Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Microelectromechanical Systems

Monolithically Integrated 3D Atomic Chip for Quantum Optical Magnetometry

Ziji Wang, Junming Wu, Gong Sun, Jintang Shang

Published Dec 5, 2023• 2 citations
Publisher

Abstract

A monolithically integrated 3D atomic chip for weak magnetic field detection is presented in this work. A 14.8 ohm MEMS thin film non-magnetic micro heater is monolithically integrated onto a micro spherical alkali vapor cell to realize on-chip atomic density control. Both magnetic and thermal characteristics of the non-magnetic heater are analyzed theoretically. Based on the heater-integrated atomic chip, a chip-scale scalar atomic magnetometer is realized and tested in a magnetic shield. Effect of heating noise suppression methods including high frequency heating, noise-shifting heating and high precision feedback control on magnetometer performance is experimentally analyzed. By further analyzing and eliminating glitch noise in output signal, magnetic noise floor of the constructed device reduced by over 88 %. The proposed atomic chip is especially advantageous for future low-cost and high integration quantum optical magnetometry. [2023-0152]

DOI
10.1109/jmems.2023.3337513

Related papers

Wafer-level integration of micro heaters on an alkali vapor cell for chip-scale atomic magnetometers

Guoliang Li, Jintang Shang, Jin Zhang +1 more

Wafer-level integration of micro heater on an alkali vapor cell for chip-scale SERF magnetometers is presented. In order to obtain a suitable resistivity, polysilicon and aluminum are mixed as the target material. Magnetron sputtering is adopted to fabricate the heater on the surface of the alkali vapor cell. Various voltages are applied to the heater, of which the temperatures are measured by thermal sensitive sensors. Spin exchange relaxation free (SERF) atomic magnetometer with the heater integrated on the alkali vapor cell is characterized. Results show that the micro heater is successfully integrated on the alkali vapor cell. With the integrated heater, the rubidium vapor cell is heated up to 120°C by a 445kHz AC current. The sensitivity of the SERF magnetometer is 6.3pT/Hz1/2. Results also indicate that it provides an effective and low-cost solution for the miniaturization of atomic magnetometers.

International Conference on Electronic Packaging Technology (ICEPT)•Aug 1, 2018•1 citation

Machine learning-assisted design of zero magnetic temperature-control chips for on-chip quantum sensors

Yintao Ma, Di Xiao, Pan Chen +7 more

Alkali-vapor atom-based quantum sensors are urgently needed in the cutting-edge frontier of extremely weak field measurements. However, the generation and control of atomic vapor currently heavily rely on the flexible heater and the discrete temperature sensor, which severely hinder practical application. Herein, we report on-chip, high-performance temperature-control chips with very low residual magnetic flux density, enabled by the multipole-field suppression microstructure designed by particle swarm optimization algorithms, achieving two to three orders of magnitude reduction compared with conventional structures. The unique structure is formed by multiturn parallel winding arrangement, resulting in a synergistic cancelation of the stray magnetic field. A one-step manufacturing process based on oxygen plasma treatment and metal lift-off facilitated tough adhesion is developed for high-efficiency fabrication. As a result, a low magnetic field coefficient of ∼4.3 pT/mA, a high heating power of ∼1 W, and an exceptional temperature fluctuation of ±10 mK are reached, which represents significant improvement in comprehensive performance compared to previous reports. Furthermore, we configure a chip-scale quantum magnetometer with the optimal sensitivity of 10 fT/Hz1/2. Benefiting from its high-performance capabilities, integrated functionality, and the straightforward microfabrication process, the methods reported here are, in principle, generalizable to all thermal alkali-atom-based quantum sensors, including atomic magnetometers, atomic clocks, atomic gyroscopes, and beyond.

Applied Physics Reviews•Nov 12, 2026•0 citations

Demonstration of an integrated nanophotonic chip-scale alkali vapor magnetometer using inverse design

Yoel Sebbag, Eliran Talker, Alex Naiman +2 more

Recently, there has been growing interest in the miniaturization and integration of atomic-based quantum technologies. In addition to the obvious advantages brought by such integration in facilitating mass production, reducing the footprint, and reducing the cost, the flexibility offered by on-chip integration enables the development of new concepts and capabilities. In particular, recent advanced techniques based on computer-assisted optimization algorithms enable the development of newly engineered photonic structures with unconventional functionalities. Taking this concept further, we hereby demonstrate the design, fabrication, and experimental characterization of an integrated nanophotonic-atomic chip magnetometer based on alkali vapor with a micrometer-scale spatial resolution and a magnetic sensitivity of 700 pT/√Hz. The presented platform paves the way for future applications using integrated photonic-atomic chips, including high-spatial-resolution magnetometry, near-field vectorial imaging, magnetically induced switching, and optical isolation.

