the optical state selection.