Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Lightwave Technology

Experimental Demonstration of Datagram Switching With Monitoring in Quantum Wrapper Networks

Mehmet Berkay On, Roberto Proietti, Gamze Gül, Gregory S. Kanter, Sandeep Kumar Singh, Prem Kumar, S. J. Ben Yoo

Published Feb 5, 2024• 8 citations
Publisher

Abstract

Adapting the architecture and protocols of classical networks to quantum networking is challenging due to the quantum mechanical properties. In this paper, we utilize a Quantum Wrapper Networking architecture that enables transparent and interoperable transportation of quantum wrapper (QW) datagrams, consisting of quantum payloads and classical headers, over optical fiber networks. We experimentally demonstrate end-to-end transportation of QW datagrams in a three-node packet-switched optical network testbed. The header and payload of a QW datagram are multiplexed in time and wavelength, i.e., the 1561.41 nm header precedes the L-band payload. A QW switch/router performs packet switching by reading the headers, generating new headers, and routing the datagrams to their destinations without disturbing quantum information in the payload. We use 20 km fiber links from the source to two distinct destinations in the testbed. Our experiments show$>$22 coincidence-to-accidental ratio (CAR) for both destinations at two different wavelength channels and clear visibility,$>$79%. We further investigate impairments such as chromatic dispersion and wavelength-dependent polarization rotations in the fiber. We observe that the classical headers' bit-error rate (BER) and the quantum payloads' CAR are correlated under the wavelength-independent channel attenuation. Thus, QW network control and management can utilize a type of performance monitoring. We also discuss the QW datagram design constraints and future fast packet switching implementations.

DOI
10.1109/jlt.2024.3362292

Related papers

Experimental demonstration of optical packet switching in quantum wrapper networks

Mehmet Berkay On, Sunil Kumar Singh, G. Gül +4 more

We experimentally demonstrate optical packet switching for quantum payloads and classical burst headers in a three-node quantum wrapper network. Further, we record coincidence count distributions of polarization-entangled photon pairs between the source node and two distinct destination nodes and measure the coincidence-to-accidental ratio above 6.02.

IET conference proceedings.•Nov 13, 2023•0 citations

Quantum Wrapper Networking

S. J. Ben Yoo, Sandeep Kumar Singh, Mehmet Berkay On +4 more

We propose Quantum Wrapper as a novel networking technology that enables simultaneous control, management, and operation of quantum networks that coexist with classical networks. The quantum wrapper networks enable the transparent and interoperable transportation of quantum wrapper datagrams consisting of quantum payloads and, notably, classical headers, to facilitate the datagram switching without measuring or disturbing the qubits of the quantum payload. Furthermore, quantum wrapper networks can utilize the common network control and management for performance monitoring on the classical header, and infer the quantum channel quality.

arXiv:2305.00591•IEEE Communications Magazine•Jan 8, 2024•28 citations

Rerouting in Quantum Wrapper Networks by Monitoring Single-Photon Level Noise

Mehmet Berkay On, Roberto Proietti, Gamze Gül +3 more

We demonstrate routing polarization-entangled photon payloads multiplexed with classical datagram headers. Our testbed quantum network guarantees >77% interference visibility as a quality of transmission metric by monitoring single-photon level noise due to coexisting classical traffic.

Optical Fiber Communication Conference•Jan 1, 2025•0 citations

Noise impact of classical headers on the quantum payload in quantum wrapper networking

Gamze Gül, Gregory S. Kanter, Sze Tiong Tan +4 more

The fundamental properties of quantum mechanics, such as the no-cloning theorem, make management and control of quantum networks challenging. Quantum wrapper networking (QWN) offers a solution to this problem by wrapping quantum payloads with classical bits (as headers and/or tails) that can be used to assist with networking, performance monitoring, and probing the properties of the fiber interconnection. Since the classical header and quantum payload travel in the same fiber, one should carefully design the system to mitigate potentially deleterious effects such as noise and cross-talk. In this paper, we identify and characterize the noise induced by the classical headers by in-fiber scattering processes. We study the noise by using a tunable continuous-wave laser to emulate O-band (∼1310 nm) classical headers, which are time- and wavelength-multiplexed with O-band quantum signals. The noise is characterized as a function of the headers’ power, classical-quantum wavelength detuning, and optical fiber length. We demonstrate that the dominant noise contribution originates from spontaneous Raman scattering for wavelength detunings that are larger than 3 nm. We also observe that some noise photons can bleed into the quantum payload due to Rayleigh scattering of backward Raman scattered photons. We further investigate system level impacts of the noise created by classical headers that are produced by employing a small form-factor pluggable transceiver. We demonstrate that the associated noise level has negligible impact on quantum payloads for a 47.8 km deployed fiber link, the longest length used in QWN experiments to date, achieving a coincidences-to-accidentals ratio of 56 and a two-photon interference visibility of 88.8%.

Optica Quantum•May 23, 2025•3 citations

Demonstration of Quantum Channel Monitoring via Quantum Wrappers

Mehmet Berkay On, Sandeep Kumar Singh, Gamze Gül +4 more

We experimentally demonstrate quantum channel monitoring by wavelength-time multiplexing of classical wrapper bits with quantum payloads. Bit-error-rate measurements of 5 Gb/s classical bits infer the coincidence-to-accidental ratio of the quantum channel up to 13.3 dB.