Light Science & Applications•Mar 11, 2021•72 citations

Chip-Scale Integration of a SERF-Regime Optical Magnetometer

Lei Wu, Jintang Shang, Qi Gan +1 more

Highly sensitive optical magnetometers present high performance in detection of biological magnetic fields from the heart or the brain and have impact on other areas as diverse as magnetic resonance imaging, space science and remote monitoring. A chip-scale SERF-regime optical magnetometer based on a MEMS process is fabricated instead of a large-chamber one and the optical module and the vapor cell are fabricated based on the MEMS process. Industrialization, low cost and high systematic integration level of magnetic sensors can also be achieved based on the wafer-level packaging. Besides, a 200KHz AC electronic current was applied to the heaters for reducing magnetic noises generated by DC currents from heating resistors. The experimental setup based on a SERF-regime magnetometer to test magnetic fields is shown and results indicate that magnetic fields are tested successfully.

IEEE Electronic Components and Technology Conference (ECTC)•May 1, 2016•3 citations

Chip Scale Atomic Magnetometers

Peter D. D. Schwindt, B. J. Lindseth, Svenja A. Knappe +5 more

An optically pumped magnetometer was drastically miniaturized, by taking advantage of MEMS techniques, producing the chip-scale atomic magnetometers (CSAM) physics package. The key component of the package is an alkali vapor cell. To probe the magnetic field experienced by the atoms, the injection current to the VCSEL was modulated at 3.4 GHz near half the hyperfine frequency of87Rb. Lock-in detection is used to determine the center of the resonance, and the magnetic field is determined by counting the modulation frequency, which is related to the Larmor precession frequency under these locked conditions. The ITO heaters create a large magnetic field gradient, which broadens the resonance and reduces the sensitivity.

IEEE International Magnetics Conference•May 1, 2006•15 citations

Microfabricated SERF Atomic Magnetometers for Measurement of Weak Magnetic Field

Kangni Liu, Jintang Shang, Jin Zhang +4 more

This paper introduces measurement of weak magnetic field using a novel design of chip-scale Spin Exchange Relaxation Free (SERF) atomic magnetometer based on a microfabricated Rubidium (Rb) vapor cell. The sensor, which integrates a micro-fabricated Rb vapor cell, a heater and related components, is fabricated by stacking printed circuit boards (PCB) and Micro Electro Mechanical Systems (MEMS) process technology. During the experiments, the noise of the measurement using the atomic magnetometer was obtained. In addition, a test of the simulated magnetic field was performed in a shielding cylinder, and the signal of the simulated magnetic field about 100 pT at 1.2 Hz was measured. The signal is processed by the software using a notch filter to suppress the Direct Current (DC) noise and 50Hz noise. This paper provides a novel micro-fabricated device for detecting weak magnetic field.

IEEE Electronic Components and Technology Conference (ECTC)•Jun 1, 2020•3 citations
A monolithically integrated 3D atomic chip for weak magnetic field detection is presented in this work. A 14.8 ohm MEMS thin film non-magnetic micro heater is monolithically integrated onto a micro spherical alkali vapor cell to realize on-chip atomic density control. Both magnetic and thermal characteristics of the non-magnetic heater are analyzed theoretically. Based on the heater-integrated atomic chip, a chip-scale scalar atomic magnetometer is realized and tested in a magnetic shield. Effect of heating noise suppression methods including high frequency heating, noise-shifting heating and high precision feedback control on magnetometer performance is experimentally analyzed. By further analyzing and eliminating glitch noise in output signal, magnetic noise floor of the constructed device reduced by over 88 %. The proposed atomic chip is especially advantageous for future low-cost and high integration quantum optical magnetometry. [2023-0152]
Wafer-level integration of micro heater on an alkali vapor cell for chip-scale SERF magnetometers is presented. In order to obtain a suitable resistivity, polysilicon and aluminum are mixed as the target material. Magnetron sputtering is adopted to fabricate the heater on the surface of the alkali vapor cell. Various voltages are applied to the heater, of which the temperatures are measured by thermal sensitive sensors. Spin exchange relaxation free (SERF) atomic magnetometer with the heater integrated on the alkali vapor cell is characterized. Results show that the micro heater is successfully integrated on the alkali vapor cell. With the integrated heater, the rubidium vapor cell is heated up to 120°C by a 445kHz AC current. The sensitivity of the SERF magnetometer is 6.3pT/Hz1/2. Results also indicate that it provides an effective and low-cost solution for the miniaturization of atomic magnetometers.
Alkali-vapor atom-based quantum sensors are urgently needed in the cutting-edge frontier of extremely weak field measurements. However, the generation and control of atomic vapor currently heavily rely on the flexible heater and the discrete temperature sensor, which severely hinder practical application. Herein, we report on-chip, high-performance temperature-control chips with very low residual magnetic flux density, enabled by the multipole-field suppression microstructure designed by particle swarm optimization algorithms, achieving two to three orders of magnitude reduction compared with conventional structures. The unique structure is formed by multiturn parallel winding arrangement, resulting in a synergistic cancelation of the stray magnetic field. A one-step manufacturing process based on oxygen plasma treatment and metal lift-off facilitated tough adhesion is developed for high-efficiency fabrication. As a result, a low magnetic field coefficient of ∼4.3 pT/mA, a high heating power of ∼1 W, and an exceptional temperature fluctuation of ±10 mK are reached, which represents significant improvement in comprehensive performance compared to previous reports. Furthermore, we configure a chip-scale quantum magnetometer with the optimal sensitivity of 10 fT/Hz1/2. Benefiting from its high-performance capabilities, integrated functionality, and the straightforward microfabrication process, the methods reported here are, in principle, generalizable to all thermal alkali-atom-based quantum sensors, including atomic magnetometers, atomic clocks, atomic gyroscopes, and beyond.
Recently, there has been growing interest in the miniaturization and integration of atomic-based quantum technologies. In addition to the obvious advantages brought by such integration in facilitating mass production, reducing the footprint, and reducing the cost, the flexibility offered by on-chip integration enables the development of new concepts and capabilities. In particular, recent advanced techniques based on computer-assisted optimization algorithms enable the development of newly engineered photonic structures with unconventional functionalities. Taking this concept further, we hereby demonstrate the design, fabrication, and experimental characterization of an integrated nanophotonic-atomic chip magnetometer based on alkali vapor with a micrometer-scale spatial resolution and a magnetic sensitivity of 700 pT/√Hz. The presented platform paves the way for future applications using integrated photonic-atomic chips, including high-spatial-resolution magnetometry, near-field vectorial imaging, magnetically induced switching, and optical isolation.
Highly sensitive optical magnetometers present high performance in detection of biological magnetic fields from the heart or the brain and have impact on other areas as diverse as magnetic resonance imaging, space science and remote monitoring. A chip-scale SERF-regime optical magnetometer based on a MEMS process is fabricated instead of a large-chamber one and the optical module and the vapor cell are fabricated based on the MEMS process. Industrialization, low cost and high systematic integration level of magnetic sensors can also be achieved based on the wafer-level packaging. Besides, a 200KHz AC electronic current was applied to the heaters for reducing magnetic noises generated by DC currents from heating resistors. The experimental setup based on a SERF-regime magnetometer to test magnetic fields is shown and results indicate that magnetic fields are tested successfully.
An optically pumped magnetometer was drastically miniaturized, by taking advantage of MEMS techniques, producing the chip-scale atomic magnetometers (CSAM) physics package. The key component of the package is an alkali vapor cell. To probe the magnetic field experienced by the atoms, the injection current to the VCSEL was modulated at 3.4 GHz near half the hyperfine frequency of87Rb. Lock-in detection is used to determine the center of the resonance, and the magnetic field is determined by counting the modulation frequency, which is related to the Larmor precession frequency under these locked conditions. The ITO heaters create a large magnetic field gradient, which broadens the resonance and reduces the sensitivity.
This paper introduces measurement of weak magnetic field using a novel design of chip-scale Spin Exchange Relaxation Free (SERF) atomic magnetometer based on a microfabricated Rubidium (Rb) vapor cell. The sensor, which integrates a micro-fabricated Rb vapor cell, a heater and related components, is fabricated by stacking printed circuit boards (PCB) and Micro Electro Mechanical Systems (MEMS) process technology. During the experiments, the noise of the measurement using the atomic magnetometer was obtained. In addition, a test of the simulated magnetic field was performed in a shielding cylinder, and the signal of the simulated magnetic field about 100 pT at 1.2 Hz was measured. The signal is processed by the software using a notch filter to suppress the Direct Current (DC) noise and 50Hz noise. This paper provides a novel micro-fabricated device for detecting weak magnetic field.