Optical Fiber Communication Conference•Jan 1, 2023•4 citations

Polarization Tracking and Active Compensation Using Classical Headers in Quantum Wrapper Networking

Gamze Gül, James van Howe, Gregory S. Kanter +6 more

Quantum wrapper networking (QWN) is an emerging quantum networking protocol that wraps qubits in classical header bits to enable switching/routing, monitoring, and control without detecting the quantum signal. In this work, we encode header bits with two nonorthogonal polarization references to track and actively compensate for the changing birefringence of a 48 km deployed fiber link. Our method is analytical and deterministic, using motorized waveplates and a variable phase retarder to accurately and stably compensate the channel. We verify successful compensation by measuring the polarization stability of single photon qubits and the visibility of entangled photon pairs under both slow birefringence drift due to environmental fluctuations and large sudden changes designed to emulate those that occur during packet switching and rerouting over different fiber paths. For large, sudden changes, our compensator recovers the Stokes vector of single photons to within 10 degrees of the target state on the Poincaré sphere and restores the two-photon interference visibilities to their original levels on the deployed fiber link. Additionally, experiments monitoring long-term compensation over 44 hours show that active polarization compensation maintains the two-photon interference visibility, whereas disabling the compensator leads to visibility degradation over time, particularly in the diagonal-antidiagonal basis, where the average raw visibility decreases by 7.7%. These results add a polarization-control layer to QWN and illustrate that information-carrying headers can enable deterministic physical-layer compensation in the quantum channel over long-distance deployed fiber links.

quant-pharXiv:2604.09846•Journal of Optical Communications and Networking•Apr 14, 2026•2 citations
Adapting the architecture and protocols of classical networks to quantum networking is challenging due to the quantum mechanical properties. In this paper, we utilize a Quantum Wrapper Networking architecture that enables transparent and interoperable transportation of quantum wrapper (QW) datagrams, consisting of quantum payloads and classical headers, over optical fiber networks. We experimentally demonstrate end-to-end transportation of QW datagrams in a three-node packet-switched optical network testbed. The header and payload of a QW datagram are multiplexed in time and wavelength, i.e., the 1561.41 nm header precedes the L-band payload. A QW switch/router performs packet switching by reading the headers, generating new headers, and routing the datagrams to their destinations without disturbing quantum information in the payload. We use 20 km fiber links from the source to two distinct destinations in the testbed. Our experiments show>>>22 coincidence-to-accidental ratio (CAR) for both destinations at two different wavelength channels and clear visibility,>>>79%. We further investigate impairments such as chromatic dispersion and wavelength-dependent polarization rotations in the fiber. We observe that the classical headers' bit-error rate (BER) and the quantum payloads' CAR are correlated under the wavelength-independent channel attenuation. Thus, QW network control and management can utilize a type of performance monitoring. We also discuss the QW datagram design constraints and future fast packet switching implementations.
We propose Quantum Wrapper as a novel networking technology that enables simultaneous control, management, and operation of quantum networks that coexist with classical networks. The quantum wrapper networks enable the transparent and interoperable transportation of quantum wrapper datagrams consisting of quantum payloads and, notably, classical headers, to facilitate the datagram switching without measuring or disturbing the qubits of the quantum payload. Furthermore, quantum wrapper networks can utilize the common network control and management for performance monitoring on the classical header, and infer the quantum channel quality.
The fundamental properties of quantum mechanics, such as the no-cloning theorem, make management and control of quantum networks challenging. Quantum wrapper networking (QWN) offers a solution to this problem by wrapping quantum payloads with classical bits (as headers and/or tails) that can be used to assist with networking, performance monitoring, and probing the properties of the fiber interconnection. Since the classical header and quantum payload travel in the same fiber, one should carefully design the system to mitigate potentially deleterious effects such as noise and cross-talk. In this paper, we identify and characterize the noise induced by the classical headers by in-fiber scattering processes. We study the noise by using a tunable continuous-wave laser to emulate O-band (∼1310 nm) classical headers, which are time- and wavelength-multiplexed with O-band quantum signals. The noise is characterized as a function of the headers’ power, classical-quantum wavelength detuning, and optical fiber length. We demonstrate that the dominant noise contribution originates from spontaneous Raman scattering for wavelength detunings that are larger than 3 nm. We also observe that some noise photons can bleed into the quantum payload due to Rayleigh scattering of backward Raman scattered photons. We further investigate system level impacts of the noise created by classical headers that are produced by employing a small form-factor pluggable transceiver. We demonstrate that the associated noise level has negligible impact on quantum payloads for a 47.8 km deployed fiber link, the longest length used in QWN experiments to date, achieving a coincidences-to-accidentals ratio of 56 and a two-photon interference visibility of 88.8%.
Quantum wrapper networking (QWN) is an emerging quantum networking protocol that wraps qubits in classical header bits to enable switching/routing, monitoring, and control without detecting the quantum signal. In this work, we encode header bits with two nonorthogonal polarization references to track and actively compensate for the changing birefringence of a 48 km deployed fiber link. Our method is analytical and deterministic, using motorized waveplates and a variable phase retarder to accurately and stably compensate the channel. We verify successful compensation by measuring the polarization stability of single photon qubits and the visibility of entangled photon pairs under both slow birefringence drift due to environmental fluctuations and large sudden changes designed to emulate those that occur during packet switching and rerouting over different fiber paths. For large, sudden changes, our compensator recovers the Stokes vector of single photons to within 10 degrees of the target state on the Poincaré sphere and restores the two-photon interference visibilities to their original levels on the deployed fiber link. Additionally, experiments monitoring long-term compensation over 44 hours show that active polarization compensation maintains the two-photon interference visibility, whereas disabling the compensator leads to visibility degradation over time, particularly in the diagonal-antidiagonal basis, where the average raw visibility decreases by 7.7%. These results add a polarization-control layer to QWN and illustrate that information-carrying headers can enable deterministic physical-layer compensation in the quantum channel over long-distance deployed fiber links.